铜(Ⅱ)-三氮唑偶氮络合物与脱氧核糖核酸相互作用的电化学行为

运用电化学方法研究了铜（Ⅱ）－三氮唑偶氮（2－[2,3,5-三氮唑偶氮]-5－二甲氨基苯甲酸，TZAMB）络合物与脱氧核糖核酸（DAN）的相互作用。在pH2.5(0.05mol/L）邻苯二甲酸氢钾（PBS）缓冲溶液中，DNA与Cu(Ⅱ）－TZAMB络合物形成一种电惰性结合物，使Cu（Ⅱ）－TZAMB络合物的还原峰电流减小。通过循环伏安法、盐效应以及紫外－可见吸收谱证实了是由Cu(Ⅱ）－TZAMB络合物与DNA形成一种插入式的电惰性结合物而使其峰电流下降。根据这种峰电流下降可以测定DNA，测定结果令人满意。     

Swelling behavior of ionically cross-linked polyampholytic hydrogels in varied salt solutions

Ionically cross-linked polyampholytic hydrogels were synthesized by redox copolymerization of acrylamide and an ionic complex of (N,N-diethylamino)ethyl methacrylate and acrylic acid (designated as PADA hydrogel). The swelling behavior of the hydrogels in water indicated that a minimal equilibrium swelling ratio is found when the molar ratio of anionic/cationic monomers was 1.55. In NaCl solution, the hydrogels exhibited the typical swelling behavior of conventional polyampholytic gels. Their equilibrium swelling ratios increased with an increase in the NaCl concentration. In solutions of multivalent ions (CaCl₂ and trisodium citrate solutions), the equilibrium swelling ratios of the hydrogels increased first and were then followed by a decrease with an increase in salt concentration. Interestingly, an unexpected abrupt swelling phenomenon was observed when the fully swollen hydrogels in salt solution were transmitted to pure water. The unique swelling behavior of PADA hydrogels depends not only on the molar ratio of the anionic/cationic monomers but also on the valency of the ions.     

Rheological Behavior for Mica-filled Polypropylene Composite Melts

The study on rheological properties of a series of mica-filled polypropylene (PP) composites was carried out. The influence of surface-treatment of mica particles on dynamic rheological behavior of the composites were dealt with. The viscosity (η) and dynamic modulus ( G‘ ) of the composite melts were higher than those of PP matrix, especially those for systems treated with silane, which was attributed to the interfacial adhesion enhancement. However, surface-treatment of mica by titanate resulted in lower η and G‘, as compared with the treatment by silane. The reason for this is believed to be the formation of the mono-molecular layer on the mica surface.     

Static ultrasonic oscillations induced degradation and its effect on the linear rheological behavior of novel propylene based plastomer melts

The ultrasonic degradation of novel propylene based plastomer (DP) melts with different melt viscosities was conducted in a “static” ultrasonic device where the samples were taken from various distances from the tip of an ultrasonic probe. The effects of ultrasonic time, oscillation temperature, ultrasonic intensity and the distance from the ultrasonic probe tip on the degradation behavior of DP melts as well as the ultrasonic degradation effect on the linear rheological behavior of DP melts were studied. The results show that the increase of initial melt viscosity of DP (higher molecular weight) has greater impact on the ultrasonic degradation of DP melt. The molecular weight and intrinsic viscosity of DP decrease with the increase of ultrasonic oscillation time and they approach to a limiting value. The molecular weight distribution of DP increases after ultrasonic degradation. Decreasing oscillation temperature and distance from probe tip and increasing ultrasonic intensity lead to an increase in the degradation of DP melt. The linear rheological behavior measurements of the samples obtained near the ultrasonic probe tip show that ultrasonic oscillations decrease the complex viscosity, zero shear viscosity, viscoelastic moduli, cross modulus, relaxation time and the slope of log G′ − log G″ for DP melts.     

Effect of polarization on the electrode behavior and microstructure of (La,Sr)MnO<Subscript>3</Subscript> electrodes of solid oxide fuel cells

The electrode behavior and microstructure of freshly prepared (La_0.8Sr_0.2)_0.9MnO₃ (LSM) electrodes were investigated under various polarization conditions. The original, large agglomerates in freshly prepared LSM electrodes were broken down into sphere-shaped grains when exposed to cathodic or anodic current passage of 200 mA cm^–2 at 800 °C in air for 3 h. Microstructural changes under cathodic polarization could be related to the pronounced diffusion and migration of oxygen vacancies and Mn ions on the LSM surface and lattice expansion, while lattice shrinkage under oxidation conditions most likely contributes to the structural changes under anodic polarization. Such morphological changes were irreversible and were found to be beneficial to the performance of freshly prepared LSM electrodes. Freshly prepared LSM electrodes behaved very differently with respect to the cathodic and anodic current passage treatment.     

Biofuel cell anode based on the Gluconobacter oxydans bacteria cells and 2,6-dichlorophenolindophenol as an electron transport mediator

A basic scheme of the use of the Gluconobacter oxydans bacteria cells as a biocatalyst at an anode of a biofuel cell with air-based cathode is raised up. The anode and cathode of the cell are made of graphite; 2,6-dichlorophenolindophenol serves as an electron transport mediator; and glucose is the substrate to be oxidized. The open-circuit voltage is 55 mV, for the bacteria cell, the mediator, and glucose concentrations of 3 mg/ml (raw weight), 34 mM, and 10 mM, respectively. The voltage and current of the biofuel cell loaded with an external resistance of 10 kohm are 5.6 mV and 0.56 mA. The cell’s internal resistance is 88 kohm.     

CuO超细粉体的形貌与红外特性研究

CuO作为一种多功能精细无机材料，在印染、陶瓷、玻璃及医药等领域的应用已有数十年的历史，作为催化剂的主要活性成分，近年来在氧化、加氢、C１化学合成、NOx还原、CO及碳氢化合物燃烧、精细化工等多种催化反应中也得到了广泛的应用。可以推测，当CuO材料的粒度达到纳米级时，将使它的功能更加独特，应用更为广泛。因此CuO纳米材料的制备方法、聚集状态、与其他组分或载体的作用状况及催化活性等成为当前功能材料发展的研究热点之一犤１～８犦。我们在前文中报道了直接热解Cu２（OH）２CO３所得CuO粒径小、分布均匀、比表面积大，…     

Dynamic surface elasticity of polymer solutions

The surfaces of surfactant solutions exhibit viscoelastic dilational behavior which may be investigated by modern optical and mechanical methods. The present study focuses on the dynamic dilational properties of the polymer solution — gas interface. Linear flexible polymer chains at the surface are considered as consisting of trains, lying on the surface, and loops and tails that protrude into the liquid. The Rouse model is used to describe the inner dynamics of the trains, whereas their motion relative to their neighbors on the surface can be described with the help of the reptation conception. An expression for the complex dynamic dilational surface elasticity has been derived. Although, in general, the relaxation of the surface tension is characterized by an infinite series of relaxation times, it is shown that for many systems the dynamics of the surface layer can be described approximately by only two main relaxation times. The dispersion equation, which was obtained earlier for solutions of conventional surfactants, is shown to be fulfilled for polymer solutions also.     

表面电沉积Ni—La2O3复合镀层的Fe26Cr1Mo不锈钢的氧化行为研究

Ｆｅ２６Ｃｒ１Ｍｏ不锈钢在９００℃氧化时，生成的氧化层在冷却过程中大量剥落，经表面共电沉积ＮｉＬａ２Ｏ３复合镀层后，抗热循环能力明显提高。     

A novel approach for introducing particulate matter into thermal plasmas: The triple-cathode arc

A coalesced high-intensity dc discharge is maintained between three cathodes and a single anode, stabilized by using resistors on each cathode leg. Jets of plasma gas are produced from either the cathode area or the anode area of the device. Cathode jets are generated by the self-induced pumping at the cathode tips and augmented by central gas injection. Arc voltage-current characteristics show classical convection-stabilized arc behavior. Anode heat transfer rates may be substantially increased by central gas injection toward the anode. Temperature fields in the coalesced, axially symmetric portion of the arc are determined spectrometrically and compared to those of a classical single-cathode free-burning arc.