New ligands for the Fe(III)‐mediated reverse atom transfer radical polymerization of methyl methacrylate

A series of (di)picolinic acids and their derivates are investigated as novel complexing tridentate or bidentate ligands in the iron‐mediated reverse atom transfer radical polymerization of methyl methacrylate in N,N‐dimethylformamide at 100 °C with 2,2′‐azobisisobutyrontrile as an initiator. The polymerization rates and polydispersity indices (1.32–1.8) of the resulting polymers are dependent on the structures of the ligands employed. Different iron complexes may be involved in iron‐mediated reverse atom transfer radical polymerization, depending on the type of acid used. ¹H NMR spectroscopy has been used to study the structure of the resulting polymers. Chain‐extension reactions have been performed to further confirm the living nature of this catalytic system. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2912–2921, 2006     

HgCl2/I2复合催化剂协同催化合成异丙醇钇的研究

以金属钇和异丙醇为原料，以HgCl2/I2为复合催化剂，通过对金属钇的机械加工以增加其比表面，并将异丙醇脱水使其含水量降低至0．05％，体系在82℃回流5h，经过滤、减压蒸馏，得到了白色海绵状异丙醇钇，其产率高达83％，合成时间比文献报道的缩短了19h，产率提高了8％。文章确定了催化剂的最佳用量为20gY加入60mg HgCl2/I2，研究了合成产率与HgCl2/I2催化剂和HgCl2催化剂的依赖关系及异丙醇中含水量对合成产率的影响，并对HgCl2/I2的催化作用机理进行了初步探讨。     

Synthesis of coumarins by Pt-catalyzed hydroarylation of propiolic acids with phenols

Synthesis of coumarins from phenols and propiolic acids was examined by using a Pt catalyst such as PtCl₂/AgOTf, K₂PtCl₄/AgOTf, and K₂PtCl₄/AgOAc. Propiolic acid reacted even with less reactive phenols in trifluoroacetic acid to give coumarins and dihydrocoumarins. In the case of substituted propiolic acids, phenylpropiolic acid and 2-octynoic acid, the reactions proceeded selectively to afford coumarins in good to high yields.     

催化剂薄层内甲烷水蒸气重整反应强化管内对流换热的数值模拟

本文以竖直圆管内壁催化剂薄层内发生甲烷水蒸气重整反应强化对流换热作为研究对象,对其进行了数值模拟．结果发现,催化剂薄层内的吸热化学反应可以有效地强化对流换热,降低流体和壁面温度,从而对壁面起到保护作用;极限热流密度的大小与流体的入口温度有关,存在最佳入口温度使极限热流密度最大．     

A solvent-free synthesis of coumarins using a Wells-Dawson heteropolyacid as catalyst

Substituted coumarins are synthesized from phenols and β-ketoesters by the Pechmann reaction, using a Wells-Dawson heteropolyacid (H₆P₂W₁₈O₆₂·24H₂O) as catalyst by a solvent-free procedure. This one requires low reaction times, 130 °C temperature and as little as 1 mol % of Wells-Dawson acid, obtaining good to excellent yields of coumarins. The catalyst showed to be reusable with no differences in the yields. The results are compared with those of the reactions performed in toluene solution. The presented synthetic procedure is a convenient, clean and fast alternative for synthesizing 4-substituted coumarins (17 examples).     

Preparation of rhodium–phyllosilicate catalysts without leaching in liquid-phase 1-hexene hydrogenation

Rhodium catalysts have been prepared on palygorskite and montmorillonite (clay) supports by reduction with hydrogen (1 atmosphere) at room temperature of a cationic organometallic rhodium compound anchored to the support. The activity of these catalysts for the hydrogenation of liquid-phase 1-hexene remains constant with increase of prehydrogenation time and with re-use for several runs. No rhodium leaching is observed.     

Li3N、Mg3N2、Ca3N2催化作用的比较和分析

 Li₃N、Mg₃N₂和Ca₃N₂是高温高压下以hBN为原料合成cBN的催化剂。在实验中发现它们对常压高温下生成hBN的反应也表现出催化作用。对比了三种氮化物催化效果的差异，发现三种氮化物都只有在熔融状态下才能表现出催化效果，以及三种氮化物对生成hBN反应的催化效果与它们在高温高压下合成cBN反应的催化效果次序相似。提出了对合成hBN有催化作用的化合物也将对合成cBN表现出催化作用的观点。     

Polymerization behaviors of racemic and chiral amphiphilic monomers in organized bilayer membranes of lamellar liquid crystalline phase

A racemic amphiphilic monomer, n‐dodecyl glyceryl itaconate (DGI), forms bilayer membranes in water in the presence of small amount of ionic cosurfactant and shows iridescent color. A chiral DGI, S‐DGI, also shows an iridescent property, but with a rather red shift in the color, which can be ascribed to the increased packing density of the monomer in the bilayer membranes. Chrial DGI has a more compact packing density than racemic one owing to closer distance between the monomer molecules; the conversion rate, however, is slower than that of racemic one when H₂O₂ is used as an initiator. When the initiator is changed to an amphiphilic one, 4‐(2‐hydroxyethoxy) phenyl‐(2‐hydroxy‐2‐propyl) ketone (Irgacure 2959), the chiral DGI shows even a little faster conversion rate than that of racemic one. The NMR chemical shift results of protons in benzene ring show that the molecules of Irgacure 2959 insert into the bilayer membranes. The molecular weights of the corresponding polymers prove that the initiation by H₂O₂ is restricted compared to that by Irgacure 2959. It is concluded that the decelerated polymerization behavior of chiral DGI initiated by H₂O₂ is a result of limited diffusion of the initiator into the lamellar bilayer structures. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4891–4900, 2007     

A simplified green chemistry approach to the Biginelli reaction using ‘Grindstone Chemistry’

Grindstone Chemistry--a greatly evolved version of Toda’s method of grinding solids together for solvent-free chemical reactions--has been described and its usefulness illustrated by the successful application of this technique to a simplified process for conducting the multi-component Biginelli reaction for the synthesis of physiologically active tetrahydropyrimidinones.     

Self‐assembly of amphiphilic tris(2,2′‐bipyridine)ruthenium‐cored star‐shaped polymers

Amphiphilic tris(2,2′‐bipyridine)ruthenium‐cored star‐shaped polymers consisting of one polystyrene block and two poly(N‐isopropylacrylamide) blocks were prepared by the “arm‐first” method in which RAFT polymerization and nonconvalent ligand–metal complexation were employed. The prepared amphiphilic star‐shaped metallopolymers are able to form micelles in water. The size and distribution of the micelles were studied by dynamic light scattering and transmission electron microscopy techniques. Preliminary studies indicate that the polymer concentration and the hydrophilic poly(N‐isopropylacrylamide) block length can affect the morphologies of the formed metal‐interfaced core–shell micelles in water. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4204–4210, 2007