Development of an Automatic Electrochemical System for Differential Pulse Amperometry and Its Application for Se(IV) Determination

This work presents the development of an automatic system for differential pulse amperometry (DPA) with electrochemical deposition. The system consists of a microcomputer, running a home‐made software, connected to a commercial potentiostat through a data acquisition board. The system was applied for selenium determination using gold electrode and flow injection analysis (FIA). Analytical curves were obtained in the concentration range of 20 to 400 μg L^?1 for Se(IV), with a calculated detection limit of 6 μg L^?1. The analysis results for fish samples doped with Se(IV) and digested in a microwave oven showed recoveries above 93%.     

Potassium Concentration Alters Calibration Sensitivities of Dopamine but not Serotonin

The use of carbon fibre microelectrodes and amperometric techniques for measurement of biological molecules has been widely studied. The use of calibrations to translate biological data is common practice between labs. Tris buffer is commonly used for conducting calibrations, where potassium ion concentrations are varied in buffers. However, little is known about how changes in this ion alter the calibration sensitivity of neurotransmitters. This work showcases that dopamine calibrations are highly dependent on the concentration of potassium ions, whilst serotonin is less affected. Our findings have implications on interpretation and comparison of measurements between different studies.     

Simultaneous Determination of Caffeine,Ibuprofen, and Paracetamol by Flow‐injection Analysis with Multiple‐pulse Amperometric Detection on Boron‐doped Diamond Electrode

This work presents a simple, fast and low‐cost method for the simultaneous determination of three drugs by flow‐injection analysis with multiple‐pulse amperometric (MPA) detection using a wall‐jet flow cell with a boron‐doped diamond electrode. The amperometric determination of caffeine (CF), ibuprofen (IB) and paracetamol (PC) was performed by the application of a four‐potential waveform using the MPA technique. PC is oxidized at E₁ (1.20 V/70 ms) and thus selectively detected; PC and CF are oxidized at E₂ (1.49 V/40 ms); PC, CF and IB are oxidized at E₃ (1.70 V/70 ms); and E₄ (1.80 V/100 ms) is applied for electrode cleaning. The subtraction of currents obtained at the different potentials did not provide accurate determinations of CF and IB, thus it was required to investigate correction factors to determine CF and IB without the interference from PC and CF using the respective amperometric signals obtained at E₂ and E₃. The proposed method was successfully applied for the determination of three drugs in pharmaceutical samples with low generation of residues and a high analytical frequency (150 h^?1) in comparison with HPLC‐DAD method.     

Flow‐Injection Pulsed‐Amperometric Determination of Free Glycerol in Biodiesel at a Gold Electrode

This work reports the highly‐sensitive amperometric determination of free glycerol in biodiesel at a gold electrode adapted in a flow‐injection analysis (FIA) cell. The amperometric method involved the continuous application of three sequential pulses to the working electrode (+250 mV, +700 mV, and ?200 mV, for 100 ms each). This sequence of potential pulses eliminated electrode passivation and dramatically increased the analytical signal. The proposed FIA‐amperometric method presented low relative standard deviation between injections (1.5 %, n=15), high analytical frequency (85 h^?1), satisfactory recovery values (93–118 %) for spiked samples, wide linear range (from 1 to 300 µmol L^?1), and low detection limit (0.5 µmol L^?1).     

Electrodes Potentiometriques Et Amperometriques a Levures Permeabilisees: Determination Du L-Lactate

Abstract

A biosensor using permeabilized yeasts (Hansenula anomala) is described for the determination of L-lactate. The same electrode can be used either potentiometrically or amperometrically. The linear ranges are respectively of 4.10^?5M to 2.10^?3M for potentiometry and 8.10^?7M to 3.10^?3M for amperometry with a reproducibility and a precision of ± 2 to 3%. The parameters involved in the optimization of electrode response, such as pH, temperature, cofactor concentration and ionic strength of the buffers, are discussed in details for both types of measurements. The amperometric technique is suitable for lactate determinations in biological media. In this case, differential measurements are used in order to eliminate interferences of biological redox reactions.     

Amperometry with Two Polarizable Electrodes. Chelometric Determination of Rare Earths

Abstract

The method of determining rare earths by chelometric EDTA titration with biamperometric end-point indication using two stationary platinum electrodes was studied. The convenient pH range for the determination of lanthanum is 5.0 – 8.0, for yttrium 3.5 – 8.0 and for ytterbium 3.0 – 8.0. Rare earths have been determined in the presence of iron and thorium. Iron and thorium can be titrated at pH 1.5 – 2.0 and rare earths of the lanthanum group can be determined by successive titration at pH 5.0. Large amounts of rare earths of the yttrium group interfere with the determination of iron and thorium.     

Disposable Amperometric Immunosensor for the Determination of the E‐Cadherin Tumor Suppressor Protein in Cancer Cells and Human Tissues

This paper describes the results obtained in the development of the first electrochemical immunosensor described to date for the detection of E‐cadherin (E‐cad) protein, a relevant biomarker of prognosis and metastasis in cancer, based on the use of magnetic microcarriers (MBs) and amperometric transduction at screen‐printed carbon electrodes (SPCEs). Thus, the determination of E‐cad protein involved the use of two specific antibodies against this protein (one of them labelled with HRP) in a sandwich configuration onto HOOC‐MBs. The magnetic bioconjugates were captured onto SPCEs and the amperometric transduction was performed using the H₂O₂/hydroquinone (HQ) system. Under optimal conditions, this bioplatform demonstrated a wide linear concentration range (0.50–25 ng mL^?1) and a detection limit as low as 0.16 ng mL^?1, well below the optimal cut‐off level for the E‐cad protein (defined as 10,000 ng mL^?1 for soluble E‐cad levels in serum). The developed sensor also showed a good reproducibility among measurements with seven different sensors constructed in the same manner (RSD, 5.4 %), stability for more than 15 days and good specificity towards other proteins commonly found on biological samples. The applicability of this simple handling bioplatform for the direct determination of this protein in cell lysates with different metastatic potential and extracts from paraffined‐embedded human colorectal cancer tissues of different grade were also demonstrated.     

Electrochemical Detection of Droplets in Microfluidic Devices: Simultaneous Determination of Velocity,Size and Content

Microfluidic devices were designed to electrochemically detect in a two‐phase flow the velocity, size and content of aqueous droplets containing redox species. The principle of these determinations is based on the analysis of a unique chronoamperometric response recorded during the passage of a droplet over channel microelectrodes. Two configurations of electrochemical cell with different geometries were investigated both theoretically and experimentally. Velocity and size of droplets, as well as internal recirculating convection within droplets, were evaluated from chronoamperometric curves by specific transition times depending on the cell configuration. In addition, the droplet content was probed from the Faradaic current controlled by mass transport and by internal hydrodynamic regime. For droplet velocity and size, experimental data were systematically compared to optical measurements. All the results demonstrated the high performance of the electrochemical detection reached under these conditions. They successfully validate the concept of self‐consistent electrochemical detections of aqueous droplets within microchannels for the simultaneous determination of their velocity, size and content.     

In Vitro Antioxidant and Prooxidant Activities of Red Raspberry (Rubus idaeus L.) Stem Extracts

Leaves and stems of red raspberry (Rubus idaeus) are used in Lithuanian folk medicine. Healing properties of raspberry are related to the content of bioactive compounds, mainly polyphenols. Extracts of raspberry leaves contained higher total phenolic content (TPC) (1290 mg/L, expressed in gallic acid equivalent) compared to that in extracts of stems or peeled bark (up to 420 mg/L and 598 mg/L, respectively). To find out whether the collection time of herbal material was critical for the properties of the extracts, the stems were collected at different times of the year. TPC in the extracts depended more on extraction conditions rather than on the sampling time. Antioxidant activity of raspberry stem and bark extracts tested by spectrophotometric (DPPH^● scavenging) and electrochemical (cyclic and differential pulse voltammetry) assays correlated with TPC. DPPH radical scavenging activity values for stem, leaf, and bark extracts were as follows: ≤1.18 ± 0.07, 1.63 ± 0.10, and ≤1.90 ± 0.04 (mmol/L, TROLOX equivalent), respectively. Assessed electrochemically, hydrogen peroxide-scavenging activity of extracts was independent on TPC. The latter activity was related to the presence of some protein in the extract as revealed by gel electrophoresis. Prooxidant activity of raspberry stem extracts was dependent on solution pH and temperature.     

Liquid Chromatography Electrochemical Determination of Nicotine in Third‐Hand Smoke

Third‐hand smoke (THS) can be defined as the contamination of surfaces by second‐hand smoke. This residue can form further pollutants which can be re‐suspended in dust or be re‐emitted into the gas phase. THS is a complex mixture and as a result studies have focused on nicotine as a marker of THS, it being the most abundant and indicative organic compound deposited. In this present study, the extraction of dust wipe samples and the subsequent chromatographic conditions required for the separation of nicotine by liquid chromatography with electrochemical detection were investigated and optimised. The optimum chromatographic conditions were identified as a 150 mm×4.6 mm, 5 µm C₁₈ column with a mobile phase consisting of 65 % methanol, 35 % pH 8 20 mM phosphate buffer. Hydrodynamic voltammetry was used to optimise the applied potential which was identified to be +1.8 V (vs . stainless steel). Under these conditions, a linear range for nicotine of 13 to 3240 µg/L (0.26 ng–65 ng on column) was obtained, with a detection limit of 3.0 µg/L (0.06 ng on column) based on a signal‐to‐noise ratio of three. Dust wipe samples were extracted in methanol with the aid of sonication. Mean recoveries of 98.4 % (% CV=7.8 %) were found for dust wipe samples spiked with 6.50 µg of nicotine. Musk ketone, urea and stearic acid were found not to interfere. Communal entrance ways were found to be contaminated with THS nicotine levels of between 66.8 and 156 µg/m².