Skin Thickness and β-Crystals Development in Injection-Molded iPP Along the Flow Direction

In this study, iPP was injection molded at 180°C, 200°C, and 220°C. According to polarization optical microscopy (POM) results, for a given part, the skin thickness steadily decreases along the flow direction. However, at the same distance from the gate, the skin thickness of the parts molded at lower melt temperature is larger than that molded at higher melt temperature. It is found that flow time (here, the time taken for melt to pass the specific position along the flow direction) and melt temperature are two significant factors leading to this phenomenon, while the gate size is another one.

The DSC and WAXD results show that the relative fraction of β-form crystals, for a specific part, decreases along the flow direction, which is mainly determined by flow time. However, for the parts molded at different molding temperatures, the fraction of the β-form crystals is mainly determined by the molding temperature, though this influence is very complex.     

无线光通信中脉冲位置调制信号误码率的蒙特卡罗仿真

分析了在无线光通信链路中对激光脉冲应用脉冲位置调制的误码率,介绍了蒙特卡罗仿真方法的基本思想及其处理概率问题的方法步骤,并用蒙特卡罗仿真方法得到了脉冲位置调制信号的误码率.仿真结果表明,脉冲位置调制信号的误码率随入射光强的增大而减小,可用雪崩光电二极管对其进行探测以得到良好的接收性能.这对探讨脉冲位置调制光通信链路的系统特性和无线光通信接收系统的设计具有一定的参考价值.     

整体X光透镜性能实验研究

利用高计数率探测器和低功率光源,在大的能量范围内,同时测量了整体X光透镜的传输效率和焦斑直径与能量的关系。实验结果表明：透镜的焦斑直径随着能量的升高而减小;对04-5-10-5透镜而言,在高于5．8keV的能量范围内,透镜的传输效率随着能量的升高而降低,在低于5．8keV的能量范围内,透镜的传输效率随着能量的升高而增加。通过测量不同能量的X射线在透镜会聚光束中的空间分布,研究了短出口焦距透镜的光晕现象,光晕会导致透镜焦斑直径增大和传输效率测量值的增加。利用轴向扫描法研究了整体X光透镜出口焦距和能量的关系,实验结果表明：会聚透镜的出口焦距随着X射线能量的升高而增加。     

Steric effects on the mechanism of reaction of nucleophilic substitution of β‐substituted alkoxyvinyl trifluoromethyl ketones with four secondary amines

The kinetics of the reaction of β‐substituted β‐alkoxyvinyl trifluoromethyl ketones R¹O‐CR²?CH‐COCF₃ ( 1a – e ) [( 1a ), R¹?C₂H₅, R²?H; ( 1b ), R¹?R²?CH₃; ( 1c ), R¹?C₂H₅, R²?C₆H₅; ( 1d ), R¹?C₂H₅, R²?V^?pNO₂C₆H₄; ( 1e ), R¹?C₂H₅, R²?C(CH₃)₃] with four aliphatic amines ( 2a – d ) [( 2a ), (C₂H₅)₂NH; ( 2b ), (i‐C₃H₇)₂NH; ( 2c ), (CH₂)₅NH; ( 2d ), O(CH₂CH₂)₂NH] was studied in two aprotic solvents, hexane and acetonitrile. The least reactive stereoisomeric form of ( 1a – d ) was the most populated ( E‐s‐Z‐o‐Z ) form, whereas in ( 1e ), the more reactive form ( Z‐s‐Z‐o‐Z ) dominated. The reactions studied proceeded via common transition state formation whose decomposition occurred by ‘uncatalyzed’ and/or ‘catalyzed’ route. Shielding of the reaction centre by bulky β‐substituents lowered abruptly both k′ (‘uncatalyzed’ rate constant) and k″ (‘catalyzed’ rate constant) of this reaction. Bulky amines reduced k″ to a greater extent than k′ as a result of an additional steric retardation to the approach of the bulky amine to its ammonium ion in the transition state. An increase in the electron‐withdrawing ability of the β‐substituent increased ‘uncatalyzed’ k′ due to the acceleration of the initial nucleophile attack (k₁) and ‘uncatalyzed’ decomposition of transition state (k₂) via promoting electrophilic assistance (through transition state 8 ). The amine basicity determined the route of the reaction: the higher amine basicity, the higher k₃/k₂ ratio (a measure of the ‘catalyzed’ route contribution as compared to the ‘uncatalyzed’ process) was. ‘Uncatalyzed’ route predominated for all reactions; however in polar acetonitrile the contribution of the ‘catalyzed’ route was significant for amines with high pK_a and small bulk. Copyright © 2007 John Wiley & Sons, Ltd.     

High strain rate sensitivity of hardness in quinary Ti-Zr-Hf-Cu-Ni high entropy metallic glass thin films

Quinary Ti-Zr-Hf-Cu-Ni high-entropy metallic glass thin films were produced by magnetron sputter deposition. Nanoindentation tests indicate that the deposited film exhibits a relatively large hardness of 10.4±0.6 GPa and a high elastic modulus of 131±11 GPa under the strain rate of 0.5 s⁻¹. Specifically, the strain rate sensitivity of hardness measured for the thin film is 0.05, the highest value reported for metallic glasses so far. Such high strain rate sensitivity of hardness is likely due to the high-entropy effect which stabilizes the amorphous structure with enhanced homogeneity.     

Investigation of Hybrid Optical Amplifiers for Dense Wavelength Division Multiplexed System with Reduced Spacings at Higher Bit Rates

Abstract

This article proposes various combinations of optical amplifiers for a dense wavelength division multiplexed system and investigates the impact of reduced channel spacing at high bit rates in terms of quality factor, bit error rate, eye closure, and output power. It is reported that the hybrid optical amplifier (Raman–erbium-doped fiber amplifier [EDFA]) provides better results with a maximum covered single span distance (220 km) at channel spacing of 6.25 GHz. The maximum acceptable bit rate for the 12.5-GHz channel spacing dense wavelength division multiplexed system is also investigated, and the recommendation is provided that for the Raman–EDFA, Raman–EDFA–Raman, EDFA–Raman–EDFA, and EDFA–semiconductor optical amplifier–EDFA, the operating bit rate should not be greater than 20, 16, 19, and 20 Gbps, respectively.     

Gastrennung mit Hilfe des Zirkulations-Diffusions-Verfahrens Teil I : Hochanreicherung von Gasen in Trennrohren mit natürlicher Zirkulation

Auf der Grundlage des Zirkulations-Diffusions-Prinzips wurden zwei Trennrohre für die Hochanreicherung von Gasen enytwickelt. Als Modellgasmischungen dienten H₂-N₂ Kr-CH₄ und Luft. Neben Wasserdampf wurden Methanol- und Äthaanoldämpfe als Treibmittel benutzt. Gute Trennungen wurden in einem nur 20 cm langen Rohr erzielt, dessen Trennspalt horizontal durch Lamellen in kleine Sektionen und durch ein Drahtdiaphragma vertikal in zwei Ringkammern geteilt wird. Drei Rohre dieses Typs wurden in einer rechteckigen Kaskadenanordnung getestet. Die Theorie des Transportes im Trennrohr sowie die Behandlung des hydrodynamischen Problems werden angegeben. Eine Anwendung des beschriebenen Trennrohres zur Isotopentrennung und zur Gashochanreicherung erscheint aussichtsreich.     

Some Analytical Properties of the Model for Stochastic Evolutionary Games in Finite Populations with Non-uniform Interaction Rate

Traditional evolutionary games assume uniform interaction rate, which means that the rate at which individuals meet and interact is independent of their strategies. But in some systems, especially biological systems, the players interact with each other discriminately. Taylor and Nowak (2006) were the first to establish the corresponding non-uniform interaction rate model by allowing the interaction rates to depend on strategies. Their model is based on replicator dynamics which assumes an infinite size population. But in reality, the number of individuals in the population is always finite, and there will be some random interference in the individuals' strategy selection process. Therefore, it is more practical to establish the corresponding stochastic evolutionary model in finite populations. In fact, the analysis of evolutionary games in a finite size population is more difficult. Just as Taylor and Nowak said in the outlook section of their paper, "The analysis of non-uniform interaction rates should be extended to stochastic game dynamics of finite populations." In this paper, we are exactly doing this work. We extend Taylor and Nowak's model from infinite to finite case, especially focusing on the influence of non-uniform connection characteristics on the evolutionary stable state of the system. We model the strategy evolutionary process of the population by a continuous ergodic Markov process. Based on the limit distribution of the process, we can give the evolutionary stable state of the system. We make a complete classification of the symmetric 2×2 games. For each case game, the corresponding limit distribution of the Markov-based process is given when noise intensity is small enough. In contrast with most literatures in evolutionary games using the simulation method, all our results obtained are analytical. Especially, in the dominant-case game, coexistence of the two strategies may become evolutionary stable states in our model. This result can be used to explain the emergence of cooperation in the Prisoner is Dilemma Games to some extent. Some specific examples are given to illustrate our results.     

Mdm2生成速率调控的p53-Mdm2振子的全局动力学和稳定性

肿瘤抑制蛋白p53的动力学在一定程度上可以决定DNA损伤后的细胞命运.p53的动力学行为与p53信号通路中p53-Mdm2振子模块密切相关.然而,p53的负调控子Mdm2的生成速率的增加使其在一些癌细胞中过表达.因此探讨Mdm2生成速率对p53动力学的影响有重要意义.同时,PDCD5作为p53的激活子也调控p53的表达.因此,本文针对PDCD5调控的p53-Mdm2振子模型,通过分岔分析获得了Mdm2生成速率所调控的p53的单稳态、振荡以及单稳态与振荡共存的动力学行为,且稳定性通过能量面进行了分析.此外,噪声强度对p53动力学的稳定性有重要的影响.因此,针对p53的振荡行为,探讨了噪声强度对势垒高度和周期的影响.本文所获得的结果对理解DNA损伤后的p53信号通路调控起到一定的指导作用.     

孤立系内热传导过程(火积)耗散的解析解

(火积)耗散与熵增均可以作为传热不可逆性的度量, 当前(火积)理论的反对者认为(火积)是不必要的. 为说明(火积)的必要性, 从有效性的角度进行了论证, 即在描述传热过程不可逆性的变化上, (火积)的严格解析解存在, 而熵的严格解析解难以得到. 本文构建了孤立系内的一维及多维热传导模型, 求解了温度及其梯度的级数型解析解, 将其代入(火积)耗散的求解式, 得到其最初的形式为一多重级数的多重积分, 交换积分与级数计算顺序, 并利用特征函数的正交性, 将(火积)耗散求解式中的积分运算求出, 并使级数的维数降低, 最终将其表示为一稳态项与一瞬态项加和的形式, 其极限与文献中的结果一致. 通过对孤立系内(火积)耗散解析解的求解可以得出: 由于热传导过程熵与(火积)的解析解求解难度不同, 在描述传热过程不可逆性变化上, (火积)更加有效; 对于孤立系内不同维数的热传导问题, 只要温度场解析解存在, (火积)耗散解析解均可以应用特征函数正交性求解得到.