CuZnAl水滑石衍生催化剂上甲醇水蒸气重整制氢Ⅲ.合成水滑石用金属盐的影响

采用共沉淀法,用不同金属盐为Cu源和Zn源合成了一系列CuZnAl水滑石,以此为前体经600℃焙烧后制得相应催化剂.用硝酸盐和醋酸盐合成的水滑石结晶度高,其衍生催化剂比表面积大、Cu的分散性好且易于还原;而用硫酸盐和盐酸盐合成的水滑石结晶度差,其衍生催化剂比表面积小、Cu的分散性差且不易还原.反应评价结果显示,用硝酸盐和醋酸盐制得的催化剂活性高、反应稳定性好;而用硫酸盐和盐酸盐制得的催化剂由于低的Cu表面积以及S和Cl的毒化作用而几乎无催化活性.在醋酸盐制备的催化剂上,产物干气中CO的浓度明显较低,在250℃和WHSV=3.28 h-1的条件下约为0.03%~0.04%,仅为硝酸盐所制催化剂上CO浓度的1/5;在210℃和WHSV=0.5 h-1的条件下,该催化剂上甲醇几乎完全转化,同时CO浓度降至约0.005%.N2O滴定、CO2程序升温脱附和程序升温还原结果显示,用醋酸盐和硝酸盐制备的催化剂具有极相近的Cu表面积和表面碱性,但前者CuO的还原峰温较后者低近70℃,归因于ZnO与CuO间的强相互作用,这是催化剂具有良好选择性的可能原因.     

Skeletal Isomerization of <Emphasis Type="Italic">n</Emphasis>-butenes over Solid Acid Catalysts

Conversion reactions of n-butenes over zeolites and amorphous catalysts have been investigated to deduce the factor that determines the selectivity for the skeletal isomerization producing isobutene. The effects of pore structure and acid site concentration on the selectivity for the skeletal isomerization are discussed on various catalysts. The pore structures of FER and CLI zeolites induce the distant locations of butene molecules, accelerating monomolecular skeletal isomerization. On the other hand, acid site concentration determines the preferred reaction path of n-butenes on amorphous catalysts. Oligomerization followed by cracking that produces various hydrocarbons is suppressed on the catalyst with low acid site concentration, resulting in high selectivity for isobutene. The feasibility of monomolecular skeletal isomerization on zeolites and amorphous catalysts is confirmed by its reversibility with high selectivity.     

CdSe纳米线阵列的制备及其表征(英)

通过在含有SeSO₃^2-和Cd²⁺的室温水溶液中，用模板-电沉积法在纳米孔阵列阳极氧化铝膜(AAM)模板中制备了高有序性的CdSe纳米线阵列，并对其形貌、结构和组分进行了表征。扫描电子显微镜(SEM)和透射电子显微镜(TEM)结果表明，纳米线阵列中的CdSe纳米线具有相同的长度和直径，分别对应于使用的AAM模板的厚度和孔径；X-射线衍射(XRD)和X-射线能谱(EDAX)结果表明，CdSe纳米线中Cd和Se的化学组成非常接近于1∶1，其结构为立方CdSe。另外，对模板-电沉积法制备CdSe纳米线的机理进行了讨论。     

Complete Oxidation of Methane over Palladium Supported on Alumina Modified with Calcium,Lanthanum,and Cerium Ions

The activity and thermal stability of Pd/Al_2O_3 and Pd/(Al_2O_3 MO_x)(M=Ca,La,Ce) palladium catalysts in the reaction of complete oxidation of methane are presented in this study.The catalyst supports were prepared by sol-gel method and they were dried either conventionally or with supercritical carbon dioxide.Then they were impregnated with palladium nitrate solution.The catalysts with unmodified alumina had a high surface area.The activity and thermal stability of the alumina- supported catalyst was also very high.The introduction of calcium,lanthanum,or cerium oxide into alumina support caused a decrease of the surface area in the way dependent on the support precursor drying method.These modifiers decreased the activity of palladium catalysts,and they required higher temperatures for the complete oxidation of methane than unmodified Pd/Al_2O_3.The improvement of the palladium activity by lanthanum and cerium support modifier was observed only at low temperatures of the reaction.     

催化裂化汽油脱硫添加剂USY/ZnO/Al2O3的性能评价

 在固定流化床催化裂化装置上，以减压蜡油为原料，对制备的U\r\nSY／ZnO／Al2O3催化裂化汽油脱硫添加剂的性能进行了评价．结果表明\r\n，随着添加剂添加量和剂油比的增加，生成汽油的硫含量降低．在500\r\n℃和剂油比为5的条件下，在FCC平衡催化剂中添加30％的添加剂时，汽\r\n油的硫含量可由不加添加剂时的1230μg／g降低到770μg／g左右．添\r\n加剂的添加量（10％）较低时，对催化裂化产物的分布基本没有影响；\r\n添加30％的添加剂时，焦炭的产率有所增加，但汽油收率基本不变．X\r\nRD表征结果表明，USY／ZnO／Al2O3添加剂中的ZnO对USY的晶相结构有\r\n一定的破坏作用，但随着反应与再生次数的增多，ZnO与Al2O3之间形成\r\n较为稳定的锌铝尖晶石结构，使添加剂的性能趋于稳定．     

Modification of Non-Hydrolytic Sol-Gel Derived Alumina by Solvent Treatments

The effect of wetting non-hydrolytic derived alumina xerogels with water and organic solvents in the 20–70°C range on the alumina's properties was investigated. Wetting with organic solvents does not affect the alumina. However, contact with water was found to change the sharp crystallization at 800°C to a continuous crystallization starting at 450°C. Water treatment for a day at room temperature (RT) followed by second calcination decreased the surface area by 10%. This decrease in surface area is less pronounced with increasing wetting periods. On the other hand water treatment at 50–70°C followed by a second calcination resulted in a surface area increase of up to 15%. Upon water treatment the total pore volume has decreased from 0.65 (cm³/gr) to 0.48 (cm³/gr) and the average pore size decreased from 6.8 nm to 4.1 nm. The Cl content was found to be uneffected by the water treatment, remaining at 2.5% wt. Wetting with water at elevated temperature (70°C) accelerated the morphological changes, eliminating the crystallization peak at 800°C in one hour. A dissolution-reprecipitation mechanism is suggested to explain the results. In addition, Mass-Spectroscopy of the effluent gas during heat treatment revealed the emission of CO₂ and water upon phase transition into -Al₂O₃, at 1150–1300°C.     

Influence of velocity and surface temperature of alumina particles on the properties of plasma sprayed coatings

In this paper are described the main characteristics of the plasma spraying process of alumina deposits, i.e., the temperature and flow field of the plasma jets obtained with the classical spraying torches, the injection of the particles into the plasma jet, the particle surface temperature and velocities in the plasma (measured for calibrated alumina particles), and the coating generation. The measurements on the alumina particles are compared with the predictions of a mathematical model. The experimental and computed particle velocities are in rather good agreement. However, this is not the case for the particle surface temperature. Possible reasons for the discrepancy are proposed (influence of the carrier gas, thermophoretic forces, and poor penetration of the particles into the plasma core even for an injection velocity twice that of the optimal calculated one, as shown by recent measurements). Finally the correlations between the particle velocities and surface temperature, and the properties of the alumina coating (porosity, crystal structure, mechanical properties) are studied.     

Reactions of Hydroxyazolidines with π-Donor Heterocycles. 3. Reaction of 1-Acetyl-5-hydroxypyrazolidines with Oxindoles

The reaction of oxindoles with 5-hydroxypyrazolidines on the surface of potassium fluoride-modified alumina leads to 3-(5-pyrazolidinyl)oxindoles. The structure of these products was studied.     

Chemical environment of copper at the surface of a CuAl2 model alloy: XPS,MEIS and TEM analyses

Air‐formed oxide on a CuAl₂ model alloy is shown to be free of copper species, with copper enriching in the alloy. With thickening of the oxide by anodizing, copper enriches further to a critical concentration at which its oxidation proceeds with incorporation of Cu(II) species into the film. Such species migrate more rapidly through the film than aluminium species. Incorporation of copper species is associated with generation of oxygen gas within the film and subsequent film rupture is due to release of the gas. Reduction of Cu(II) to Cu(I) species during XPS analysis is characterized and the accelerating role of charge neutralizing is highlighted. Copyright © 2004 John Wiley & Sons, Ltd.     

高比表面积窄孔分布氧化铝的制备研究 Ⅰ.沉淀条件的影响

 以硫酸铝液为原料，以氨水、氢氧化钠和铝酸钠为碱沉淀剂，采用pH摆动法制备了高比表面积、大孔径、窄孔分布、大孔体积氧化铝，考察了沉淀剂、沉淀温度及沉淀时酸侧pH值对氧化铝物性的影响，并对pH摆动法与等pH沉淀法的结果进行了比较．结果表明，通过改变制备参数可以获得高比表面积、大孔体积的氧化铝，当沉淀温度为70℃，pH摆动3或4次时，氧化铝的孔体积可高达1．0ml／g，比表面积仍大于300m2／g．用pH摆动法制得的样品比用等pH沉淀法制得的样品容易酸溶，对挤压成型有利．不同样品在酸溶液中的分散性表明，用氨水沉淀剂可获得相对较小的沉淀粒子．改变沉淀时酸侧的pH值，可导致沉淀粒子的结构发生变化．