Biosorption of metal ions with Penicillium chrysogenum

Biosorption of metal ions with Penicillium chrysogenum mycelium is described in this article. Alkaline pretreatment was used to remove proteins and nucleic acids from cells, and this treatment increased the adsorption capacities, for Cr³⁺ from 18.6 mg g⁻¹ to 27.2 mg g⁻¹, for Ni²⁺ from 13.2 mg g⁻¹ to 19.2 mg g⁻¹, for Zn²⁺ from 6.8 mg g⁻¹ to 24.5 mg g⁻¹. The adsorption of metal ions was strongly pH dependent. The mycelium could beused for large-scale removal of Cr³⁺ from tannery wastewater. The results show that this inexpensive mycelium adsorbent has potential in industry because of its high adsorption capacity. The main chelating sites are amino groups (−NH₂) of chitosan in the mycelium. A new model is established, which describes the relation of adsorption of metal ions on pH according to amino group chelating with metal ions and H⁺. The relative errors of simulation for Cu²⁺, Ni²⁺, Zn²⁺, and Cr³⁺ are 4.66%, 5.45%, 11.55%, and 1.69%, respectively.     

New Type of an Adsorption Layer of Organic Molecules with a Cage Structure Condensed at the Electrode/Solution Interface: The Adsorption of Cubane Derivatives on a Mercury Electrode

A synthesis and a study by method of measuring the differential capacitance on a stationary mercury drop of the adsorption of a number of cubane derivatives in a surface-inactive electrolyte are performed. It is established that the compounds studied exhibit a high surface activity. For bromine derivatives of cubane (4-bromomethoxycarbonylcubane, 4-bromohydroxymethylcubane) the formation of two-dimensional adsorption layers is discovered. Values of adsorption parameters for these compounds are evaluated with use made of the Frumkin isotherm.     

Synthesis and spectroscopic properties of a new bipyridine-bipyrazoyl(pyridine)-thiocyanato-ruthenium(II) complex

The complex [Ru(II)(dcbpyH₂)(bdmpp)NCS](PF₆) (1) (where dcbpyH₂ is 2,2′-bipyridine-4,4′-dicarboxylic acid, bdmpp is 2,6-bis(3,5-dimethyl-N-pyrazoyl)pyridine,) is synthesized and characterized extensively by ¹H NMR and ¹³C NMR 1D and 2D, mass spectroscopy, cyclic voltammetry, electronic absorption spectroscopy and IR. The half-wave potential of the Ru(II)/Ru(III) redox couple was measured at E_1/2=+0.795 V versus Ag/AgCl in CH₃CN. The complex presents three intense metal-to-ligand charge transfer (MLCT) (d_M→π_L*) absorption bands centered at 383 (=21 300 M⁻¹ cm⁻¹), 432 (=22 400 M⁻¹ cm⁻¹) and 475 nm (=23 400 M⁻¹ cm⁻¹), respectively. The absorbance is extremely strong between 400 and 500 nm and even at 620 nm, the extinction coefficient is still high (=3768 M⁻¹ cm⁻¹). The strong π-acceptor property of the trans-isothiocyanate ligand compared with the Cl⁻ ligand is probably the cause of the blue-shift observed in complex 1. These properties make the complex potentially promising for the photosensitization process. The incorporation of TiO₂ photoelectrodes derivatized with this complex into a solar cell using a composite polymer/inorganic oxide solid-state electrolyte confirmed its sensitizing ability. Incident monochromatic photon-to-current conversion efficiency (IPCE) values of about 30% and overall energy conversion efficiency (η) of 1.7% were obtained.     

Effect of pressure on the adsorption and micelle formation of aqueous dodecyltrimethylammonium chloride solution-hexane system

The interfacial tension of aqueous dodecyltrimethylammonium chloride (DTAC) solution/hexane interface has been measured as a function of pressure at concentrations around the critical micelle concentration (CMC). The derivative of the interfacial tension with respect to pressure has been observed to change abruptly at the CMC as in the case of aqueous dodecylammonium chloride (DAC) solution-hexane system studied already. The volume changes associated with the adsorption of DTAC from its monomeric and micellar states have been calculated. The results have indicated that the micelle formation of surfactant is treated like the appearance of a new macroscopic phase in the system. It has also been concluded that the micelle solubilizing hexane bears resemblance to the adsorbed film in terms of the volume. The difference in the pressure dependence of the volume of micelle formation ^MW between DTAC and DAC has been attributed to a larger polar group of DTAC. The fact that the value of ^MW is larger than that estimated from the conductivity data has been explained by the solubilization of hexane into the micelle.     

Adsorption of the Ternary Liquid Mixture Ethanol/n-Octane/n-Hexadecane onto Activated Carbon: I. The Adsorption Excess of the Ternary Mixture and of Its Binary Combinations

The adsorption isotherms of the binary mixtures of ethanol/n-Octane, ethanol/n-hexadecane and n-octane/n-hexadecane onto the activated carbon TA 95 were measured at 278 K, 288 K, 298 K and 308 K and described with mathematical functions. About 300 experimental values of the adsorption excess of the ternary mixture ethanol/n-octane/n-hexadecane onto activated carbon TA 95 at 298 K were measured by gas chromatography inside the ternary triangle. The ternary miscibility gap was determined at three temperatures. A good representation of the ternary data and the calculated activity coefficients (using the UNIFAC model) in three-dimensional space was possible with the help of transformation of coordinates. It was possible, too, by utilization of the conception of the quasi two-component representation of the mole fractions with and without miscibility gap. Several influencing factors on ternary adsorption isotherms were discussed for the system ethanol/n-octane/n-hexadecane/TA 95.     

Effect of chemical potential on the computer simulation of hydrogen storage in single walled carbon nanotubes

Hydrogen is a kind of clean, sustainable and renewable energy carrier. Of the problems to be solved for the utilization of hydrogen energy, how to store and transport hydrogen has been given high priority on the research agenda. Recently, carbon nanotubes (CNTs) were reported to be very promising candidates for hydrogen uptake[1], which may have possibility to satisfy the benchmark set by the US Department of Energy (DOE) Hydrogen Plan for fuel cell powered vehicles: a gravimetric density …     

Photoinduced graft polymerization of 2-methacryloyloxyethyl phosphorylcholine on polyethylene membrane surface for obtaining blood cell adhesion resistance

Phospholipid polymer, poly[2-methacryloyloxyethyl phosphorylcholine (MPC)], was grafted with polyethylene (PE) membrane using photoinduced polymerization technique to make the membrane resistant to cell adhesion. The water contact angle on the PE membrane grafted with poly(MPC) decreased with an increase in the photopolymerization time. This decrease corresponded to the increase in the amount of poly(MPC) grafted on the PE surface. The same graft polymerization procedure was applied using other hydrophilic monomers, such as acrylamide (AAm), N-vinylpyrrolidone (VPy) and methacryloyl poly(ethylene glycol) (MPEG). These monomers were also polymerized to form grafted chains on the PE membrane, and the grafting was confirmed with X-ray photoelectron spectroscopy. Analysis of amount and distribution of plasma proteins at the plasma-contacting surface of the original and the modified PE membranes were analyzed using immunogold assay. The grafting of poly(MPC) and poly(VPy) on PE membrane reduced the plasma protein adsorption significantly compared with that on the original PE membrane. However, the PE membranes grafted with poly(AAm) or poly(MPEG) did not show any effects on protein adsorption. Platelet adhesion on the original and modified PE membranes from platelet-rich plasma was also examined. A large number of platelets adhered and activated on the original PE membrane. Grafting with poly(AAm) did not suppress platelet adhesion, but grafting with poly(MPC) or poly(VPy) on the PE membrane was effective in preventing platelet adhesion. It is concluded that the introduction of the phosphorylcholine group on the surface could decrease the cell adhesion to substrate polymer.     

Adsorption properties of low-silica zeolite ZK-5

Water vapor, methanol, and argon adsorption isotherms, as well as the heat of adsorption of ammonia, methanol, and carbon dioxide have been determined on zeolite types A, ZK-4, and ZK-5. The results are explained by the distribution and the bond lengths of cations in the zeolite crystal lattice. It was shown that the exchange of 10–15% of the Na⁺ ions with Li⁺ in zeolite ZK-5 leads to a deformation of the 8-membered ring impeding the diffusion of adsorbed molecules. Cations contained in the 8-membered ZK-5 zeolite ring are bound more strongly to the framework, than in zeolite NaA, resulting in their smaller adsorption capacity.I. V. Grebenshchikov Institute of Silicate Chemistry, Russian Academy of Sciences, 199164 St. Petersburg, Russia. Translated fromIzvestiya Akademii Nauk, Seriya Khimicheskaya, No. 11, pp. 2494–2500, November, 1992.     

Analogy in adsorption behavior of homopolyelectrolyte mixtures as compared to analogous diblock polyampholytes

The adsorption behavior of aqueous mixtures of the homopolyelectrolytes poly(methacrylic acid) (PMAA) and poly[(dimethylamino)ethyl methacrylate] (PDMAEMA) was investigated in comparison with the adsorption of the ampholytic diblock copolymer PMAA‐b‐PDMAEMA on silicon substrates. Ellipsometry was used to determine the amount of adsorbed homopolyelectrolyte and diblock polyampholyte. Furthermore, the topography of the adsorbed polymers was investigated with atomic force microscopy (AFM) and compared with the structures observed in aqueous solutions by dynamic light scattering (DLS). For all types of investigated polyelectrolytic mixtures or the single polyampholyte, the adsorption was strongly influenced by the pH of the polymer solution. Although single homopolyelectrolytes showed only one maximum in adsorption according to their charge, the mixtures made from these homopolyelectrolytes showed two or three maxima. The third maximum near the isoelectric point of the mixture was assigned to a new species formed by aggregation of the two homopolyelectrolytes. Altogether, the adsorption behavior of the polyelectrolytic mixtures was in between the behavior of the pure homopolyelectrolytes and the analogous polyampholytes and therefore understandable from both of these polymer species. © 2002 John Wiley & Sons, Inc. J Polym Sci Part B: Polym Phys 40: 338–345, 2002; DOI 10.1002/polb.10091     

镀金和碳纳米管修饰金电极上吸附态葡萄糖氧化酶比活性的EQCM研究

采用石英晶体微天平(EQCM)技术监测了裸金电极、镀金和碳纳米管修饰金电极上葡萄糖氧化酶(GOD)的吸附过程. 通过EQCM测量吸附固定的GOD质量, 并实时检测酶反应产物H2O2的氧化电量, 求算了各表面上吸附态GOD的比活性(ESAi). 结果表明, 各表面上均可吸附一定的GOD, 且吸附态GOD均有一定的酶活性; 修饰CNTs可增大酶吸附量和酶电极对葡萄糖的响应电流, 但ESAi随CNTs修饰量的增大而降低; Au电极上电镀金后, 酶吸附量和酶电极对葡萄糖的响应电流亦增大, 但ESAi与裸金电极上的基本一致.