Electrospun cellulose acetate fibers: effect of solvent system on morphology and fiber diameter

This paper reports an investigation of the effects of solvent system, solution concentration, and applied electrostatic field strength (EFS) on the morphological appearance and/or size of as-spun cellulose acetate (CA) products. The single-solvent systems were acetone, chloroform, N,N -dimethylformamide (DMF), dichloromethane (DCM), methanol (MeOH), formic acid, and pyridine. The mixed-solvent systems were acetone–DMAc, chloroform–MeOH, and DCM–MeOH. Chloroform, DMF, DCM, MeOH, formic acid, and pyridine were able to dissolve CA, forming clear solutions (at 5% w/v), but electrospinning of these solutions produced mainly discrete beads. In contrast, electrospinning of the solution of CA in acetone produced short and beaded fibers. At the same solution concentration of 5% (w/v) electrospinning of the CA solutions was improved by addition of MeOH to either chloroform or DCM. For all the solvent systems investigated smooth fibers were obtained from 16% (w/v) CA solutions in 1:1, 2:1, and 3:1 (v/v) acetone–DMAc, 14–20% (w/v) CA solutions in 2:1 (v/v) acetone–DMAc, and 8–12% (w/v) CA solutions in 4:1 (v/v) DCM–MeOH. For the as-spun fibers from CA solutions in acetone–DMAc the average diameter ranged between 0.14 and 0.37 μm whereas for the fibers from solutions in DCM–MeOH it ranged between 0.48 and 1.58 μm. After submersion in distilled water for 24 h the as-spun CA fibers swelled appreciably (i.e. from 620 to 1110%) but the physical integrity of the fibrous structure remained intact.     

铁催化剂在碳—氧反应中的热重研究

采用动态TG－DTG，研究了铁催化剂的制备方法、前驱化合物的 种类及 热处理对其在碳－氧反应中催化活性的影响。观察到在干混法制备催化剂时，所用铁盐分解温度越低活性越高。此外还发现，热处理可明显提高由分解温度高的含氧铁盐制备的 催化剂的活性，但对于不含氧铁盐和分解温度低的含氧铁盐无影响。     

杂多酸在活性炭上的固载化Ⅲ．活性炭在酸性介质中对钨硅杂多酸（SiW_（12））的吸附

在氢离子浓度均为３ｍｏｌ／Ｌ的硫酸，盐酸，磷酸，醋酸水溶液中和冰醋酸中研究了具有Ｋｅｇｇｉｎ结构的硅钨杂多酸（ＳｉＷ＿（１２））在不同来源活性炭上的吸附作用。各活性炭对ＳｉＷ＿（１２）吸附等温线的形式是不相同的，吸附剂载体的微孔结构以及杂多酸的溶剂化起着重要的作用。并且在无机酸介质中，杂多酸的吸附量比在水溶液中成规律性地增加，且与酸强度成正比关系。在有机酸介质中，吸附作用比较复杂。根据所得结果，提出了在酸性介质中杂多酸在活性炭表面的吸附模型。     

基于氮化碳复合材料磁性固相萃取结合高效液相色谱法测定尿液中3种羟基多环芳烃

建立了测定尿液中3种羟基多环芳烃的氮化碳复合材料磁性固相萃取结合高效液相色谱-荧光检测法。所构筑的磁性氮化碳材料，经扫描电子显微镜、X射线衍射仪、振动样品磁强计和比表面积分析仪表征后，用于尿液中3种羟基多环芳烃的富集净化。考察了吸附剂用量、吸附时间、洗脱溶液和洗脱体积（单次洗脱体积×洗脱次数）对萃取效率的影响。结合高效液相色谱-荧光分析，在0.25~250 μg/L范围内线性关系良好（相关系数r=0.999），3种羟基多环芳烃的检出限和定量限分别为0.08和0.25 μg/L，回收率为90.1%~102%，日内和日间精密度分别为1.5%~7.7%和2.2%~8.7%。该本方法简单、快速、高效，可用于尿液中羟基多环芳烃的分析。     

Synthesis and Characterization of Core‐Shell Selenium/Carbon Colloids and Hollow Carbon Capsules

A novel Se/C nanocomposite with core‐shell structures has been prepared through a facile one‐pot microwave‐induced hydrothermal process. The new material consists of a trigonal‐Se (t‐Se) core and an amorphous‐C (a‐C) shell. The Se/C composite can be converted to hollow carbon capsules by thermal treatment. These products were characterized by transmission electron microscopy (TEM), powder X‐ray diffraction (XRD), scanning electron microscopy (SEM), selected area electron diffraction (SAED), energy‐dispersive X‐ray (EDX) spectroscopy, and X‐ray photoelectron spectroscopy (XPS).     

Comparison of the retention behaviour of phenol derivatives on porous graphitized and octadecylsilica columns

Summary The retention of 22 ring-substituted phenol derivatives on porous graphitized carbon (PGC) (eluents: acetonitrile — water and methanol — water mixtures) and on octadecylsilica (ODS) (eluents: methanol — 0.025 M KH₂PO₄ mixtures) was determined, and the relationship between retention and physicochemical parameters were evaluated by principal component analysis followed by two-dimensional nonlinear mapping and by cluster analysis as well as by canonical correlation analysis. Calculations proved that marked differences can be detected between the retention characteristics of PGC and ODS columns, and the electronic parameters of phenol derivatives have the highest impact on their retention. The comparison of various multivariate mathematical-statistical methods indicated that principal component analysis followed by two dimensional non-linear mapping is the most appropriate method for the evaluation of large data matrices in RP-HPLC.     

Neosappanone A, a xanthine oxidase (XO) inhibitory dimeric methanodibenzoxocinone with a new carbon skeleton from Caesalpinia sappan

A novel dimeric methanodibenzoxocinone, named neosappanone A (1), possessing a unique unprecedented novel carbon framework, has been isolated from the heartwood of Caesalpinia sappan L. of Vietnam, and its structure was elucidated on the basis of spectroscopic analysis. Neosappanone A (1) competitively inhibited xanthine oxidase in a concentration-dependent manner (IC₅₀, 29.7 μM; K_i, 16.3 μM).     

Comparison between self-reinforced composites based on ultra-high molecular weight polyethylene fibers and isotropic UHMWPE

1. Download : Download high-res image (140KB)
2. Download : Download full-size image

     

Effect of multi-walled carbon nanotubes on non-isothermal crystallization kinetics of polyamide 6

The non-isothermal crystallization behaviors of multi-walled carbon nanotubes (MWNTs)/polyamide 6 (PA6) composites were investigated by differential scanning calorimetry (DSC). Three methods, namely, Avrami, Ozawa and Mo, were carried out to analyze the non-isothermal crystallization data. The results showed that the MWNTs in PA6 acted as effective nucleation agents. However the crystallization rate of composites obtained was lower than that of the neat PA6. It is indicated that the presence of MWNTs influenced the mechanism of nucleation and the growth of PA6 crystallites.     

Characterization of the barrier properties of composites of HDPE and purified cellulose fibers

The present work presents and discusses the interrelation between composition, morphology, thermal history, mechanical and barrier properties to oxygen and limonene of composites of HDPE/MA-PE/cellulose fibers of significant interest in, among others, food packaging applications. From the overall results, it was observed that increasing the loading of purified alpha-cellulose fibers in the polyethylene matrix beyond 10 wt.% led to a decrease in the permeability coefficient of d-limonene, effect which was found to be primarily related to a decrease in the overall solubility of this strongly plasticizing aroma component. On the other hand, the oxygen permeability was found to decrease to a significant extend with increasing fiber content beyond 5 wt.%, but this effect was more strongly ascribed to a significant decrease in the diffusion coefficient. Therefore, the fibers are thought to generate a more tortuous path for the non-interacting gas molecules to travel across the composites thickness, even when tested at high relative humidity conditions. Optimum fiber loading levels in terms of overall property balance were found to be around 20 wt.%.