典型无机含氧酸自由基的特性

碳酸自由基、硝酸自由基、磷酸自由基和硫酸自由基是化学反应的重要中间体，都具有氧化性，对污染物在自然和人为环境中的迁移转化会产生重要的影响.文中较为详细地介绍这几种自由基的电极电位、产生方式、检测方法及与有机物的反应方式.总结四种自由基的特性及与有机物的反应方式可发现，四种自由基和羟自由基电极电位不同，导致它们和有机物反应速率的不同；碳酸自由基并不是羟自由基去除剂，对于一些容易被氧化的化合物，碳酸自由基氧化效果比羟自由基好；四种自由基均可由羟自由基转化而来，并且这四种自由基和羟自由基与有机物反应方式基本一致，都通过电子转移、夺氢和加成的方式进行.可以预测四种自由基和羟自由基降解有机物的机理将非常相似，今后应研究四种自由基与羟自由基相互转化的规律，以及与代表性有机物的反应机理.     

一种含有亚微米孔洞的新型微孔磷酸盐晶体材料的合成及其生长机理

采用水热法成功地合成了一种含有亚微米级孔洞的微孔磷酸盐晶体材料(记为HAP-TAP),其形貌特征是:六棱柱形的晶体表面分布着大量0.4～0.8μm的亚微米级孔洞,孔洞内长有片层状晶体.在样品晶化的过程中,通过控制合成时间,获得了纯六棱柱形晶体的大单晶(记为HAP).使用扫描电子显微镜(SEM)、粉末X射线衍射(XRD)、红外光谱和电子能谱(EDX)对HAP-TAP独特形貌的形成机理进行了研究和揭示.HAP的单晶XRD数据表明,HAP是一种具有二维空旷骨架结构的新型微孔磷酸铝晶体,其分子式为Al5(OH)2(PO4)7(C2N2H10)3.0.5H2O.EDX分析结果表明,生长于六棱柱形晶体孔洞内的片层状晶体为磷酸钛铝材料.     

胶束溶液中高氯酸二水(四胺)合钴(Ⅲ)配合物催化磷酸二酯水解的研究

本文合成了疏水性高氯酸二水（四胺）合钴（Ⅲ）配合物，研究了它与非离子表面活性剂Brij35形成的金属2胶束催化二（对硝基苯酚）磷酸二酯水解的动力学及其机理。结果表明此金属胶束对磷酸二酯水解的速率大约提高10^4倍，这主要是由于表面活性剂胶束的pH效应和浓聚效应所致，暗示着顺式二水类配合物形成的金属胶束是一个潜在的磷酸二酯水解剪切的催化剂。     

Influence of target surface degradation on the properties of r.f. magnetron‐sputtered calcium phosphate coatings

This paper reports a detailed study of how repeated r.f. magnetron sputtering from a hydroxyapatite (HA) powder target affects the nature and reproducibility of a sequential series of thin‐film coatings deposited onto Ti6Al4V substrates. An evaluation of the effective lifespan of the HA sputter targets and the reproducibility of the calcium phosphate (CaP) coatings produced from them has been made from Fourier transform infrared spectroscopy, XPS and, as appropriate, atomic force microscopy and SEM/energy dispersive x‐ray analyses. The annulus region of the target surface, from which sputtering under r.f. magnetron conditions normally occurs, showed severe surface degradation after only one deposition run, as indicated by significant PO₄^3? and OH^? depletion. This deterioration continued after each subsequent deposition cycle but to a much lesser extent than that observed in the initial sputtering period. The layers produced from all of the sputter runs contained the expected Ca²⁺ and PO₄^3? species characteristic of a CaP system but were OH^? deficient in the as‐deposited state. However, the chemical and morphological properties of the coatings did not change significantly until after the third consecutive sputter cycle. Hence, these data indicate that, even though a significant level of degradation of the HA target occurs at the outset of the sputtering procedure, the general plasma conditions employed here have a dominant influence on the coating properties until a critical degradation condition is met. As such, the compacted HA powder targets of interest can have a life‐cycle greater than single usage without detriment to the chemistry and morphology of the coatings produced from them. Copyright © 2003 John Wiley & Sons, Ltd.     

微乳液法合成LiFePO4 / C正极材料及其电化学性能

本文采用微乳液方法合成了纳米LiFePO₄ / C正极材料。制备样品分别用XRD和SEM进行表征，充放电测试其电化学性能。600 ℃制备样品为单一物相，平均粒径90 nm，在室温2.0～4.0 V (vs Li) 放电电压范围和15 mA·g^-1放电速率下，首次放电容量达到159 mAh·g^-1。制备样品同样展现良好的循环性能。在15 mA·g^-1速率下40次循环后，制备样品放电容量仍保持首次放电容量的98.9%。优异的电化学性能得益于样品颗粒的纳米尺寸、均匀分布以及表面碳层包覆提高了活性材料的电子电导率。     

氧化钇粒度控制与测定

用氨水或碳酸氢铵与氯化钇溶液反应生成沉淀，煅烧沉淀制备了D50为0．45μmt 2-10μm的各种粒径的氧化钇粉末。分别采用Coulter MultisizerⅡ和90Plus粒度仪测定微米和亚微米级氧化钇粉体粒度，研究了分散剂，待测样品量，分散时间等因素对亚微米级氧化钇粉体粒度测量精度的影响。     

钇对IMI829钛合金及Ti—14Al—21Nb合金显微组织和性能的影响

采用光学显微镜、扫描电和力学性能测试设备，研究了在ＩＭＩ８２９和Ｔｉ－１４Ａｌ－２１Ｎｂ合金中添加Ｙ，对合金显微组织遥影响。结果表明，在ＩＭＩ８２９和Ｔｉ－１４Ａｌ－２１Ｎｂ合金中添加Ｙ，可以细化这两种合金的组织和晶粒，使ＩＭＩ８２９－０．２Ｙ合金获得良好的室温力学性能和５５０℃蠕变性能，ｗｇｋｑＴｉ－１４Ａｌ－２１Ｎｂ－０．１Ｙ合金的高温力学性能得到改善。     

桑蚕丝素蛋白初始结构对其矿化作用的影响

以碱金属离子诱导桑蚕丝素蛋白溶液发生构象转变, 研究了蛋白质初始结构对其矿化作用的影响. FT-IR, XRD和SEM等测试结果显示, 未经任何处理的桑蚕丝素蛋白溶液矿化后形成片状复合物, 其无机相以二水磷酸氢钙(DCPD)为主; 而经过K^＋和Na^＋金属离子处理后, 桑蚕丝素溶液的结构由无规线团/螺旋构象向β-折叠发生转变, 矿化后成纤维状, 并相互结合呈现纳米级的三维多孔结构, 其无机相以热力学稳定的羟基磷灰石(HA)为主. 可以认为, 丝素蛋白结构转化为较伸展的β-折叠后, 使得更多的亲水基团暴露在外面, 在丝素蛋白分子不断凝聚成纤过程中, HA结晶快速生长并附着在这些微纤上, 最终形成纤维状的丝素蛋白/HA复合物. 该结果为阐明蛋白质的生物矿化过程及其调控机理提供了理论依据, 同时可以从矿化复合物的形成来反映这些微量元素可能对骨组织形成的影响, 为临床骨组织的修复提供一定的参考.     

Intercalation of 1,2-Alkanediols into α-Zirconium Hydrogenphosphate

Intercalation compounds of α-Zr(HPO₄)₂ · H₂O with 1,2-alkanediols (from C3 to C16) have been prepared by replacing 1-propanol in α-Zr(HPO₄)₂ · 2C₃H₇OH with the desired 1,2-alkanediols by a treatment in a microwave field. It was found that the intercalates contain 1.5 molecules of diol per formula unit. The diol molecules are placed between the host layers in a bimolecular way with their aliphatic chains tilted at an angle of 51°. The diol molecules are anchored in the interlayer space by H-bonds. A mixed intercalate, containing 1,2-butanediol and 1,2-decanediol in a roughly equimolar ratio, is formed when the α-Zr(HPO₄)₂ · 2C₃H₇OH intercalate, suspended in a mixture of 1,2-butanediol and 1,2-decanediol, is exposed to microwave radiation. No new phase containing both types of the guest molecules was observed when the 1-propanol intercalate, suspended in a mixture of 1-propanol and 1,2-octanediol, is exposed to microwave radiation.