Rheooptical investigation of the crystallization of poly(ethylene terephthalate) under tensile strain

The crystallization of poly(ethylene terephthalate) under uniaxial tensile strain at different extension rates was investigated with optical polarimetry in a temperature range between the glass-transition temperature and the quiescent crystallization temperature. The evolution of the optical properties of the polymer, including the turbidity, birefringence, and dichroism, were monitored simultaneously with the mechanical parameters. To complete the semicrystalline microstructure characterization of the polymer under strain, an online wide-angle X-ray diffraction (WAXD) technique was used in separate experiments, which were performed under the same thermomechanical conditions. For real-time measurements, a high-energy synchrotron radiation source was used. The optical properties provided information about both the crystalline and amorphous phases, whereas the WAXD patterns essentially gave information about the crystalline phase. The two experimental techniques were then used in a complementary way to characterize the semicrystalline microstructure. Significant deviations from the stress-optical rule were found. This was attributed to both transient effects and the appearance of crystallites, which consisted of highly oriented molecular segments that could contribute to the optical anisotropy but not necessarily to the stress. The behavior of the optical dichroism was found to be qualitatively different from that of the birefringence. The latter monotonically increased with the strain, whereas the former first increased with the strain, passed through a maximum, and then decreased to a steady-state value. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 1915–1927, 2004     

Preparation and characterization of finely dispersed drugs. 5. Ethyl 3,5-di(acetylamino)-2,4,6-triiodobenzoate

Controlled precipitation of the diagnostic imaging agent ethyl 3,5-di(acetylamino)-2,4,6-triiodobenzoate has been used to produce fine particles of various sizes, morphologies, and degrees of crystallinity, which depended on experimental conditions. In addition, two distinct polymorphic forms of the drug have been fully characterized by single crystal X-ray diffraction studies, and evidence for a third polymorph was also observed. Some of the so prepared dry particles were coated with a thin layer of silica.     

滤片-XRD探测系统响应时间测量

 研究了软X射线能谱仪探测道系统(系统包括X射线二极管（XRD）、SUJ-50-10电缆和不同频带示波器)的响应时间。实验利用上海激光联合实验室的20TW激光器激光(激光能量约20J，脉冲宽度约1ps)打金箔靶产生的X光，用XRD探测系统测量，记录示波器有TK684C，TK694C和WM8500等。将实验数据进行了线性拟合和比对分析。滤片XRD探测系统的响应时间随偏压升高而加快，随传输电缆长度的增加而变慢，因此测量快信号过程时，应提高探测器偏压，缩短传输电缆，选择宽频带高采样率示波器，以便减少系统的响应时间，减小信号失真程度。     

制作高密度衍射光栅的光电式刻划控制的研究

高精度的光电式刻划控制系统是制作高密度母光栅的关键技术,以光栅干涉仪为控制核心,设计了光电式的光栅刻划控制系统,并对可能产生的加工误差进行了初步的分析;采用该控制系统的光栅刻划实践表明,所设计的光电式刻划控制系统已完全达到了高密度衍射光栅的亚微米栅距分度要求。     

聚焦慢速高荷态重离子束微束斑X射线源

利用电子束离子源(EBIS)或者电子束离子陷阱(EBIT)产生的慢速高电荷态重离子束轰击金属靶面,离子束与靶面作用并复合辐射特征X射线;并将高荷态离子束采用离子光学系统会聚为微细束后再与靶面作用,能够辐射出微米甚至亚微米级、纳米级的微束斑X射线.本文介绍这一新型微束斑X射线源的结构、机理及其特性等.     

19.6nm波长类氖锗X光激光光源理论模拟

 波长19.6nm的类氖锗X光激光适合作为诊断激光等离子体界面不稳定性的光源。用经过实验检验的系列程序对预-主短脉冲驱动类氖锗进行了系统的优化设计和理论分析。采用2%~3%的预脉冲强度，6~8ns的预-主脉冲时间间隔，在4×10¹³W/cm²功率密度驱动下, 波长19.6nm增益区的宽度可以超过60μm，增益区的维持时间可以达到90ps。对于16mm长的平板靶，增益系数可达11.8/cm；弯曲靶增益系数可达13.3/cm；单靶小增益长度积可达21.3，单靶就可以获得饱和增益。采用双靶对接，其小讯号增益可达38.4，可以获得深度饱和增益，能满足应用演示所需的X光激光光源。     

利用普通视频CCD作为紫外激光和软X射线探测器的研究

 介绍了利用价格便宜的普通视频CCD来获取紫外激光和软X射线图像的方法和应用结果，以代替价格昂贵的紫外CCD、使用不方便的X光胶片或者昂贵的X光CCD，其关键点是：（1）去除CCD相机的自动增益校正；（2）将相机的校正系数γ值设置为1；（3）去除CCD相机前面的保护窗。作为一种简易的装置，可以用于紫外激光测量及激光与等离子体相互作用研究。结果表明，采用改造后的普通视频CCD测量紫外激光光斑，准确可靠，其灵敏度比科学级紫外CCD的低一个量级，它还可以测量软X射线的二维分布，作为X光针孔相机使用非常方便。     

The Crystal Structure of N-Benzoyl-N''-(2-hydroxyethyl)-thiourea

Thiourea compounds are excellent agents of bioactive substance. A number of biological activities are associated with substituted thiourea derivatives. A survey of literature reveals that some work has been reported on benzoylthiourea, which has found plenty of applications as a facile and simple ligand in determination of trances of the transition metal and as an available starting material in preparation of a wide variety of metal complexes. In recent years,N-benzoyl-N'-(2-hydroxyethyl)-thiourea has attracted considerable attention as selective reagents for the liquid-liquid extraction and preconcentration of platinum group metals and its antifungle activity.As a part of our works in studying coordination behaviours of N-benzoyl-N'-(2-hydroxyethyl)-thiourea and its bioactivity, in view of these observations and in continuation of our previous works on it, the present work was reported on the crystal structure of N-benzoyl-N'-( 2-hydroxyethyl)-thiourea.The crystals structure in the monoclinic system and space group of P21/c of N-benzoyl-N'-(2-hydroxyethyl)- thiourea (C10H12N2O2S) was determined from single-crystal X-ray diffraction analysis, a = 17.083 (3) A, b = 4.5490 (10) A, c = 14.279 (3)A, a = 90.00°, a = 102.44(3)°, a = 90.00 °, Ⅴ = 1083.6 (4)A3, Z = 4, Dc = 1.375 Mg/m3, i (Mo Ka)= 0.280 mm-1, F(000) =472. The final R and u R are 0.0399 and 0.0881 for 783 observed reflections [Ⅰ＞26(Ⅰ)].Fig. 1 shows the molecular crystal structure of N-benzoyl-N'-(2-hydroxyethyl)thiourea indicating that the carbonyl and thiocarbonyl moieties are pointing in approximate opposite directions. The six atoms in the ring structure hydrogen bonded are almost in one plane. The N(2)-H proton pendant arm extends to the carbonyl oxygen atom, forms hydrogen bond between them.The existence of hydrogen bond in benzoyl-thiourea molecular six-membered ring structure has significant implications on coordination properties, suggest the possibility of intramolecular hydrogen bond controlled coordination behaviors of these potentially bidentate ligands. In the coordination compound reported by Bourne et al.,cis-bis(N-benzoyl-N'-propylthiourea)dichloroplatinum(Ⅱ), the two ligand molecules bind to Pt(Ⅱ)via the sulfur atoms only, the carbonyl oxygen atom being locked into hydrogen bond similar to that in the free ligands.     

Hydroxylation-induced modifications of the Al2O3/NiAl(0 0 1) surface at low water vapour pressure

STM, STS, LEED and XPS data for crystalline θ-Al₂O₃ and non-crystalline Al₂O₃ ultra-thin films grown on NiAl(0 0 1) at 1025 K and exposed to water vapour at low pressure (1 × 10⁻⁷-1 × 10⁻⁵ mbar) and room temperature are reported. Water dissociation is observed at low pressure. This reactivity is assigned to the presence of a high density of coordinatively unsaturated cationic sites at the surface of the oxide film. The hydroxyl/hydroxide groups cannot be directly identify by their XPS binding energy, which is interpreted as resulting from the high BE positions of the oxide anions (O_1s signal at 532.5-532.8 eV). However the XPS intensities give evidence of an uptake of oxygen accompanied by an increase of the surface coverage by Al³⁺ cations, and a decrease of the concentration in metallic Al at the alloy interface. A value of ∼2 for the oxygen to aluminium ions surface concentration ratio indicates the formation of an oxy-hydroxide (AlO_xOH_y with x + y ∼ 2) hydroxylation product. STM and LEED show the amorphisation and roughening of the oxide film. At P(H₂O) = 1 × 10⁻⁷ mbar, only the surface of the oxide film is modified, with formation of nodules of ∼2 nm lateral size covering homogeneously the surface. STS shows that essentially the valence band is modified with an increase of the density of states at the band edge. With increasing pressure, hydroxylation is amplified, leading to an increased coverage of the alloy by oxy-hydroxide products and to the formation of larger nodules (∼7 nm) of amorphous oxy-hydroxide. Roughening and loss of the nanostructure indicate a propagation of the reaction that modifies the bulk structure of the oxide film. Amorphisation can be reverted to crystallization by annealing under UHV at 1025 K when the surface of the oxide film has been modified, but not when the bulk structure has been modified.     

Local adsorption sites and bondlength changes in Ni(1 0 0)/H/CO and Ni(1 0 0)/CO

The local adsorption geometry of CO adsorbed in different states on Ni(1 0 0) and on Ni(1 0 0) precovered with atomic hydrogen has been determined by C 1s (and O 1s) scanned-energy mode photoelectron diffraction, using the photoelectron binding energy changes to characterise the different states. The results confirm previous spectroscopic assignments of local atop and bridge sites both with and without coadsorbed hydrogen. The measured Ni–C bondlengths for the Ni(1 0 0)/CO states show an increase of 0.16 ± 0.04 Å in going from atop to bridge sites, while comparison with similar results for Ni(1 1 1)/CO for threefold coordinated adsorption sites show a further lengthening of the bond by 0.05 ± 0.04 Å. These changes in the Ni–CO chemisorption bondlength with bond order (for approximately constant adsorption energy) are consistent with the standard Pauling rules. However, comparison of CO adsorbed in the atop geometry with and without coadsorbed hydrogen shows that the coadsorption increases the Ni–C bondlength by only 0.06 ± 0.04 Å, despite the decrease in adsorption energy of a factor of 2 or more. This result is also reproduced by density functional theory slab calculations. The results of both the experiments and the density functional theory calculations show that CO adsorption onto the Ni(1 0 0)/H surface is accompanied by significant structural modification; the low desorption energy may then be attributed to the energy cost of this restructuring rather than weak local bonding.