Synthesis of monodisperse poly(chloromethylstyrene-co-divinylbenzene) beads and their application in separation of biopolymers

The monodisperse, porous poly(chloromethylstyrene-co-divinylbenzene) beads of 7.9 microm were prepared by a single-step swelling and polymerization method. The seed particles prepared by dispersion polymerization exhibited good absorption of the monomer phase. Based on this media, a weak cation-exchange (WCX) stationary phase for HPLC was synthesized by a new chemically modified method. The prepared resin has advantages of biopolymer separation, high column efficiency, low column backpressure, high protein mass recovery, and good resolution for proteins. The dynamic protein-loading capacity of the synthesized WCX packings was 18.2 mg/g. Five proteins were separated in 3.0 min using the synthesized WCX stationary phase. The experimental results show that the obtained WCX resin has very weak hydrophobicity. The WCX resin was also used for the rapid separation and purification of lysozyme from egg white in 5.0 min with only one step. The purity and specific bioactivity of the purified lysozyme were found to be more than 93% and 70 245 U/mg, respectively.     

氨基羧酸纤维分离富集-电感耦合等离子体原子发射光谱法测定多种痕量稀土元素

本文制备了氨基羧酸纤维滤纸片作为柱填充物，成功地分离和富集了地化样品中的多种稀土元素。富集后的稀土元素采用电感耦合等离子体原子发射光谱法测定，回收率为90％～109％。本文还对基体干扰及其消除进行了研究。     

Indirect automatic atomic absorption determination of sulphate based on its precipitation with barium

A continuous precipitation flame atomization atomic absorption spectrometric method for the indirect determination of sulphate is proposed. By using a reversed flow-injection configuration for precipitation as barium sulphate, this anion was determined in the range 10–150 g/ml, with a relative standard deviation of 2.6%. The sensitivity was increased by a factor of seven by using a nitrous oxide-acetylene flame to measure barium.     

聚电解质与相反电荷表面活性剂的相互作用

通过透光度测定、电导滴定和粘度法考察了阳离子聚电解质聚苯乙烯 4 乙烯基吡啶硫酸甲酯盐与阴离子表面活性剂十二烷基硫酸钠 (SDS)的相互作用。研究表明 ,在表面活性剂未过量时 ,二者之间的静电作用占主导地位 ,并且当二者电荷总量相等时 ,生成的复合物沉淀最多 ;在表面活性剂过量后 ,复合物可部分溶解 ,溶解的原因是疏水相互作用。本文初步阐述了二者的作用机理     

衬钽管石墨炉原子吸收法测定痕量镓时基体改进剂的研究及应用

提出用钒和铜混合基体改进剂衬钽管石墨炉原子吸收测定镓的方法。衬钽管使镓的灵敏度提高6倍左右,钒和铜混合基体改进剂不仅能进一步提高灵敏度,而且能提高灰化温度,降低原子化温度,增强抗干扰能力。测定 GSD 标准样品中的镓时,不需对样品进行预分离即可直接进行测定,结果与参考值相符。     

Temperature Development of Homo- and Hetero-Clustering in Saturated Vapors

Computational findings of temperature increase of clustering degree in saturated vapors are analyzed. A thermodynamic proof is presented and a simple criterion derived. Illustrations are based on saturated steam, magnesium and carbon vapor. The results are applicable to synthesis of fullerenes, metallofullerenes, and heterofullerenes, chemical vapor deposition technique, or atmospheric chemistry.     

Numerical computation of the electrostatic interaction energy between methanol and the dyad water-imidazole

Summary The electrostatic interaction energy between methanol and the dyad water-imidazole has been computed numerically at three levels of approximation from 3D grids of the charge density of one partner and the electrostatic potential of the other. The minimum positions and energy values thus obtained compare well with those calculated analytically. The numerical procedure is especially interesting for the prediction of the stable conformers.     

Characterisation of Sol-Gel TiO2 Films by Etching

This article describes the SmartKom Companion, one of three demonstrators developed within the SmartKom project whose goal has been to provide an intuitive and intelligent interface for non-expert users to everyday computer-based applications in different scenarios of use. Conceived for the SmartKom Mobile scenario, the Companion allows intuitive multimodal interaction for drivers and pedestrians. The development of the SmartKom prototypes was constantly accompanied by Wizard-of-Oz experiments as well as system evaluations at different stages of the project. Some usability evaluation results relative to the SmartKom Companion will also be presented.     

On the physical adsorption of gases on carbon materials from molecular simulation

In this paper we present a series of work covering a range of aspects relating molecular simulation to experiment. The importance of surface mediation type effects to the adsorption of simple and complex gases is demonstrated. Coupled with the adsorption of simple gases is their projection area when used for surface area determination. The pressure dependence of a projection area is demonstrated for argon at 77 and 87.3 K. A simple model is used to account for the degree of graphitisation of a surface is demonstrated and used to account for the isosteric heat behaviour of non-graphitised carbon blacks. Turning from surfaces to porous solids, an alternative treatment of experiment data (either sub or super critical) is presented that avoids the ambiguity of excess amounts adsorbed. Using this method one is able to obtain pore size distributions and amounts adsorbed without relying on such things as helium expansion volumes. Since this type of method is usually applied to composite solids we also demonstrate the correct method for calculating the heat of adsorption using independent sets of simulations. The final topic covered in this paper is an example of the information that can be gained from the heat capacity of an adsorbed phase.     

Thermodynamic properties of organic compounds in aqueous solution. II. Apparent molal heat capacities of piperidines,morpholines, and piperazines

Apparent molal heat capacities of some piperidine, morpholine, and piperazine derivatives in aqueous solution have been determined by adiabatic calorimetry in the temperature range 20–55°C and in the molality range 0.2–1m. Comparison of experimental values with those calculated through group contributions, found for monofunctional compounds, indicates strong interactions between the hydrophilic centers. An interpretation is given of the possible mechanism of this interaction. Also, values of ΔC _p for the addition reaction of proton to nitrogen centers of mono- and bifunctional organic compounds are examined.