铁羰基络合物制备的一氧化碳加氢催化剂的研究

本文采用Ｆｅ＿３（ＣＯ）＿（１２）制备担载型络合物催化剂。采用程序升温反应技术考察了这类催化剂（ＣＯ＋Ｈ＿２）的反应性能，井使用紫外漫反射光谱和穆斯堡尔谱对催化剂进行了表征。经２５０℃和１５０℃还原的Ｆｅ／γ－Ａｌ＿２Ｏ＿３催化剂不仅活性远远高于４５０℃还原的Ｆｅ／γ－Ａｌ＿２Ｏ＿３，而且前者在反应过程中有乙烯和乙烷生成，后者则只有甲烷生成。经２５０℃还原的Ｆｅ／分子筛催化剂的活性高于４５０℃还原的Ｆｅ／分子筛催化剂，而且前者在反应过程中有乙烯、乙烷和丙烯生成，后者则只有甲烷生成。紫外漫反射谱和穆斯堡尔谱结果表明：较温和条件下活化的催化剂上有金属于属键骨架的存在。     

硅酸盐中桥联键的机制及其性质的CNDO/2法研究

法计算模型,分析了桥联键的成键机制,解释了硅酸盐的通常性质。以体系总能量随桥角变化关系,解释了硅酸盐矿物及沸石分子筛中桥角Si-O-T出现的范围和几率。 由计算结果还发现,桥氧上具有较高的非键p-电子电荷Q_o~n,并随桥氧的第三配原子性质和距离R(M-O~(br))而变化,使桥氧具有授受电子的双重性质。在此基础上,探讨了沸石分子筛的碳离子催化活性机理,提出了锁与匙匹配原子对的催化活性中心的新观点。     

简便快速的硫化氢测定法

本文提出了有一种简易快速测定剂来测定水样中的硫化氢的方法。该法的检出限为０．１ｍｇ／Ｌ，对１．０１ｍｇ／Ｌ的Ｈ２Ｓ样品７次测定的相对标准偏差＜４．１％，１ｈ能测定１２个样品。用本测定了几种水样中的Ｈ２Ｓ含量，回收率为８４％－１０５％。应用它可上标准法的４ｈ左右缩短到５ｍｉｎ；使分析成本降低９／１０；不需配制一系列分析试剂和仪器，只需一支小型塑料管和几片药片，便于渔业水质和环境水质的野外现场监测。     

Catalysis of nucleophilic substitution reactions in supramolecular systems

The factors determining the catalytic effect of supramolecular systems on the nucleophilic substitution reactions are analyzed. The role of the structural and phase transitions of nanoaggregates in the catalytic mechanism are determined. The substrate specificity is shown for different structures of the supramolecular composition.     

Donor-acceptor properties, catalytic activity, and negative charge exoemission from the alumina surface modified with lithium cations

Donor-acceptor properties of alumina modified with lithium cations were studied by ESR of paramagnetic complexes of adsorbed anthraquinone. The results were compared with the data on negative ion emission (exoemission) accompanying the decomposition of isopropyl alcohol in the adsorption layer. The data on the activity measured by the pulse microcatalytic technique in isopropyl alcohol decomposition are discussed. Small additives of lithium were found to promote catalytic activity of the samples. The role of acid and basic sites in isopropyl alcohol decomposition was discussed. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 4, pp. 616–621, April, 2006.     

An unusual new reaction of α-olefins with magnesiumn-alkyl derivatives catalyzed by Cp2ZrCl2

The reaction of organomagnesium compounds (OMC) containing alkyl radicals of normal structure with -olefins, resulting in the formation of alkenylorganomagnesium compounds and accompanied by hydride transfer was discovered and systematically investigated. A scheme providing for the formation of zirconacyclopentane complexes was proposed for the mechanism of the reaction.Institute of Organic Chemistry, Ural Branch, Russian Academy of Sciences, 450054 Ufa. Translated from Izvestiya Akademii Nauk, Seriya Khimicheskaya, No. 5, pp. 1187–1196, May, 1992.     

Molecular beams and model catalysis: activity and selectivity of specific reaction centers on supported nanoparticles.

Reaction kinetics on nanometer-scale particles are different from those on extended surfaces of bulk materials. This fact has been utilized for a long time to empirically maximize the performance of heterogeneous catalysts, but the understanding of the underlying effects is poor at the microscopic level. Modern molecular beam-based methods, however, allow us to derive very detailed kinetic information on catalytically active surfaces. In combination with structurally highly controlled model catalysts, microscopic insights into the activity and selectivity of specific reaction centers on catalyst nanoparticles can be obtained. This combined approach is illustrated through simple model reactions.     

Quantitative analysis of imazamox herbicide in environmental water samples by capillary electrophoresis electrospray ionization mass spectrometry

Capillary electrophoresis-mass spectrometry (CE-MS) with an electrospray ionization interface was applied for the quantitative analysis of imazamox pesticide in well water, potable water, and pond water. The detector response for imazamox was determined to be linear over the concentration range of 50-1 ng/ml. The limits of quantitation and detection of the method were determined to be 200 and 20 ng/l for imazamox compound in each type of water sample, respectively. The total sample preparation and CE-MS analysis time was under 2 h.