一次消解测定蔬菜中多种重金属的简捷方法

针对一般实验室检测人员少,检测任务重的问题,研究了蔬菜通过一次湿化消解后,消解液可以测定多种重金属元素的方法,大大提高了效率,减轻了工作量.     

现场拉曼光谱研究乙腈在金电极上的解离吸附行为

利用共焦显微拉曼系统、结合合适的电极表面粗糙方法研究了非水体系 0 1mol/LLiClO4 /CH3CN溶液中 ,乙腈分子在金表面的吸附和解离行为。结果表明非水体系中乙腈可在金表面发生还原反应 ,产物CN- 离子与电极表面作用形成的表面配合物可在较宽的电位区间吸附于电极表面。溶液中的微量水、激光照射以及电极电位均对该反应有较大的影响。通过拉曼谱图的比较得出乙腈分子解离出的CN- 在金电极表面比在银电极表面有更强的吸附作用。     

ICLAS of weak transitions of water between 11 300 and 12 850 cm: Comparison with FTS databases

Very weak water vapor absorption lines have been investigated by intracavity laser absorption spectroscopy (ICLAS) in the 11 335-11 947 and 12 336-12 843 cm⁻¹ spectral regions dominated by the ν₁ + 3ν₂ + ν₃ and ν₂ + 3ν₃ bands, respectively. A detectivity on the order of α_min ∼ 10⁻⁹ cm⁻¹ was achieved with an ICLAS spectrometer based on a Ti: Sapphire laser. It allowed detecting transitions with an intensity down to 5 × 10⁻²⁸ cm/molecule which is about 10 times lower than the weakest line intensities previously detected in the considered region. A line list corresponding to 1281 transitions with intensity lower than 5 × 10⁻²⁶ cm/molecule has been generated. A detailed comparison with the line lists provided by the HITRAN database and by recent investigations by Fourier transform spectroscopy associated with very long multi pass cell is presented. The rovibrational assignment performed on the basis of the ab initio calculations of Schwenke and Partridge, has allowed for determining 176 new energy levels belonging to a total of 16 vibrational states.     

空气中水含量的计算及其在色谱分析中的应用

本文介绍了空气中水含量的计算式并编制了空气中的水含量表。实验证明,表上的数据适用于色谱分析。     

Carbon–epoxy composites based on fibers coated with nylon 6,6: hygrothermal ageing versus interlaminar shear strength

Carbon fibers were coated in situ with a thin film of polyhexamethylene adipamide by an interfacial polycondensation technique. The modified fibers were used for the preparation of epoxy-based unidirectional composites. Specimens of these materials were immersed in water until equilibrium conditions were attained. The weight gain at equilibrium was determined as a function of the immersion temperature, the fiber volume fraction and the polyamide content deposited on the fibers. Water penetration in specimens made with uncoated carbon fibers increases when the volume fraction decreases. Introduction of the polyamide interlayer initially increases the water absorption, but reduces it at higher immersion temperatures and/or higher polyamide contents. The treated specimens were subjected to the short beam test to determine the interlaminar shear strength (ILSS). The data show that the ILSS decreases with water penetration but increases when the immersion temperature increases from 40 to 70°C. The overall performance encountered is discussed in terms of the possible roles of the polyamide interphase while taking into account mechanisms concerned with matrix plasticization, interphase degradation and residual stress relaxation.     

Use of zwitterionic buffer additives to improve the separation of proteins in capillary zone electrophoresis

In CZE, the adsorption of the proteins on the capillary wall is a common problem. This paper describes the simple method of utilizing zwitterionic buffer additives to improve the separation of proteins in untreated fused silica capillaries at neutral pH. Three kinds of zwitterion are evaluated in the separation of acidic, neutral, and basic proteins, including their effect on protein efficiency, mobility, separation, and resolution; the difference between the effects of the different additives are also highlighted. The method has proved to be a possible means of reducing protein adsorption, especially for basic proteins.     

High sensitivity CW-cavity ring down spectroscopy of water in the region of the 1.5 μm atmospheric window

The absorption spectrum of natural water vapour around 1.5 μm has been recorded with a typical sensitivity of 5 × 10⁻¹⁰ cm⁻¹ by using a CW-cavity ring down spectroscopy set up based on fibred DFB lasers. A series of 31 DFB lasers has allowed a full coverage of the 6130.8-6748.5 cm⁻¹ (1.63-1.48 μm) region corresponding to the H transparency band of the atmosphere. The line parameters (wavenumber and intensity) of a total of 5190 lines, including 4247 lines of water vapor, were derived by a one by one fit of the lines to a Voigt profile. Different isotopologues of water (H₂¹⁶O, H₂¹⁸O, H₂¹⁷O, and HD¹⁶O) present in natural abundance in the sample contribute to the spectrum. For the main isotopologue, H₂¹⁶O, 2130 lines were measured with line intensities as weak as 10⁻²⁹ cm/molecule while only 926 lines (including a proportion of 30% inaccurate calculated lines) with a minimum intensity of 3 × 10⁻²⁷ cm/molecule are provided by the HITRAN and GEISA databases. Our comparison in the whole 5750-7965 cm⁻¹ region, has also evidenced that an error in the process of conversion of the intensity units from cm⁻²/atm to cm⁻¹/(molecule × cm⁻²) at 296 K, has led to H₂¹⁶O line intensities values listed in the HITRAN-2000 database, systematically 8 % below the original FTS values. The rovibrational assignment was performed on the basis of the ab initio calculations by Schwenke and Partridge with a subsequent refinement and validation using the Ritz combination principle together with all previously measured water transitions relevant to this study. This procedure allowed determining 172, 139, 71, and 115 new energy levels for the H₂¹⁶O, H₂¹⁸O, H₂¹⁷O, and HD¹⁶O isotopologues, respectively. The results are compared with the available databases and discussed in regard of previous investigations by Fourier transform spectroscopy. The spectrum analysis has showed that most of the transitions which cannot be assigned to water are very weak and are due to impurities such as carbon dioxide and ammonia, leaving only about 3% of the observed transitions unassigned. The interest of a detailed knowledge of water absorption for trace detectors developed in the 1.5 μm range is underlined: for instance HDO contributes significantly to the considered spectrum while no HDO line parameters are provided by the HITRAN database.     

Succinic acid adsorption from fermentation broth and regeneration

More than 25 sorbents were tested for uptake of succinic acid from aqueous solutions. The best resins were then tested for successive loading and regeneration using hotwater. The key desired properties for an ideal sorbent are high capacity, complete stable regenerability, and specificity for the product. The best resins have a stable capacity of about 0.06 g of succinic acid/g of resin at moderate concentrations (1–5 g/L) of succinic acid. Several sorbents were tested more exhaustively for uptake of succinic acid and for successive loading and regeneration using hot water. One resin, XUS 40285, has a good stable isotherm capacity, prefers succinate over glucose, and has good capacities at both acidic and neutral pH. Succinic acid was removed from simulated media containing salts, succinic acid, acetic acid, and sugar using a packed column of sorbent resin, XUS 40285. The fermentation byproduct, acetate, was completely separated from succinate. A simple hot water regeneration successfully concentrated succinate from 10 g/L (inlet) to 40–110 g/L in the effluent. If successful, this would lower separation costs by reducing the need for chemicals for the initial purification step. Despie promising initial results of good capacity (0.06 g of succinic/g of sorbent), 70% recovery using hot water, and a recovered concentration of >100 g/L, this regeneration was not stable over 10 cycles in the column. Alternative regeneration schemes using acid and base were examined. Two (XUS 40285 and XFS-40422) showed both good stable capacities for succinic acid over 10 cycles and >95% recovery in a batch operation using a modified extraction procedure combining acid and hot water washes. These resins showed comparable results with actual broth.     

Enthalpies of sorption of linear hydrocarbons (C2–C8) and chloroderivatives of methane and ethylene on the surface of hydrotalcite

Differential molar adsorption enthalpies (DMAE) were determined by gas chromatographic measurements of specific retention volume of vapors on the surface of two forms of Mg–Al hydrotalcite. A linear dependence of the DMAE on the number of the carbon atoms in hydrocarbons was observed for both form of hydrotalcite. The dependence of the differential molar adsorption enthalpies on the number of chlorine atoms in organic molecules is discussed. A linear dependence of DMAE on the molecular weight of chloroderivatives of methane and ethylene on the basic form in an order monochloromethane < dichloromethane < trichloromethane or vinylidene chloride < 1,1-dichloroethylene < trichloroethylene was found.     

Bio-regeneration of p-complexation desulfurization adsorbents

More and more stringent regulations of gasoline and diesel oil were proposed with the awareness of environmental protection. Hydrodesulfurization (HDS) is a conventional method to remove sulfur compounds for industrial purpose. The main drawbacks of this …