利用电子束蒸发制备铝隧道结工艺研究

采用电子束蒸发的方法在Si片上制备超导铝(Al)薄膜。利用X射线衍射和直流四电极电阻法分别测试了厚度从100埃到5000埃的Al薄膜物向组成,超导转变温度(Tc)和临界电流密度(Jc)。当Al薄膜厚度大于500埃时,超导转变温度Tc=1.2K。电子束蒸发制备的Al薄膜性能良好,具有较高的结晶质量,为制备Al超导隧道结奠定了良好基础。对小面积的Al超导隧道结工艺进行了研究,该超导隧道结两层的超导体材料为Al薄膜,中间势垒层材料为Al2O3。其中Al薄膜利用电子束蒸发制备,势垒层通过直接氧化Al薄膜表面实现,该工艺和采用直接蒸发氧化物薄膜工艺相比不仅简单而且能有效防止势垒层不连续造成的弱连接。     

Effect of Pb adatom flux rate on adlayer coverage for Stranski-Krastanov growth mode on Si(1 1 1)7 × 7 surface

Lead (Pb) has been a prototypical system to study diffusion and reconstruction of silicon surfaces. However, there is a discrepancy in literature regarding the critical coverage at which island formation takes place in the Stranski-Krastanov (S-K) mode. We address this issue by studying the initial stages of evolution of the Pb/Si(1 1 1)7 × 7 system by careful experiments in ultra-high vacuum with in situ characterization by auger electron spectroscopy, electron energy loss spectroscopy and low-energy electron diffraction. We have adsorbed Pb onto clean Si(1 1 1 )7 × 7 surface with sub-monolayer control at different flux rates of 0.05 ML/min, 0.14 ML/min and 0.22 ML/min, at room temperature. The results clearly show that the coverage of the Pb adlayer before the onset of 3D Pb islands in the S-K mode depends on the flux rates. LEED results show the persistence of the (7 × 7) substrate reconstruction until the onset of the island formation, while EELS results do not show any intermixing at the interface. This suggests that the flux rates influence the kinetics of growth and the passivation of dangling bonds to result in the observed rate-dependent adlayer coverages.     

In-plane ESPI using an achromatic interferometer with low-coherence laser source

The use of an achromatic interferometer is explored as a means of doing in-plane ESPI measurements using a laser diode as the light source. This interferometer type, which uses a diffraction grating in place of the conventional beamsplitter, has two features that make it suitable for making ESPI measurements over extended areas, even when using a low-coherence laser diode source. First, the parallelogram optical geometry of the interferometer causes all rays passing through to have the same optical path lengths. Second, the interferometer is achromatic, whereby the piezo-actuated mirror that steps the illumination light does so by the same phase angle, independent of wavelength. This latter feature accommodates the spectral impurity of a laser diode source. A periodic variation of fringe visibility is observed in experiments, where narrow ranges of high visibility occur at regular spatial intervals. This behavior derives from the clustered discrete spectral character of laser diode light output. A method to “tune” the interferometer by slightly rotating the diffraction grating is described so as to achieve consistent high fringe visibility throughout the measured images.     

合肥光源逐圈束流位置监测系统中的定时系统

定时系统是合肥光源逐圈束流位置监测和相空间测量系统中的重要组成部分，其主要目的是为数据采集卡提供与环内电子束团同步的时钟信号。该系统包含高速ECL时钟成形、分频电路、程控延时电路、控制模块等部分。可实现延时范围0～220ns，最小延时步距0.5ns，调整精度0.1ns，时钟抖动小于200ps。系统控制软件基于客户/服务器结构，操作灵活、方便。     

液体表面低频声波的非线性声光效应

实现了液体表面上低频声波的光衍射,得到了稳定的、具有高阶衍射的高反衬衍射图样.理论上首次考虑到表面声波中的高次谐波,得到了相应的非线性条件下衍射强度分布的解析表达式,并将这种非线性理论与实验结果进行对比.对比结果表明,非线性理论与实验结果有更高的吻合程度.     

Growth process of TiC clusters from Ti nanoparticles with evaporated carbon layer

Titanium carbide formation by the solid–solid reaction on the surface of Ti nanoparticles was studied in situ using a high-resolution transmission electron microscope with a heating stage. The cross-sectional image of the Ti surface was clearly observed. Vacuum-deposited carbon covered the whole the surface of Ti nanoparticles in spite of the partly evaporation on the nanoparticle surface. The diffusion of the carbon atoms inside the Ti nanoparticles depended on the size of the nanoparticles. When the Ti nanoparticle diameter was less than 30 nm, carbon atoms diffused into the Ti nanoparticle and formed TiC. The superstructure of the Ti nanoparticles was observed, which revealed the growth process of TiC to be the diffusion of carbon atoms. For Ti nanoparticles with diameter larger than 30 nm it was observed that diffusion of Ti atoms into the carbon layer was dominant, which resulted in formation of TiC in the carbon layer at the surface of Ti nanoparticles.     

Electron beam evaporated LaF3 thin films prepared by different temperatures and deposition rates

LaF₃ thin films were prepared by electron beam evaporation with different temperatures and deposition rates. Microstructure properties including crystalline structure and surface roughness were investigated by X-ray diffraction (XRD) and optical profilograph. X-ray photoelectron spectroscopy (XPS) was employed to study the chemical composition of the films. Optical properties (transmittance and refractive index) and laser induce damage threshold (LIDT) at 355 nm of the films were also characterized. The effects of deposition rate and substrate temperature on microstructure, optical properties and LIDT of LaF₃ thin films were discussed, respectively.     

Analysis of beam quality for the laser beams after spectral beam combining

The beam quality of the laser beams after spectral beam combining (SBC) has been analyzed in this paper. Based on the propagation model of the spectral beam combining system, the expression for the output field of an individual beam passing through the spectral beam combining system with lens aberration has been given and the intensity distribution of the combined beam has been studied by the principle of incoherent superposition. Consequently, according to the intensity second-order moments method, the M²-factor of the combined beam has been calculated and the effect of lens aberration on the characteristics of the combined beam has been analyzed quantitatively. It can be shown that the SBC system can improve the beam quality of laser array significantly, and the M²-factor of the combined beam passing through the ideal spectral beam combining system is almost the same as that of an individual beam. For the spectral beam combining system with lens aberration, the spherical aberration has greater effect on the off-axis beam than on the on-axis beam, and the beam quality of combined beam degrades with increase in lens aberration.     

Numerical study of chaotic oscillations in the electron beam with virtual cathode in the external non-uniform magnetic fields

In this Letter the results of theoretical investigations of the chaotic microwave oscillator based on the electron beam with a virtual cathode are presented. Nonlinear non-stationary processes in these electron systems are studied by means of numerical analysis of 2.5D model. It was discovered that the non-uniform external magnetic field value controls the dynamical regime of oscillations in the virtual cathode oscillator. The processes of the chaotization of output microwave radiation are described and interpreted from the point of view of the formation and interaction of electron structures (bunches) in the electron beams. The numerical results have shown that the investigated electron system with virtual cathode could be considered as a promising controlled source of wideband chaotic oscillations in the microwave range.     

PADE'逼近在FEL数值模拟中的应用

应用PADE'逼近方法构造出高阶格式,对一类简单方程组,该方法可导出一种快速递推算法,它能满足这类简单方程自身存在的守恒要求。