Static ultrasonic oscillations induced degradation and its effect on the linear rheological behavior of novel propylene based plastomer melts

The ultrasonic degradation of novel propylene based plastomer (DP) melts with different melt viscosities was conducted in a “static” ultrasonic device where the samples were taken from various distances from the tip of an ultrasonic probe. The effects of ultrasonic time, oscillation temperature, ultrasonic intensity and the distance from the ultrasonic probe tip on the degradation behavior of DP melts as well as the ultrasonic degradation effect on the linear rheological behavior of DP melts were studied. The results show that the increase of initial melt viscosity of DP (higher molecular weight) has greater impact on the ultrasonic degradation of DP melt. The molecular weight and intrinsic viscosity of DP decrease with the increase of ultrasonic oscillation time and they approach to a limiting value. The molecular weight distribution of DP increases after ultrasonic degradation. Decreasing oscillation temperature and distance from probe tip and increasing ultrasonic intensity lead to an increase in the degradation of DP melt. The linear rheological behavior measurements of the samples obtained near the ultrasonic probe tip show that ultrasonic oscillations decrease the complex viscosity, zero shear viscosity, viscoelastic moduli, cross modulus, relaxation time and the slope of log G′ − log G″ for DP melts.     

Reversed Capillary Electrochromatography: Investigation of Peak Symmetry for Eluting Curves of Solutes

Summary A clean method without use of organic solvents has been developed for isolation and high-performance liquid chromatographic (HPLC) determination of oxytetracycline (OTC) and sulphadimidine (SDD) in cow's milk. Isolation is rapid and simple—homogenization with an inorganic acid solution by means of a handy ultrasonic homogenizer, which is easy-to-use and portable, followed by centrifugation. Reversed-phase HPLC was performed on a C₄ column, with 1.25 mmol L⁻¹ succinic acid solution as mobile phase, and identification was by means of a photodiode-array detector. Separation of the analytes was achieved in less than 8 min. Significant linearity was established over the concentration range of 0.1–1.0 μg mL⁻¹ for both target compounds (r>0.99,P<0.01). Average recoveries of OTC and SDD (each spiked at 0.1–1.0 μg mL⁻¹) were ≥88.8, and inter- and intra-assay variability was ≤2.8%. The total time required for analysis of one sample was <20 min. The limits of quantitation of the method (μg mL⁻¹ in milk) were 0.044 for OTC and 0.023 for SDD. No organic solvent was used at any stage of the analysis.     

Particle formation mechanism and kinetic model of ultrasonically initiated emulsion polymerization

A general kinetic model of particle formation in an ultrasonically initiated emulsion polymerization system is presented. This model takes into account homogeneous, micelle entry, and monomer droplet nucleation mechanism. The effects of the ultrasound in producing free radical, degrading free radical and influencing the fashion of the nucleation are also considered. Moreover, chain transfer to monomer and termination in the aqueous phase, capture of oligomer radicals by particles, and coagulation of particles are also considered. An analytical solution is obtained for the initial particle stage consideration. This model predicts that, if the desorption of radical from particles can be neglected, the concentration of the total radical in the aqueous phase is directly proportional to the cavitation concentration. Model predictions are in good agreement with experimental data obtained from the literature.     

The extraction,antioxidant and against β-amyloid induced toxicity of polyphenols from Alsophila spinulosa leaves

Alsophila spinulosa is a tree-like fern, and many evidences suggested that plant polyphenols had the potential therapeutic for Alzheimer s disease (AD). Herein, polyphenols (ASP) was isolated from A. spinulosa leaves and its major constituent were isoorientin and vitexin. ASP displayed excellent antioxidant activity and obvious anti-lipid peroxidation capacity in vitro. ASP improved the survival rate of C. elegans under high temperature by enhancing the antioxidant enzymes activities and decreasing the lipid peroxidation level. Moreover, ASP alleviated β-amyloid (Aβ) induced paralysis and reduced Aβ deposition, decreased reactive oxygen species (ROS) accumulation and improved the level of skn-1 mRNA. In addition, ASP decreased the levels of pdk-1 and akt-1 mRNA in P13K/AKT signaling pathway. In conclusion, ASP may be a potential ingredient for the alleviation of AD.     

Novel polyester/SiO2 nanocomposite membranes: Synthesis,properties and morphological studies

In this paper, a new type of soluble polyester/silica (PE/SiO₂) hybrid was prepared by the ultrasonic irradiation process. The coupling agent γ-glycidyloxypropyltrimethoxysilane (GOTMS) was chosen to enhance the compatibility between the polyester (PE) and silica (SiO₂). Furthermore, the effects of the coupling agent on the morphologies and properties of the PE/SiO₂ hybrids were investigated using UV-vis and FT-IR spectroscopies and FE-SEM. The densities and solubilities of the PE/SiO₂ hybrids were also measured. The results show that the size of the silica particle was markedly reduced by the introduction of the coupling agent, which made the PE/SiO₂ hybrid films become transparent. Furthermore, thermal stability, residual solvent in the membrane film and structural ruination of membranes were analyzed by thermal gravimetric analysis (TGA). The effects of SiO₂ nanoparticles on the glass transition temperature (T_g) of the prepared nanocomposites were studied by differential scanning calorimetry (DSC). Moreover, their mechanical properties were also characterized. It can be observed that the Young's moduli (E) of the hybrid films increase linearly with the silica content. The results obtained from gas permeation experiments with a constant pressure setup showed that adding SiO₂ nanoparticles to the polymeric membrane structure increased the permeability of the membranes.     

Distorted wave response of ultrasonic annular stator incorporating non-uniform geometry

The traveling wave ultrasonic stator is normally fabricated with teeth. The tooth geometry improves the driving speed, but it creates natural frequency splitting and mode contamination, especially a distorted traveling wave. A dynamic model of a stepped-plate periodic stator is developed to examine the distortion. The stator is treated as an annular supported by a thin mid plate, and the support stiffness is formulated by using equivalent energy principle. The effects of the tooth and mid plate on the natural frequency and vibration mode are examined by using the perturbation method. The rules governing the frequency splitting, frequency perturbation as well as mode contamination are also identified. The traveling wave response and elliptical trace on stator surface are obtained by using the mode superposition method and they are proved to be distorted due to the tooth geometry. The response at the repeated doublets becomes coupled forward and backward traveling waves, but that at the split doublets becomes coupled forward traveling, standing and backward traveling waves. The results indicate that the tooth mass instead of the stiffness decreases the vibration amplitude and driving speed of the dominant wave, but their effects are different at the repeated and split doublets. Inspection of the model implies that the distortion can be suppressed by using a suitable combination of the wavenumber, tooth count, tooth height and occupying fraction. Numerical calculations are carried out to demonstrate the tooth geometry effect on the transient waveform, driving speed and elliptical trace. The optimization of the tooth geometry that can help achieve a purer traveling wave is discussed.     

Effect of ultrasound on the synthesis of low-modulus zeolites from a metakaolin

It was studied the effect of ultrasonic processing (22 kHz) of the aqueous suspension of metakaolin, sodium hydroxide and alumina with a molar ratio 2Al₂Si₂O₇:12NaOH:2Al₂O₃ on the low-modulus zeolite synthesis processes. To investigate the XRD, SEM, IR, EDS had been used. It was shown that after ultrasonic processing, sodium aluminates are formed, what leads to a change in process of further synthesis. It was found that without ultrasonic processing on the stage of thermal treatment at 650 °C, SOD zeolite (|Na₆|[Al₆Si₆O₂₄]) and sodium aluminosilicate (Na₆Al₄Si₄O₁₇) are synthesized. In the sample after ultrasound during thermal treatment, only sodium aluminosilicates of cubic syngony (Na₆Al₄Si₄O₁₇ and Na₈Al₄Si₄O₁₈) are formed. It was demonstrated that sodium aluminosilicates are precursors for the formation of LTA zeolite (|Na₁₂|[Al₁₂Si₁₂O₄₈]). As a result zeolitization of sodium aluminosilicates after the hydrothermal crystallization in alkaline solution, the sonicated sample contained 97 wt% LTA. Without ultrasonic processing, the product of synthesis contained 50 wt% SOD and 40 wt% LTA.     

连续臂丛神经阻滞镇痛对断指再植血流动力学影响的研究

目的研究连续臂丛神经阻滞镇痛对断指再植术后再植指血流动力学的影响，探讨其缓解血管痉挛、增加血流量的可行性。方法将60例急诊行断指再植术患者按随机数字表法分为术后连续臂丛神经阻滞镇痛组（CA组）和对照组（NA组），每组30例。观察两组患者再植指术后血管痉挛、血管栓塞和指体坏死发生例数并计算再植指成活率，记录两组术后即刻（T1）、术后24h（T2）再植指固有动脉血流动力学参数及动脉内径（AD）、远指端血氧饱和度（SpO2）和温度（Ts）变化。结果断指再植术后成活率CA组高于NA组，血管痉挛、血管栓塞和指体坏死发生率CA组均低于NA组，差异均有统计学意义（均P＜0.05）。在T2时CA组各项血流动力学参数、AD、SpO2、Ts均高于NA组，阻力指数（RI）低于NA组，差异均有统计学意义（均P＜0.05）。结论术后连续臂丛神经阻滞镇痛可以缓解再植指固有动脉痉挛，增加指体血流量，提高了断指再植的成功率。     

DETERMINATION OF QUADRICEPS FORCES IN SQUAT AND ITS APPLICATION IN CONTACT PRESSURE ANALYSIS OF KNEE JOINT

While the quadriceps muscles of human body are quite important to the daily activities of knee joints,the determination of quadriceps forces poses significant challenges since it cannot be measured in ...