表面起伏光栅形成速率的影响规律 Ⅰ.偶氮生色团种类和官能度的影响

设计并合成了含有不同生色团以及不同官能度的环氧树脂基偶氮高分子 ,系统研究了偶氮生色团的种类和官能度对光栅形成速率的影响规律 .实验结果表明 ,偶氮苯对位是羧基的聚合物的光栅形成速率明显快于偶氮苯对位是硝基的聚合物 ,光栅形成速率随偶氮生色团官能度的增加而加快 .这两类聚合物都可以形成规整的可擦式表面起伏光栅     

酚醛基活性炭纤维孔结构及其电化学性能研究

利用水蒸汽活化法制备了酚醛基活性炭纤维(ACF-H2O), 对其比表面积、孔结构与在LiClO4/PC(聚碳酸丙烯酯)有机电解液中的电容性能之间的关系进行了探讨. 用N2(77 K)吸附法测定活性炭纤维的孔结构和比表面积, 用恒流充放电法和交流阻抗技术测量双电层电容器(EDLC)的电容量及内部阻抗. 研究表明, 在LiClO4/PC有机电解液中, ACF-H2O电极的可用孔径(d)应在0.7 nm以上. 随着活化时间的延长, ACF-H2O的孔容和比表面不断增大, 但微孔(0.7 nm ＜ d ＜ 2.0 nm)和中孔(d ＞ 2.0 nm)率变化很小, 活化过程中孔的延伸和拓宽同步进行, 但过度活化则造成孔壁塌陷, 孔容和比表面迅速下降. 因此, 除活化过度的样品外, 电容量随比表面积呈线性增长, 最高达到109. 6 F•g-1. 但中孔和微孔的孔表面对电容的贡献不同, 其单位面积电容分别为8.44 μF•cm-2和4.29 μF•cm-2, 中孔具有更高的表面利用率. ACF-H2O电极的电容量、阻抗特性和孔结构密切相关. 随着孔径的增大, 时间常数减小, 电解液离子更易于向孔内快速迁移, 阻抗降低, 电极具有更好的充放电倍率特性. 因此, 提高孔径和比表面积, 减少超微孔(d ＜ 0.7 nm), 是提高 EDLC能量密度和功率密度的重要途径. 然而仅采用水蒸汽活化, 只能在小中孔以下的孔径范围内进行调孔, ACF-H2O电极电容性能的提高受限.     

Rapid qualitative analysis of metallic alloys by electrospot chromatography

Summary Electrography and paper chromatography were combined to analyse rapidly metallic alloys in an almost non destructive technique. Using anodic dissolution the sample is applied on the start point of the chromatographic paper. Known ketones-HCl-water mixtures are usually used as solvents to analyse electrospots of different alloys and metal coatings and a separate electrospottest is recommended for Cr. Results of qualitative analysis of some steels, Cu–Ni, and Pb alloys are presented.     

Interactions of water and methanol with a mixture of copper and zinc metals: a theoretical <Emphasis Type="Italic">ab initio</Emphasis> study

Ab initio cluster quantum chemical calculations at the Hartree–Fock and second-order Møller–Plesset perturbation theory levels were carried out to mimic the interactions of water and methanol with a mixture of Cu and Zn metals. It was shown that both molecular and dissociative adsorption of methanol on a mixture of Cu and Zn metal catalyst are preferred over the corresponding adsorptions of water. Estimated transition-state structures for dissociation of methanol into CH·₃ and OH· lie about 9.0 and 22.0 kcal/mol higher compared to the dissociated (forward reaction) and molecular adsorption (reverse reaction) complexes, respectively. Based on distinct radicals' bond energies with the active sites of the catalyst considered, it is suggested that hydrogen molecules could be formed through a chain of homogeneous reactions of methyl radicals released into the gas phase with the water and/or methanol molecules.     

A new electrolytic dissolution of aluminum alloys and determination of some constituents by inductively coupled plasma optical emission spectrometry

The new electrolytic dissolution in batch of aluminum alloys samples as grains or turns and the determination of Fe, Cu, Mn, Mg, Cr, Ni, Zn, Pb and Ti by ICP OES was investigated. In on-line electrodissolution procedures described in the literature, samples were restricted to be in the form of solid blocks or plates with one polished flat face. Here, the sample was loaded in the barrel of a modified disposable syringe (the anodic semi-cell) and pressed with a modified plunger fitted with a platinum disk to establish electrical contact with the analyte. This arrangement was introduced in a beaker containing the electrolyte (1 mol L⁻¹ HNO₃) and a platinum wire as the cathode. The resulting solution from electrodissolution (0.6 A) was used for the ICP OES determinations. The influence of the aluminum concentration increase on the determination of the elements was evaluated. Electrodissolution of certified reference materials and commercial samples revealed relative errors lower than 10% for the elements Fe, Cu, Mg, Ni, Cr, Zn and Ti (when their content is above 0.1%). Higher inaccuracies (>10%) were observed for Mn and for Fe in B.C.S. 268/1 reference material certified. The proposed method presented a relative standard deviations (R.S.D.) lower or circa 10% to all of the elements (except Pb). In comparison with traditional acid dissolution, the proposed electrodissolution method is relatively fast (about 30 min), it is clean (there is no projection of solution) and simple (heating and fumes exhaust system were not necessaries).     

Direct spectrophotometric method for the determination of cobalt with indane 1,2,3-trionetrioxime in aqueous medium

A simple, sensitive and selective Spectrophotometric method has been developed for the determination of cobalt using indane 1,2,3-trionetrioxime (ITT): The method is based on the colour reaction between ITT and cobalt(II) in sodium acetate-acetic acid buffer (pH 4.5–7.5) medium. The calibration graph for measurement at 320 nm is linear in the range 1.18–23.60g of cobalt per 25 ml, with molar absorptivity of 5.32×10⁴1mol^–1 cm^–1. The effect of interfering ions has been studied and the method was applied to the determination of cobalt in alloys, with good results.     

铬系乙烯齐聚和聚合催化剂

综述了近年来国内外铬系催化剂的最新研究进展。介绍了该类催化剂齐聚和合的性能研究和应用，讨论了该催化剂长期引起争议的活性中心，活性价态，以及反应机理，并同时预测了铬系催化剂在工业和纳米技术方面的发展趋势。     

Computer based screening of compound databases: 1. Preselection of benzamidine-based thrombin inhibitors

We present a computational protocol which uses the known three-dimensional structure of a target enzyme to identify possible ligands from databases of compounds with low molecular weight. This is accomplished by first mapping the essential interactions in the binding site with the program GRID. The resulting regions of favorable interaction between target and ligand are translated into a database query, and with UNITY a flexible 3D database search is performed. The feasibility of this approach is calibrated with thrombin as the target. Our results show that the resulting hit lists are enriched with thrombin inhibitors compared to the total database.     

Analysis of nickel-niobium alloys by inductively coupled plasma optical emission spectrometry

Inductively coupled plasma optical emission spectrometry (ICP-OES) was applied to the analysis of major and minor elements of Ni-Nb alloys obtained by aluminothermic reduction process. Digestion of samples was made using a mixture of HF+HNO₃. Minor and trace elements were determined without matrix separation. The precision for all constituents was <3%. Recoveries for the analyte-spiked samples were 95%.     

微量元素La对Al—Si合金凝固过程的影响

本文用差热分析法系统地研究了La掺杂对Al-Si共晶合金、亚共晶、超共晶的动态凝固过程的影响。结果表明,La促使α(Al)成核,使体系中初晶α(Al)的析出温度比AJ-Si二元合金中Al初晶的实际析出温度明显提高;La对初晶Si的成核和长大起抑制作用,使超共晶中初晶Si相析出温度较二元合金中的Si初晶的实际析出温度明显降低。