High-temperature transformations of Cu-rich hydrotalcites

CuM(II)Al ternary hydrotalcites (M(II) = Ni, Co and Mg) with a (Cu+M(II))/Al atomic ratio of 3.0 and Cu/M(II) atomic ratio of 5.0 were synthesized by coprecipitation under low supersaturation. Powder X-ray diffraction of the as-synthesized samples showed a pattern characteristic of hydrotalcite-like (HT-like) structure (JCPDS: 41-1428). Thermal analyses of these samples showed four stages of weight loss/heat change when recorded in nitrogen. Analysis of the evolved gases characterized the nature of these transformations. The thermoanalytical effects differed significantly especially for the high-temperature transformations, when the treatment was performed in oxygen. In situ powder X-ray diffraction of the samples was carried out to elucidate the phase evolution of these compounds. Surprisingly formation of CuO was noted at temperatures around 200°C well below the destruction of the layered network. The nature of the resulting phases varied with both the nature of the co-bivalent metal ion and the heating atmosphere. FT-IR spectroscopy confirmed the retention of carbonate ions at higher temperatures (above 700°C), although the concentration of carbonate anion (most likely unidentate) varied with the calcination temperature. The crystallinity of CuO increased significantly above 600°C, probably through dissociation of copper oxycarbonate. Significant differences in the thermal transformation temperatures (for the third and the fourth transformations) of these samples containing different co-bivalent metal ions were not observed. This suggests that an association of the co-bivalent metal ions and/or trivalent metal ion in this phase is unlikely. A plausible thermal evolution scheme of these hydrotalcites is proposed.     

Influence of the Excited States of Atomic Nitrogen N(<Superscript>2</Superscript>D) and N(<Superscript>2</Superscript>P) on the Transport Properties of Nitrogen. Part I: Atomic Nitrogen Properties

In this paper, calculated values of the viscosity and thermal conductivity of atomic nitrogen, taking into account three species (the ground and two excited states), are presented. The calculations, which assume that the temperature dependent probability of occupation of the states is given by the Boltzmann factor, are performed for atmospheric-pressure in the temperature range from 1,000 to 20,000 K. Six collision integrals are used in calculating the transport coefficients and we have introduced new averaged collision integrals where the weight associated at each interacting species pair is the probable collision frequency. The influence of the collision integral values and energy transfer between two different species is studied. These results are compared which those of published theoretical studies.     

A study of the thermal decarboxylation of three perfluoropolyether salts

The thermal decarboxylation of three dicarboxylic perfluoropolyether potassium salts of relatively short chain length has been investigated and the products and kinetics of the main reactions have been defined. From the rate constants and Arrhenius parameters data, the second decarboxylation appears to be quantitatively rather close to the first.     

Experimental study of the concentration dependence of the soret coefficient by thermal field-flow fractionation: the case of polystyrene in decalin

Summary Thermal field-flow fractionation separates polymers with high selectivity according to their Soret coefficient,S _τ, hence, according to their molar mass, and therefore consitutes an efficeint physicochemical tool for the determination of the Soret coefficient of a given polymer in the carrier liquid from its retention time. However, the polymer concentration in the sample influences the retention time and, hence, the value ofS _τ derived from it. An experimental study of the influence of sample concentration on retention,S _τ, and peak shape was performed for the polystyrene-decalin system over a relatively large temperature domain and for various molar masses. It is found that the retention time and the value ofS _τ increase with increasing sample concentration, the more so as the cold wall temperature is lower. This appears to be in contradiction with the general non-equilibrium thermodynamic expression derived for polymer-solvent systems with positive second virial coefficients, such as the present system over the temperature range investigated. There seems to be a temperature for which the dependence ofS _τ on sample concentration vanishes. This temperature is about 375 K for the polystyrene-decalin system. As the sample concentration increases, the peak barycentre and the standard deviation increases. As the peaks are fronting, the skewness is negative and becomes more negative as the sample concentration increases. The peak skewness appears to be a good indicator of the onset of sample concentration effects. The threshold concentration, for which these effects begin to become significant, decreases with increasing molar mass.     

配合物聚合反应研究──Ⅱ.以二氨基磺磷酸盐配合物合成聚脲

以二氨基磺酸盐配合物合成了一系列主链上合金属元素(Ca,Ni,Co,Cu)的聚脲聚合物。用IR和1HNMR对其结构进行了表征,以TG-DTA研究了其热性能,并讨论了金属元素种类及其含量对聚脲聚合物溶液粘度的影响。     

Thermal oxidation of cellulose investigated by chemiluminescence. The effect of magnesium and calcium carbonates and of different pHs

Whatman cellulose impregnated with calcium and magnesium carbonates was oxidized and chemiluminescence accompanying this oxidation has been measured. It was shown that magnesium ions in deacidified cellulose pulp promote the light emission significantly. On the other hand, acid papers give the more pronounced light signals at temperatures close to ambient. The relation between chemiluminescence runs and paper degradation has been implicated, with an attempt to extrapolate half-lives of paper samples to conditions close to ambient. To cite this article: J. Rychlý et al., C. R. Chimie 9 (2006).     

聚丙烯-聚乙烯嵌段共聚物的分子结构及性能的研究

本工作用核磁共振(~(13)C-NMR)、示差扫描量热(DSC)、动态力学分析(DMA)和扫描电子显微镜(SEM)等技术研究了将丙烯、乙烯单体两步分段共聚、预期为聚丙烯-聚乙烯嵌段共聚物的合成物(简称为聚丙烯-聚乙烯嵌段共聚物或嵌段共聚物)。结果表明,在嵌段共聚物中含有一定量的、能为正庚烷抽提出来的乙丙无规共聚物(EPR);分段共聚的产物并非预想的PP-b-PE两嵌段共聚物,而是含有多种组分的共混物;形态表征的结果表明了嵌段共聚物为多相体系,EPR和PE形成分散相以球形无规分布于PP基体中。     

The structural phase transitions of aminoguanidinium(1+) dihydrogen phosphate—study of crystal structures, vibrational spectra and thermal behavior

Aminoguanidinium(1+) dihydrogen phosphate was prepared by crystallization from aqueous solution. On the basis of the results of DSC measurements, X-ray structural analysis was carried out at temperatures of 160, 215 and 293 K for three aminoguanidinium(1+) dihydrogen phosphate phases ( |Z=2|non-ferroic |melting point 408 K; II |201-222 K|(2) |Z=2|non-ferroic|-; III |<201 K|(2)|Z=4|non-ferroic|-). The triclinic unit cell dimensions (a=6.8220(2), b=7.1000(2), c=7.4500(2) Å, α=86.925(2)°, β=80.731(2)°, γ=79.630(2)°, V=350.21(2) Å³—phase I) are similar for all three structural phases with the exception of phase III, where doubling of the c-axis length leads to an increase in the volume to 692.34(3) Å³. The crystal structure of all three modifications consists of parallel layers of dihydrogen phosphate anions that are interconnected by aminoguanidinium(1+) cations through hydrogen bonds of the N-H…O type. The planar aminoguanidinium(1+) cations are oriented almost parallel to each other and are perpendicular to the anion layers. The primary differences amongst phases I, II and III lie in the location of the H atom in the short O-H…O bonds connecting the dihydrogen phosphate anions in layers. The FTIR and FT Raman spectra of natural and deuterated compounds were recorded and interpreted. The FTIR spectra were studied down to a temperature of 90 K.     

聚苯基不对称三嗪的热分解

用高分辨裂解气相色谱－质谱（ＨＲＰｙＧＣ－ＭＳ）考察了由对苯二眯腙和四种不同芳香族四酮合成的聚苯基不对称三嗪的热分解行为，鉴定了相应裂解产物的组成、分布及其与高分子结构的关系，并用热重法（ＴＧ）测定了它们的热分解反应动力学参数，提出了其热分解反应机理．     

Physico-chemical aspects of polyethylene processing in an open mixer. Part 20: Additional product yields on bimolecular hydroperoxide decomposition with an alcohol group

Most products formed on polyethylene oxidation result from hydroperoxide decomposition. The product yields can be calculated for various mechanisms of hydroperoxide decomposition. This work concerns the reaction of a hydroperoxide with an alcohol group thought to be dominant in the advanced stages of polyethylene processing in the high temperature range (170-200 °C). Besides hydrogen abstraction by caged alkoxy radicals already envisaged previously, the possibility of β-scission is taken into account. This additional reaction introduces significant complexity into the reaction schemes. This is especially so because additional caged radical pairs must be included into the schemes and the calculations. It becomes possible to calculate the yields of aldehyde and vinyl groups that do not result from hydroperoxide decomposition in the absence of β-scission. The yields of the main oxidation products such as alcohols and ketones are not much affected by taking into account β-scission. The yield of aldehydes is important in the whole temperature range and increases considerably if the temperature is raised from 170 to 200 °C. It becomes more important than the ketone yield. The vinyl groups are formed in amounts corresponding roughly to 10-15% of the trans-vinylene groups in the temperature range of 170-200 °C.