A New Two‐Dimensional Coordination Polymer of Mercury(II) with very High Thermal Stability

A 2D Hg^II coordination polymer containing ligands 1,2,4‐triazole (Htrz) and thiocyanate, [Hg(μ₃‐trz)(SCN)]_n ( 1 ) has been synthesized and characterized by elemental analysis and IR spectroscopy. The single‐crystal X‐ray data show the coordination number of Hg atoms is four and the ligand trz^? acts as a three‐fold donor. The thermal stability of compound 1 was studied by thermal gravimetric and differential thermal analyses. The composition and formation of the complex in methanol solution were found to be in support of its solid state structure.     

一种新的WDM光网中的共享链路保护策略

研究了WDM光网中的链路保护问题.提出了一种新的共享链路保护策略--基于SRLG的共享链路保护策略(SRLG-SLP).SRLG(共享风险链路组)定义了对一条工作光通道分配保护资源时的资源可用性的约束.它规定任意两条有着同样故障风险或者说处于同一个SRLG的工作光通道不能利用同样的保护资源.另外,还提出了一种更加符合实际的单链路故障模型,其中链路故障间隔时间和链路故障保持时间被考虑作为两个独立的变量.基于该链路故障模型,通过大量的仿真试验,比较了专用链路保护(DLP)、共享链路保护(SLP)和提出的SRLG-SLP保护策略的资源利用率、保护效率以及业务中断率.结果显示,我们提出的SRLG-SLP在保护效率和业务中断率方面的保护性能远好于DLP和SLP,但会牺牲一些资源利用率.     

A note on the unsteady boundary layers over a flat plate

The unsteady boundary layer over a semi-infinite flat plate was investigated in this paper. The flow involves the unsteady flow over a flat plate with leading edge accretion or ablation. The momentum boundary layer was further analyzed and it was shown that the leading edge ablation had a similar effect to the wall mass injection or upstream wall movement making the fluid blown away from the wall. The thermal boundary layer of the same flow was also studied. Results show that the leading edge accretion or ablation can greatly change the fluid motion and the heat transfer characteristics.     

负载型CO3[Fe（CN）6]2及CN^—加氢反应的研究

双金属催化剂是一类重要的多相催化剂。其中d电子在催化活性方面起着重要的作用.本文在Co_3[Fe(CN)_6]_2的工作基础上,进一步研究了该配合物在硅胶、氧化铝、以及氧化镁上的热性质,同时考察了CN~-在Co-Fe体系双端基配位的活化加氢,探讨了载体的影响.     

机载海洋激光测深系统参量设计与最大探测深度能力分析

详细讨论了机载海洋激光测深系统最大测量深度与相关因子之间的关系，并利用最小可探测信噪比为判据，对机载海洋激光测深系统在白天和晚上工作进行了数值模拟，通过比较最大测量深度与激光脉冲峰值功率、接收视场角、接收口径和光谱接收带宽等关系，确定了系统的主要参量。以确定的参量建立的系统具有白天49m和晚上65m的最大测深能力，可完全满足在沿岸带以及岛礁的测量要求。     

New protonic solid electrolyte with tetragonal tungsten bronze structure obtained through ionic exchange

Proton exchange reactions have been performed on tetragonal tungsten bronze-like NaNbWO₆ by using nitric acid as an exchanging agent. The characterization of the exchange reaction products has been made by means of chemical analysis, X-ray diffraction, thermal analysis, and IR spectroscopy. The exchange reaction takes place topotactically and the following formula is proposed for the obtained phase of variable composition: Na_1−xH_xNbWO₆·yH₂O (0<x?0.46 and 0?y?0.12). Impedance spectroscopy on the present proton exchanged samples indicated that these samples behaved as solid electrolytes under high humidity. As an example, the compound with the composition Na_0.68H_0.32NbWO₆·0.1 H₂O exhibits ionic conductivity of 8×10⁻³ and 1×10⁻² S cm⁻¹ at 70°C and 90°C, respectively.     

Predictability and model selection in the context of ARCH models

Most of the methods used in the ARCH literature for selecting the appropriate model are based on evaluating the ability of the models to describe the data. An alternative model selection approach is examined based on the evaluation of the predictability of the models in terms of standardized prediction errors. Copyright © 2005 John Wiley & Sons, Ltd.     

Sulfonated poly(aryl ether ketone)s containing naphthalene moieties obtained by direct copolymerization as novel polymers for proton exchange membranes

A series of sulfonated poly(aryl ether ketone)s (SPAEKs) were prepared by aromatic nucleophilic polycondensation of 2,6‐dihydroxynaphthalene with 5,5′‐carbonyl‐bis(2‐fluorobenzenesulfonate) and 4,4′‐difluorobenzophenone. The structure and degree of sulfonation (DS) of the SPAEKs were characterized using ¹H NMR spectroscopy. The experimentally observed DS values were close to the expected values derived from the starting material ratios. The thermal stabilities of the SPAEKs were characterized by thermogravimetric analysis, which showed that in acid and sodium salt forms they were thermally stable in air up to about 240 and 380 °C, respectively. Transparent membranes cast from the directly polymerized SPAEKs exhibited good mechanical properties in both dry and hydrated states. The dependence of water uptake and of membrane swelling on the DS at different temperatures was studied. SPAEK membranes with a DS from 0.72 to 1.60 maintained adequate mechanical properties after immersion in water at 80 °C for 24 h. The proton conductivity of SPAEK membranes with different degrees of sulfonation was measured as a function of temperature. The proton conductivity of the SPAEK films increased with increased DS, and the highest room temperature conductivity (4.2 × 10^?2 S/cm) was recorded for a SPAEK membrane with a DS of 1.60, which further increased to 1.1 × 10^?1 S/cm at 80 °C. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2866–2876, 2004     

Antimicrobial activity on the copolymers of 2,4‐dichlorophenyl methacrylate with methyl methacrylate: Synthesis and characterization

Copolymers of monomers 2,4‐dichlorophenyl methacrylate (2,4‐DMA) and methyl methacrylate (MMA) were synthesized with different monomer feed ratios using toluene as a solvent and 2,2′‐azobisisobutyronitrile (AIBN) as an initiator at 70 °C. The copolymers were characterized by IR‐spectroscopy, and copolymer composition was determined with UV‐spectroscopy. The linearization method of Fineman–Ross was employed to obtain the monomer reactivity ratios. The molecular weights and polydispersity indexes were determined by gel permeation chromatography (GPC). Thermogravimetric analyses of polymers were carried out in nitrogen atmosphere. The homo‐ and copolymers were tested for their antimicrobial properties against selected microorganisms. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5227–5234, 2004     

THE RELATIONSHIP BETWEEN PROJECTIVE GEOMETRIC AND RATIONAL QUADRATIC B-SPLINE CURVES

For two rational quadratic B-spline curves with same control vertexes, the cross ratio of four eollinear points are represented; which are any one of the vertexes, and the two points that the ray initialing from the vertex intersects with the corresponding segments of the twocurves, and the point the ray intersecting with the connecting line between the two neighboring vertexes. Different from rational quadratic Beeier curves, the value is generally related with the loeation of the ray, and the necessary and sufficient condition o5 the ratio being independent of the ray‘s loeation is showed. Alsn another cross ratio o5 the following four collinear points are suggested, i.e. one vertex, the points that the ray from the initlal vertex intersects respectivdy with the curve segmentt the line connecting the segments end points, and the line connecting the two neighboring vertexes. This cross ratio is concerned only whh the ray‘s location, butnot with the weights of the curve. Furthermore, the cross ratio is projective invariant under the projective transformation between the two segments.