Entrapped mixed microorganisms to treat organic wastewater from food industry

Limited land and insufficient technicians to operate a wastewater treatment system are main restrictions for many factories. Therefore, an ideal wastewater treatment method for a small or land-limited factory must possess merits such as high performance efficiency, high organic loading rate, little odor, simple operation, easy maintenance, and little land required (simultaneously). An entrapment technique to immobilize mixed microorganisms to treat organic wastewater, which was developed in the present work, possesses these characteristics. This project was done on a laboratory scale. The microorganisms were activated sludge (an undefined mixture of microorganisms obtained directly from a domestic wastewater treatment plan) and the mixed microorganisms were immobilized in cellulose triacetate by means of an entrapment technique to treat organic wastewater from food industry. After wastewater was treated by this system, the SCOD (soluble COD) removal efficiency of 81% evaluated samples exceeded 80% in 1.5 ± 0.9 g SCOD/L/d of the volumetric loading rate and 7–10 h for the hydraulic retention time. This wastewater treatment method can be applied to other organic industrial wastewater.     

难降解有机废水的催化氧化法处理

催化氧化法可通过多种途径来加强传统的化学法处理效果，目前已成为难降解有机废水处理的一项重要新技术。本文介绍了光催化氧化法、均相氧化法、多相氧化法(包括电催化氧化法)以及超临界水氧化技术的国内外研究现状及特点，并对其在有机废水中的应用情况和发展前景作了扼要评述。     

Method Development for the Speciation of Chromium in River and Industrial Wastewater Using GFAAS

A simple, sensitive and inexpensive method for the speciation of Cr(VI) and Cr(III) in river and industrial wastewater was developed, optimized and validated. Samples were collected, filtered and then chromium species were determined in the filtrate. In the filtrate, total Cr was determined directly by Graphite Furnace Atomic Absorption Spectrometry (GFAAS). A portion of the filtered sample was buffered to pH 6.4, extracted with Amberlite LA-2/MIBK and finally Cr(VI) was determined in the organic extract and Cr(III) in the aqueous phase using GFAAS. The method was evaluated by analysis of the certified reference material, CRM 544, and good accuracy was obtained. The limit of detection for Cr(VI) and Cr(tot)/Cr(III) was found to be 0.30 and 0.08 µg L⁻¹, respectively, and a precision expressed as relative standard deviation of better than 11% was achieved for nine replicates. A number of water samples from the Tinishu Akaki River, Ethiopia, and wastewater samples from a chemical plant in Germany, were analysed. In addition to the GFAAS method, Cr(tot) was also determined using ICP-MS (in CRM 544, lyophilized water, and Tinishu Akaki River water samples) and Cr(tot) and Cr(VI) using UV-VIS spectrophotometry (in CRM 544 and industrial wastewater samples). Good agreement between the different methods was found.     

Treatment of coke plant wastewater by A/O fixed biofilm system

The long-term environmental impacts of wastewa-ter from coke plant can be very high, especially due to the discharge of large amounts of wastewater. The composition of coke plant wastewater is complicated and varies from one factory to another, depending …     

Preparation and Characterization of Nanotitanium Dioxide Coating Film Doped with Fe^3＋ Ions on Porous Ceramic

The nanotitanium dioxide （TiO2） photocatalytic and porous ceramic filtering technique is one of the advanced methods to effectively treat organic wastewater. The TiO2 sol doped with Fe^3＋ ions was prepared by sol-gel processing. The influences of the process conditions of coating nanophotocatalytic material- Fe^3＋-TiO2 film on the surface of porous ceramic filter by dipping-lift method on the performance of porous ceramic filter were studied. The porous ceramic filters have two functions at the same time, filtration and photocatalytic degradation. The results of this study showed that the pH and viscosity of the sol, amount of Fe^3＋ ions doped as well as the coating times greatly affect the quality of coating film, the performance parameters and the photocatalytic activity of the porous ceramic filter. When the pH of the sol is 3-4, the viscosity is about 6 mPa.S, the amount of doped Fe^3＋ ions is about 2.0 g/L, the porous ceramic filter has been shown to have the best filtering performance and photocatalytic activity. In this condition, the porosity of porous ceramic is about 42.5%, the pore diameter is 8-10μm. The degradation of methyl-orange is 74.76% under lighting for 120 rain.     

Cassava flour wastewater as a substrate for biosurfactant production

Five cassava flour wastewater (manipueira) preparations were tested as culture media for biosurfactant production by a wild-type Bacillus sp. isolate. No-solids (F), no-solids diluted (F/2), natural (I), natural diluted (I/2), and decanted (IPS) were the tested manipueira media. The microorganism was able to grow and to produce biosurfactant on all manipueira preparations. The media whose solids were removed (F and F/2) showed better results than preparations with the presence of solids (I, I/2, and IPS). No-solids medium (F) showed a surface tension of 26,59 mN/m and reciprocal of critical micelle concentration of over 100 and was selected as a potential substrate for biosurfactant production.     

活性炭纤维电极电解法处理墨绿B染料废水

将铁丝缠绕在活性炭纤维(简称ACF)上制成电极,并在阴极鼓入空气,用电解生成的Fenton试剂处理墨绿B染料模拟废水.研究了电压、pH值、温度、空气流量、支持电解质的浓度等因素对染料脱色率的影响.结果表明,pH值越低,温度越高,处理效果越好,气流量的改变对于处理效果影响不大.室温时处理浓度为50mg·L-1的活性染料墨绿B,在实验电压为11V,中性条件下,无水硫酸钠的浓度为20g·L-1,通入空气流量为60L·min-1时,处理60min,色度去除率达到95%左右.55℃时,电解30min色度去除率就达到96%,60min时达到100%.     

A New Neutral Carrier for Silver Ions Based on a Bis(Thiothiazole) Derivative and its Evaluation in Membrane Electrodes

Membrane electrodes based on 2,2-dithiobis(benzothiazole), DTBBT, as a neutral carrier for silver ions are described. Silver-selective membrane electrodes formulated with 2wt% DTBBT ionophore and 50mol% TFPB in an FPNPE plasticized poly (vinyl chloride) exhibited near-Nernstian responses towards silver ions (60.3±0.5mVdecade^–1) over a wide silver ion activity range of 0.83µM to 94mM. Increasing the amount of anionic sites, TFPB, to 100 or 150mol% (relative to the DTBBT weight) resulted in super-Nernstian responses toward silver ions. Membrane electrodes prepared using a low dielectric constant plasticizer, however, exhibited sub-Nernstian responses. Polymer membrane electrodes with optimal composition (i.e., 2wt% DTBBT, 50mol% TFPB in FPNPE plasticized poly(vinyl chloride)) exhibited high potentiometric selectivity towards silver ions over alkali, alkaline earth, transition metal ions, as well as heavy metal ions such as Hg²⁺ and Pb²⁺. A good correlation was found between the potentiometric selectivity coefficients and the change in the UV-visible spectra of the ionophore upon exposure to different metal ions. The overall performance of the silver-selective membrane electrodes based on DTBBT ionophore, which is available at low cost, was found to be comparable to the performance of silver electrodes prepared with Fluka silver ionophore-IV. A DTBBT-based silver electrode was used as an indicator electrode for titrations of silver ions using standard sodium chloride solutions. Sharp inflections occur at the end point, and the data obtained showed 99.4% recovery with a standard deviation of 0.7% (n=3). In addition, the applicability of the DTBBT-based silver-selective electrode is illustrated by measuring the silver concentrations in natural water spiked with silver nitrate and by analyzing the silver in electroplating wastewater samples. The results obtained utilizing a DTBBT-based silver electrode showed very good agreement with the standard methods of analysis.     

Pretreatment of swine wastewater using anaerobic filter

Efforts were made to assess the efficiency of an anaerobic filter packed with porous floating ceramic media and to identify the optimum operational condition of anaerobic filter as a pretreatment of swine wastewater for the subsequent biological removal of nitrogen and phosphorus. A stepwise decrease in hydraulic retention time (HRT) and an increase in organic loading rate (OLR) were utilized in an anaerobic filter reactor at mesophilic temperature (35°C). The optimum operating condition of the anaerobic filter was found to be at an HRT of 1 d. A soluble chemical oxygen demand (COD) removal efficiency of 62% and a total suspended solids removal efficiency of 39% at an HRT of 1 d were achieved with an OLR of 16.0 kg total COD/(m³·d), respectively. The maximum methane production rate approached 1.70 vol of biogas produced per volume of reactor per day at an HRT of 1 d. It was likely that the effluent COD/total Kjeldahl nitrogen ratio, of 22, the COD/total phosphorous ratio of 47, and the high effluent alkalinity >2500 mg/L as CaCO₃ of the anaerobic filter operated at an HRT of 1 d was adequate for the subsequent biological removal of nitrogen and phosphorus.     

Treatment of dairy wastewater using a selected bacterial isolate, Alcaligenes sp. MMRR7

Physicochemical and biologic analysis of dairy wastewater showed that the effluent had a high organic load (chemical oxygen demand [COD]: 5095 mg/L), an acidic pH (6.4), and a high probability of coliforms (most probable number [MPN]>1100). The various bacterial strains isolated and purified were identified as Sporolactobacillus sp., Citrobacter sp., Pseudomonas sp., Alcaligenes sp., Bacillus sp., Staphylococcus sp., and Proteus sp., as per the Bergey’s manual of systematic bacteriology. Among the five selected bacterial strains, the strain designated as MMRR₇ and identified as Alcaligenes sp. was found to give a maximum reduction in COD (62%) in 5 d of incubation. Chemical coagulation using alum at a concentration of 0.5 g/100 mL was found to be effective in the primary treatment of the effluent. Studies on free-cell treatment of the coagulated effluent with the selected bacterial strain Alcaligenes sp. MMRR₇ gave a maximum COD reduction of 91% in 120 h. This study clearly indicates the possibility of using Alcaligenes sp. MMRR₇ for the effective treatment of dairy wastewater.