Some results from 50 years' research on surface forces

A review is presented about research on surface forces and surface interactions conducted over the past half-century, with some emphasis on the pioneering contributions of the Department of Surface Phenomena at the Institute of Physical Chemistry of the USSR Academy of Sciences.     

Inhibition of the reduction of Cr(VI) at the magnetite–water interface by calcium carbonate coatings

The effect of calcium carbonate coatings on the reduction of aqueous chromate on the magnetite(1 1 1) surface has been investigated using a combination of synchrotron based X-ray photoemission spectroscopy (PES) and X-ray absorption near edge structure (XANES) spectroscopy, along with laboratory-based powder X-ray diffraction (XRD) and scanning electron microscopy (SEM). CaCO₃ coatings (dominantly calcite with minor quantities of aragonite and vaterite) of thicknesses ranging from 10 Å to 20 m were grown on magnetite(1 1 1) surfaces by exposure to supersaturated aqueous solutions followed by evaporation of the solution—a process that mimics pore-water evaporation in vadose zones leading to the formation of caliche and calcium carbonate coatings on mineral grains. Coating thicknesses were determined from attenuation of the Fe 2p photoemission signal by the carbonate coating. For coatings less than 15 Å thick, Cr 2p photoemission and Cr L_II, L_III-edge XANES spectra show that chromate is reduced by the underlying magnetite surface; however, as the minimum coating thickness increases beyond 15 Å, the magnetite surface becomes passivated and further chromate reduction ceases. Our findings suggest that carbonate coatings on natural magnetite grains can significantly reduce or eliminate their ability to reduce Cr(VI), which is a toxic and highly mobile environmental contaminant.     

AFM, SEM and GIXRD studies of thin films of red polycarbazolyldiacetylenes

In this paper we report the results of a morphological and structural investigation on film properties of a soluble polydiacetylene, the poly[1,6-bis(3,6-dihexadecyl-N-carbazolyl)-2,4-hexadiyne] (polyDCHD-HS). The red films of this polymer, prepared by standard spin-coating techniques, revealed absence of linear dichroism and birefringence in contrast with the ordered mesophases detected by powder X-ray studies. In order to interpret the optical behavior of this polymer, we performed AFM and SEM studies of polyDCHD-HS films spun on hydrophylic and hydrophobic glass substrates. We found the presence of surfaces organized in rod-like particles, more regularly oriented on the hydrophylic substrate. GIXRD studies, carried out on films sufficiently thick to allow the observation of the diffraction pattern, reveled the presence of a lamellar structure with a spacing of 3.22 nm. The low intensity of the diffraction peaks and the isotropic linear optical properties of the films show that the lamellar mesophases are not extended over large areas. These findings were compared with the data obtained from AFM and SEM studies on films of two other polydiacetylenes, the poly[1-(3,6-dihexadexyl-N-carbazolyl)-6-(N-carbazolyl)-2,4-hexadyine] (polya-DCHD) and the poly[1,6-bis(3,6-dipalmitoyl-N-carbazolyl)-2,4-hexadyine] (polyDPCHD), spun on hydrophylic glass substrate. The results confirmed the presence of nodular morphologies which seem to be a general characteristic of this class of materials. The particles organization appears instead related to the chemical nature of the substituents on the carbazolyl rings.     

长柱形CsI(Tl)闪烁晶体探测器的能量重建

提出了用于TEXONO实验中双端读出的长柱形CsI(Tl)闪烁晶体探测器的两种粒子能量重建方法———“算术平均值能量重建法”和“几何平均值能量重建法”,讨论了两种算法的理论依据和计算方法,并对两种算法进行了比较     

Surface elastic properties of Si decorated with Ni nanostructures

Brillouin spectroscopy was used to study elastic properties of the Si (1 1 1) decorated with Ni nanostructures deposited by nanospherical lithography. The height of the nickel nanostructure deposited was about 25 nm, while the area taken by the structure differed depending on the type of matrix used. It was found that the Ni nanostructures change the velocity of both bulk and surface phonons in the systems studied. This finding is in contradiction to the results concerning the surface phonons velocities in different media covered with a homogenous thin metal film, in which the effect was observed for films thicker than 70 nm.     

Effect of various adsorbates in dephasing and population decay of the Cu(1 0 0) image potential states

A theoretical study of the electron dynamics in image potential states on Cu(1 0 0) surfaces with different types of adsorbates is presented. Scattering of the image state electron by an adsorbate induces inter-band and intra-band transitions leading respectively to the population decay and to the dephasing of the image state. We compare results obtained with low coverage (typically 1 adsorbate atom per 1000 surface atoms) Cs, Ar, and a model electronegative adsorbates. As follows from our results, Cs adsorbates lead to both appreciable dephasing and decay, while electronegative adsorbates mostly affect the dephasing rate. The effect of low coverage Ar adsorbates is small, consistent with their neutrality.     

On the hydrogen etching mechanism in plasma nitriding of metals

Iron alloys and aluminum were nitrogen implanted in a controlled oxygen atmosphere and the role of hydrogen on the surface etching mechanisms studied. The surface composition was analyzed by in situ photoemission electron spectroscopy (XPS). In iron alloys, hydrogen strongly etches oxygen, improving nitrogen retention on the surface. On the other hand, hydrogen removes nitrogen from aluminum surfaces, with a deleterious effect on the nitriding effectiveness. The oxygen removal in iron alloys is associated with the catalytic effect of electrons in d-orbitals and the nitrogen removal in aluminum is associated with a steric effect.     

Scanning probe microscopy studies of PbS surfaces oxidized in air and etched in aqueous acid solutions

Natural n-type PbS single crystals have been studied using AFM, STM and STS after long-term oxidation in air at ambient temperatures and extensive etching in aqueous acid solutions, in contrast to previous work devoted to initial corrosion of fresh surfaces. The exposure of PbS to atmosphere at high relative humidity for several days yields widespread loose oxidation products; the process is much slower at low humidity. Surface morphologies diverge after the treatment in 1 M perchloric and hydrochloric acid solutions at room temperature and become widely different at elevated temperatures, displaying commonly etch pits up to several micrometers in size and depth along with rather uniformly distributed 20-100 nm protrusions of PbS phase. The changes both in topography and semiconducting properties of PbS found by tunneling spectroscopy have been explained in terms of the non-uniform distribution of donor- and acceptor-type defects D⁺/D⁻ in the metal depleted surface layer, which are generated by chemical reactions and, in turn, determine the rates of the PbS corrosion. In particular, the D⁻ centers exhibit a self-catalyzing effect on the non-oxidative local dissolution of PbS in HCl media, resulting in the deep etch pits.     

Optimal reconstruction of the solution of the wave equation from inaccurate initial data

In the present paper, we consider the problem of the optimal reconstruction of the solution of the wave equation from the approximate values of the Fourier coefficients of the function specifying the initial form of the string. For an operator defined on the weight space of vectors from l ₂, we present the solution of the more general problem of reconstruction from the approximate values of the coordinates of these vectors.     

用小型全息设备做傅里叶变换全息图存储资料实验

阐述了用小型全息设备做傅里叶变换全息图存储资料实验所采用的光路、详细的操作步骤和实验中的关键问题.