蝴蝶翅膀表面水滴各向异性黏附性质

采用扫描电子显微镜(SEM)观察了双带闪蝶(Morpho Achilles)翅膀表面的微观形貌, 通过样品的表观接触角表征了其浸润性, 采用高敏感性微电力学天平比较了水滴在蝴蝶翅膀表面不同方向运动时受到的黏附力. 实验结果表明, 水滴沿着干燥的蝴蝶翅膀鳞片堆叠方向运动时受到的黏附力要明显小于其它方向运动时受到的力, 且受力较稳定; 当蝴蝶翅膀被水滴浸润后, 水滴沿着湿润的蝴蝶翅膀鳞片堆叠方向运动时受到的黏附力接近甚至大于逆着鳞片堆叠方向运动时受到的力.     

CuS/TiO2纳米管异质结阵列的制备及光电性能

利用水热反应制备了CuS/TiO2纳米管异质结阵列,采用场发射扫描电子显微镜(FESEM)、透射电子显微镜(TEM)和X射线衍射谱(XRD)等手段表征了异质结阵列的表面形貌和晶体结构.电流-电压曲线结果表明,CuS/TiO2纳米管异质结阵列具有明显的整流效应.根据表面光电压谱和相位谱,在376～600 nm之间,CuS/TiO2纳米管异质结阵列表现为p型半导体特征,电子在表面聚集;在300～376 nm之间表现为n型半导体特征,空穴在表面聚集;在376 nm处异质结阵列的表面光伏响应为零.CuS/TiO2和CuS/ITO之间界面电场的不同导致异质结在不同波长范围内表面电荷聚集的差异.光电化学性能测试发现,以CuS/TiO2纳米管异质结阵列为光阳极组成的光化学太阳电池,在大气质量AM 1.5G,100 mW/cm2标准光强作用下具有0.4%的光电转换能力.     

Chemical modification of polymer surfaces: a review

The main approaches that have been taken to chemically modify polymer surfaces are introduced and reviewed. These are wet chemical oxidation, plasma treatment, classical organic chemistry, and attachment of polymer chains. The extent to which each of these approaches can produce the specific modifications desired is discussed, and any unwanted effects that commonly occur are cited. Finally, the need for using several methods of surface analysis in concert to obtain adequate surface characterization is described.     

钛胶的制备条件和物性关系

钛胶是新型有广泛用途的催化剂载体。本实验测定了钛胶的孔容、比表面积、铁含量和晶型结构；研究了钛胶的制备条件和物性关系，得到一些有实用价值的实验结果。     

煤粉在热分解过程中比表面积和孔隙结构的变化

用氮气等温吸附（７７Ｋ）方法测量了四种不同煤粉在热分解过程中的ＢＥＴ比表面积和孔隙结构。结果表明，不同煤种的比表面积在热分解过程中其变化有着相似的规律。在热分解温度低于５００℃时，煤粉所释放的挥发份主要来自煤粒外表面。当热分解温度高于５００℃后，煤粉释放出的挥发份主要来自煤粒内部深处。在８００℃时，由于煤的塑性，煤粒的部分孔减小和关闭，使其比表面积以及孔隙明显减少。在热分解温度高于８５０℃后，煤粉的比表面积随温度升高而急剧增大。     

193 nm激光引发PET表面的化学接枝

将聚对苯二甲酸乙二醇酯[Poly(ethylene terephthalate), PET]材料置于氨气气氛中, 利用激光光子同时激发材料表面及氨气形成自由基, 用激光引发反应并促进氨基在材料表面的接枝. 改性后的测试结果表明, 材料表面粗糙度没有显著变化, 但水接触角的减小表明表面化学结构发生了某种变化. 傅里叶变换红外光谱(FTIR/ATR)图谱在3352和1613 cm-1处出现了新的氨基吸收峰, 证实了表面接枝了氨基. 同时X射线光电子能谱(XPS)也证明了材料表面C—N键的存在, 其C1s结合能为285.5 eV, N1s为398.9 eV. 飞行时间二次离子质谱(Tof-SIMS)也检测到含氨基的分子碎片, 其碎片成像图显示接枝仅发生在激光辐照部位. 实验结果表明, 激光能在生物材料表面进行局部区域的选择性接枝.     

INFLUENCE OF SURFACE-MODIFICATION FOR CALCIUM CARBONATE ON THE INTERACTION BETWEEN THE FILLERS AND POLYDIMETHYLSILOXANE

The surface of calcium carbonate(CaCO_3)particles was modified with stearic acid(SA)and the chemical structures of the product were characterized by FT-IR analysis.The interaction between polydimethylsiloxane(PDMS)and CaCO_3 fillers with different surface character was investigated by means of dynamic rheological and bound rubber tests for uncured compounds and mechanical properties measurements for the corresponding vulcanites.The results of dynamic tests indicate that with the increase of SA mass fract...     

Sensitive electrochemical detection of arsenic (III) using gold nanoparticle modified carbon nanotubes via anodic stripping voltammetry

Gold nanoparticles were deposited electrolessly on multiwalled carbon nanotubes (CNTs) via in situ reduction of HAuCl₄ by NaBH₄. The resulting gold covered nanotubes were immobilised onto the surface of a glassy carbon electrode via evaporation of a suspension in chloroform. Anodic stripping voltammetry was performed with the modified electrode in As(III) solutions. A limit of detection (LOD based on 3σ) of 0.1 μg L⁻¹ was obtained but more importantly a sensitivity of 1985 μA μM⁻¹ was obtained with square wave voltammetry (SWV) in an optimised system with a deposition time of 120 s. These values, particularly the high sensitivity compare favourably with previously reported methods in the area of electrochemical arsenic detection.     

A comparison of the surface properties of lignin and sulfonated lignins by FTIR spectroscopy and wicking technique

The comparison of the FTIR spectra indicated that the sulfonation without caused changes in the main structure of lignin and only in the lignin chains. The surface properties, e.g. the surface free energy and related components, e.g. the Lifshitz–van der Waals and Lewis acid–base interactions components, of lignin and lignosulfonates, LGSs, with different ions, e.g. Na⁺–, Mg²⁺–, and Ca²⁺–, studied and compared by wicking technique indicated that the surface free energy of lignin is lower than that of all used LGSs. This suggests that the sulfonation can enhance the surface property for lignin by increasing of the Lifshitz–van der Waals component and Lewis base component of lignin.     

CO分子在TiC(001)表面上的吸附构型与电子结构

采用第一性原理方法和平板模型对CO分子在TiC(001)表面的吸附构型和电子结构进行了详细研究. 结果表明, CO分子倾向于采用C端吸附在表层Ti原子上方. 对于该吸附方式, 计算得到的吸附能、CO各电子态所处能级位置以及C—O键伸缩振动频率的红移值均与实验观测结果相吻合. 由能带结构和Mvlliken布居分析结果可知, 当采用C端吸附时, CO的5σ和2π鄢态受到底物影响最为显著, 尤其是C端的桥位吸附方式. 此外, 还进一步对底物表面态在CO吸附过程中的作用进行了探讨.