The Ho thickness dependence of spin-triplet supercurrents in Nb/Ho/Co/Ho/Nb films

Robinson et al. [J.W.A. Robinson, et al., Science 329 (2010) 59] reported control of spin-triplet supercurrents into ferromagnets by varying the thicknesses of the Ho injector and attributed the voltage peaks to non-integer spiral wavelengths of λ/2 and 5λ/2 in Ho. Here we demonstrate that these peaks correspond to λ/2 and 3λ/2.     

Random resistivity network calculations for cuprate superconductors with an electronic phase separation transition

The resistivity as a function of temperature for high temperature superconductors is very unusual and, despite its importance, lacks a unified theoretical explanation. It is linear with the temperature for overdoped compounds but it falls more quickly as the doping level decreases. The resistivity of underdoped cuprates increases like that of an insulator below a characteristic temperature where it shows a minimum. We show that this overall behavior can be explained by calculations using an electronic phase segregation into two main component phases with low and high electronic densities. The total resistance is calculated from the various contributions through several processes of random picking of the local resistivities and using a common statistical random resistor network approach.     

A novel method of flat YBCO rings development for shield-type superconducting fault current limiters fabrication

The application of flat superconductor rings has been investigated in the structure of inductive shield-type high temperature superconducting fault current limiters, HT_c-SFCL. A laboratory scale inductive shield-type HT_c-SFCL has been designed and fabricated using flat superconductor rings. The fabrication process has been fully presented. YBCO powder has been used for the fabrication of superconductor rings. This fabrication process, being quite innovative, is introduced completely. The method of the trapped field measurement has been used for the critical current density measurement of the fabricated superconductor rings. The device with nominal current of 2 A was tested in a 30 V circuit. The SFCL successfully limited the fault currents of up to 10 times the nominal current to an approximately fixed value of 3 A. The voltage-current characteristic of the fabricated prototype has also been obtained and has shown compatibility with the fault current limitation results.     

高温超导YBCO带材的交流损耗的FEM仿真分析

对高温超导带材YBCO的交流损耗进行了仿真分析。运用有限元FEM方法,基于Maxwell方程组的数值建模,引入了基于实验数据的power-law对交流损耗进行计算。首先对自场下的交流损耗值进行了仿真计算并分析了带材的电流密度与磁场分布情况,并通过与实验测量数据做比较验证仿真方法的有效性。其次分别对不同幅值下的平行场与垂直场下的交流损耗进行了计算,将自场、平行场以及垂直场下的电流密度与磁场强度的分布以及交流损耗值进行了对比分析。     

高压下 MgB2 超导的涡旋动力学研究*

我们首次通过磁弛豫的方法系统研究了高压下 MgB2 样品的磁通钉扎以及涡旋动力学, 测量了其在不同温度和磁场下的磁化强度 M 随时间t 的衰变, 即 M(t) . 根据集体蠕动理论, 明确了高压效应在低磁场时抑制了磁衰变速率, 但在高场下大大的加快了磁衰变. 高压降低了临界电流密度J c 和钉扎能. 另外, 在 MgB2 样品里低场下没有观测到弹性蠕变向塑性蠕变的转变.