Determination of volatile organic compounds in urban and industrial air from Tarragona by thermal desorption and gas chromatography-mass spectrometry

This study describes the optimisation of an analytical method to determine 54 volatile organic compounds (VOCs) in air samples by active collection on multisorbent tubes, followed by thermal desorption and gas chromatography-mass spectrometry. Two multisorbent beds, Carbograph 1/Carboxen 1000 and Tenax/Carbograph 1TD, were tested. The latter gave better results, mainly in terms of the peaks that appeared in blank chromatograms. Temperatures, times and flow desorption were optimised. Recoveries were higher than 98.9%, except methylene dichloride, for which the recovery was 74.9%. The method's detection limits were between 0.01 and 1.25 μg m⁻³ for a volume sample of 1200 ml, and the repeatability on analysis of 100 ng of VOCs, expressed as relative standard deviation for n = 3, was lower than 4% for all compounds. Urban and industrial air samples from the Tarragona region were analysed. Benzene, toluene, ethylbenzene and xylenes (BTEX) were found to be the most abundant VOCs in urban air. Total VOCs in urban samples ranged between 18 and 307 μg m⁻³. Methylene chloride, 1,4-dichlorobenzene, chloroform and styrene were the most abundant VOCs in industrial samples, and total VOCs ranged between 19 and 85 μg m⁻³.     

Improved general correlation for critical heat flux during upflow in uniformly heated vertical tubes

An improved version of the author's earlier correlation for CHF in vertical tubes is presented. It is compared with data that include 23 fluids (water, refrigerants, cryogens, chemicals, and liquid metals), tube diameters 0.315 to 37.5 mm, tube length 1.3 to 940 times diameter, mass flux 4 to 29051 kg/m²s, reduced pressures 0.0014 to 0.96, inlet quality −4 to +0.85, and critical quality −2.6 to +1. These data, from 62 independent sources, are also compared with Katto's general correlation and those of Bowring for water and Subbotin for helium. The present correlation shows much better agreement with data.     

Development of GC–MS/MS method with programmable temperature vaporization large volume injection for monitoring of 17β-estradiol and 2-methoxyestradiol in plasma

Monitoring of estradiol and its metabolites in biological samples is essential for the accurate diagnosis of a number of endocrine diseases. In this study, a sensitive, precise and specific GC–MS/MS method for the quantification of 17β-estradiol (17-BE) and its main metabolite, 2-methoxyestradiol (2-MEOE), in plasma was developed and validated. Plasma concentrations of these steroids are currently investigated as diagnostic markers for pre-eclampsia, a systematic disorder of pregnancy and a leading cause of maternal and fetal morbidity and mortality worldwide.     

Determination of nickel in natural waters by FAAS after sorption on octadecyl silica membrane disks modified with a recently synthesized Schiff's base

A simple, highly sensitive, accurate and selective method for the determination of trace amounts of Ni²⁺ ions in water samples is proposed. The method is based on the separation and preconcentration of Ni²⁺ on an octadecyl-bonded silica (ODBS) membrane disk modified by a recently synthesized Schiff’s base N,N′-bis (3-methylsalicylidene) ortho phenylene diamine (MSOPD) at pH 7. The synthesis of this extractant ligand is also described. The retained nickel on the membrane was eluted with 2×5 ml 0.5 M HNO₃ and measured by flame atomic absorption spectrometry (FAAS) at 232.0 nm. The extraction efficiency and the influence of the type and least amount of eluent for the stripping of Ni²⁺ from the disks, pH, flow rates of sample solution and eluent, amount of MSOPD, effect of other ions, and breakthrough volume were evaluated. The maximum capacity of the membrane disks modified by 3 mg of MSOPD was found to be 146±4 μg Ni²⁺. The 3σ limit of detection of the method was 30 ng per 1000 ml and also an enrichment factor of 250 was obtained. The proposed method has been applied to the determination of nickel in several water samples with satisfactory results.     

Flames in narrow circular tubes

We examine an axi-symmetric deflagration located in a tube with thermally active walls. It is noted that the flame-in-tube configuration defines a classical edge-flame, a flame in a shear flow for which there is a water-shed solution for a critical value of the Damköhler number (D), ignition front solutions for larger values of D, and failure wave solutions for smaller values. We examine semi-infinite tubes with a heat flux imposed at the tube wall ends, to simulate experiments reported in the 30th Symposium. We identify parameters for which stable solutions are obtained at certain flow rates, but unstable solutions are generated at higher flow rates, followed by stable solutions at still higher flow rates. These solutions are consistent with the experimental record. Instability leads either to regular oscillations or to a violent process characterized by quenching and re-ignition.     

Combined implementing the hole-drilling method and reflection hologram interferometry for residual stresses determination in cylindrical shells and tubes

Main features inherent in simplified approach to residual stresses determination in cylindrical shells and tubes, external diameter of which is not less than 60 mm, by combing the hole-drilling method and reflection hologram interferometry are discussed in detail. Initial experimental information in a form of hole diameter increments in principal stress directions is derived from high-quality reflection holograms recorded near cylindrical objects of intermediate curvature value. Converting measured parameters into required stress values is based on the transition model that corresponds to plane stress conditions of pure membrane type. The technique developed is capable of determining residual stress component values within 5% accuracy in an absence of stress gradients over the probe hole diameter when a type of residual stress field corresponds to the transition model adopted. The accuracy analysis involved is based on matrix formulation of conventionally direct problem and an assumption on a pure membrane character of residual stress field under study for thin-walled shell. Required error estimations in a case of inspecting thick-walled cylindrical tube are obtained by combining the above-mentioned approach and an analogy of reconstructed fringe patterns with actual and artificial interferograms, which follow from drilling blind hole of the same geometrical parameters in thick-walled plates. Experimental verification of the developed approach is founded upon a determination of actual stresses in thin-walled cylindrical shell and obtaining residual stress distributions at the proximity of welded joint in thick-walled cylindrical tube.     

Simultaneous Determination of Caffeine and Theophylline in Human Plasma with a Weak Cation Monolithic SPE-column

A simple reversed‐phase high performance liquid chromatography (RP‐HPLC) method was developed to determine the level of caffeine and theophylline in human plasma samples. The sample clean‐up step involved the on‐line solid‐phase extraction (SPE) of the analytes from plasma samples into a weak cation monolithic column using a column switching system. Separation was performed on a C₁₈ column (5 µm, 150 mm×4.6 mm) with ultraviolet detection at 274 nm. The mobile phase consisted of methanol‐water (32/68, V/V) under isocratic conditions at a flow rate of 0.6 mL·min⁻¹. The measured concentration of caffeine and theophylline showed a good linear relationship over the concentrations range, 0.1–80.0 µg·mL⁻¹. The absolute recoveries ranged from 77.10% to 85.39%, and the inter‐day and intra‐day relative standard deviations (RSD) were all less than 5%. This method avoids a tedious pretreatment and provides an economic, repeatable and effective method for assaying trace drugs in biological samples.     

Determination of Testosterone Metabolites in Rat Hepatocytes with and without Cryopreservation by On-Line SPE Column-Switching LC and MS Detection

In a recently published paper development of a sensitive automated “on-line” solid-phase extraction (SPE)/RP-HPLC assay for 6β-hydroxytestosterone (6β-OHT) with corticosterone as the internal standard (IS) was reported and its potential for quantification of various testosterone metabolites in culture media reflecting metabolic activity of cultured human and animal hepatocytes demonstrated [1]. In this following contribution the technique has been extended to determination of another five testosterone metabolites in cultured rat hepatocytes using an identical “on-line” SPE/RP-HPLC procedure and detection by tandem MS-MS with an atmospheric pressure chemical ionization (APCI) source in the selected reaction monitoring (SRM) mode as that described in [1]. All six testosterone metabolites, namely 2α-OHT, 2β-OHT, 6α-OHT, 6β-OHT, 7α-OHT and 16α-OHT, could be sufficiently separated from each other and thus an unequivocal assignment to the individual structures was achieved. Validation data are presented specifying the limits of quantitation as well as the mean values of the coefficients of variation (CV) for the target analytes and the accuracy obtained at five different days. Regio- and stereoselective testosterone hydroxylation by rat hepatocytes was measured in a long-term culture system with and without exposure to rifampicin as an inducer of liver CYP 3A4 activity. In addition, testosterone hydroxylation was analyzed in cultures of cryopreserved hepatocytes that had been stored at −196 °C. The rat hepatocytes were cultured after thawing for up to 11 days and induction of testosterone hydroxylase activity could be demonstrated in cultures which underwent a new cryopreservation protocol. This paper is dedicated to Professor Hinrich Cramer on the occasion of his 75th birthday.     

A survey of works on the theory of toroidal shells and curved tubes

This paper gives a survey of works on the theory of toroidal shells which were done by our two universities in recent years. This paper was supported by DAAD Germany