反向流动注射化学发光法测定痕量铁

基于邻菲别名林对高碘酸钾－碱性鲁米诺－铁体系发光强度的增敏作用建立了水体中总铁的反向流动性化学发光检测方法。该法线性范围在１×１０＾－４－１０ｍｇ／Ｌ，检测限为３×１０＾－６ｍｇ／Ｌ，对于５×１０＾－３ｍｇ／Ｌ Ｆｅ测定９次的相对标准偏差为０．９％。此方法已用在水处理中总铁的监测。     

Volatile phase profiling of mainstream smoke by glass capillary gas-chromatographic techniques

A heated injection system for a microprocessor-controlled GC has been developed for the (GC)² analysis of the volatile phase of whole smoke of a cigarette. Effects of injection port temperature and the presence of a Cambridge filter pad are demonstrated. Chromatograms are shown for smoke samples with and without a Cambridge Filter with the sample valve oven at 25°, 165° and 205°C. The use of a flame ionization and a nitrogen-phosphorous detector is illustrated.     

A photometric detector driven by beta radiation

It was recently found that typical Chromatographic carrier gases such as argon or nitrogen could be used in a modified flame photometric detector for general or selective determination of eluted molecules. The detector was powered not by a flame but by a radioactively stimulated, mild discharge. The luminescence arose from the second positive system of nitrogen (in argon), and various emissions from aroyl-containing molecules (in nitrogen).This study describes experiments that take away not only the flame but also the discharge: The energy that produces the luminescence is derived solely from the beta decay of⁶³Ni. Because of this low power input, the sensitivity of the present beta-driven photometric detector (-PD) is limited to about 25 ppm of nitrogen (in argon), and to about 5 pg/s for benzaldehyde and other well-responding aroyl compounds (in nitrogen). In accordance with mechanisms postulated earlier, other types of molecules do not produce significant responses in the absence of an electrical field.Material taken from doctoral thesis     

利用压电频移法测定水中的痕量亚硝酸盐

提出了利用压电频移法测定亚硝酸盐的方法。方法以碘离子与亚硝酸根之间的氧化还原反应为依据，通过测定由反应生成的碘所引起的压电晶体频率的变化，在被萃取水相中亚硝酸盐浓度为０．００９￣２．３ｍｇ／Ｌ范围内，频移值与浓度成正比：ΔＦ＝５．８＋２．５×１０＾３Ｃ（ｍｇ／Ｌ），ｒ＝０．９９０１。方法简便，用于天然水中亚硝酸盐的测定，结果令人满意。     

Hypercoulometric effect in an electron capture detector polarized with an additional voltage

Summary This paper reports measurements of the current characteristics and of the signal corresponding to a constant concentration of Freon F-11 for an electron-capture detector, supplied with a pulse voltage with a changeable pulse duration, amplitude and repetition time. It was found that an additional voltage applied to the detector cathode increased the detector signal by about 50% and that the maximal signal was observed at 5 V. The influence of the polarized voltage on the electron caputure efficiency coefficient (p) measured with two detectors in series was demonstrated and the reliability of the sample mass calculation by means of (p) is discussed.     

Supercritical fluid chromatography of petroleum products using flameless sulfur chemiluminescence detection

Supercritical fluid chromatography using flameless sulfur chemiluminescence detection has been investigated for the analysis of sulfur compounds in petroleum products. The chromatography and detection system was easy to implement and exhibited good precision, linearity, selectivity, and sensitivity. A minimum detectable limit of 0.3 pg sulfur/s was obtained, and response to sulfur in different sulfur species was nearly equimolar.     

丙烯中微量硫的测定

本文采用燃烧方法将不同形式的可燃性硫转化为SO2，在硝酸介质中用H2O2将SO2氧化为SO4^2-，并用离子色谱法测定。结果表明，该法样品处理简单，干扰离子少，灵敏度高，能较准确测定出丙烯中的微量硫。     

Voltammetric Detector for Liquid Chromatography: Determination of Triclosan in Rabbit Urine and Serum

A flow-electrolytic cell containing a strand of carbon fibers has been designed and characterized for use in a voltammetric detector for high-performance liquid chromatography. The detector was used for determination of triclosan (2,4,4-trichloro-2-hydroxydiphenyl ether) in rabbit serum and urine. Analysis of rabbit serum and urine 1 day and 1 to 5 days, respectively, after ingestion of oral triclosan revealed that the concentration of triclosan was higher than for control serum and urine. The concentration reached maximum levels after 6 h and 34 h or 44 h in serum and urine, respectively. When triclosan was determined in rabbit samples with the method proposed the results obtained were comparable with those obtained by high-performance liquid chromatography with ultraviolet detection.     

Highly sensitive determination of haloperidol in human serum by capillary gas chromatography using a surface ionization detector

A method has been developed for highly sensitive determination of haloperidol in human serum involving a simple extraction procedure followed by gas chromatographic separation. Target components were separated from the extracting solvents with a Van den Berg type solventless sample injector before introduction Into a DB-1 capillary separation column. A surface ionization detector (SID), which has highly selective sensitivity for Substituted amines, was employed for quantitation using bromperidol as an internal standard. Chloroform proved to be the best extracting solvent, yielding a quantitative detection limit of 5 ng/ml (S/N = 2). Comparison of the response to target compounds obtained by the SID, FTD (flame thermionic detector), and FID (flame ionization detector) showed the SID to be superior.