鲤鱼体中鱼腥味物质的提取和鉴定

采用同时蒸馏萃取法提取鲤鱼鱼体中的挥发和半挥发性有机物，用GC／MS从提取物中分析鉴定出鱼腥味和疑是鱼腥味物质16种。包括醛、烯醛、酮和呋喃4类化合物。其中己醛、庚醛和2，4-二烯癸醛被确认为鱼腥味的化合物。研究发现，这些物质总量在鲤鱼体的鱼鳞、鱼鳃和鱼肉的分布呈现下降趋势，且其总量与鱼腥味强度之间具有可比较的对应关系。     

示差半微分循环伏安法研究琥珀酰胆碱在水/硝基苯界面的传递行为

研究了油/水界面电解的示差半微分循环伏安行为。在0.01mol/L LiCl(w)-0.01mol/L TBATCIPB(nb)体系“电位窗”比TBATPB(nb)向正方向扩展约50mV,残余电流基本消除,使“电位窗”内的平台向左右拓宽约50mV。算得界面电容约为16μF/cm~2。考察了琥珀酰胆碱离子在w/nb界面的传递伏安特性,结果与一般半微分循环伏安法相似。但峰形改善,检测限降低一个数量级(1×10~(-6)mol/L),相对标准偏差在5％以内,可用于定量测定琥珀酰胆碱。     

结构—饱和土壤相互作用的固结有限元分析

讨论了结构与饱和土壤相互作用的固结分析问题.对于结构利用多重子结构分析技术实现向饱和土交界面上的凝聚.从而建立了结构与饱和土壤相互作用的固结控制方程.文中给出了问题求解的一次性算法方案,采取压力主从关系的手段处理边界上的不排水条件.文末给出数值算例.本文工作为大型结构与土体相互作用固结分析研究工作的深入创造了条件.     

Influence of heat treatment conditions on the porosity changes of sulfonated styrene/divinylbenzene copolymers

Sulfonic cation exchangers with two ion exchange group concentrations (0.5 and 2.4 mmol/g, samples A and B, respectively) were obtained by sulfonation of a porous styrene (S) and divinylbenzene (DVB) copolymer with chlorosulfonic acid. Strong thermal decomposition of the sulfonated copolymer A, accompanied by significant changes in its porous structure, starts at ca. 400°C. The char has no sulfonic groups. After heat treatment at 400°C in steam, a sorbent was obtained (yield 65%) that shows higher phenol sorption than the untreated sample when related to the bed volume. The chlorosulfonic derivatives of the initial copolymer were less thermally resistant than the sulfonic ones obtained by hydrolysis. Pyrolysis of the cation exchanger B, in its H+ and Ca²⁺ forms, was carried out at 900°C (yield of both chars close to 30%). By subsequent steam activation at 800°C to a 50% burn-off of the char, sorbents with well-developed, but distinctly different, porous structures were obtained. The activated char from the sulfonated copolymer in its hydrogen form was highly microporous and indicated an effective surface area of 1180 m²/g. However, because of a low contribution of mesopores, its ability to adsorb phenol from the liquid phase was not very high. The activated char from the calcium-doped copolymer, indicating a smaller surface area (580 m²/g) but characterized by a well-developed mesoporosity, was a better sorbent for phenol. © 1994 John Wiley & Sons, Inc.     

通过J/Ψ→N(N-)M衰变研究N*时的核子极点效应

研究了J／Ψ→pp^-π衰变过程中核子极点图的贡献，特别是由离壳效应带来的贡献．发现衰变宽度对形状因子是敏感的．在通过用J／Ψ→pp^-π衰变研究N^*时，核子极点图作为背景道的贡献是非常重要的；在通过J／Ψ→pp^-η和pp^-η研究N^*时，核子极点图的贡献可忽略不计；在通过J／Ψ→pp^-ω研究N^*时，核子极点图有明显的贡献．     

Pervaporation of benzene/cyclohexane mixtures using ion-exchange membrane containing copper ions

The sorption, diffusion, and pervaporation (PV) properties of benzene/cyclohexane (Bz/Cx) mixtures on cation-exchange membranes containing copper ions (Cu(II)) were investigated. The equilibrium sorption isotherms of pure vapors in the membranes and the partial solubility of binary solutions in the membranes were described using the UNIQUAC model. The τ_iM and τ_Mi values were 0.978 and 0.591 for Bz, and 0.922 and 0.475 for Cx. The transient regimes of vapor sorption were employed to calculate the concentration-dependent diffusion coefficients. Long’s model sufficiently explained the diffusivity of Bz and Cx in the membranes. The pre-exponential factors were 3×10⁻¹³ m²/s and the plasticization factors were 3.0 and 3.6 for Bz and Cx, respectively. Excellent agreement was found with the experimental results applying the solubility and diffusivity data to simulate the pervaporation performance (flux and selectivity) using the modified Maxwell–Stefan equation. The membrane containing Cu(II) demonstrates better facilitating capability for Bz transport than that with Na(I), mainly due to its preferential sorption property toward Bz. Replacing Na(I) with Cu(II) into a Neosepta membrane resulted in better separation efficiency and higher Bz flux throughout the entire Bz concentration range.     

定常的热传导-对流问题的Galerkin/Petrov最小二乘混合元方法

1.引言 热传导-对流问题是大气动力学中的一个重要的方程,这个方程组也称为强迫耗散的非线性系统方程组,其较Navier-Stokes方程多了一个未知函数温度场,且温度与速度和压力之间存在着复杂的非线性关系.从热动力学可知,任何运动都会产生热量即有温度,而且温度与速度和压力之间必定互相转化,因此对该非线性系统的研究更具有实际意义.[1]先对     

Formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber blends: Effects of preparation method,composition, and thermal condition

The effects of preparation method, composition, and thermal condition on formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber (iPP/EPR) blends were studied using modulated differential scanning calorimeter (MDSC), wide angle X‐ray diffraction (WAXD), and phase contrast microscopy (PCM). It was found that the α‐iPP and β‐iPP can simultaneity form in the melt‐blended samples, whereas only α‐iPP exists in the solution‐blended samples. The results show that the formation of β‐iPP in the melt‐blended samples is related to the crystallization temperature and the β‐iPP generally diminishes and finally vanishes when the crystallization temperature moves far from 125 °C. The phenomena that the lower critical temperature of β‐iPP in iPP/EPR obviously increases to 114 °C and the upper critical temperature decreases to 134 °C indicate the narrowing of temperature interval, facilitating the formation of β‐iPP in iPP/EPR. Furthermore, it was found that the amount of β‐iPP in melt‐blended iPP/EPR samples is dependent on the composition and the maximum amount of β‐iPP formed when the composition of iPP/EPR blends is 85:15 in weight. The results through examining the effect of annealing for iPP/EPR samples at melt state indicate that this annealing may eliminate the susceptibility to β‐crystallization of iPP. However, only α‐iPP can be observed in solution‐blended samples subjected to annealing for different time. The PCM images demonstrate that an obvious phase‐separation happens in both melt‐blended and solution‐blended iPP/EPR samples, implying that compared with the disperse degree of EPR in iPP, the preparation method plays a dominant role in formation of β‐iPP. It is suggested that the origin of formation of β‐iPP results from the thermomechanical history of the EPR component in iPP/EPR. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1704–1712, 2007     

Optical Spectroscopy and Theoretical Studies in Calixarene Chemistry

This review summarizes different applications of optical spectroscopic methods in calixarene chemistry including UV/Vis spectrometry, vibrational spectroscopic techniques (FTIR and Raman spectroscopy), luminescence spectroscopy (including fluorescence and phosphorescence), ellipsometry and various optical microscopic methods. Moreover, the results of theoretical studies (AM1, PM3, DFT, ab initio, etc.) are summarized based on selected papers in the field of conformational studies, thermodynamics and complexation features. About 300 references are processed systematically from the results reported mainly in the recent years with emphasis on the potential of practical application of these molecules.