最大似然方法和Bayes方法在结构方程模型分析中的讨论(英文)

本文通过模拟研究,讨论了最大似然方法和Bayes方法在分析结构方程模型中的相似点和不同之处。     

InAs/GaSb/AlSb resonant tunneling spin device concepts

We discuss device concepts for creating spin-polarized current sources without external magnetic fields, using non-magnetic 6.1 Å semiconductor resonant tunneling structures. Spin filters, spin pumps, and spin transistors that exploit structural and bulk inversion asymmetries will be examined.     

On the trajectory of a single electron under the action of a linearly polarized laser field

The dynamics of a single electron submitted to a linearly polarized laser field is examined in the non-relativistic case by calculating an upper bound of the position of the electron in the time domain.     

On the dynamic electromechanical loading of dielectric elastomer membranes

Dielectric elastomer actuators (DEAs) have received considerable attention recently due to large voltage-induced strains, which can be over 100%. Previously, a large deformation quasi-static model that describes the out-of-plane deformations of clamped diaphragms was derived. The numerical model results compare well with quasi-static experimental results for the same configuration. With relevance to dynamic applications, the time-varying response of initially planar dielectric elastomer membranes configured for out-of-plane deformations has not been reported until now. In this paper, an experimental investigation and analysis of the dynamic response of a dielectric elastomer membrane is reported. The experiments were conducted with prestretched DEAs fabricated from 0.5 mm thick polyacrylate films and carbon grease electrodes. The experiments covered the electromechanical spectrum by investigating membrane response due to (i) a time-varying voltage input and (ii) a time-varying pressure input, resulting in a combined electromechanical loading state in both cases. For the time-varying voltage experiments, the membrane had a prestretch of three and was passively inflated to various predetermined states, and then actuated. The pole strains incurred during the inflation were as high as 25.6%, corresponding to slightly less than a hemispherical state. On actuation, the membrane would inflate further, causing a maximum additional strain of 9.5%. For the time-varying pressure experiments, the prestretched membrane was inflated and deflated mechanically while a constant voltage was applied. The membrane was cycled between various predetermined inflation states, the largest of which was nearly hemispherical, which with an applied constant voltage of 3 kV corresponded to a maximum polar strain of 28%. The results from these experiments reveal that the response of the membrane is a departure from the classical dynamic response of continuum membrane structures. The dynamic response of the membrane is that of a damped system with specific deformation shapes reminiscent of the classical membrane mode shapes but without same-phase oscillation, that is to say all parts of the system do not pass through the equilibrium configuration at the same time. Of particular interest is the ability to excite these deformations through a varying electrical load at constant mechanical pressure.     

Whirling frequencies and amplitudes due to deviations of generator shape

Earlier measurements in large synchronous generators indicate the existence of backward whirling motion, and also relatively large deviations of shape in both the rotor and the stator. These non-symmetric geometries produce an attraction force between the rotor and the stator, called unbalanced magnetic pull (UMP). The target of this paper is to analyse the whirling frequencies and amplitude of the response for large synchronous generators with a high number of poles, due to deviations of shape in the rotor and stator. A mathematical model is developed to describe the shapes of the rotor and stator, and the corresponding UMP is obtained by using the law of energy conservation. The UMP is analysed due to different deviations of shape. The result gives the average angular frequency and the magnitude of the UMP for certain deviations of shape. From this result, the whirling frequency and the amplitude of the corresponding response can be approximated. Simulations of the response of a Jeffcott rotor model show good agreement with the theoretical results of the UMP for some generator geometries. The conclusion is that different whirling frequencies, both backward and forward whirling, can occur in these machines due to deviations in shape of the generator. Therefore, the shape of the generator can excite resonance vibrations on several other frequencies than the rotation frequency. During maintenance of hydropower generators the shapes of the rotor and stator are frequently measured. The results from this paper can be used to evaluate such measurements and to explain the existence of complicated whirling motion.     

40,48Ca+90,96Zr融合反应的动力学模型研究

应用改进的量子分子动力学模型,在严格挑选初始核考虑弹靶结构效应的基础上,研究了近垒和垒上融合反应^40,48Ca+^90,96Zr. 研究表明: 4个反应的理论计算截面与实验值很好符合; 丰中子反应⁴⁰Ca+⁹⁶Zr的垒下融合截面比其他3个反应有明显增强的现象.为了理解丰中子反应⁴⁰Ca+⁹⁶Zr与⁴⁰Ca+⁹⁰Zr相比垒下融合截面增强,而Ca+⁹⁶Zr垒下融合截面没有明显增强的原因, 进一步分析了484个反应的融合位垒,中子转移与融合位垒的关系、中子转移与Q值的关系,结果表明: 正反应Q值会引起核子(特别是中子)转移的增强,从而导致动力学融合位垒的下降和垒下融合截面增强.     

Structural and electrical characterization of SxSe100−x thin films

Thin films of samples of the glassy S_xSe_100−x system with 0 ≤ x ≤ 7.28 have been prepared by thermal evaporation technique at room temperature (300 K). X-ray investigations show that the structure of pure selenium (Se) does change seriously by the addition of small amount of sulphur S ≤7.28%. The lattice parameters were determined as a function of sulphur content. Results of differential thermal analysis (DTA) of the glassy compositions of the system S_xSe_100−x were discussed. The characteristic temperatures (T_g, T_c and T_m) were evaluated. Dark electrical resistivities, ρ, of S_xSe_100−x thin films with different thicknesses from 100 to 500 nm, were measured in the temperature range from 300 to 423 K. Two distinct linear parts with different activation energies were observed. The variation of electrical resistivity of examined compositions has been discussed as a function of the film thickness, temperature and the sulphur content. The application of Mott model for the phonon assisted hopping of small polarons gave the same two activation energies obtained from the resistivity temperature calculations.     

An evolutionary method for optimization of plate buckling resistance

Optimization of plate buckling resistance is very complicated, because the in-plane stress resultants in the prebuckled state of a plate are functions of thickness distribution. This paper discusses the problem of finding the optimum thickness distribution of isotropic plate structures, with a given volume and layout, that would maximise the buckling load. A simple numerical method using the finite-element analysis is presented to obtain the optimum thickness distribution. Optimum designs of compression-loaded rectangular plates with different boundary conditions and plate aspect ratios are obtained by using the proposed method. Optimum designs from earlier studies and the methods of buckling analysis used to attain these results are discussed and compared with the designs from the proposed method. This paper also examines the reliability of the optimality criterion generally used for plate buckling optimization, which is based on the uniform strain energy density.     

CuO—ZnO／Al2O3—TiO2催化剂中TiO2的结构和电子效应

采用XPS,XRD,TPR,TPD和指标反应等方法研究了TiO_2在负载型CuO-ZnO/Al_2O_3-TiO_2催化剂中所起的作用.发现TiO_2起双重作用,即结构效应和电子效应,TiO_2的结构效应主要表现为它改善了CuO在载体上的分布.TiO_2的电子效应表现为它对Cu~0具有吸电子的作用,从而削弱了Cu和S之间的吸附力,使S容易脱除.另外,部分还原形成的Ti~(3+)具有促进CuS中的Cu~(2+)还原为Cu~0的能力,TiO_2的上述效应的综合结果使催化剂的抗硫中毒性能大大增强.     

Intrinsic field theory of chemical reactions

An intrinsic principle of least action is presented for the intrinsic dynamism of chemical reactions. Then, as the stationary trajectory, a meta-IRC (intrinsic reaction coordinate) draws a geodesic curve in a rigged Riemannian space. This establishes a geodesic law for the intrinsic dynamism. Moreover, a diagrammatic perturbation theory is formulated for the intrinsic dynamism, and a dynamical interaction between a chemically reacting system and a background system is investigated. Then, the structural stability of the system is discussed using a new concept of the dynamical potential field. An example is given in order to elucidate the present theory.Dedicated to Prof. Hermann Hartmann on the occasion of his 65th birthday.