超临界NaCl水溶液的分子动力学模拟

采用分子动力学模拟的方法对超临界NaCl水溶液的微观结构进行了研究.模拟发现在所研究超临界条件下,密度的变化比温度的变化对超临界NaCl水溶液的微观结构影响更大.温度及密度对Cl－ H2O径向分布函数的影响比对Na＋ H2O径向分布函数的影响要大.超临界条件下,各gNa＋－Cl－在0.261 nm处出现峰值,表明Na＋、Cl－之间发生了离子的缔合.超临界条件下,随温度增加,缔合作用增强；随密度增加,缔合作用减弱.本文工作为建立可适用于超临界条件下的电解质热力学模型提供了依据.     

Ion chromatographic determination of chloride,chlorate, and perchlorate in sulfuric acid solutions

Summary The determination of chloride and perchlorate by non-suppressed ion chromatography in aqueous process solutions containing a high sulfate background is described. The method is reliable and fast. The sensitivity for perchlorate is lower than for other anions like nitrate, nitrite and chlorate. The detection limits are about 0.3 g/ml with linear calibration curves within a concentration range from 1 to 50 g/ml.     

Chloride distribution coefficient on strongly basic anion-exchange resin: Dependence on co-ion in alkali fluoride solutions

Summary The dependence of the chloride distribution coefficient on the co-ion of solutions of different alkali fluorides, MF, up to 11M is tested on the strongly basic anion-exchange resin AG1-X10. Under the same experimental conditions the distribution coefficient decreases in the following order for M⁺: Na⁺>K⁺>Rb⁺>Cs⁺. This can be explained by the different co-ion-chloride interactions. The consequence of this interaction for a chromatographic separation of chloride is shown with 5M KF and CsF solutions, used as eluants. Depending on the fluoride concentration, the distribution coefficient passes through a minimum value to increase again at higher electrolyte concentration. The non-exchange electrolyte in the resin phase is responsible for this effect. In addition, the bromide and the iodide distribution coefficients up to 10M KF solutions are determined. One results is that the selectivity coefficient between halide ions increases at higher electrolyte concentrations.     

HoClTe2O5: Ein tellurdioxidreiches Holmium(III)‐Chlorid‐Oxotellurat(IV)

HoClTe₂O₅: A Telluriumdioxide‐rich Holmium(III) Chloride Oxotellurate(IV) While attempting to synthesize anionically derivatized holmium oxotellurates by reacting holmium chloride (HoCl₃) with tellurium oxide (TeO₃; molar ratio 1 : 3, 800°C 10 d) in evacuated silica ampoules, transparent, greenish yellow and coarse single crystals of holmium(III) chloride oxotellurate(IV) HoClTe₂O₅ (triclinic, P1; a = 762.07(6), b = 796.79(6), c = 1010.36(8) pm, α = 100.987(4), ß = 99.358(4), γ = 91.719(4)°; Z = 4) were obtained. The crystal structure contains eightfold coordinated (Ho1)³⁺ (only surrounded by oxygen atoms) and sevenfold coordinated (Ho2)³⁺ cations (surrounded by one chloride and six oxide anions). Each sort of holmium polyhedra convenes independently to chains along [100] by edge‐sharing which again combine alternately via O6 and O9 to form ²{[Ho₂O₁₀(Cl1)]^15—} layers parallel (001). Each of the four crystallographically different Te⁴⁺ cations are surrounded by three close oxygen atoms (d(Te—O) = 188 — 195 pm) and always one more situated further away. The stereochemical activity of the non‐bonding electron pairs (“lone pairs”) leads to ψ¹‐trigonal bipyramidal coordination figures. The ψ¹‐tetrahedral [TeO₃]^2— basic units form discrete [Te₂O₅]^2— doubles with ecliptic conformation which are arranged in a fish‐bone pattern parallel to (001) on both sides of the ²{[Ho₂O₁₀Cl]^15—} layers. The coherence of the ²{[Ho₂(Cl1)Te₄O₁₀]⁺} layers is exclusively maintained via Cl2—Te1 contacts with an extraordinary long distance of 335 pm. As (Cl1)^— belongs to the coordination sphere of (Ho2)³⁺ and (Cl2)^— is only surrounded by Te⁴⁺, the compound should be correctly named holmium(III) chloride oxochlorotellurate(IV) Ho₂Cl[Te₄O₁₀Cl] (Z = 2).     

双光束流动注射光度法测定生活用水中氯离子

将流动注射分析技术应用到双光束分光光度法中，对其理论和实验技术进行了研究，采用自行组装的流动注射系统进行了生活用水中氯离子的测定，获得满意结果。     

Effect of chloride on heavy metal mobility of harbour sediments

To evaluate the environmental impact of polluted sediments, several operationally defined sequential extraction procedures (SEPs) have been described. Salinity has long been recognised as an important variable determining the physicochemical behaviour of heavy metals in marine sediments. Thus, in the present paper, the modified BCR-SEP has been applied to harbour sediments in order to assess to what extent trace metal mobility (Cd, Cr, Cu, Ni, Pb and Zn) could be influenced by chloride content in sediments. For this, washed (W) and non-washed (NW) sediments were compared. The relative mobility order observed for the six trace metals studied was not seen to be influenced by the presence of chloride in the sediments, but an increase of mobility was observed for Cd and Zn (the most mobile metals) when chloride was present in the sediments. Characterisation of the sediments and of the pseudo-total metal contents by means of an aqua regia extraction was also assessed.     

Synthese von [(η-C5H5)2Ti(Cl)(CCSiMe3)]Ni(CO) und dessen Reaktionsverhalten gegenüber Phosphiten: die Festkörperstruktur von (CO)2Ni[P(OC6H4CH3-2)3]2

Treatment of [Ti](Cl)(CCSiMe₃) (1) {[Ti]=(η⁵-C₅H₅)₂Ti} with Ni(CO)₄ (2) in a 1:1 molar ratio produces the heterobimetallic early-late transition metal complex {[Ti](Cl)(CCSiMe₃)}Ni(CO) (3), which features a low-valent Ni(CO) entity stabilized by a datively bonded Cl and a η²-coordinated Me₃SiCC ligand. As side-products [Ti]Cl₂ (8) and {[Ti](CCSiMe₃)₂}Ni(CO) (5) are formed. The latter complex can also be synthesized by the reaction of [Ti](CCSiMe₃)₂ (4) with equimolar amounts of 2. If 3 is reacted with stoichiometric amounts of P(OR)₃ (6a, R=C₆H₅; 6b, R=C₆H₄CH₃-2; 6c, R=C₆H₄^tBu-2) the bis(alkynyl) titanocene 4, (CO)₂Ni[P(OR)₃]₂ (7a, R=C₆H₅; 7b, R=C₆H₄CH₃-2; 7c, R=C₆H₄^tBu-2), complex 8, {[Ti](μ,η¹:η²-CCSiMe₃)}₂ (9) along with Me₃SiCCCCSiMe₃ (10) is produced. A possible mechanism for the formation of these species is presented. The solid-state structure of 7b is reported. Complex 7b crystallizes in the tetragonalic space group P-42₁c with the following parameters: a=14.852(2), b=14.852(2), c=19.410(4) Å, V=4281.5(12) ų, Z=4 and ρ=1.271 g cm⁻³. Mononuclear 7b features a Ni(0) centre in a pseudo-tetrahedral environment, caused by the CO and P(OC₆H₄CH₃-2)₃ ligands.     

Cs[Er6C]I12 und Cs2Lu[Lu6C]Cl18: Beispiele für quaternäre reduzierte Halogenide der Lanthanide mit isolierten „Clustern”︁

CS[Er₆C]I₁₂ and cs₂Lu[Lu₆C]CI₁₈: Examples for Quaternary Reduced Halides of the Lanthanides with Isolated “Clusters” Cs[Er₆C]I₁₂ and Cs₂Lu[Lu₆C]Cl₁₈ were obtained as byproducts through metallothermic reductions of ErI₃ and LuCl, with cesium in the presence of carbon in sealed tantalum containers at temperatures ranging from 700 to 940 °C. Cs₂Lu[Lu₆C]Cl₁₈ (isostructural with Cs₂Zr[Zr₆H]Cl₁₈, R 3 , a = 981.7 pm, c = 2723.2 pm, Z = 3, R = 0.082, R, = 0.053) contains octahedral [Lu₆C] clusters which are slightly compressed along the threefold axis and edge-bridged by twelve chloride anions to form [Lu₆C]Cl₁₂ units. Six additional Cl in exo positions of the cluster provide octahedral coordination for the seventh Lu³⁺. Cs⁺ occupies anticuboctahedral interstices within the Cl⁺ layers as a part of the (hexagonal) closest packed arrangement. Cs[Er₆C]I₁₂ (trigonal, R 3, a = 1112.0pm, c = 2063.8pm, Z = 3, R = 0.094, R, = 0.068) exhibits [Er₆C]I₁₂ units as well and shows the structural framework of Sc[Sc₆N]Cl₁₂. Instead of Sc³⁺ in octahedral holes, cesium occupies a regular iodide position within the ccp sheets forming [CsI₃] layers. Both halides are compared with other compounds of the lanthanides containing isolated [M₆X₁₂] clusters. The extreme electron deficiency is discussed.     

Flow injection spectrophotometric method for chloride determination in natural waters using Hg(SCN)(2) immobilized in epoxy resin

A flow injection (FI) spectrophotometric method was proposed for the determination of chloride ion in natural waters. The determination of chloride was carried out by reaction with Hg(SCN)₂ immobilized in an epoxy resin bead in a solid-phase reactor (SPR) and the thiocyanate ions released were determined spectrophotometrically at 480 nm after complexing reaction with Fe(III). The analytical curve for chloride was linear in the concentration range from 5.6 × 10⁻⁵ to 2.2 × 10⁻⁴ mol l⁻¹ with a detection limit of 1.4 × 10⁻⁵ mol l⁻¹. The relative standard deviation (R.S.D.) was 2.2% for a solution containing 2.2 × 10⁻⁴ mol l⁻¹ (n = 10). The simple manifold allows a routine analytical frequency of 100 determinations per hour. The main advantage of the developed method is the 400% reduction of the Hg waste solution generated when compared to conventional methods for chloride determination based on the same spectrophotometric reaction.     

N2 Laser Excited Fluorescence of Oxalyl Chloride at 77°K

The N₂ laser excited fluorescence spectrum and the intensity of fluorescence of oxalyl chloride C₂O₂Cl₂) condensed at 77°K either alone, or, diluted with a non-hydrocarbon or a hydrocarbon with dilution ratios ranging from 10 to 100 were studied. A slow condensation of the hydrocarbon matrix diluted sample showed a considerable reduction in the fluorescence intensity as compared to a fast condensation of the same sample.