以1,1,1-三(N-甲基-N_苯基氨基羰甲氧甲基)丙烷为载体的钙离子选择电极

报道了以三脚架化合物1,1,1_三 (N_甲基_N_苯基氨基羰甲氧甲基 )丙烷 (TMPP)为载体的钙离子选择电极的研制;探讨了增塑剂、载体浓度、pH等因素对电极性能的影响 ;结果表明电极对钙离子有较好的近能斯特响应 ,相应的斜率为27.6 mV/pcCa2+ ,线性响应范围为5×10-5 ～5×10-2 mol/L,检出限为2.3×10-5mol/L ;电极在pH4～13范围内具有强的抗干扰能力 ,并具有很好的重复性和稳定性 ;该电极作为钙离子选择电极 ,用于乳酸钙口服液中钙含量的测定 ,取得了满意的结果     

Electron density distribution in potassium bis -(carbonato)cuprate(II)

The electron density distribution in potassiumbis-(carbonato)cuprate(II) has been analyzed using x-ray diffraction data from an earlier structure determination. While the copper-ligand geometry is close to square planar the deformation density near the metal is strongly asymmetric. There are local maxima near the copper atom along the line of the Cu-K vectors. These resemble features found in corresponding regions in normal length metal-metal bonds. The observation is consistent with the long range nature of the Coulomb potential associated with the potassium ion.     

The intermolecular potential function of Smith–Thakkar type for C60

The intermolecular potential function of Smith–Thakkar type for C₆₀ has been proposed, and its expression is as follows

The unit of u(r) is J/mol, r is the distance between two C₆₀ molecules center and the unit is nm. Some properties of C₆₀ in the gas and crystal have been studied using the interaction potential of Smith–Thakkar type, such as stability of C₆₀ crystals, virial coefficient and lattice dynamics.     

Determination of chloride by stripping chronopotentiometry with silver-film electrode

The experimental parameters of cathodic stripping chronopotentiometry of chloride at a silver-film electrode are investigated and optimized. The chloride preconcentration is achieved in the form of silver chloride by a controlled potential oxidation of the working electrode under vigorous stirring. Cathodic stripping of the deposit is obtained by the constant current, under the condition of diffusive mass transfer. Deaeration of the solution is not necessary. A detection limit of 35 μ dm⁻³ (10⁻⁶ mol dm⁻³) is obtained at a deposition time of 180 s, with a reproducibility of 6.7 % (expressed as relative standard deviation, RSD).     

PVA固定化脲酶电极的制作及电极特性的研究

利用PVA低温下的物理交联固定酶,制成酶电极并在不同尿素浓度、pH值、温度等条件下进一步研究这种酶电极的响应特性.     

电极条件对硫酸介质中电解还原提纯镱过程的影响

研究了以钌铱钛合金网和汞分别为阳、阴电极, 在无气氛保护条件下, 采用电解还原方法从铥、镱、镥硫酸盐溶液中分离提纯镱的过程. 讨论了在8 V恒电压时的电极间距、位置, 以及阴、阳极表面积对电解过程中的电流、还原率影响. 优化了电解还原过程, YbSO4产品的纯度稳定达到99.5%以上, 一次收率可达80%;提镱后母液中的铥和镥被富集4倍以上, 其中Lu含量高于50%, 十分有利于后续铥/镥分离.     

Determination of diethanolamine or <Emphasis Type="Italic">N</Emphasis>-methyldiethanolamine in high ammonium concentration matrices by capillary electrophoresis with indirect UV detection: application to the analysis of refinery process waters

Alkanolamines such as diethanolamine (DEA) and N-methyldiethanolamine (MDEA) are used in desulfurization processes in crude oil refineries. These compounds may be found in process waters following an accidental contamination. The analysis of alkanolamines in refinery process waters is very difficult due to the high ammonium concentration of the samples. This paper describes a method for the determination of DEA in high ammonium concentration refinery process waters by using capillary electrophoresis (CE) with indirect UV detection. The same method can be used for the determination of MDEA. Best results were achieved with a background electrolyte (BGE) comprising 10 mM histidine adjusted to pH 5.0 with acetic acid. The development of this electrolyte and the analytical performances are discussed. The quantification was performed by using internal standardization, by which triethanolamine (TEA) was used as internal standard. A matrix effect due to the high ammonium content has been highlighted and standard addition was therefore used. The developed method was characterized in terms of repeatability of migration times and corrected peak areas, linearity, and accuracy. Limits of detection (LODs) and quantification (LOQs) obtained were 0.2 and 0.7 ppm, respectively. The CE method was applied to the determination of DEA or MDEA in refinery process waters spiked with known amounts of analytes and it gave excellent results, since uncertainties obtained were 8 and 5%, respectively.     

Calculations of van der Waals interaction energies for Al, Cr, Fe, and Ir acetylacetonate crystals

Experimental data have been analyzed and interpreted for four volatile acetylacetonates of trivalent metals Al, Cr, Fe, and Ir. The crystal lattice energies were calculated by the atom-atom potential method. The lattice energies obtained by using the Buckingham potential are in better agreement with the sublimation heats of these metal complexes than those calculated from the Lennard-Jones potential. The experimental dependences of vapor pressure for the complexes are in satisfactory agreement with the values obtained from the calculated lattice energies and entropies of crystal-gas transitions.     

Vanadium Doped Sol-Gel TiO2 Coatings

A study of the experimental conditions required to obtain vanadium doped sol-gel TiO2 coatings is presented. Tetraethyl orthotitanate was employed as the TiO2 source and VCl3, VOSO4 · H2O and VOSO4 dissolved H2SO4 where employed as vanadium sources.Dip coating has been used to produce coatings on silicon wafers, spectral carbon electrodes and titanium electrodes. Both supported and unsupported films have been studied by UV-Vis spectra, IR spectroscopy and X-ray diffraction (XRD). The measurements have been made on samples as prepared and treated thermally at temperatures between 100°C and 300°C. The thermal treatment temperatures have been established from DTA/TGA measurements.The vanadium doped sol-gel TiO2 coatings have been tested as sensors for redox potential measurements in electrochemical processes. The influence of both the thickness of films and the nature of substrate has been investigated.     

Characteristic behavior of macro-, semimicro- and microelectrodes in voltammetric and chronoamperometric measurements

The advantages of microelectrodes such as the improvement of signal-to-noise ratio, the ability to perform electrochemical measurements in high resistive solutions and small RC-time constants give the possibility of an extended use for voltammetric and chronoamperometric techniques in analytical chemistry. In this comparative study, the microelectrode properties of three selected electrodes were examined. The characterization of a RAM-microarray electrode, an epoxy-impregnated carbon electrode and a conventional glassy carbon macroelectrode was performed by cyclic voltammetry at different scan rates, by DP-voltammetric measurements using different concentrations of supporting electrolyte and by transient measurements. It could be shown, that in comparison to the microarray electrode and to the glassy carbon macroelectrode, respectively, the results obtained by using the epoxy-impregnated carbon electrode are caused by its semimicroelectrode character.