Electrogenerated Chemiluminescence Based on Tris(2,2′-bipyridyl) Ruthenium(II) with Hydroxyl Carboxylic Acid

Upon the electrochemical oxidation of tris(2,2′-bipyridyl) ruthenium(II) [Ru(bpy)²⁺₃] and hydroxyl carboxylic acids, for instance, citric acid, tartaric acid, malic acid, and -gluconic acid, bright electrochemiluminescences (ECLs) were observed. Different luminescent reactions were presented depending on the applied potential. The light emission was mainly caused by the reaction between alkoxide radical ion and Ru(bpy)³⁺₃below the potential +1.80 V (vs Ag/AgCl). The luminescence intensity obviously increased because of the more complex reaction process. The luminescence wavelength of 608 nm, which could be found either at higher potential than +1.80 V or in the potential range from +1.30 to +1.80 V, confirmed that ECL was caused by Ru(bpy)²⁺₃*. The factors which affect the determination and HPLC separation of the four acids were also investigated.     

Ag+ ion transport studies in a polyvinyl alcohol-based polymer electrolyte system

Thick films of pure polyvinyl alcohol and polyvinyl alcohol doped with silver nitrate with different compositions have been prepared by solution cast technique. The FT-IR spectrum confirms the complexation process. The conductivity of the pure polyvinyl alcohol is of the order of 10⁻⁷ Sm⁻¹ at 90 °C, and its value increases by two orders of magnitude when doped with 20 wt% of AgNO₃. The activation energy, calculated from the Arrhenius plot for all compositions of the poly vinyl alcohol doped with silver nitrate, is between 0.24 and 0.35 eV. The migration energy for the ion in polymer electrolyte has been calculated from the modulus spectrum, and is in good agreement with the activation energy calculated from the Arrhenius plot. The modulus spectra indicate the non-Debye nature of the material.     

Solid-state binding of dimethyl sulphoxide involving carboxylic host molecules. X-ray crystal structures of four inclusion species

The crystal structures of four dimethyl sulphoxide (DMSO) inclusion compounds with different carboxylic acid hosts,1–4, have been studied by single crystal X-ray analysis. Crystals of thetrans-9,10-dihydro-9,10-ethanoanthracene-11,12-dicarboxylic acid inclusion compound (1a), [1 · DMSO (1: 1)] show monoclinic (P2₁/n) symmetry with the unit cell dimensionsa = 11.522(4),b = 18.658(2),c = 8.709(1) Å and = 98.92(2)°. The clathrate of the 9,10-dihydro-9,10-ethanoanthracene-11,12-dicarboxylic acid (2a), [2 · DMSO (1: 2)] is triclinic (P) with the cell dimensionsa = 15.043(7),b =9.657(4),c = 8.118(7) Å, = 101.81(5), = 96.05(4) and = 100.04(4)°. Triclinic (P) symmetry is shown also by the inclusion compound of 9,10-dihydro-9,10-ethanoanthracene-11-monocarboxylic acid (3a) [3 · DMSO (1:1)] with the cell dimensionsa=6.3132(1),b=7.9846(2),c=17.5314(4) Å, = 96.46(2), = 87.08(2) and = 106.02(2)°. The 9,9-bianthryl-2-monocarboxylic acid clathrate (4a) [4 · DMSO (1:1)] is monoclinic (P2₁/n) and the cell dimensions area = 19.625(18),b = 8.817(1),c = 14.076(8) Å and = 97.92(6)°. In all these structures, the hosts show the same basic recognition pattern for the DMSO guest, involving a strong O-H ... O bond from the COON to the S=O group, and a possible C-H ... O type interaction between the carbonyl O atom of the host and a CH₃ group of the guest. The crystals consist of discrete host-guest aggregates which are mainly held together by weak intermolecular interactions of the Van der Waals' type. The stoichiometries of the aggregates are, however, different.     

Comparison of Different Sorbents for Solid-Phase Extraction of Phenoxyalkanoic Acid Herbicides

An HPLC procedure for determination of phenoxyalkanoic acid herbicides in water samples is proposed. The analytical column Phenomenex C18(2) Luna 5 µm and UV detection at 225 nm were applied. Baseline resolution was achieved in isocratic mode with a mobile phase consisting of acetonitrile/acetic acid (40/60, v/v), adjusted to pH 2.5. SPE sorbents – C₁₈ BondElut, phenyl-silica, LiChrolut SAX and polymeric sorbents – were compared for isolation and preconcentration of 6 phenoxyalkanoic acid herbicides. Higher (above 95%) and more reproducible recoveries were obtained with polymeric and phenyl-silica sorbents using pure methanol for elution. The method was tested for river water samples with the limit of detection in the range of 2–3 µg L⁻¹ (for 50 mL sample) and a reproducibility of 5% RSD.     

Development and validation of a capillary electrophoresis method for the determination of phenothiazines in human urine in the low nanogram per milliliter concentration range using field-amplified sample injection

A capillary zone electrophoresis (CZE) method with ultraviolet-visible detection has been established and validated for the determination of five phenothiazines: thiazinamium methylsulfate, promazine hydrochloride, chlorpromazine hydrochloride, thioridazine hydrochloride, and promethazine hydrochloride in human urine. Optimum separation was obtained on a 64.5 cm x 75 microm bubble cell capillary using a buffer containing 150 mM tris(hydroxymethyl)aminomethane and 25% acetonitrile at pH 8.2, with temperature and voltage of 25 degrees C and 20 kV, respectively. Naphazoline hydrochloride was used as an internal standard. Field-amplified sample injection (FASI) has been applied to improve the sensitivity of the detection. Considering the influence of parameters affecting the on-line preconcentration (nature of preinjection plug, sample solvent composition, injection times, and injection voltage) and due to the significant interactions among them, in this paper we propose for the first time the application of a multivariate approach to carry out the study. The optimized conditions were as follows: preinjection plug of water for 7 s at 50 mbar, electrokinetic injection for 40 s at 6.2 kV, and 32 microm of H3PO4 in the sample solvent. Also, a solid-phase extraction (SPE) procedure is developed to obtain low detection limits and an adequate selectivity for urine samples. The combination of SPE and FASI-CZE-UV allows adequate linearities and recoveries, low detection limits (from 2 to 5 ng/mL), and satisfactory precisions (3.0-7.2% for an intermediate RSD %).     

Biosensors for environmental pollutants and food contaminants

This review article provides an overview of the most recent literature on biosensors for environmental pollutants and food contaminants. Due to the large number of publications, only papers published between 2000 and January 2003 were considered. Also, while not all of the published literature could be reviewed here, over 200 references are cited to provide a good overview of research undertaken in the last two years. Older publications are covered by a number of earlier review articles. This article provides an introduction into the field including specific consideration of the application areas, describes the typical biosensor assay format used, and is subsequently structured according to the biorecognition elements used (i.e., nucleic acids, enzymes, whole cells, tissue and whole organisms, antibodies and receptors, and biomimetic materials). In addition, a section on microbiosensing systems is provided. Since only very few microbiosensors with applications in environmental and food systems have been published, enabling technology is also covered in this article.Abbreviations BOD biological oxygen demand - cfu colony forming units - DNP dinitrophenol - GFP green fluorescent protein - NASBA nucleic acid sequence-based amplification - PCR polymerase chain reaction - ppt parts per trillion - QCM quartz crystal microbalance - SPR surface plasmon resonance     

Chemically-bonded stationary phases for thin-layer chromatography of metal ions

Summary A numer of bonded stationary phases were investigated for the separation of Cd²⁺, Cu²⁺, Fe³⁺, Mn²⁺, Ni²⁺, Pb²⁺, and Zn²⁺ by thin-layer chromatography. The effect of structure, surface loading, type of silica gel and mobile phase concentration was considered.     

Dynamic headspace liquid-phase microextraction of alcohols

A method was developed using dynamic headspace liquid-phase microextraction and gas chromatography-mass spectrometry for extraction and determination of 9 alcohols from water samples. Four different solvents, hexyl acetate, n-octanol, o-xylene and n-decane were studied as extractants. The analytes were extracted using 0.8 microl of n-octanol from the headspace of a 2 ml sample solution. The effect of sampling volume, solvent volume, sample temperature, syringe plunger withdrawal rate and ionic strength of the solution on the extraction performance were studied. A semiautomated system including a variable speed stirring motor was used to ensure a uniform movement of syringe plunger through the barrel. The method provided a fairly good precision for all compounds (5.5-9.3%), except methanol (16.4%). Detection limits were found to be between 1 and 97 microg/l within an extraction time of approximately 9.5 min under GC-MS in full scan mode.     

汞的形态分析研究 Ⅱ.固相萃取预富集-液相色谱分离测定不同形态的有机汞

本文报道了固相萃取预富集处理样品继以液相色谱分离测定不同形态痕量有机汞的方法.二乙基二硫代氨基甲酸钠(DDTC)作络合剂及甲醇作洗脱液的预富集系统能在线富集甲基汞(MeHg)、乙基汞(EtHg)和苯基汞(PhHg).用于测定加标海水中MeHg、EtHg和PhHg,回收率分别为96.9％、102.4％和98.0％;相对标准偏差分别为3.5％、5.0％和5.0％;检测下限分别为 1.0μg/L、1.2 μg/L和 1.2 μg/L.