Analysis of organic pollutants in water at trace levels using fully automated solid-phase extraction coupled to high-performance liquid chromatography

Summary A method has been developed for the determination of trace levels of 32 pesticides, 19 explosives and 16 polycyclic aromatic hydrocarbons (PAH) in water in three individual steps. Solid-phase enrichment (SPE) is coupled to high-performance liquid chromatography (HPLC) with a fully automated system. The organic pollutants are enriched on reusable cartridges packed with adsorbent materials: pesticides and explosives on a mixed bed of divinylbenzene-ethylvinylbenzene copolymers (LiChrolut EN^?) and perfluorinated polyethylene (PolyF^?), and polycyclic aromatic hydrocarbons on C₁₈-modified silica (Zorbax^? ODS1). Thermally assisted desorption (TAD) has been shown to increase the recovery of analytes significantly. As all enriched analytes are transferred to the detector, only fifty millilitres of sample is needed for each single on-line analysis, compared with at least a litre for conventional methods. The separation of the enriched organic analytes is performed on specialized HPLC columns based on reversed-phase materials. The limits of detection of the system employed were found to be below 100 ng L⁻¹. Use of fluorescence detection for the polycyclic aromatic hydrocarbons resulted in limits of detection in the upper pg L⁻¹ range. Thek values, number of theoretical plates, the recovery rates and the limits of detection of this method for fast screening of organic pollutants from three fifty-millilitre aqueous samples are described. Presented at the 21^st ISC held in Stuttgart, Germany, 15^th–20^th September, 1996     

HPLC Analysis of Cotinine in Urine After SPE with a Cholesterol-Modified Adsorbent

A one-step solid-phase extraction procedure, based on a new silica gel adsorbent modified with cholesterol groups, has been investigated for measurement of cotinine in urine. Cotinine is the main metabolite of nicotine in the human body and is analyzed as a biomarker for assessment of direct or passive exposure to tobacco smoke. New cholesterol-modified adsorbents have been obtained by chemical modification of silica gel of different porosity with cholesterol ligands. Although recovery by this extraction procedure were optimum over a relatively broad range of sample pH (3.1–8.0), analytical conditions such as sample loading, washing and elution conditions, concentration of cotinine to be extracted, and the type of adsorbent used for extraction were found to affect the efficiency of the procedure and had to be controlled for optimum recovery. When these conditions were controlled, recovery of cotinine from spiked human urine was reproducible and depended on compound ionization. Quantitative analysis of cotinine was performed by reversed-phase high-performance liquid chromatography with UV detection. Presented at: Conference of the Hyphenation of Liquid Chromatography–Nuclear Magnetic Resonance Spectroscopy, Liquid Chromatography–Mass Spectrometry and Related Topics, Tuebingen, Germany, March 25–29, 2006.     

The use of solid sorbents for direct accumulation of organic compounds from water matrices–a review of solid-phase extraction techniques

The main principles of solid-phase extraction techniques are reviewed in this paper. Various solid sorbents can be used as a suitable trap for direct accumulation of organic compounds from aqueous solutions. The trapped analytes can be desorbed by elution with suitably chosen liquid phases. These preconcentration procedures can be considered as low performance liquid chromatography and the efficiency of the procedure can thus be related to the retention characteristics of the preconcentration column. The main sorbents used for trace enrichment purposes are also reviewed. Besides, the concise methodology, sample storage, and automation are discussed. The advantages of solid phase extraction as compared to liquid-liquid extraction are given as well as some drawbacks of this method.     

Microwave-assisted solid-phase Dötz benzannulation reaction: a facile synthesis of 2,3-disubstituted-1,4-naphthoquinones

A microwave-assisted solid-supported Dötz benzannulation of chromium carbene complexes with various alkynes has been developed. The oxidative cleavage of the resulting resin-bound 1,4-naphthols affords 2,3-disubstituted-1,4-naphthoquinone derivatives in good to moderate yields with high purities.     

Spectrofluorimetric method for the determination of piroxicam and pyridoxine

A simple and highly selective method for the determination of piroxicam and pyridoxine (vitamin B6) in pharmaceutical formulations is presented. The approach is based on the combination of solid-phase extraction (SPE) and room-temperature fluorimetry (RTF). SPE under optimum pH conditions provides the separation between piroxicam and pyridoxine. The selectivity of analysis, the analytical figures of merit, and the accuracy of the method are demonstrated with the determination of piroxicam and pyridoxine in several pharmaceutical preparations.     

Hetero Diels-Alder reactions (HDAR) of α,α′-dioxothiones on solid support

Solid-supported α,α′-dioxothiones are easily obtained starting from β-ketoester modified Wang and hydroxymethylated polystyrene resins. The hetero Diels-Alder reactions (HDAR) of these species, used either as electron-poor dienes or dienophiles, followed by a simple cleavage of the products from the resin by trans-esterification with sodium methoxide, allowed the isolation of the desired cycloadducts in overall yields up to 90%.     

High extraction efficiency fiber coated with calix[4] open-chain crown ether for solid-phase microextraction of polar aromatic and aliphatic compounds

The calix[4] open-chain crown ether, 5,11,17,23-tetra-tert-butyl-25,27-di(2-allyloxyethoxyl)-26,28-dihydroxycalix[4]arene was synthesized and used for preparation of solid-phase microextraction (SPME) fibers of enhanced extraction efficiency. The new SPME coating made from calix[4] open-chain crown ether and hydroxyl-terminated silicone oil was developed with the aid of vinyltriethoxylsilane as bridge using sol-gel method and cross-linking technology. The efficiency of the novel fiber in the extraction of polar aromatic and aliphatic compounds, such as phenols, alcohols, and volatile fatty acids, was also investigated. Due to the introduction of the polar open-chain crown ether in calix[4]arene molecules, the calix[4] open-chain crown ether fiber showed much better selectivity and sensitivity to these polar compounds in comparison with calix[4]arene fiber. It also had superior extraction efficiency when compared to commercial poly(dimethylsiloxane)-divinylbenzene and polyacrylate fibers. Parts per billion to parts per trillion level detection limits were achieved for most of the analytes through SPME in conjunction with GC and flame ionization detector. The linear ranges were two to four orders of magnitude, and the RSD values were below 7% for all analytes. The novel fiber was applied to determine volatile alcohols and fatty acids in wine samples. The volatile-free wine prepared in this work was used to assure similar chemical environment for analytes in both calibration solutions and in real wine samples, thus compensating for possible matrix interferences. The established internal standard method using 4-methyl-2-pentanol as internal standard showed satisfactory accuracy and precision.     

Closed tube sample introduction for gas chromatography-ion mobility spectrometry analysis of water contaminated with a chemical warfare agent surrogate compound

Ion mobility spectrometry (IMS) is a proven technology for detection of vapor phase chemical warfare agents. The technology is suitable for field portable instrumentation due to its small size, high sensitivity, speed of analysis, and low power consumption. However, it suffers from a limited dynamic range and potential difficulties in identifying compounds in complex matrices. The use of gas chromatography (GC) coupled to IMS can overcome the difficulty of chemical identification in mixtures by separating the sample into individual components before detection. Using this approach, IMS technology has previously been adapted to detect biological aerosols using an open tube pyrolyzer and a short GC column (Py-GC-IMS). The open sample introduction tube of a Py-GC-IMS instrument would be a convenient configuration to accept aerosol particulates, and while viewed as needed for aerosol trapping, is not optimal for liquid chemical analyses. To examine the usefulness of an existing Py-GC-IMS system for analysis of chemicals in water, an existing open-port sample interface was replaced with a septum-equipped closed tube injector to contain analyte vapors resulting from liquid injection. Tributylphosphate (TBP) was used as a surrogate chemical warfare agent, and aqueous injections into both closed and open tube assemblies were performed. Sample introduction into the closed tube inlet was also accomplished using solid phase microextraction (SPME) preconcentration. The limit of detection for TBP using an open tube, closed tube, and closed tube configuration with SPME sample introduction was 0.980, 0.196, and 0.0098 mg/L, respectively.     

Comparative assessment of solid-phase extraction clean-up procedures, GC columns and perfluoroacylation reagents for determination of type B trichothecenes in wheat by GC-ECD

Various solid-phase extraction (SPE) procedures for clean-up, two perfluoroacylation reagents (pentafluoropropionic anhydride (PFPA) and heptafluorobutyric anhydride (HFBA)) and two chromatographic columns (HP-1701 and HP-5) have been assessed comparatively to achieve the determination of type B trichothecenes (deoxynivalenol (DON), nivalenol (NIV), 3- and 15-acetyldeoxynivalenol (3- and 15-ADON)) in wheat grain by gas chromatography (GC)-electron-capture detection (ECD). Spiked wheat samples were extracted with acetonitrile-water (84:16, v/v). Tested SPE procedures were MycoSep 225 column, Florisil and different cartridges prepared in the laboratory with mixtures of various sorbents like alumina, Celite 545, C18, silica and charcoal. We propose MycoSep 225 column, and cartridges made with alumina-charcoal-silica and alumina-charcoal-C18 silica mixtures as clean-up procedures on the basis of recovery values (89.6, 87.3 and 86.1% for deoxynivalenol, respectively, at 1.0 mg/kg spiking level). The two last procedures are less expensive. Pentafluoropropionic anhydride was more stable against moisture and less expensive, while recoveries were similar to those obtained with heptafluorobutyric anhydride. HP-1701 column can separate 3- and 15-acetyldeoxynivalenol derivatives while HP-5 cannot, although this last column provided lower bleed and better sensitivity.     

Sequential injection analysis for benzophenone-4 and phenylbenzimidazole sulphonic acid in sunscreen sprays by solid-phase extraction coupled with ultraviolet spectrometry

A sequential injection UV method was developed to determine benzophenone-4 (BZ4) and phenylbenzimidazole sulphonic acid (PBS) simultaneously, these being the most commonly used UV-filters in aqueous formulations used as sunscreen sprays. The selective elution of both was performed by on-line solid-phase extraction, by retention on a SAX microcolumn and separation by varying the pH of elution. The sensitivity obtained was 0.042±0.001 ml μg⁻¹ for PBS and 0.0159±0.0003 ml μg⁻¹ for BZ4. The limit of detection was 1.6 μg ml⁻¹ for PBS and 0.6 μg ml⁻¹ for BZ4. The R.S.D. of the results was 1-6% for PBS and 1-12% for BZ4. The method was validated using commercial sunscreen formulations with concentrations determined by a liquid chromatographic procedure. The two procedures gave comparable results. Automation of the method means the amount of reagents used and residues generated are decreased. The system allows the required analysis sequence to be programmed using suitable software.