A novel scheme to acquire enhanced up-conversion emissions of Ho3+ and Yb3+ co-doped Sc2O3

A detailed investigation about the effect of Sc₂O₃: 1 mol%Ho³⁺/5 mol%Yb³⁺ co-doped with Ce⁴⁺ ions prepared by sol-gel methods was performed systematically. Under the excitation of 980 nm laser diode, both green emission (553 nm, ⁵F₄/⁵S₂→⁵I₈) and red emission (672 nm, ⁵F₅→⁵I₈) were both observed in the emission spectra of the samples, which were found to be two-photon process and sensitized by Yb³⁺ ions. With the increasing of Ce⁴⁺ ions, the up-conversion green emission intensity are increased by 6.52, 8.69, 10.85, 13.92 and 16.66 fold, corresponding to the Ce⁴⁺ ions concentrations from 5 mol% to 13 mol%, respectively. The number of photons are necessary to populate the upper emitting state decreases to 2 and the infrared absorption coefficient is reduced, when the Ce⁴⁺ ions concentration increase to 13 mol%. Ce⁴⁺ ions play an important role in tailoring the local crystal field around Ho³⁺ ions, lowering the highest phonon cut-off energy of matrix and reducing the infrared absorption coefficient, thus hindering the non-radiative processes, which contribute to the increased emission intensity. The excellent enhancement makes it a promising multifunctional optical luminescence material.     

Investigation of electrochemical performance of MgNiO2 prepared by sol-gel synthesis route for aqueous-based supercapacitor application

In this work, we have successfully synthesized MgNiO₂ using a sol-gel wet chemical synthesis technique named MNO - 3. Electrochemical measurements in the presence of aqueous 1 M Li₂SO₄ electrolyte indicate that MNO - 3 samples exhibit a capacitance value of about 30 F/g and an energy density of about 20 Wh/kg. Subsequently, in the experiment involving aqueous 0.5 M Na₂SO₄ electrolyte system, it has been found that the capacitance for MNO - 3 sample is about 34 F/g and the energy density is about 23 Wh/kg for MNO - 3 sample. Finally, in the presence of aqueous-based 1 M Mg(ClO₄)₂ electrolyte, MNO - 3 sample is found to exhibit a capacitance of about 26 F/g and an energy density of about 17 Wh/kg, respectively. In all three electrolyte systems, the MNO -3 sample exhibit a long cycle capacitance retention of greater than 85% for 1000 charge-discharge cycles.     

Growth and characterization of model oxide catalysts

Oxide catalysts are frequently used to convert toxic species to environmentally benign molecules, and to prevent the formation of toxic species in the first place. In this paper, growth and characterization of model oxide systems employed in both approaches is discussed. An example of the former approach is the selective catalytic reduction (SCR) of NO emitted from power plants by NH₃, which employs tungsten and vanadium oxides supported on the anatase polymorph of TiO₂. To model SCR catalysts, epitaxial titanium, vanadium and tungsten oxide films were grown using molecular beam epitaxy and magnetron sputtering. Two different anatase orientations were grown on LaAlO₃ substrates and their interactions with vanadia were characterized. On LaAlO₃ (0 0 1), anatase exposed a (4 × 1) reconstructed (0 0 1) surface. Vanadia lifted the reconstruction and at 1 ML a (1 × 1) surface with mostly V⁵⁺ was observed. Continued V₂O₅ growth led to loss of order, but at high temperatures epitaxial VO₂ could be grown; vanadia behaved similarly on anatase films on LaAlO₃ (1 1 0). Results suggested that the monolayer is pseudomorphic with O adsorption oxidizing the surface V to 5+, since the anatase structure cannot accommodate more bulk oxygen, only a monolayer can be pseudomorphic and have only V⁵⁺. Thus the vanadia monolayer has unique structural and chemical properties that can help explain why vanadia monolayers on TiO₂ are much more active than bulk V₂O₅. For WO₃, a series of added row reconstructions were observed as the epitaxial films were reduced. The effect of these structures on surface chemistry was characterized by studying 1-propanol adsorption. The results indicated that the structure of the WO₃ surface did not alter its catalytic function but had a strong effect on reaction kinetics. As an example of a system where catalysts prevent the formation of toxic species, the reactivity of oxidized Pd surfaces used in CH₄ catalytic combustion were studied. An ordered PdO-like monolayer was found to be less reactive towards CO than adsorbed O on Pd. On the other hand, the PdO layer favored a lower activation energy C₃H₆ oxidation pathway. The results indicated that Pd oxidation reduces the sticking coefficient of reactive species but once molecules adsorb, the oxide surface can reduce the activation energy for subsequent reaction.     

Interrelation between inhomogeneity and cyclability in O3‐NaFe1/2Co1/2O2

O3‐NaFe_1/2Co_1/2O₂ shows initial capacity of 160 mAh/g and an average operating voltage of 3.1 V (vs. Na) with good cyclability, and is a promising candidate of the cathode materials for sodium‐ion secondary batteries (SIBs). Here, we found that the cyclability of the slowly‐cooled sample is much worse than that of quenched one, even though the former sample keeps the O3‐type structure. The energy dispersive X‐ray spectroscopy (EDX) images suggest that the slow‐cooled sample (Na_x Fe_1–yCo_y O₂) is inhomogeneous in the Fe concentration (1 – y), perhaps triggered by the Na deficiency (1 – x). We ascribed the poor cyclability in the slowly‐cooled sample to the concentration inhomogeneity (Δy). The Δy is further responsible for the fluctuation of the lattice constants (a and c), as revealed by the Williamson–Hall plot. (© 2016 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

间苯二酚-甲醛凝胶自发成膜技术研究

 以间苯二酚和甲醛为原料,对水相溶胶-凝胶聚合自发成膜技术获得间苯二酚-甲醛(RF)凝胶薄膜进行了研究。主要研究了溶胶-凝胶过程中冰醋酸（HAC）含量和反应温度对凝胶过程的影响,分析了RF有机凝胶自发成膜的形成机理。IR和SEM分析表明,所得到的凝胶膜具有典型的RF有机气凝胶结构,薄膜厚度大约为50 μm,膜由直径10 μm左右的粒子组成,没有观察到明显的孔洞结构。分析认为,在间苯二酚和甲醛占总溶液的质量分数为67％左右及控制pH值在一定的酸性范围,RF凝胶自发成膜过程和机理可以用RF凝胶的收缩机理加以解释,RF自发膜的表面形貌及形成机理与均匀泡沫的连续相分离机理类似。     

Ab initio study of sodium intercalation into metal oxides

Using the full-potential linearized augmented plane wave (FP-LAPW) method, we have studied the effect of chemistry on the average intercalation voltage (AIV) caused by the Na ions intercalating into transition metal oxides. The effect of transition metal was systematically studied by varying M=Co, Ni and Mn in NaMO₂ and fixing the α-NaFeO₂ layered structure. The effect of the guest atoms into the host material is discussed in terms of the structural and electronic properties. Comparatively to Li intercalation, a significant electron transfer towards transition metal was found. This observation suggests that the transition metal contribute to the AIV determination and confirms the common assumption that intercalated electron reduces M⁴⁺ to M³⁺.     

Interaction of indigo carmine dye with silica modified with humic acids at solid/liquid interface

Two distinct humic acids, one extracted from Brazilian peat soil, HA_PS, and another one obtained from commercial source, HA_FL, were attachment onto silica gel modified with aminopropyltrimethoxysilane, producing two material named SiHA_PS and SiHA_FL, respectively. The ability of these materials in removing indigo carmine dye from aqueous solution was followed through series of adsorption isotherms adjusted to modified Langmuir equation. The maximum number of moles adsorbed gave 6.82 ± 0.12 × 10⁻⁴ and 2.15 ± 0.17 × 10⁻⁴ mol g⁻¹ for SiHA_PS and SiHA_FL, respectively. Same interactions were calorimetrically followed and the thermodynamic data showed endothermic enthalpic values: 12.31 ± 0.55 and 24.69 ± 1.05 kJ mol⁻¹ for SiHA_PS and SiHA_FL surfaces, respectively. Gibbs free energies for two adsorption processes of indigo carmine dye presented negative values, reflecting dye/surface interactions must be accompanied by an increased in entropy values, which are 65 ± 3 and 98 ± 5 J mol⁻¹ K⁻¹ for SiHA_PS and SiHA_FL materials, respectively. The adsorption processes for both materials were spontaneous in nature although they presented an endothermic enthalpy for the interaction, resulting in an entropically favored process.     

一维锰氧化物纳米棒在以O2为氧源的苯甲醇氧化反应中的催化性能

采用水热法合成MnOOH一维纳米线,通过MnOOH在不同气氛和温度中煅烧得到尺寸和形貌相似的不同锰氧化物,并用于以O₂为氧源的苯甲醇液相氧化反应. 结果表明,MnO₂对苯甲醇氧化反应具有较高的催化活性. 通过XPS、SEM、TEM和H₂-TPR等手段对催化剂的形貌和结构进行了表征,并讨论了可能影响反应活性的一些因素. MnO₂的良好催化性能可能与其晶格氧具有较高的迁移率以及氧化还原能力有关. 通过简单的焙烧处理,可以使MnO₂催化剂在苯甲醇氧化反应中具有良好的重复使用性.     

Formation of 10-30 nm SiO2/Si structure with a uniform thickness at ∼120 °C by nitric acid oxidation method

Silicon dioxide (SiO₂) layers with a thickness more than 10 nm can be formed at ∼120 °C by direct Si oxidation with nitric acid (HNO₃). Si is initially immersed in 40 wt.% HNO₃ at the boiling temperature of 108 °C, which forms a ∼1 nm SiO₂ layer, and the immersion is continued after reaching the azeotropic point (i.e., 68 wt.% HNO₃ at 121 °C), resulting in an increase in the SiO₂ thickness. The nitric acid oxidation rates are the same for (1 1 1) and (1 0 0) orientations, and n-type and p-type Si wafers. The oxidation rate is constant at least up to 15 nm SiO₂ thickness (i.e., 1.5 nm/h for single crystalline Si and 3.4 nm/h for polycrystalline Si (poly-Si)), indicating that the interfacial reaction is the rate-determining step. SiO₂ layers with a uniform thickness are formed even on a rough surface of poly-Si thin film.     

Adsorption behavior and reaction properties of NO and CO on Rh(1 1 1)

Reactions between NO and CO on Rh(1 1 1) surfaces were investigated using infrared reflection absorption spectroscopy, X-ray photoelectron spectroscopy, and temperature-programmed desorption. NO adsorbed on the fcc, atop, and hcp sites in that order, whereas CO adsorbed initially on the atop sites and then on the hollow (fcc + hcp) sites. The results of experiments with NO exposure on CO-preadsorbed Rh(1 1 1) surfaces indicated that the adsorption of NO on the hcp sites was inhibited by preadsorption of CO on the atop sites, and NO adsorption on the atop and fcc sites was inhibited by CO preadsorbed on each type of site, which indicates that NO and CO competitively adsorbed on Rh(1 1 1). From a Rh(1 1 1) surface with coadsorbed NO and CO, N₂ was produced from the dissociation of fcc-NO, and CO₂ was formed by the reaction of adsorbed CO with atomic oxygen from dissociated fcc-NO. The CO₂ production increased remarkably in the presence of hollow-CO. Coverage of fcc-NO and hollow-CO on Rh(1 1 1) depended on the composition ratio of the NO/CO gas mixture, and a gas mixture with NO/CO ? 1/2 was required for the co-existence of fcc-NO and hollow-CO at 273 K.