超临界NaCl水溶液的分子动力学模拟

采用分子动力学模拟的方法对超临界NaCl水溶液的微观结构进行了研究.模拟发现在所研究超临界条件下,密度的变化比温度的变化对超临界NaCl水溶液的微观结构影响更大.温度及密度对Cl－ H2O径向分布函数的影响比对Na＋ H2O径向分布函数的影响要大.超临界条件下,各gNa＋－Cl－在0.261 nm处出现峰值,表明Na＋、Cl－之间发生了离子的缔合.超临界条件下,随温度增加,缔合作用增强；随密度增加,缔合作用减弱.本文工作为建立可适用于超临界条件下的电解质热力学模型提供了依据.     

Easy saponification by metal silanolates: application in SPPS and in (S)-5-hydroxynorvaline preparation

Alkali metal trimethylsilanolates, TMSO⁻, M⁺, has been used for efficient conversion of methyl esters into their corresponding anhydrous acid salts under mild non-aqueous conditions. This strategy has been applied to SPPS for the preparation of neurotoxin cyclic analogues and in (S)-5-hydroxynorvaline synthesis.     

十六烷基三甲基溴化铵光度滴定法测定硫酸软骨素钠盐

建立一种测定硫酸软骨素的新方法。十六烷基三甲基溴化铵在KH2 PO4 Na2 HPO4 缓冲溶液中、乳化剂OP共存下与硫酸软骨素反应形成离子对缔合物 ,溶液转变成稳定的乳化液。用光度滴定法测定硫酸软骨素。用标准加入法做回收试验 ,回收率为 99.9%～ 10 0 .2 % ,相对标准偏差0 .32 %～ 0 .4 0 %。方法应用于外贸样品测定 ,结果满意 ,方法准确、简便、快速     

Conductance studies in amide-water mixtures. II. Sodium salts inN,N-dimethylformamide-water mixtures at 35°C

Conductance data for sodium nitrite, chloride, and acetate in water andN,N-dimethylformamide (DMF)-water mixtures (74.82D42.48) for the concentration range 0.001–0.04N, as well as the densities, viscosities, and dielectric constants of the solvent mixtures at 35°C, are reported. The data have been analyzed by the Fuoss (1975) equation. The existence of a maximum in the viscosity at a 13 mole ratio of DMF and water is indicated. The Walden products for all the three salts pass through a maximum while the equivalent conductances show a minimum with increasing DMF content. The maxima in the Walden product are attributed to the dehydration of ions by the cosolvent (DMF).Part I:Indian J. Chem. 14A, 1015 (1976).Deceased.     

Vesicle formation in oleyldimethylamine oxide/sodium oleate mixtures

Vesicle formation in a mixture of oleyldimethylamine oxide (OleylDMAO) and sodium oleate (NaOl) was investigated by viscoelastic measurements and cryoscopic transmission electron micrograph (cryo-TEM) observations. The viscoelastic properties changed with increasing mole fraction of NaOl (X _NaOl) from the Maxwell behavior of OleylDMAO solutions (X _NaOl=0) suggesting a transient network of long flexible chains. For X _NaOl=0.2 and 0.4 mixtures, both the shear storage modulus G and the shear loss modulus G showed weak dependences on angular frequency with a relation G>G. From cryo-TEM observations, vesicles coexisted with threadlike micelles in mixtures of X _NaOl=0.2 and 0.3. As X _NaOl increased further (X _NaOl=0.5 and 0.6), threadlike micelles disappeared and the coexistence of vesicles and globular micelles was observed. At X _NaOl=0.5, the viscosity decreased remarkably, which was consistent with the disappearance of threadlike micelles. The results indicated that vesicles were formed by the addition of NaOl to OleylDMAO solutions, contrary to the expectation of a decrease of the packing parameter with the introduction of electric charges.     

谷氨酸钠从其水溶液中的周期结晶现象

早在本世纪初物理化学家们就已观察到，某些物质从其熔融态或溶液中结晶出来时，在某些条件下可形成周期性的宏观结晶条纹［1，2］，这就是周期结晶现象，由于这种现象和晶体生长、材料物性以及成矿过程等重要问题紧密相关，很早就引起了人们的重视．近年来有关非平衡非线性系统中自发产生各种时空有序现象（自组织现象）的各种理论（如耗散结构理论）［3］的兴起，重新引起了人们对这类现象的兴趣．八十年代，Iwamoto等先后报道了甲基苄基氨基甲酸酯（MethylMesitylcarbamate）从氯仿溶液［4］和抗坏血酸（AscorbicAcid）从甲醇溶液［5］…     

Thermodynamics of multicomponent electrolyte solutions: Aqueous mixtures of two salts from among NaCl,KCl, NaH2PO4, and KH2PO4 at 25° C

Five of the six possible aqueous two-salt mixtures from among NaCl, KCl, NaH₂PO₄,and KH₂PO₄ have been studied by the isopiestic method at 25°C. The sixth mixture, NaCl–KCl, has been studied previously. The deviations from ideal mixing behavior are described by a series of coefficients which were found by regression analysis. The coefficients were used to calculate the excess Gibbs energies of mixing for equal ionic strength fractions of each salt and the trace activity coefficient of each salt at an ionic strength of 2 mode-kg^–1. The cross-square mixing rule is obeyed within experimental uncertainty for the excess Gibbs energies of mixing.     

Morphology, crystallization behavior and properties of impact-modified polypropylene copolymer with or without sodium benzoate as a nucleating agent

 The morphology, crystallization behavior, and properties of an impact-modified polypropylene (PP) copolymer with or without sodium benzoate were investigated. The contents of ethylene–propylene rubber (EPR) in the reactor-made PP copolymer is about 15 wt%. For comparison, blends of PP and EPR containing the same EPR composition were prepared by melt-mixing. Morphological studies by scanning probe microscopy indicated that the impact-modified copolymer consists of three different phases, i.e., polyethylene, PP, and EPR phases, which is considerably different from the morphology of the conventional PP/EPR blend of the corresponding composition. The impact-modified PP copolymer exhibited a higher crystallization rate in terms of the lower crystallization half-time and thus higher thermal and mechanical properties, such as impact strength and hardness, than the PP/EPR blend did. The addition of sodium benzoate as a nucleating agent to the copolymer increased the crystallization rate and the mechanical properties. Received: 4 June 2001 Accepted: 31 October 2001     

Natriumkomplexe mit Salicylideniminen: Synthesen,Strukturen, CO2‐Aufnahme und Carboxylierung von 2‐Fluorpropiophenon bzw. Estronmethylether

Chiral salicylidenphenethylamines (R)‐HA or (S)‐HA , 2‐salicylidenfurfuryl‐imines HB , and 2‐salicylidenaminoethanol HC react with sodium hydride or sodium hexamethyldisilylamide to form the sodium complexes [Na(R)‐A] ₄ · 0,5 Et ₂ , [Na(S)‐A] ₄ · 0,5 Et ₂ O (1) , [NaB] ₄ · 0,5 Ph‐Me (2) and [(dme)NaC] ₄ (3) . In the presence of 18‐crown‐6 the complex [Na(18‐crown‐6)(thf) ₂ ] ₂ [Na ₂ (C)] ₄ · THF (4) can also be isolated. The crystal structure analyses of both 1 and 2 show that heterocubane structures with a Na₄O₄ frame work are formed. Additionally, the imine nitrogen atom is bonded at the Na atom which has the coordination number 4 in 1 . Additional coordination of the furfuryl oxygen atom results in the coordination number five for the sodium atom in 2 . In 3 which is also a tetramer, two Na₂O₂ units are connected via two imino‐ethanol bridges Na(1)‐N(=CH‐phenolat)‐CH₂CH₂‐OH‐Na(2A). The crystal structure analysis displays that 4 is an ionic compound consisting of two [(thf)₂Na(18‐crown‐6)]⁺ cations and the dinuclear dianion [Na ₂ (C) ₄ ] ^2? . Both 1 and 2 are carboxylation reagents which transfer CO₂ to 2‐fluoropropiophenone. 1 is more active than 2 , but 3 and 4 are inactive.     

Interaction of sodium cholate with dioctadecyldimethylammonium chloride vesicles in aqueous dispersion

Mixtures of dioctadecyldimethylammonium chloride (DODAC) cationic vesicle dispersions with aqueous micelle solutions of the anionic sodium cholate (NaC) were investigated by differential scanning calorimetry, DSC, turbidity and light scattering. Within the concentration range investigated (constant 1.0 mM DODAC and varying NaC concentration up to 4 mM), vesicle → micelle → aggregate transitions were observed. The turbidity of DODAC/NaC/water depends on time and NaC/DODAB molar concentration ratio R. At equilibrium, turbidity initially decreases smoothly with R to a low value (owing to the vesicle–micelle transition) when R = 0.5–0.8 and then increases steeply to a high value (owing to the micelle–aggregate transition) when R = 0.9–1.0. DSC thermograms exhibit a single and sharp endothermic peak at T_m ≈ 49 °C, characteristic of the melting temperature of neat DODAC vesicles in water. Upon addition of NaC, T_m initially decreases to vanish around R = 0.5, and the main transition peak broadens as R increases. For R > 1.0 two new (endo- and exothermic) peaks appear at lower temperatures indicating the formation of large aggregates since the dispersion is turbid. All samples are non-birefringent. Dynamic light scattering (DLS) data indicate that both DODAC and DODAC/NaC dispersions are highly polydisperse, and that the mean size of the aggregates tends to decrease as R increases.