铝酸钠溶液的紫外吸收峰

分别用量子化学MNDO和DV-X_α方法计算了二聚铝酸离子[Al_2O(OH)_6]~(2-)和Al(OH)_4~-。结果表明前者旋转势垒很低, 只有10.08 kJ·mol~(-1), 最稳定平衡构型为C_s。用X_α过渡态理论计算获得这两个离子紫外吸收峰的理论值分别为266.6 nm和234.4 nm, 与实验值270.0 nm和230.0 nm相当接近。因此可以认为, 紫外吸收峰270.0 nm和230.0 nm分别为[Al_2O(OH)_6]~(2-)和Al(OH)_4~-离子的最高占有轨道电子向最低空轨道跃迁时产生的吸收峰。计算结果支持铝酸钠溶液中存在二聚铝酸离子的观点。     

RING-OPENING POLYMERIZATION OF TRIMETHYLENE CARBONATE CATALYZED BY NOVEL SINGLE COMPONENT RARE EARTH CALIXARENE COMPLEXES

In this paper, ring-opening polymerization of trimethylene carbonate (TMC) with rare earth (Nd, Y, La) p-tert-butylcalix[n]arene (n=4, 6, and 8) complexes as catalysts has been studied. Poly(trimethylene carbonate) (PTMC) with Mv of 21,400 was produced by bulk polymerization under the conditions as follows: [TMC]0/[Nd] (molar ratio)=1000,80℃,8h. Mechanism study reveals that the polymerization proceeds via a coordination mechanism.     

Microgel-based engineered nanostructures and their applicability with template-directed layer-by-layer polyelectrolyte assembly in protein encapsulation

A novel strategy for the fabrication of microcapsules is elaborated by employing biomacromolecules and a dissolvable template. Calcium carbonate (CaCO(3)) microparticles were used as sacrificial templates for the two-step deposition of polyelectrolyte coatings by surface controlled precipitation (SCP) followed by the layer-by-layer (LbL) adsorption technique to form capsule shells. When sodium alginate was used for inner shell assembly, template decomposition with an acid resulted in simultaneous formation of microgel-like structures due to calcium ion-induced gelation. An extraction of the calcium after further LbL treatment resulted in microcapsules filled with the biopolymer. The hollow as well as the polymer-filled polyelectrolyte capsules were characterized using confocal laser scanning microscopy (CLSM), scanning electron microscopy (SEM), and scanning force microscopy (SFM). The results demonstrated multiple functionalities of the CaCO(3) core - as supporting template, porous core for increased polymer accommodation/immobilization, and as a source of shell-hardening material. The LbL treatment of the core-inner shell assembly resulted in further surface stabilization of the capsule wall and supplementation of a nanostructured diffusion barrier for encapsulated material. The polymer forming the inner shell governs the chemistry of the capsule interior and could be engineered to obtain a matrix for protein/drug encapsulation or immobilization. The outer shell could be used to precisely tune the properties of the capsule wall and exterior. [Diagram: see text] Confocal laser scanning microscopy (CLSM) image of microcapsules (insert is after treating with rhodamine 6G to stain the capsule wall).     

Chemical fixation of CO2 with highly efficient ZnCl2/[BMIm]Br catalyst system

The chemical fixation of CO₂ with mono-substituted terminal epoxides or cyclohexene oxide to form cyclic carbonates under the ZnCl₂/[BMIm]Br catalyst system without using additional organic solvents was achieved in excellent selectivity (>98%) and TOF (5410 h⁻¹) and the catalyst could be used six times almost without losing its catalytic activity and selectivity. Besides, the pure cis-cyclic carbonate of cyclohexene oxide was obtained in this catalyst system.     

Phenol methylation over CrPO4 and CrPO4?AlPO4 catalysts

The vapor-phase catalytic alkylation of phenol with methanol and dimethyl carbonate on a series of differently prepared CrPO₄ (Cr/P=1) and CrPO₄-AlPO₄ (CrAIP) catalysts, has been studied at different temperatures (473–673 K). The reaction is first order in phenol, giving a mixture of O- and C-alkylated products (C-alkylation taking place preferentially at theortho-position). Moreover, dimethyl carbonate is a better methylating agent than methanol.     

Tribromoisocyanuric Acid (TBCA) and Oxone®‐MX Systems as Oxidizing Agents: Oxidative Coupling of Thiols to Their Corresponding Disulfides under Mild and Heterogeneous Conditions

Tribromoisocyanuric acid (TBCA) and Oxone^®‐MX systems were used as effective oxidizing agents for the oxidation of thiols to their corresponding disulfides under mild conditions at room temperature with good to excellent yields.     

Comparison of standard capillary and chip separations of sodium dodecylsulfate-protein complexes

Conditions for converting a set of five standard proteins to electrochemically active sodium dodecylsulfate (SDS) complexes were worked out with the aim of using such complexes for conductivity detection with a a chip electrophoresis system. The results obtained were compared with standard capillary electrophoresis (37 cm (effective length 30 cm)×75 μm I.D. capillary, 10 kV, negative polarity at the inlet). The chip separations were run at 500 V per chip (100 V/cm) as compared to the standard capillary arrangement, which was run at 266.6 V/cm. For the capillary set-up the protein complexes were prepared in aqueous solution (Milli-Q water) made 10 mM with respect to SDS. If the SDS concentration was increased to 50 mM, the separation in the capillary was incomplete. On the other hand with the chip system both approaches yielded acceptable results. The chip separations were slightly (but not distinctly) shorter and offered better separations than the standard set-up. The concentration of the surfactant used for the preparation the complexes results in alternations of the elution sequence, which is preserved if the chip separation is used instead of the capillary set-up. Apparently the full capacity of protein–SDS binding is not exploited for the preparation of the adducts.     

Voltammetric Behavior of Arsenic(III) in the Presence of Sodium Diethyl Dithiocarbamate and Its Determination in Water and Highly Saline Samples by Adsorptive Stripping Voltammetry

This paper describes the voltammetric behavior of As(III) at the hanging mercury drop electrode (HMDE) in the presence of sodium diethyl dithiocarbamate (SDDC) and a new voltammetric method for the determination of As(III) at trace levels. The method is based on the adsorptive deposition of a As(III) complex with SDDC at ?0.45 V (vs. Ag/AgCl) on the HMDE in acidic medium of 0.01 mol L^?1 HCl (pH 2.0) and its cathodic stripping during the potential scan (100 mV s^?1). The linear range for the determination of As(III) in the presence of SDDC (4 μmol L^?1) in water samples was between 1 and 10 μg L^?1 for a deposition time of 300 s (r=0.994) and between 10 and 100 μg L^?1 for a deposition time of 60 s (r=0.999). For the determination of As(III) in dialysis concentrate samples, the linear range was between 5 and 25 μg L^?1 for a deposition time of 180 s (r=0.992) and between 10 and 100 μg L^?1 for a deposition time of 60 s (r=0.996). Detection limits of 0.3 and 2.2 μg L^?1 in water and dialysis concentrate samples were calculated for the method using a deposition time of 300 and 180 s, respectively. Recovery values between 93.0 and 110.0% for As(III) added to deionized, mineral, seawater (synthetic and real) and dialysis concentrate samples prove the satisfactory accuracy and applicability of the procedure.     

Enzymatic Synthesis and Polymerization of Cyclic Trimethylene Carbonate Monomer with/without Methyl Substituent

The direct enzymatic synthesis of a cyclic trimethylene carbonate (1,3‐dioxane‐2‐one) monomer with/without a methyl substituent was carried out using dimethyl or diethyl carbonate and 1,3‐diol with the objective of producing aliphatic poly(trimethylene carbonate), a typical biodegradable synthetic plastic. The lipase‐catalyzed condensation of dimethyl or diethyl carbonate with aliphatic 1,3‐diols using immobilized Candida antarctica lipase (lipase CA) in an organic solvent at 70 °C afforded the corresponding methyl‐substituted and unsubstituted cyclic trimethylene carbonates. The cyclic trimethylene carbonates obtained by the reaction of dimethyl or diethyl carbonates with 1,3‐propanediol and 2‐methyl‐1,3‐propanediol were polymerized by lipase to produce the corresponding polycarbonates.

Total TMC yield as a function of the reaction time.     

碳酸氢铵制纯碱的研究

本文对“中间盐”复分解制碱法进行了研究。“中间盐”的加入不能使两个三盐共饱和点在干盐图上发生明显的移动,但能使三盐介稳平衡点的介稳期延长,从而使得用碳酸氢铵和食盐通过复分解制碱成为可能。