Electrical Property of Tin Oxide Doped with Multi‐Walled Carbon Nanotubes

Tin oxide doped with multi‐walled carbon nanotubes (MWNTs) was prepared via a wet‐chemical process and characterized with x‐ray diffraction (XRD) and transmission electron microscope (TEM). Meanwhile, the conductivity of composites obtained was measured using Source Meter. The results show that carbon nanotubes have great effect on the electrical property of SnO₂ nanoparticles. Compared with undoped SnO₂ nanoparticles, the resistivity of SnO₂ nanoparticles doped with 0.3‰ wt MWNTs decreased by a factor of 37. This may be ascribed to the presence of π energy levers of MWNTs and their high aspect ratio. Moreover, the effect of annealing temperature on the electrical property of SnO₂ nanoparticles doped with MWNTs also was discussed.     

铁铈复合氧化物催化剂SCR脱硝的改性研究

利用共沉淀法制备了铁铈催化剂,考察添加钛、锆、钨和钼对其SCR脱硝的改性规律。结果表明,钨和钼的添加提高了铁铈催化剂高温脱硝性能,却使其低温活性有所降低;钛的添加对铁铈催化剂脱硝性能具有促进作用,尤其提高了其低温活性,并拓宽了其完全转化温度窗口,为最佳改性物。当钛的物质的量比逐渐由0.10增至0.40,铁铈钛催化剂低温脱硝效率先增大后减小,但其高温脱硝效率逐渐增大至100%,钛的最佳物质的量比为0.15。XRD和N₂吸附分析结果表明,钛能优化铁铈催化剂的孔隙结构,增大其比表面积和比孔容,细化其孔径,并与催化剂中铁、铈氧化物形成良好的固溶体,从而提高了铁铈催化剂的SCR脱硝性能。Fe_0.8Ce_0.05Ti_0.15O_z催化剂在150～400℃取得了高于90%的NO_x转化率。     

碳酸钾催化的铁基氧载体煤催化化学链燃烧

研究了K₂CO₃催化剂及惰性担体对铁基氧载体煤化学链燃烧的影响.实验结果表明,K₂CO₃的添加可明显促进铁基氧载体与煤之间的反应速率,其原因可归结为从氧载体上迁移到煤颗粒上的K₂CO₃对煤-CO₂气化步骤的催化作用(该步骤为整个还原过程的速率控制步骤);由于K₂CO₃本身的促熔效果及加入K₂CO₃后导致的剧烈氧化还原反应,可以发现,K₂CO₃会增大铁基氧载体的烧结;不同惰性担体对铁基氧载体与煤的反应性影响不大,这是由于惰性担体对还原速控步没有影响;K₂CO₃在多循环化学链燃烧过程中依然可以保持一定的催化活性,另外由于催化剂的流失与失活,使得氧载体的反应活性有所下降.     

磷化镍催化剂的制备机理及其加氢脱氮性能

采用热重-质谱联用技术研究了次磷酸盐在氮气中的热分解过程,探讨了次磷酸盐热分解法制备磷化镍的反应机理:次磷酸镍中的Ni²⁺能够"催化"H₂PO₂^-低温发生歧化反应生成PH₃,继而还原Ni²⁺得到Ni₂P。制备了不同负载量的Ni₂P/SiO₂催化剂,用X射线衍射(XRD)、低温N₂吸附-脱附、高分辨透射电镜(HRTEM)等分析技术对催化剂结构进行表征。结果表明,Ni₂P活性组分在SiO₂载体上具有良好的分散性,颗粒粒径为5～8 nm。以喹啉为加氢脱氮模型化合物,在高压微型固定床反应器上对催化剂活性进行评价,在反应温度为360℃、氢气压力为2.0 MPa、液时空速为2.0 h^-1、氢油体积比为500:1时,Ni₂P(20%)/SiO₂催化剂的加氢脱氮率为41.5%。     

Ni基催化剂催化燃油重整耦合选择性催化还原NOx反应

分别以La₂O₂CO₃, CeO₂, ZrO₂和Al₂O₃为载体, 采用浸渍法制备了Ni基重整催化剂, 并以正十二烷模拟车载燃油进行催化重整反应以同时制备小分子碳氢化合物(HCs)和H₂, 考察了其在4wt%Ag/Al₂O₃上选择性催化还原(HC-SCR)氮氧化物(NO_x)的性能. 采用N₂吸附-脱附、X射线粉末衍射、H₂程序升温还原和热重等手段对Ni基催化剂进行了表征. 结果表明, 随着重整催化剂氧化还原性能增强, 产物中H₂浓度增加, 可参与SCR反应的HCs含量减少, 从而导致重整-SCR耦合体系上NO_x净化活性温度窗口向低温移动, NO_x最高转化率降低. Ni/ZrO₂+Ag/Al₂O₃耦合体系中H₂/HCs符合SCR反应所需的最优比例, 在柴油车典型排气温度范围内表现出良好的NO_x净化能力. 同时, 在Ni/ZrO₂+Ag/Al₂O₃耦合体系上考察了其燃油重整-SCR的活性稳定性. 结果显示, 重整催化剂的耐久性有待进一步提高.     

溶胶-凝胶新方法合成介孔铁酸铜纳米粉体催化剂上CO低温氧化(英文)

Mesoporous CuFe2O4 solid solution nanopowders with high specific surface areas were synthesized by a novel, very simple and inexpensive sol-gel route using propylene oxide as gelation agent, and used as the catalyst in low temperature CO oxidation. The samples were characterized by X-ray diffraction, N2 adsorption-desorption, thermogravimetric/differential thermal analysis, Fourier transform infrared spectroscopy, scanning electron microscopy, transmission electron microscopy, and temperature-programmed reduction. The results revealed that the samples have a nanocrystalline structure with crystals in the range of 10 to 25 nm, and that all the catalysts have mesoporous pores. The addition of Cu into iron oxide affected its structural and catalytic properties. The sample containing 15 mol% Cu showed the highest specific surface area and catalytic activity, and showed high catalytic stability in low temperature CO oxidation.     

制备方法对Al2O3掺杂Pt/WO3-ZrO2催化剂上正庚烷异构化反应的影响

采用恒pH法和非恒pH法制备了Al₂O₃掺杂的Pt/WO₃/ZrO₂催化剂,并用N₂吸附-脱附、X射线衍射、紫外-可见漫反射、CO化学吸附、X射线光电子能谱、²⁷Al魔角旋转核磁共振和吡啶吸附红外等技术对催化剂进行了表征.结果表明,相比于非恒pH法制备的催化剂,恒pH法制备的催化剂具有较高的比表面积和Pt分散度,在H₂气氛中产生更多的B酸位,从而表现出更高的催化正庚烷临氢异构化反应活性; 在200℃和质量空速0.9h^-1的反应条件下,正庚烷转化率达70.0%,明显高于非恒pH法制备的催化剂(43.5%).     

A Trinuclear Ni(Ⅱ) Mixed-ligand Complex Containing Pentadentate N-butylsalicylhydrazide and Monodentate Imidazole:Synthesis, Characterization and Crystal Structure

A novel trinuclear nickel(Ⅱ) complex [Ni3(bushz)2(Himdz)2(H2O)2]?2DMF (1, bushz=N-butylsalicylhydrazide, Himdz=imidazole, DMF=N,N-dimethyl-formamide) has been synthesized and characterized by X-ray single-crystal diffraction characterization. Complex 1 crystallizes in the monoclinic system, space group P21/c with a=7.706(7), b=14.882(6), c=18.639(6) , β=108.08(2)o, V=2032(1) 3, Dc=1.525 g/cm3, Mr=932.95, Z=2, F(000)=972, μ=1.442 mm-1, the final R=0.0359 and wR=0.0771. The three nickel(Ⅱ) atoms in 1 are arranged in a strictly linear structure and exhibit alternating square-planar and octahedral geometries. The complex is connected to form a supramolecule with an infinite three-dimensional network through intermolecular hydrogen bonds. The electrochemical studies reveal that redox of Ni3+/Ni2+ in the complex is a quasi-reversible process. The thermal stability of the title complex was also studied.     

钙钛矿型氧化物负载纳米金属催化剂结构的动态调变及其催化氧化CO反应性能

研究了钛酸钡和钛酸钙担载的Ag和Pt纳米催化剂的表面结构随氧化-还原处理过程的动态变化及其对CO完全氧化反应性能的影响.发现氧化物担载的Ag催化剂在氧化处理后其催化活性较还原处理的高; X射线衍射(XRD)和X射线光电子能谱(XPS)表征结果表明,氧化处理能够提高载体表面Ag颗粒的分散度,而还原处理导致Ag颗粒的聚集,从而降低了催化氧化CO反应的活性.氧化-还原处理改变了担载Ag纳米粒子的尺寸并影响其CO氧化反应活性.与此相反,氧化物担载的Pt催化剂在还原处理后所表现出的CO氧化反应活性较氧化处理的高; 对比研究发现,氧化和还原处理后Pt纳米粒子的尺寸基本相同,但是氧化处理的样品中Pt表面物种以氧化态为主,而还原处理后Pt表面物种主要为金属态.Pt纳米粒子表面化学状态随氧化-还原处理的调变是导致表面催化活性差异的主要原因.