Separation selectivity patterns of fully charged achiral compounds in capillary electrophoresis with a neutral cyclodextrin

Based on the separation selectivity equation, related to the dimensionless parameters for fully charged achiral analytes using a neutral CD, the separation selectivity can be classified into seven patterns. With respect to CZE without CD, the presence of CD in the buffer may improve, or reduce, the separation selectivity with this effect being accompanied by the same or reversed electrophoretic mobility order for charged analytes. This can depend on the separation selectivity of the two analytes in free solution, the binding selectivity, the separation selectivity of analyte–CD complexes and the ratio of electrophoretic mobility of the analytes in free, and complexed forms. Using positional isomers of benzoic acids and phenoxy acids as test analytes and α‐CD as a selector, the observed separation selectivity shapes were found to be in excellent agreement with the predicted separation selectivities.     

Development of a manual method for the determination of mineral oil in foods and paperboard

So far the majority of the measurements of mineral oil saturated hydrocarbons (MOSH) and mineral oil aromatic hydrocarbons (MOAH) were obtained from on-line high performance liquid chromatography–gas chromatography–flame ionization detection (on-line HPLC–GC–FID). Since this technique is not available in many laboratories, an alternative method with more easily available tools has been developed. Preseparation on a small conventional liquid chromatographic column was optimized to achieve robust separation between the MOSH and the MOAH, but also to keep out the wax esters from the MOAH fraction. This was achieved by mixing a small portion of silica gel with silver nitrate into highly activated silica gel and by adding toluene into the eluent for the MOAH. Toluene was also added to the MOSH fraction to facilitate reconcentration and to serve as a keeper preventing loss of volatiles during solvent evaporation. A 50 μl volume was injected on-column into GC–FID to achieve a detection limit for MOSH and MOAH below 1 mg/kg in most foods.     

Electric migration of α‐hemolysin in supported n‐bilayers: A model for transmembrane protein microelectrophoresis

Proteome analysis involves separating proteins as a preliminary step toward their characterization. This paper reports on the translational migration of a model transmembrane protein (α‐hemolysin) in supported n‐bilayers (n, the number of bilayers, varies from 1 to around 500 bilayers) when an electric field parallel to the membrane plane is applied. The migration changes in direction as the charge on the protein changes its sign. Its electrophoretic mobility is shown to depend on size and charge. The electrophoretic mobility varies as 1/R², with R the equivalent geometric radius of the embedded part of the protein. Measuring mobilities at differing pH in our system enables us to determine the pI and the charge of the protein. Establishing all these variations points to the feasibility of electrophoretic transport of a charged object in this medium and is a first step toward electrophoretic separation of membrane proteins in n‐bilayer systems.     

Mechanism and Influencing Factors of Wettability Alteration of Water-Wet Sandstone Surface by CTAB

Different experimental methods including ellipsometry, zeta potential measurements, imbibition studies, and contact angle measurements were used to study the mechanism and influencing factors of wettability alteration of water-wet sandstone surface caused by CTAB (hexadecyl trimethyl ammonium bromide). Results show that when the concentration of CTAB reaches a certain level (below CMC), due to the electrostatic attraction between the positively charged head groups of CTAB and the negatively charged sandstone surface, the monolayer of CTAB is formed and hydrophobic chains of CTAB molecules are toward the aqueous phase, making the solid surface oil-wet. When the concentration of CTAB continues to increase (above CMC), due to the hydrophobic interaction, the compact bilayer of CTAB is formed and hydrophilic head groups of CTAB molecules are toward the aqueous phase, rendering the solid surface water-wet. The contact angles between the oil–water interface and the surface treated with CTAB increase with the increase of the concentration of NaCl and CaCl_2. Compared to NaCl, the inorganic salt CaCl₂ has a greater impact on the contact angle. In addition, the contact angles increase with the increase of temperature and decrease with the increase of pH value of the aqueous solution.     

顶空液液萃取-气相色谱-质谱法用于白术挥发性成分的分析

采用高温顶空液相萃取再转移的方法,对中药白术中挥发性成分进行萃取分离富集,采用顶空液液萃取/气相色谱-质谱(HS-LP-LPE/GC-MS)联用法进行测定,并与传统水蒸汽蒸馏法(SD)提取的挥发性成分进行对比。对各种测定条件和影响因素进行了考察,最佳萃取条件为:1.0 mL PEG 400为高温萃取剂,样品用量1.2 g,萃取温度120℃,萃取时间60 min,再将萃取剂用1.0 mL正己烷进行反萃取后进行GC-MS分析;采用HS-LP-LPE/GC-MS鉴定了33个组分,占总组分含量93.18%;SD鉴定了31个组分,占总组分含量97.12%。两种方法共同检测到的组分有29个,均以苍术酮(Atractylone)含量最高。结果表明,两种方法所提取的组分基本相同,可用于白术挥发性成分的测定。     

Handling of Environmental and Biological Samples via Pre-Column Technologies

Abstract

Sample handling is still a weak point in chromatography and in analytical chemisty in general. One consideration is the automation potential of new procedures. Solid-liquid extraction techniques in combination with pre-column technology are particularly promising in this regards. The construction and geometry of pre-columns both for conventional and narrow-bore HPLC are of major importance, since band broadening should be kept at a minimum for an optimal functioning of the analytical system. The various operations that can be carried out with such a pre-column are trace-enrichment, clean-up of the sample which depends on the type of adsorbents used in the precolumn, i.e., polar or apolar materials, ion exchangers or metal covered surfaces, etc., protection of the analytical column, field sampling and storage of samples and as a substrate for on-column chemical derivatizations. These various operations are demonstrated with practical examples from the fields of environmental and biological analysis. The selectivity can be further enhanced by coupling precolumn technology with selective detection modes such as diode array UV, electrochemical or fluorescence detection. This enables the construction of optimal and integrated analysis sytems which are fully automated and microprocessor controlled. They can also be made compatible with miniaturized LC-technology.     

Light-induced cis/trans isomerization of cis-[Pd(L-S,O)2] and cis-[Pt(L-S,O)2] complexes of chelating N,N-dialkyl-N′-acylthioureas: key to the formation and isolation of trans isomers

Irradiation cis-[M(Lⁿ-S,O)₂] complexes (M = Pt^II, Pd^II) derived from N,N-dialkyl-N′-benzoylthioureas (HLⁿ) with various sources of intense visible polychromatic or monochromatic light with λ < 500 nm leads to light-induced cis?→?trans isomerization in organic solvents. In all cases, white light derived from several sources or monochromatic blue-violet laser 405 nm light, efficiently results in substantial amounts of the trans isomer appearing in solution, as shown by ¹H NMR and/or reversed-phase HPLC separation in dilute solutions at room temperature. The extent and relative rates of cis/trans isomerization induced by in situ laser light (λ = 405 nm) of cis-[Pd(L²-S,O)₂] was directly monitored by ¹H NMR and ¹⁹⁵Pt NMR spectroscopy of selected cis-[Pt(L-S,O)₂] compounds in chloroform-d; both with and without light irradiation allows the δ(¹⁹⁵Pt) chemical shifts cis/trans isomer pairs to be recorded. The cis/trans isomers appear to be in a photo-thermal equilibrium between the thermodynamically favored cis isomer and its trans counterpart. In the dark, the trans isomer reverts back to the cis complex in what is probably a thermal process. The light-induced cis/trans process is the key to preparing and isolating the rare trans complexes which cannot be prepared by conventional synthesis as confirmed by the first example of trans-[Pd(L-S,O)₂] characterized by single-crystal X-ray diffraction, deliberately prepared after photo-induced isomerization in acetonitrile solution.