消除夹带溶胀的新液膜操作法

消除夹带溶胀的新液膜操作法曹汉瑾，褚莹，何彦涛，吴子生，严忠（东北师范大学化学系长春１３００２４）关键词液膜，油／水乳液，溶胀，夹带，包裹消除液膜操作中的夹带溶胀对液膜的工业化具有重要意义，夹带溶胀分为包裹溶胀和再液化溶胀。前者是乳状液滴上浮时将水相...     

溶剂浓度对PVDF相转换膜大孔结构的影响

提出决定大孔能否发展的初始分相点处溶剂浓度临界点的概念 ,认为初始分相点处较高的溶剂浓度有利于大孔的发展 ,溶剂浓度低于一定的界限后 ,大孔停止发展 ,转为海绵状结构 .实验考察了不同凝胶液组成下制得的PVDF中空膜的结构 ,建立了相应的传质模型 ,模拟不同制膜条件下初生态膜内的组成分布情况 ,根据初始分相点处溶剂浓度临界点的概念 ,预测膜的形态结构 .模拟结果与相应制膜条件下的电镜照片有很好的对应关系 ,证明了上述大孔形成机理的正确性 .     

MORPHOLOGIES AND GAS SEPARATION PROPERTIES OF MELT-SPUN ASYMMETRIC POLY(4-METHYL-1-PENTENE)HOLLOW FIBER MEMBRANES*

Poly(4-methyl-1-pentene) (PMP) hollow fiber membranes were prepared by the melt-spun and cold-stretch(MSCS) method. Scanning electronic microscopy (SEM) was used to characterize the section and surface structures of themembranes with special asymmetric structure. The preliminary results of gas permeation measurements indicated that the resultant hollow fiber membranes have the potential ability for oxygen/nitrogen separation.     

水中酚的膜萃取分离流动注射技术测定的研究

本文提出了硅橡胶膜在线萃取分离流动注射技术测定水样中苯酚的方法。由于水样中的苯酚透过硅橡胶进入萃取液的萃取量随时间的增加和温度的升高而增大，故采用停流技术及升高温度以降低酚的检出限。     

功能液晶膜的新进展

论述了功能液晶膜的新近研究结果和发展动向,指出功能液晶膜具有优异的气体分离、液体分离和电光性能,可望作为高效气体分离膜、高效液体分离膜和大面积光控膜,具有较重大的理论与实际意义。     

Mass transfer and benzene removal from air using latex rubber tubing and a hollow-fiber membrane module

A dense-phase latex rubber tube and a polyporous propylene hollow-fiber membrane module (HFMM) were investigated for control of benzene-contaminated gas streams. The abiotic mass flux observed through the latex tube was 3.9–13 mg/(min·m²) for 150 ppm of benzene at various gas and liquid flow rates, while a 100-fold lower mass flux was observed in the HFMM. After seeding with an aromatic-degrading culture enriched from activated sludge, the observed removal was 80% of 150 ppm, corresponding toa mass flux of 45 mg/(min·m²). The observed mass flux through the HFMM during biofiltration also rose, to 0.4 mg/(min·m²). Because the HFMM had a 50-fold higher surface area than the latex tube, the observed ben zene removal was 99.8%. Compared to conventional biofilters, the two reactors had modest elimination capacities, 2.5–18 g/(m³·h) in the latex tube membrane bioreactor and 4.8–58 g/(m³·h) in the HFMM. Although the HFMM had a higher elimination capacity, the gas-phase pressure drop was much greater.     

Novel Membrane Potentiometric Thiocyanate Sensor Based on Tribenzyltin(IV) Dithiocarbamate

A novel PVC membrane ion‐selective electrode based on tribenzyltin(IV) dithiocarbamate [Sn(IV)–TBDTB] as neutral carrier was developed for thiocyanate (SCN^?) determination. The electrode exhibits a near‐Nernstian response for SCN^? with a slope of 62.8±2.0 mV per decade over a wide concentration range 1.0×10^?1–2.0×10^?6 mol L^?1 and a detection limit of 1.0×10^?6 mol L^?1 in MES–NaOH buffer, pH 6.0, at 25 °C. The electrode prepared with 1.5 wt.% Sn(IV)–TBDTB, 32.5 wt.% PVC and 66.0 wt.% 2‐nitrophenyloctyl ether (o‐NPOE) shows optimal response characteristics. Anti‐Hofmeister selectivity sequence for a series of anions shown by the electrode was as follows: SCN^?>Sal^?>I^?>ClO >phCOO^?>CH₃COO^?>Br^?>Cl^?>NO >NO >Citrate>SO₄^2?. The useful pH range for the electrode was found to be 3–7 with a response time 30–40 s. The electrode has been used for direct determination of thiocyanate in wastewater with satisfactory results.     

高硅ZSM—5沸石填充硅橡胶膜的醇—水渗透蒸发分离性质

高硅ZSM－5沸石填充疏水性硅橡胶蓦地低浓度醇－水体度醇－水体的渗透蒸发性质的研究有明，提高沸石硅铝比，增加填充量以及进行酸处理皆有利于改善膜对醇－水的分离系数和通量。料液的成，浓度以及温度对膜的分离性质也有显著影响。     

Integrated Microanalytical System Coupling Permeation Liquid Membrane and Voltammetry for Trace Metal Speciation. Technical Description and Optimization

A new minicell coupling the liquid‐liquid extraction technique called permeation liquid membrane (PLM) with an integrated Ir‐based Hg‐plated microelectrode array for voltammetric detection has been developed for the speciation of heavy metals in natural waters. Lead and cadmium have been used as model compounds. The PLM consists of a carrier (0.1 M 22DD+0.1 M lauric acid) dissolved in 1 : 1 mixture of toluene/phenylhexane held in the small pores (30 nm) of a hydrophobic polypropylene membrane (Celgard 2500). One side of this membrane is in contact with a flowing source solution, containing the metal ions of interest. An acceptor or strip solution (pyrophosphate) is placed on the other side of the PLM with the microelectrode array placed at 480 μm of the PLM. The analyte is transported by the carrier from the source solution to the strip solution. The originality of the new minicell is that accumulation in the strip solution is voltammetrically followed by the integrated microelectrode array in real time, and at low concentration level, using square‐wave anodic stripping voltammetry (SWASV). In order to protect the Hg microelectrodes from the adsorption of the hydrophobic carrier, the microelectrodes are embedded in a thin gel layer (280 μm) of 1.5% LGL agarose gel containing 10% of hydrophobic silica particles C18. The choice of optimum conditions is discussed in details in this article. Due to the very small effective strip volume of the new cell (less than 1 μL), high enrichment factor can be obtained (e.g., 330 for Pb) after 2 hours of accumulation. No deaeration of the solutions is required for SWASV measurements. Detection limits under these conditions are 2 pM and 75 pM for Pb and Cd, respectively, using a voltammetric deposition time of 5 min. In addition, no fouling effects were observed with natural water samples.     

肝素化壳聚糖季铵盐／壳聚糖复合膜抗凝血性能的研究

以壳聚糖季铵盐，壳聚糖为基本原材料，选用戊二醛为交剂剂及固定剂，制备一种物理机械性能较优的抗凝血材料。探讨了戊二醛及肝素钠两者用量对肝素化程度及血液生的影响。