基于芘的荧光熄灭的单质碘荧光敏感膜的研究

单质碘熄灭固定于增塑的ＰＶＣ膜中的芘的荧光，且这种熄灭作用可逆。本据此研制了用于测定单质碘浓度的荧光敏感膜，最佳膜组成为２～４ｍｇ芘、５０ｍｇＰＶＣ粉、１００ｍｇ邻苯二甲酸二异辛酯，测定碘的浓度范围为２．２６×１０＾－５～１．０４×１０＾－３ｍｏｌ／Ｌ。此膜测定单质碘的重现性好，响应时间小于４０ｓ。除Ｆｅ＾３＋、Ｂｉ＾３＋外，其它常见离子均无干扰。将此膜用于食盐中碘的测定，结果令人满意。     

溴代及胺交联聚苯醚（PPO）膜的气体透过行为

对聚苯醚(PPO)进行了苯环溴代、甲基溴代以及胺交联,发现苯环溴代可提高O_2、N_2透过率(P),而选择性(α)基本不变。甲基溴代则相反,P降低、α有明显提高。调节两者比例可得到P、α兼优的O_2、N_2分离膜。甲基溴代后进一步胺交联可得到α更高、耐溶剂的膜材料。     

Development of an optical membrane for humidity

4-(N,N-dioctylamino)-4-trifluoroacetyl-azobenzene (ETH^T 4001), together with the catalyst tridodecylmethylammonium chloride, is dissolved in the hydrophilic polymer polyurethane Tecoflex. The resulting membrane layers show high sensitivity toward water vapour and allow the application of the membranes for humidity measurements. Upon exposure to humid air, the membrane exhibits a decrease in absorbance at a wavelength around 490 nm and an increase at around 430 nm. This signal change is caused by the conversion of the trifluoroacetyl group of the reactand into a diol, thus changing the electron delocalisation of the reactand. The sensor layer exhibits a dynamic range from 1% to 100% RH with highest sensitivity in the 5%–40% RH range. The limit of detection is 0.5% RH. The amount of added catalyst enables the sensitive range to be tailored. The selectivity over ethanol and carbonate is sufficient for the membrane to be used for long-term measurements of air. The change in colour of the humidity-sensitive membrane from red to yellow also means it can be used as an optical test strip.     

Improving the properties of the proton exchange membranes by introducing α-methylstyrene in the pre-irradiation induced graft polymerization

New proton exchange membranes (PEMs) were prepared by pre-irradiation induced grafting of α-methylstyrene (AMS)/styrene (STY)/divinylbenzene (DVB) into the crosslinked polytetrafluoroethylene (RX-PTFE) films and successively sulfonated. The new PEMs showed the improved glass transition temperature and chemical stability as compared with the PEMs prepared by pre-irradiation induced grafting of STY/DVB. The balance of the cost, grafting kinetic, thermal properties and the properties of the resulted proton exchange membrane is the key point of this work.     

Effect of Thiourea on the Kinetics of the Hydrogen Evolution Reaction at Iron and the Transport of Hydrogen through a Steel Membrane in Solutions of C<Subscript>2</Subscript>H<Subscript>4</Subscript>(OH)<Subscript>2</Subscript>-H<Subscript>2</Subscript>O-HCl

The effect of thiourea (0.5–10 mM) on the kinetics of the hydrogen evolution reaction (HER) at iron and the hydrogen transport through a steel membrane out of ethylene glycol (containing 2 and 10 wt % H₂O) and aqueous solutions containing HCl (0.1–0.99 M) with a constant ionic strength equal to unity is studied in parallel experiments. The presence of 0.5 mM of thiourea in the solutions raises the overvoltage of hydrogen evolution, while a subsequent increase in its concentration does not effect the HER kinetics. The dependence of the flux of hydrogen diffusion through the membrane on the thiourea content passes through a maximum.     

New PIM-1 copolymers containing 2,3,6,7-anthracenetetrayl moiety and their use as gas separation membranes

1. Download : Download high-res image (198KB)
2. Download : Download full-size image

     

Affinity adsorption of recombinant human interferon-α on a porous dye-affinity adsorbent

Interferons are potent biologically active proteins synthesized and secreted by somatic cells of all mammalian species. Dye-affinity adsorption is increasingly used for protein separation. Hollow fibers have several advantages as adsorbents in comparison to conventional bead supports because they are not compressible and they eliminate internal diffusion limitations. The aim of this study was to explore in detail the performance of polyamide hollow fibers to which Cibacron Blue F3GA was attached for adsorption of recombinant interferon-α (rHuIFN-α). The hollow fiber was characterized by scanning electron microscopy. These dye-carrying hollow fibers (35.8 μmol/g) were used in the rHuIFN-α adsorption-elution studies. The effects of initial concentration of rHuIFN-α, medium pH, ionic strength and temperature on the adsorption efficiency of dye-attached hollow fibers were studied in a batch system. The non-specific adsorption of rHuIFN-α on the hollow fibers was 1.2 mg/g. Cibacron Blue F3GA attachment significantly increased the rHuIFN-α adsorption up to 99.8 mg/g. Significant amount of the adsorbed rHuIFN-α (up to 94.8%) was eluted in 1 h in the elution medium containing 1.0 M NaCl. In order to determine the effects of adsorption conditions on possible conformational changes of rHuIFN-α structure, fluorescence spectrophotometry was employed. We resulted that dye-affinity hollow fibers can be applied for rHuIFN-α adsorption without causing any significant conformational changes. Repeated adsorption/elution processes showed that these dye-attached hollow fibers are suitable for rHuIFN-α adsorption.     

铸膜溶剂对CAB膜形态和性能的影响

以ＣＡＢ高分子为膜材料，研究了铸膜液的溶剂体生添加剂对膜形态及选择性渗透Ｎ２、Ｏ２、ＣＨ４、ＣＯ２等气体的影响。溶剂体系以丙酮为基本组分，混合甲酰胺或乙酸，可得到具有好的气体渗透性或气体选择性的非对称膜，通过溶剂的红外光谱羰基吸收峰的偏移，认为溶剂体系有可能存在Ｌｅｗｉｓ酸；碱络合物。     

对钠离子有选择性的中性载体

合成了十一种中性离子载体,用它们制成钠离子选择性电极,测定了电极的选择性系数并与文献报道的类似电极进行了比较。     

高分子合金分离膜材料及结构研究进展

膜材料液相共混制备高分子合金分离膜不但可以调节膜材料与被分离物的亲和性，也在一定程度上改变了膜的结构。本文介绍高分子材料浓相共混对膜材料的亲水性、耐污染性及其它理化性能的影响和对膜结构的调节作用，同时指出高分子材料间的相容性是影响合金膜结构的重要因素。