Determination of thermodynamic properties of macroporous glycidyl methacrylate‐based copolymers by inverse gas chromatography

Macroporous crosslinked poly(glycidyl methacrylate‐co‐ethylene glycol dimethacrylate) (PGME) was synthesized by suspension copolymerization and modified by ring‐opening reaction of the pendant epoxy groups with ethylene diamine (EDA). Inverse gas chromatography (IGC) at infinite dilution was applied to determine the thermodynamic interactions of PGME and modified copolymer, PGME‐en. The specific surface areas of the initial and modified copolymer samples were determined by the BET method, from low‐temperature nitrogen adsorption isotherms. The specific retention volumes, V, of 10 organic compounds of different chemical nature and polarity (nonpolar, donor, or acceptor) were determined in the temperature range 333–413 K. The weight fraction activity coefficients of test sorbates, , and Flory–Huggins interaction parameters, , were calculated and discussed in terms of interactions of sorbates with PGME and PGME‐en. Also, the partial molar free energy, , partial molar heat of mixing, , sorption molar free energy, ΔG, sorption enthalpy ΔH, and sorption entropy, ΔS, were calculated. Glass transitions in PGME and PGME‐en, determined from IGC data, were observed in the temperature range 373–393 K and 363–373 K, respectively. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 2524–2533, 2005     

The Menshutkin Reaction in the Gas Phase and in Aqueous Solution: A Valence Bond Study

The recently developed (L. Song, W. Wu, Q. Zhang, S. Shaik, J. Phys. Chem. A 2004 , 108, 6017–6024) valence bond method coupled to a polarized continuum model (VBPCM) is applied to the Menshutkin reaction, NH₃+CH₃Cl→CH₃NH₃⁺+Cl^?, in the gas phase and in aqueous solution. The computed barriers and reaction energies at the level of the breathing orbital VB method (P. C. Hiberty, J. P. Flament, E. Noizet, Chem. Phys. Lett. 1992 , 189, 259), BOVB and VBPCM//BOVB, are comparable to CCSD(T) and CCSD(T)//PCM results and to experimental values in solution. The gas‐phase reaction is endothermic and leads to an ion‐pair complex via a late transition state. By contrast, the reaction in the aqueous phase is exothermic and leads to separate solvated ions as reaction products, via an early transition state. The VB calculations provide also the reactivity parameters needed to apply the valence bond state correlation diagram method, VBSCD (S. Shaik, A. Shurki, Angew. Chem. Int. Ed. 1999 , 38, 586). It is shown that the reactivity parameters along with their semiempirical derivations provide together a satisfactory qualitative and quantitative account of the barriers.     

Selectivity enhancement of a metal-sensitive flame ionization detector for capillary gas chromatography

A novel modification of a hydrogen-atmosphere flamo ionization detector (HAFID) is presented which attenuates response to hydrocarbon compounds, significantly enhancing selectivity towards organometallic compounds by more than an order of magnitude. Chromatograms of an organometallic compound test mixture and regular leaded gasoline are presented to depict the specificity of the response.     

New selective O-debenzylation of phenol with Mg/MeOH

Carboxylate-benzyl and nitro-benzyl groups used in phenols protection were selectively debenzylated with 3-25 equiv of Mg in methanol at room temperature. Good yields of the desired phenols were obtained within 3-10 h from a wide variety of O-(carboxylate-benzyl)- or O-(nitro-benzyl)-phenols. Selective O-debenzylation was possible in the presence of O-(carboxylate-benzyl)- or O-(nitro-benzyl)-phenols with Mg/MeOH.     

Determination of methylated dibenzothiophenes in environmental sarnples by on-line HPLC-CGC

Concurrent solvent evaporation with a loop-type interface was used for on-line HPLC-CGC in the analysis of methylated dibenzothiophene (DBT) isomers in oil samples. The chromatographic behavior of 20 methyl DBT's was studied by HPLC on an aminopropylsilane DBTA phase and by GC on a selective methyl-phenylsilicone phase. That provided a method for analyzing by GC-flame photometric detection, the individual components of the DBT family, previously picked out of the crude oil matrix by HPLC. The GC oven temperature was shown to be critical during HPLC eluent introduction into the GC pre-column. Too high a temperature induced a severe broadening of early eluted peaks whereas a temperature too close to the boiling point of the liquid at the inlet pressure induced double peaks. Optimized conditions were retained on this basis and may be used for the analysis of other families of polyaromatic hydrocarbons.     

H2O−D2O solvent isotope effect in the volume behavior of some high-charge high-size electrolytes

The apparent molar volumes V of KCl, BaCl₂, K₂SO₄, LaCl₃, Co(en)₃Cl₃ [Tris(ethylenediamine)cobalt(III) chloride], K₃Co(CN)₆, K₃Fe(CN)₆, K₄Fe(CN)₆, and Ba₃[Co(CN)₆]₂ have been determined at 25°C in both light and heavy water. The V values in D₂O are systematically lower and increase more rapidly with salt concentration than the V in H₂O. The volume of transfer from H₂O to D₂O as well as the partial molar volume at infinite dilution in both solvents have also been calculated. These results together with literature values for other electrolytes were used to estimate both of these quantities for D₂O solutions of individual ions. The predictions of ion hydration models and ion-ion interactions are compared with experimental observations.     

溶剂对钯催化的叔丁基乙炔低聚反应化学选择性的调控作用

报道了溶剂对钯催化的叔丁基乙炔低聚反应化学选择性的调控作用. 反应可在苯-正丁醇双组分溶剂体系中顺利进行, 当双组分溶剂体系中苯占优势比例时, 反应发生递次的三分子炔烃顺式插入, 经由顺式s-烯钯中间体生成环三聚产物1,3,5-三叔丁基苯; 而当双组分溶剂中正丁醇组分上升至一定比例, 反应选择性生成(3Z,5Z)-2,2,7,7-四甲基- 3,6-二氯-3,5-辛二烯或(3Z,5Z)-2,2,7,7-四甲基-3,6-二溴-3,5-辛二烯, 这是由于正丁醇可显著加快C—Pd σ键的断裂, 并与叔丁基乙炔、σ-烯钯中间体形成弱氢键作用力, 同时也与Pd(II)和Cu(II)等离子存在配位效应. 在强极性质子溶剂H₂O中, 反应生成偶联双炔: 2,2,7,7-四甲基-3,5-辛二炔. 文中就反应溶剂体系、钯铜催化剂及反应可能机理等分别进行了探讨.     

Investigation into new materials for optical devices: the miscibility and solvent effects of azobenzene derivative blends

With the increasing demand for novel devices with optical applications the search for new materials to data store and process becomes a priority. By introducing blends, tailor made properties and low cost give added advantage. Miscibility is an essential requirement for a new material, this research thus involves miscibility studies of poly(4‐(N‐(2‐methacryloyloxyethyl)‐N‐ethylamino)‐4′‐nitroazobenzene)₉₀‐co‐(methyl methacrylate)₁₀, (azobenzene derivative) with polymethyl‐methacrylate (PMMA), polyvinylacetate (PVAc) and polyvinylchloride (PVC) prepared in tetrahydrofuran (THF), and/or dimethylformamide (DMF) and/or dichloromethane (CH₂Cl₂). The glass transitions, solvent and varying molecular weight effect were investigated, since these all primarily influence the miscibility. THF was found to encourage miscibility at specific compositions of PVAc and PVC blends. However, with CH₂Cl₂ and DMF immiscibility is encouraged. The Fox–Flory equation was applied to the blends analyzing the PVC blends in DMF as deviations from ideality. Different molecular weights of PMMA were identified as immiscible regardless of solvent. PMMA's lower solubility in THF and CH₂Cl₂ compared to the azobenzene derivative, displayed the existence of PMMA islands. In all blends the favorable and unfavorable interactions between polymer–solvent–polymer systems are considered. Furthermore, the miscibility effect on increasing the MMA content of the azobenzene derivative was also investigated. Copyright © 2002 John Wiley & Sons, Ltd.     

Easy saponification by metal silanolates: application in SPPS and in (S)-5-hydroxynorvaline preparation

Alkali metal trimethylsilanolates, TMSO⁻, M⁺, has been used for efficient conversion of methyl esters into their corresponding anhydrous acid salts under mild non-aqueous conditions. This strategy has been applied to SPPS for the preparation of neurotoxin cyclic analogues and in (S)-5-hydroxynorvaline synthesis.