双重信号放大的竞争型免疫传感器的制备及其应用于瘦肉精检测的研究

制备了葡萄糖氧化酶(GOD)-克伦特罗(Clenbuterol, CB)功能纳米复合物, 并采用共价键合和温育组装等方法构建了双重信号放大的竞争型免疫传感器. 研究了GOD 催化氧化葡萄糖和普鲁士蓝(PB)催化还原H2O2 双重信号放大的反应机理和传感器检测CB 的作用机制. 用扫描电子显微镜(SEM)等方法表征了纳米复合材料的形貌和复合物中GOD的活性, 复合物中的GOD 保持了良好的电催化性能和酶动力学响应, 并且符合米氏动力学方程. 最佳实验条件下, 该免疫传感器对盐酸克伦特罗的检测线性范围为0.01～100 ng/mL, 检测限达4.50 pg/mL. 实验结果表明, 该传感器对瘦肉精克伦特罗的检测具有灵敏度高, 特异性强, 重现性好, 线性范围宽和检测限低等优点. 将该方法用于猪肝样品的分析, 加标样品回收率在97.5%～102%之间. 该研究为瘦肉精及β-受体兴奋剂的分析提供了一种新方法.     

Microfabricated bioreactor chips for immobilised enzyme assays

A microfabricated device is reported that has been designed to permit the in situ packing of a section of channel with enzyme immobilised onto controlled pore glass (CPG). It is fabricated from glass and polydimethylsiloxane and to prevent dead volumes, has dedicated channels for packing the reactor. The device has the advantage of being simple in design, the flow through enzyme reactor channel being simply a widened section of the analyte channel. The system is suitable for both hydrodynamic and electro-osmotic pumping, and is designed such that when the packing is exhausted it can be repacked. Controlled pore glass provides a reproducible none swelling, high porosity medium onto which the enzyme could be immobilised. The large particle size meant that it was vital to optimise the immobilisation procedure in order to achieve acceptable enzyme activity. The microfabricated device was developed with two enzymes of different molecular masses; alkaline phosphatase and xanthine oxidase. The pore size of the CPG was found to be very important for xanthine oxidase, where the 697 Å pore size (120-200 mesh) CPG was found to give the highest activity (18-20% activity retained after immobilisation). The microfabricated device was used for the assay of p-nitrophenyl phosphate and hypoxanthine with spectrophotometric detection at 405 and 470 nm, respectively. The limits of detection were 5 and 8 μM, respectively.     

聚甲基丙烯酸甲酯-牛血清白蛋白核壳纳米粒子在金表面的吸附过程及在传感器中的应用

利用铜离子引发体系, 制备出核层为聚甲基丙烯酸甲酯(PMMA)壳层为牛血清白蛋白(BSA)的PMMA-BSA核壳纳米粒子. 通过透射电子显微镜(TEM)表征, 直接观察到PMMA-BSA纳米粒子的核壳结构.结合X射线光电子能谱(XPS)测试, 分析PMMA-BSA纳米粒子的表面成分, 证明PMMA-BSA纳米粒子的壳层是BSA. 利用带耗散的石英晶体微天平(QCM-D)研究了PMMA-BSA纳米粒子在金片表面的吸附行为. 频率的迅速下降, 耗散因子的快速上升, 说明PMMA-BSA粒子快速地吸附到金片表面. 利用磷酸盐缓冲液反复冲洗时, 频率和耗散没有变化, 表明PMMA-BSA 纳米粒子在金片上吸附较牢固. 以金电极为基底电极, 吸附PMMA-BSA纳米粒子后, 利用戊二醛修饰粒子壳层, 再通过氨基与醛基的反应来固定葡萄糖氧化酶, 制备出电流型葡萄糖传感器. 电化学测试表明该传感器对葡萄糖具有良好的电流响应, 在0.3 V的工作电位下, 响应电流与葡萄糖浓度在0.20-5.85 mmol·L^-1范围内呈现出较好的线性关系, 相关系数为0.989. 传感器的灵敏度高达28.6 μA·L·mmol^-1·cm^-2, 响应时间仅为11 s. 传感器还具有良好的稳定性, 在25℃下储存30 d, 响应电流仅下降了16%.     

A comparison of the mechanism for the reductive half-reaction between pea seedling and other copper amine oxidases (CAOs)

In a previous DFT study a mechanism for the reductive half-reaction of pea seedling amine oxidase (PSAO) was suggested. In many of the suggested steps a lysine at the active site plays an important role. However, this lysine is not found in other amine oxidases. The primary aim of the present DFT study is therefore to investigate alternative mechanisms for those amine oxidases (CAO) where the lysine residue is not present. One of the most important roles suggested for the lysine in PSAO was to protonate the O2-site of TPQ before the critical Cbond;H bond cleavage of the substrate. In the absence of lysine the O2-site of TPQ is now suggested to be protonated by a water ligand on the copper metal complex, in line with experimental suggestions. In other steps the role of lysine is taken over by an asparagine. All results are compared with experimental observations and good agreement is generally found.     

蛋白-脂质体复合物毛细管电泳筛选单胺氧化酶抑制剂

基于酶与底物间的相互作用,建立了蛋白-脂质体复合物毛细管电泳筛选单胺氧化酶(MAO)抑制剂的新方法.分别将不同浓度的4种N-炔丙基胺类化合物添加至含有蛋白-脂质体复合物的毛细管电泳缓冲液中,抑制MAO活性.考察MAO底物犬尿胺(Kyn)在含有不同浓度N-炔丙基胺类化合物缓冲液中的迁移时间比率(RMTR).结果表明,化合物N-炔丙基-N-甲基-R-2-庚胺(R-2-HMP)和N-炔丙基-R-2-庚胺(R-2-HPA)能够明显抑制MAO活性,导致MAO与Kyn的相互作用减弱,Kyn的RMTR值随着R-2-HMP和R-2-HPA的增加呈现出明显增加的趋势.化合物N,N-二炔丙基-R-2-己胺和N,N-二炔丙基-R-2-辛胺对MAO活性抑制不明显,Kyn的RMTR随这两种浓度增加变化不大.此结果与柱外孵育测定化合物活性结果一致.与传统MAO筛选剂筛选方法相比,本方法快速,成本低,酶消耗量少且不受分离电压等于扰因素的影响.     

An amperometric biosensor based on covalent immobilization of ascorbate oxidase on biocompatiable and low-toxic poly(thiophene-3-acetic acid) matrix

The biocompatiable and low-toxic poly（thiophene-3-acetic acid）（PTAA） matrix was successfully electrosynthesized in ionic liquid 1-butyl-3-methylimidazolium hexafluorophosphate（BmimPF₆） in comparison with the electrosynthesis of PTAA matrix in acetonitrile（ACN）.Ascorbate oxidase（AO） was used as a model for the development and application of biosensor.Vitamin C（VC） biosensors were facilely fabricated by the covalent immobilization of AO molecules on PTAA matrices electrosynthesized in ACN containing tetrabutylammonium tetrafluoroborate and BmimPF₆, respectively.Electrochemical impedance spectroscopy,scanning electron microscopy and FTIR spectroscopy indicated that AO molecules were covalently immobilized on PTAA matrices.Parameters of the as-obtained biosensors such as working potential,pH and temperature have been optimized.The amperometric biosensor based on PTAA matrix electrosynthesized in BmimPF₆ exhibited wider linear range,lower detection limit,higher sensitivity and bioaffinity,and better operational and storage stability than that electrosynthesized in ACN under optimal conditions.The as-obtained biosensor based on PTAA matrix electrosynthesized in BmimPF₆ was employed for the detection of VC content in commercial juices,and the result was close to the data given by manufacturers.Excellent results indicate that the PTAA matrix electrosynthesized in ionic liquid is a promising platform for the covalent immobilization of biologically-active species and the development of biosensors.     

Development of a bienzyme reactor sensor system for the determination of ornithine

A bienzyme reactor sensor system with amperometric detection was developed for the determination of ornithine. The system based on the immobilized enzymes (ornithine carbamyl transferase and pyruvate oxidase) consisted of a buffer tank, a peristaltic pump, an enzyme reactor, an oxygen electrode and a recorder. Then, 0.1 M MOPS buffer, containing pyruvic acid (0.5 mM) and carbamyl phosphate (0.5 mM), was continuously transferred into the system at 35 °C. Phosphate ion was formed enzymatically by transformation of ornithine in the presence of carbamyl phosphate. Pyruvate oxidase is activated by the presence of phosphate. Therefore, ornithine was determined from the oxygen consumed upon oxidation of pyruvic acid catalyzed by pyruvate oxidase in the presence of phosphate ion. The limit of detection was 0.05 mM and the response was linear to 3 mM (R²=0.9905). The variation coefficients were 4.9 (n=15) and 3.9% (n=15) for 1.1 and 3.0 mM standard ornithine, respectively. Good comparative results (R²=0.9238) were observed between ornithine contents in prawn muscle determined by the proposed system and by the HPLC. One assay was completed within 4 min. The immobilized enzymes were stable for 2 months at 4 °C and more than 150 samples could be continually determined using this enzyme reactor.     

A dual fluorophore system for simultaneous bioassays

A detection scheme for the simultaneous evaluation of two bioassays based on fluorescence spectroscopy is presented. For the determination of hydrogen peroxide-generating enzymes or peroxidases, the non-fluorescent 4-(N-methylhydrazino)-7-nitro-2,1,3-benzooxadiazole (MNBDH) is converted to the strongly fluorescent 4-(N-methylamino)-7-nitro-2,1,3-benzooxadiazole (MNBDA). Phosphatases are detected based on the cleavage of the non-fluorescent 5-fluorosalicyl phosphate (5-FSAP) under formation of the fluorescent 5-fluorosalicylic acid (5-FSA). While excitation of the fluorophores may be carried out at the same wavelength, their emission spectra differ significantly. This allows the read-out of both assays using commercially available microplate readers without additional chemometric tools. Compared with individual assays, limits of detection are similar, and linearity of the calibration functions for both enzymes is observed over 2-3 concentration decades starting at the limit of quantification. The simultaneous determination of glucose oxidase and acid phosphatase in honey is presented as example for the application of the detection scheme.     

Electrochemical response of ascorbic acid at conducting and electrogenerated polymer modified electrodes for electroanalytical applications: a review

The present short review deals with electroanalytical aspects of electrochemical response of ascorbic acid (Vitamin C) at conducting and electrogenerated polymer modified electrodes. Two main topics are considered: (i) electrocatalytic oxidation of ascorbate at conducting polymer modified electrodes, leading to electroanalytical techniques for ascorbate assay, and (ii) retardation of ascorbate penetration through a layer of electrogenerated polymers, leading to permselective coatings and their diverse uses, especially for biosensing devices.     

New compounds obtained by enzymatic oxidation of phloridzin

Oxidation of phloridzin was studied in a model system in the presence of apple polyphenol oxidase. In addition to 3-hydroxy phloridzin, two major oxidation products were purified by reversed phase HPLC at the semi-preparative scale. Their structures were elucidated by UV, ESI-MSⁿ and NMR spectroscopies. The first compound was a colourless product, whose novel structure strongly differs from its precursor showing a biphenyl moiety and a propionic acid chain. The second product was an oxidised form of the first one and corresponded to a stable yellow pigment with two isomeric forms. A mechanism of formation of these products, which implied successive oxidation and nucleophilic addition steps was proposed.