Preparation,characterization, and mesophase formation of esters of ethylcellulose and methylcellulose

A range of mixed ether-esters of cellulose was prepared from partially substituted ethylcellulose and methylcellulose. The ¹³C-NMR analysis of ethylcellulose with a DS of 2.5 indicated that the hydroxyl groups at carbon six of anhydroglucose units were completely substituted. Acetylation of the ethylcellulose under different conditions yielded (acetyl) (ethyl) cellulose (AEC) samples with acetyl degree of substitution ranging from 0 to 0.5. Fully substituted (propionyl) (ethyl) cellulose (PEC) and (acetyl) (methyl) cellulose (AMC) were also prepared. Chiral nematic liquid crystals were formed in these mixed ester/ethers of cellulose in concentrated solutions of acidic solvents. The critical concentration for the phase separation of the cellulosic solutions depended on the nature of the substituent, the degree of substitution, and the solvent at a given temperature. Methylcellulose solutions in trifluoroacetic acid and dichloroacetic acid form chiral nematic liquid crystals with a left-handed helicoidal structure. The acetylated methyl cellulose samples did not show the reversal of handedness with increasing acetyl content that was previously observed for the corresponding ethylcellulose samples. © 1994 John Wiley & Sons, Inc.     

Separation of transition metal ions and preconcentration of platinum (IV) and chromium (III) on alumina-immobilized diethylenetriaminepentaacetic acid by ligand exchange

Summary Basic alumina-bonded diethylenetriaminepentaacetic acid (DTPA) has been utilized for the separation and preconcentration of some transition metal ions on the basis of ligand exchange. Breakthrough capacity and rate of sorption have been studied. The distribution coefficients of 16 transition metal ions have been determined in demineralized water, 0.01 M sodium citrate and in four different pH systems. On the basis of differences in Kd values some quantitative separations of metal ions have been achieved. The greater selectivity behaviour (higher Kd values) of the adsorbent for Pt(IV)and Cr(III) has been utilized for their preconcentration in the presence of other metal ions. The method has been employed for the recovery of Pt(IV) and Cr(III) from tapwater and sea-water samples.     

Solid phase extraction and analysis of horse urine for aminocaproic acid

Summary A rapid and efficient procedure is described for extraction and determination of aminocaproic acid in horse urine. Urine was extracted by passing through a bonded silica column (Bond-Elut). The adsorbed drug was washed free of endogenous materials before being eluted. The extract was then examined by thin-layer chromatography and HPLC. The purity of the extract was determined by gas chromatography-mass spectrometry.     

A new dodecylsulfate-selective supported liquid membrane electrode based on its N-cetylpyridinium ion-pair

A supported liquid and a poly(vinyl chloride) (PVC)-based membrane selective for dodecylsulfate (DS⁻) ion are described. The active element is a membrane containing a dissolved ion association complex of DS⁻ with cetylpyridinium (CP⁺) cation. The supported liquid membrane electrode (acetophenone as solvent) showed a Nernstian response towards the DS⁻ anion over the concentration range of sodium dodecylsulfate (SDS) from 8.3×10⁻³ to 1.0×10⁻⁶ mol dm⁻³ at 25 °C. The proposed electrode also showed a super-Nernstian potential response (108±2 mV decade⁻¹) at low concentrations (1.0×10⁻⁹ to 1.0×10⁻⁶ mol dm⁻³). Moreover, this electrode showed good selectivity and precision (R.S.D.?2.0%), and was usable within the pH range 4.0-6.8. The proposed electrode revealed a lower limit of detection of 6.3×10⁻⁷ mol dm⁻³ and improved selectivity in comparison with the some previously reported DS⁻ ion selective electrodes. The isothermal temperature coefficient of this electrode amounted to −0.001 V °C⁻¹. The liquid membrane electrode may find application in the direct determination of SDS by the standard addition method at pH 5.0, and in the physicochemical studies of surfactant solutions.     

Validated Enantioselective LC Method, with Precolumn Derivatization with Marfey’s Reagent, for Analysis of the Antiepileptic Drug Pregabalin in Bulk Drug Samples

An enantioselective high-performance liquid chromatographic method, with precolumn derivatization with Marfey’s chiral reagent, sodium 2,4-dinitro-5-fluorophenyl-l-alanine amide, has been developed for resolution of the enantiomers of a new antiepileptic drug, pregabalin, in the bulk drug. The diastereomers of the pregabalin enantiomers were resolved to baseline on a reversed-phase ODS column with a 60:40 (v/v) mixture of aqueous 0.2% triethylamine (pH adjusted to 3.5 with dilute orthophosphoric acid) and acetonitrile as mobile phase. Resolution between the diastereomers was not less than five. The method was extensively validated and proved to be robust. The calibration plot was indicative of an excellent linear relationship between response and concentration over the range 750 (LOQ) to 7,500 ng L⁻¹ for the R enantiomer. The limits of detection and quantification of the R enantiomer were 250 and 750 ng L⁻¹, respectively, for an injection volume of 10 μL. Recovery of the R enantiomer from bulk drug samples of pregabalin ranged from 97.5 to 101.76%. Solutions of pregabalin in water and in the mobile phase were found to be stable for at least 48 h. The method was found to be suitable and accurate for quantitative determination of the R enantiomer in the bulk drug. It can be also used to test the stability of samples of pregabalin.     

Determination by LC of Polyphenols in Italian Red Wine

A reversed-phase liquid chromatographic method, optimised for the separation of trans-, and cis-resveratrol, catechin, epicatechin, quercetin and rutin, is reported. Separation was achieved using a C18 column and a gradient elution with acetonitrile and 5% formic acid aqueous solution. The analyses required an equilibration period of 10 min and a run time of 25 min for completion. Identification was based on retention characteristics and by relative UV spectra, obtained by photodiode array detector and were compared with commercial standards. Analyses were performed without any sample pre-treatment. Detection was carried out by UV–Vis detector at three different wavelengths. The detection limit ranged from 0.16 μgm L⁻¹ (cis-resveratrol) to 1.5 μgm L⁻¹ (+)-catechin. Investigation was extended to quantitative determination of phenol compounds in Italian red wine and to investigate the stability of the six antioxidants.     

Cationic ring-opening polymerization of 3,3-bis（chloromethyl）oxacyclobutane in ionic liquids

Cationic ring-opening polymerization of 3,3-bis(chloromethyl)oxacyclobutane catalyzed by BF_3·OEt_2 was carried out in ionic liquids [bmim]BF_4 and [bmim]PF_6.The influences of BCMO concentration and molar ratio of BCMO/BF_3·OEt_2 on the molecular weights and yield of PBCMO were investigated.The polymerization in ionic liquids proceed to high conversions,although molecular weights are limited,similar to polymerization in organic solvent such as CH_2Cl_2.Follow a viewpoint of green chemistry, we feel ionic liquid [bmim]BF_4 is superior to [bmim]PF_6.Extracting [bmim]PF_6 from the product using organic solvent as extractant limits its advantage as a green reaction media.     

Study of high-performance liquid chromatographic separation of selected herbicides by hydro-methanolic and micellar liquid chromatography using Genapol X-080 non-ionic surfactant as mobile phase constituent

Chromatographic behaviour of six selected herbicides (chlortoluron, metoxuron, chloridazon, simazine, propazine and atrazine) was studied by reversed-phase (RP) high-performance liquid chromatography (HPLC) containing Genapol X-080 non-ionic surfactant as methanol/water mobile phase constituent. The concentration of methanol was changed from 50 to 0% (v/v) for constant 2% (v/v) concentration of the surfactant. The surfactant concentration in purely aqueous micellar mobile phase varied from 1 to 5% (v/v) what is approximately 360-1800 times above the CMC. Within this concentration range Genapol X-080 proves concentration dependent selectivity changes for chlortoluron/atrazine critical pair not occurred in hydro-methanolic mobile phases. Further studies revealed that this chromatographic system offers high compatibility with cloud-point extraction environmental sample pretreatment approaches using Genapol X-080 for the purpose, too.     

β-Cyclodextrin-polyurethane polymer as solid phase extraction material for the analysis of carcinogenic aromatic amines

β-Cyclodextrin-polyurethane (β-CDPU) polymer was synthesized by the reaction of β-cyclodextrin with hexamethylene diisocyanate in dry dimethylformamide and used as a sorbent for the solid phase extraction (SPE) of carcinogenic aromatic amines from water. The polymers were characterized by Fourier transform infrared spectroscopy, thermogravimetric analysis, differential scanning calorimetry and particle size analysis. The separation and quantification was performed by Liquid chromatography with RP-C₁₈ column and diode array detection using standard arylamines for quantification. When compared with commercially available sorbents, β-CDPU gave better recovery for the aromatic amines. From the variation of pH of the extractant from 4.0 to 8.5 recovery was highest at pH 8.5. The breakthrough volume has been ascertained to be 100 ml for 200 mg of the resin. The new SPE material offers better recovery and estimation of banned arylamines.     

Simultaneous Determination of Four Active Components in a Compound Formulation by Liquid Chromatography

Summary A rapid and accurate LC method is described for simultaneous determination of pseudoephedrine hydrochloride (PSE), acetaminophen (AMP), dextromethorphen hydrobromide (DEX), and diphenhydramine hydrochloride (DPH) in a compound formulation. Chromatographic separation of the four drugs was achieved on a Hypersil CN column (150 mm × 4.6 mm, 5 m particle) by use of a mobile phase comprising a mixture of 3 mM ion-pairing solution, 2% aqueous triethylamine solution, and 2 M phosphoric acid, 68:48:88 (v/v), pH 3.0, delivered at 1.0 mL min^–1. Compounds were detected at 215 nm and the run time was less than 10 min. The linearity, accuracy, and precision of the method were found to be acceptable over the concentration ranges 6.1–36.4 g mL^–1 for PSE, 65.0–390.0 g mL^–1 for AMP, 3.1–18.6 g mL^–1 for DEX, and 5.0–30.0 g mL^–1 for DPH.