用亚硝基R盐螯合树脂分离富集催化极谱法测定矿石中的铱

本文研究了利用亚硝基Ｒ盐螯合形成的树脂，分离富集试液中痕量贵金属元素铱的实验条件。并利用ＪＰ－１型示波极谱仪，在１．５０ｍｏｌ／Ｌ盐酸＋５．０×１０＾－５ｍｏｌ／Ｌ硫脲＋０．２ｍｏｌ／Ｌ盐酸＋５．０×１０＾－５ｍｏｌ／Ｌ硫脲＋０．２ｍｏｌ／Ｌ碘化钾＋碲（ρ（Ｂ）＝０．４ｍｇ／Ｌ）的混合底液中，对铱进行极谱催化波测定。在示波极谱仪上峰电位约－０．５５Ｖ（银汞齐为参比电极），可测定试液中５．０×１．０     

用新型AP树脂分离铑—铱和同时富集测定铑`铱`铂`钯

铑-铱分离-向被认为是最困难的课题之一,即使文献曾报道Rh-Ir的分离,但实际Rh并未与萃取剂或吸附剂反应,而是与非贵金属离子一同留在溶液中。我们曾用光谱半定量方法研究了AP树脂对Rh、Ir的吸附行为,结果是Rh不被吸附而Ir能被吸附。本文通过改变Rh的离子状态,使之能被AP树脂吸附完全,而与留在溶液中的非贵金属分离,然后在柱上用不同淋洗液再使Rh-Ir分离。     

SYNTHESIS, STRUCTURE AND PROPERTIES OF INTERPENETRATING SULFONIC ACID RESINS WITH HIGH CAPACITY

Two series of interpenetrating sulfonic acid resins (ISAR), 10×n and n×10, were prepared by means of the wet method, and the physicochemical, thermodynamic and kinetic properties of the ISAR were measured. The results show: 10×n resins exhibit better properties than n×10 ones, mainly in higher apparent degree of crosslinking and larger conformational entropy effect, among which, 10×1 resin exhibits the best thermodynamic and kinetic properties. In the DTA graphs of n×10 resins, there are two T_g and two T_(ox), but in those of 10×n, only one T_g and one T_(ox). This result well supports the conclusion that 10×n resins have much better interpenetrating structural aspects.     

6-氨基青霉烷酸在弱碱性阴离子树脂IRA67上的吸附研究

用静态法研究了6-氨基青霉烷酸在弱碱性阴离子交换树脂IRA67上的吸附行为．在溶液pH为8．0，6-APA起始浓度介子3.00mg／m1-20．00mg／ml条件下，测定了25℃时IRA67树脂的静态交换动力学曲线、吸附等温线，并求得了IRA67树脂的平衡速率常数及吸附等温线方程．分别用Langmuir型和Frendlich型方程对IRA67树脂吸附等温线进行线性回归拟合，结果表明，6-APA在IRA67树脂上的吸附更符合Langmuir型吸附．     

聚氧硫杂蒽树脂固化特性及其动力学的研究

以DSC、TG等技术手段研究了聚氧硫杂蒽树脂 (POSPF)的固化特性及其动力学 .结果表明 ,用六次甲基四胺 间二氯苄作固化剂 ,加热至 10 5～ 2 2 5℃能使POSPF树脂固化 ,在固化过程树脂中的活性羟甲基和固化剂参与反应生成亚甲基桥从而形成网状体型结构 ;动态DSC曲线上出现宽的固化放热峰 ,用T β外推法确定其凝胶温度Ti=10 0 0℃、固化温度Tp=181 5℃、后固化温度Tf=2 2 5 7℃ .固化后树脂具有优良的耐热性 ,失重 5 %时热分解温度高达 4 0 3℃ .     

KINETIC MODELING OF ESTERIFICATION OF EPOXY RESIN IN THE PRESENCE OF TRIPHENYLPHOSPHINE FOR PRODUCING VINYL ESTER RESIN: MECHANISTIC RATE EQUATION

Due to its mechanical properties and ease of use, vinyl ester resin is enjoying increasing consideration. This resin normally is produced by reaction between epoxy resin and unsaturated carboxylic acid. In the present study, bis-phenol A based epoxy resin and methacrylic acid was used to produce vinyl ester resin. The reaction was conducted under both stoichiometric and non-stoichiometric conditions in the presence of triphenylphosphine as catalyst. The stoichiometric and non-stoichiometric experiments were conducted at 95, 100, 105 and 110℃and at 90 and 95℃, respectively. The first order rate equation and mechanism based rate equation were examined. Parameters are evaluated by least square method. A comparison of mechanism based rate equation and experimental data show an excellent agreement. Finally, Arrhenius equation and activation energy were presented.     

丙烯酸Fe3+型树脂在非水介质中对鞣酸的配位吸附及洗脱性能

将Fe3 载于丙烯酸树脂上,制备了在非水介质中对鞣酸具有良好吸附性能的配位吸附树脂.在甲醇中,树脂对鞣酸的吸附符合Langmuir单分子层吸附模型,静态饱和吸附量为34mg/g,吸附为粒扩散控制过程.动态吸附中,树脂对鞣酸的泄漏吸附量为25mg/g,饱和吸附量32mg/g.采用5%的甲胺乙醇溶液作洗脱剂,洗脱率95%.树脂在吸附及洗脱过程中未见Fe3 脱落.     

Synthesis and characterization of new optically active poly(amide‐imide)s containing epiclon and L‐methionine moieties in the main chain

Epiclon [3a,4,5,7a‐tetrahydro‐7‐methyl‐5‐(tetrahydro‐2,5‐dioxo‐3‐furanyl)‐1,3‐isobenzofurandione] (1) was reacted with L ‐methionine (2) in acetic acid and the resulting imide‐acid 3 was obtained in high yield. The diacid chloride 4 was prepared from diacid derivative 3 by reaction with thionyl chloride. Thermostable poly(amide‐imide)s containing epiclon structure were synthesized by reacting of diacid chloride 4 with various aromatic diamines. Polymerization reaction was performed by two conventional methods: low temperature solution polycondensation and short period reflux conditions. In order to compare conventional solution polycondensation reaction methods with microwave‐assisted polycondensation, the reactions were also carried out under microwave conditions with a small amount of o‐cresol that acts as a primary microwave absorber. The reaction mixture was irradiated for 6 min with 100% radiation power. Several new optically active poly(amide‐imide)s with inherent viscosity ranging from 0.15 to 0.36 dl/g were obtained with high yield. All of the above polymers were fully characterized by ¹H‐NMR, FT‐IR, elemental analyses and specific rotation techniques. Some structural characterizations and physical properties of these new optically active poly(amide‐imide)s are reported. Copyright © 2005 John Wiley & Sons, Ltd.     

Chemistry of polyfunctional molecules-123. Reactions of BiBr3, SbI3 and AsI3 with LiN(PPh2)2; X-ray structure of a cyclophosphazene salt containing arsenic(I)

BiBr₃ or SbI₃ react at 20°C with LiN(PPh₂)₂ (1) to give elementary Bi or Sb and the P---P coupled phosphazene ligand Ph₂P---N=PPh₂---PPh₂=N---PPh₂ (2). The reaction of AsI₃ with 1 at room temperature formed yellow needles of the eight-membered heterocycle (3), whereas AsI₃ interacted at 80°C with 1 in the molar ratio of 1:3 to give elementary arsenic and 2. Treatment of AsI₃ and 1 at 20°C in a 1:2 stoichiometry yielded the seven-membered, cyclic arsenium(I) salt

Full-size image

I·4THF (5·4THF), which was characterized by elemental analysis, conductivity, mass, IR and NMR spectroscopy and single-crystal X-ray structural analysis.     

蒙旦树脂化学组成的研究

采用阴离子交换色谱和硅胶－氧化铝柱色谱对云南寻甸蒙旦树脂（ＸＤＳＺ）、潦浒蒙旦树脂（ＬＨＳＺ）、昭通蒙旦树脂（ＺＴＳＺ）和吉林舒兰蒙旦树脂（ＳＬＳＺ）进行了族组分的分离。树脂游离酸，树脂结合酸，树脂烃和树脂醇在各树脂中的百分含量分别为ＸＤＳＺ１１．８６，８．７６，１２．３０，４５．９９；ＬＨＳＺ１５．８９，１３．９１，４．９０，４５．９９；ＳＬＳＺ２５．４６，８．０７，１７．４０，３６．２２；ＺＴ