Formamide,a water substitute XIV (1) waterless microemulsions 8. Structural analysis by X-ray scattering of CTAB aggregates in formamide and in the microemulsion system (formamide,CTAB, isooctane, 1-butanol)

X-ray scattering was used to analyse the structures of aggregates of CTAB in various formamide-containing media.Firstly, CTAB micelles were detected in formamide solutions. A spherical micelle model was proposed; at values close to the CMC, smaller micelles were observed in formamide than in water.Secondly, the structure of microemulsions in the isooctane-rich zone of the system (formamide/CTAB=2, isooctane, 1-butanol) was studied by X-ray scattering. The structure was found to be quite different in this zone from that normally observed in aqueous microemulsions. Structures compatible with small filaments of formamide were detected. The results were related to previous measurements of electrical conductivity.     

The initial oxidation of magnesium: an in situ study with XPS,HERDA and ellipsometry

The initial oxidation of magnesium at oxygen partial pressures between 1.3 × 10^?8 and 1.3 × 10^?5 Pa and at temperatures ranging from 273 to 550 K has been investigated in situ with X‐ray photoelectron spectroscopy (XPS), ellipsometry and high resolution elastic recoil detection analysis (HERDA). Quantitative analysis of the XPS spectra showed a clear oxygen deficiency with respect to MgO for the initial oxide. HERDA measurements confirmed this relatively low oxygen content in the thin oxide layers formed. Ellipsometry measurements showed that the electronic structure of the initially formed oxide differs significantly from that of bulk MgO. The band gap values at room temperature for the oxide layers investigated are clearly smaller than the value for bulk MgO. Copyright © 2006 John Wiley & Sons, Ltd.     

Study of silica supported PtxNi1-x catalysts by ion scattering spectroscopy

As supported Pt_xNi_1–x catalysts are used for hydrogenation reactions, it seemed necessary to assess the surface composition of the reduced samples. To approach the usual reduction conditions we applied in situ reduction in a reaction chamber (1 mbar H₂ up to 500 °C) placed in ultra high vacuum recipient (UHV: 10^–9 to 2.10^–10mbar). All ion scattering spectroscopy measurements were performed in UHV. Charging of the samples was avoided by electron bombardment (5 eV). The variation of the surface composition was determined after subsequent sputtering, thermal treatment at 500 °C and during oxygen adsorption. A comparison with previous results of surface compositions of binary alloys (polycrystalline foils [1, 2] and single crystals Pt_xNi_1–x [3]) is given.Dedicated to Professor Dr. rer. nat. Dr. h. c. Hubertus Nickel on the occasion of his 65th birthday     

Tetraalkylammonium bromides in methanol: Small angle neutron scattering and vapor pressure measurements

Vapor pressure measurements and small angle scattering (SANS) experiments are reported and discussed for bispiperidinium (BP) bromide and n-tetrapentylammonium bromide solutions in methanol at 25°C. The BP⁺ ion which may be considered as a tetraalkylammonium (TAA) ion with pairwise connected alkyl chains, is used for the study of the effects due to flexible TAA alkyl chains. SANS intensities are calibrated with the help of the precise osmotic coefficients from the vapor pressure measurements.     

Small angle X-ray scattering investigations of thermodynamic properties of fluid mixtures

Absolute small angle X-ray studies of concentration fluctuations were performed in order to determine thermodynamic properties of a model blend, consisting ofn-hexane and perfluoro-n-hexane. The quantities which we determined were the second derivate of the Gibbs free energy of mixing with respect to the concentration of the components, the location of the spinodal, interaction and solubility parameters, the energy gradient density coefficient as well as the correlation length of the fluctuations at various compositions and temperatures, particularly in the neighbourhood of the spinodal and the critical point. The data obtained were compared with those obtainable from the well known location of the binodal, to test the reliability of the scattering method.     

Structural Characteristics of Xyloglucan – Congo Red Aggregates as Observed by Small Angle X-ray Scattering

Xyloglucan is a type of hemicellulose with a cellulose backbone containing (1→6)-α-xylose or (1→2)-β-galactoxylose as a side chain. It is soluble in water. Its aqueous solution forms a gel or gel-like precipitate by addition of Congo red. Xyloglucan gel structures with various concentrations of Congo red were observed by small angle X-ray scattering (SAXS) at the nano-level. SAXS results indicated that the xyloglucan chains interacted with Congo red, and that an increase of concentration of Congo red induced a characteristic cross-linking domain, which consisted of a flat structure containing stacked xyloglucan chain assemblies. The Congo red molecules are inserted between the xyloglucan chains.     

Laser irradiation induced spectral evolution of the Laser irradiation induced spectral evolution of the surface-enhanced Raman scattering(SERS)of 4-tert-butylbenzylmercaptan on gold nanoparticles assembly

The spectral evolution of the surface-enhanced Raman scattering (SERS) of 4-tert-butylbenzylmer-captan(4-tBBM)on gold nanopanlcles assembly under laser irradiation is reported.The reIative intensities of typical peaks in the spectrum of 4-tBBM gradually change with irradiation time.Comparison of the rate of spectral changes under several experimental conditions indicates that the surface plasmon resonance(SPR)induced heat in the gold nanoparticles assembly is the origin of the spectraI evolution.During the process of self-assembly,4-tBBM molecules do not form a compact ordered monolayer because of the spatial hindrance of the 4-tert-butyl end group.The heat induced by laser irradiation drives the 4-tBBM molecules to rearrange to a more stable orientation.     

Laser irradiation induced spectral evolution of the surface-enhanced Raman scattering(SERS) of 4-tert-butylbenzylmercaptan on gold nanoparticles assembly

The spectral evolution of the surface-enhanced Raman scattering (SERS) of 4-tert-butylbenzylmer-captan (4-tBBM) on gold nanoparticles assembly under laser irradiation is reported. The relative intensities of typical peaks in the spectrum of 4-tBBM gradually change with irradiation time. Comparison of the rate of spectral changes under several experimental conditions indicates that the surface plasmon resonance (SPR) induced heat in the gold nanoparticles assembly is the origin of the spectral evolution. During the process of self-assembly, 4-tBBM molecules do not form a compact ordered monolayer because of the spatial hindrance of the 4-tert-butyl end group. The heat induced by laser irradiation drives the 4-tBBM molecules to rearrange to a more stable orientation.     

Aggregation processes of biomolecules in presence of trehalose

Among disaccharides, trehalose, a naturally-occurring glass-forming disaccharide, is particularly effective in terms of its ability to preserve several organisms under stress conditions. The present work is aimed to investigate the bioprotective action of trehalose on lysozyme as a function of temperature. In order to extract quantitative information about the dimensional changes of the proteins, we performed Small Angle Neutron Scattering measurements on lysozyme/D₂O solutions in absence and in presence of the disaccharide. The findings emphasise the capability of trehalose to stabilise the protein, activating aggregation processes.     

Sulfide Gels and Films: Products of Non-Oxide Gelation

The preparation of concentrated sols and transparent stiff gels of II-VI semiconductors nanocrystals is reported. A two-step process for the production of cadmium sulfide is reported. Sol stabilization and gelation control are achieved through successive passivation and depassivation of the surface of the nanocrystals which are complexed with thiols. The mechanisms driving the aggregation and the gelation are explained on the basis of NMR and SAXS experiments. Thin films as well as monoliths can be produced. The general principles of the method presented are not restricted to chalcogenide systems and thus enlarge the domain of application of the inorganic sol-gel process.