Novel palladium nanoparticles supported on β‐cyclodextrin@graphene oxide as magnetically recyclable catalyst for Suzuki–Miyaura cross‐coupling reaction with two different approaches in bio‐based solvents

A novel nanocatalyst was designed and prepared. Initially, the surface of magnetic graphene oxide (M‐GO) was modified using thionyl chloride, tris(hydroxymethyl)aminomethane and acryloyl chloride as linkers which provide reactive C═C bonds for the polymerization of vinylic monomers. Separately, β‐cyclodextrin (β‐CD) was treated with acryloyl chloride to provide a modified β‐CD. Then, in the presence methylenebisacrylamide as a cross‐linker, monomers of modified β‐CD and acrylamide were polymerized on the surface of the pre‐prepared M‐GO. Finally, palladium acetate and sodium borohydride were added to this composite to afford supported palladium nanoparticles. This fabricated nanocomposite was fully characterized using various techniques. The efficiency of this easily separable and reusable heterogeneous catalyst was successfully examined in Suzuki–Miyaura cross‐coupling reactions of aryl halides and boronic acid as well as in modified Suzuki–Miyaura cross‐coupling reactions of N‐acylsuccinimides and boronic acid in green media. The results showed that the nanocatalyst was efficient in coupling reactions for direct formation of the corresponding biphenyl as well as benzophenone derivatives in green media based on bio‐based solvents. In addition, the nanocatalyst was easily separable, using an external magnet, and could be reused several times without significant loss of activity under the optimum reaction conditions.     

聚变实验堆真空室壳体成型残余应力分析

为了了解聚变实验堆真空室壳体表面残余应力的分布以及退火工艺对残余应力的影响，通过模拟分析和实验检测两种方式对不锈钢316LN冷压曲面和热压曲面残余应力进行研究，获得退火前后曲面表面残余应力的大小，得到冷压曲面和热压曲面残余应力的分布以及退火工艺对残余应力分布的影响。研究结果为分析成型工艺提供数据支撑，对中国聚变工程实验堆真空室的研究与制造具有重要意义。     

Growth of large La2−xSrxCuO4 single crystals using tilting-mirror-type infrared heating image furnace

Large single crystals of La_2−xSr_xCuO₄ (LSCO) high-T_c superconductors were grown by the infrared heating floating zone (IR-FZ) method using a tilting-mirror-type image furnace. The maximum diameter of the LSCO crystals increased to 10 mm in the tilting-mirror-type image furnace from 6 mm in the conventional image furnace. CuO rich feeds were required for the crystal growth using the tilting-mirror-type image furnace to compensate for the lack of CuO caused by the significant evaporation of CuO during the growth. The evaporation of CuO was affected by the tilting angle of the mirrors of the image furnace and by feed diameter. The optimized growth conditions were as follows: mirror tilting angle, 20°; feed diameter, 10 mm∅; and feed composition 50.7 mol% CuO.     

Experiment on relationship between the magnetic gradient of low-carbon steel and its stress

In geomagnetic field, a series of tensile experiments on the low-carbon steel sticks were carried out. A special homemade detector was used to measure the magnetic gradient on the material surface. The results showed that the relationship between the magnetic gradient and the stress varied with different conditions of measurement. There was no obvious correlation between the magnetic gradient and the tensile stress if the sample remained on the material test machine. If the sample was taken off from the machine, the measured magnetic gradient was linear with the prior maximum stress. In Nanjing, PR China, a place of 32°N latitude, the slope of the linear relationship was about 67 (uT/m)/MPa. This offered a new method of non-destructive stress testing by measuring the magnetic gradient on the ferromagnetic component surface. The prior maximum applied stress of the sample could be tested by measuring the present surface magnetic gradient. Actually this phenomenon was the metal magnetic memory (MMM). The magnetic gradient near the stress concentration zone of the sample, the necking point, was much larger than other area. Thus, the hidden damage in the ferromagnetic component could be detected early by measuring the magnetic gradient distribution on its surface. In addition, the magnetic memory signal gradually weakened as the sample was taken off and laid aside. Therefore, it was effective for a given period of time to detect the stress or stress concentration based on the MMM testing.     

Low‐Transition‐Temperature Mixtures (LTTMs): A New Generation of Designer Solvents

A new generation of designer solvents emerged in the last decade as promising green media for multiple applications, including separation processes: the low‐transition‐temperature mixtures (LTTMs). They can be prepared by mixing natural high‐melting‐point starting materials, which form a liquid by hydrogen‐bond interactions. Among them, deep‐eutectic solvents (DESs) were presented as promising alternatives to conventional ionic liquids (ILs). Some limitations of ILs are overcome by LTTMs, which are cheap and easy to prepare from natural and readily available starting materials, biodegradable, and renewable.     

顶空气相色谱法测定瑞替加滨原料药中残留溶剂

建立了测定瑞替加滨原料药中残留溶剂乙醇、正己烷、四氢呋喃、三乙胺的顶空气相色谱方法。采用氢火焰离子化检测器,以N,N-二甲基甲酰胺为样品溶剂,通过对色谱条件优化,建立了以DB-624为分析柱、110℃为平衡温度、15 min为平衡时间的残留溶剂测定方法。经方法学验证,上述4种溶剂的方法检出限依次为0.007 5%、0.000 48%、0.002 4%、0.01%;峰面积的相对标准偏差均小于2.1%;平均回收率为100%～102%;4种溶剂的线性系数均大于0.995。结果表明,该方法的检测灵敏度高、精密度好、准确度高、线性关系良好,能够满足对瑞替加滨质量的控制要求。将该方法应用于3批瑞替加滨原料药的残留溶剂检测,均只检出乙醇和正己烷,且乙醇和正己烷的最高残留量分别为0.149%和0.022%,均未超出限量规定。     

Deep eutectic solvents and glycerol: a simple,environmentally benign and efficient catalyst/reaction media for synthesis of N-aryl phthalimide derivatives

Abstract

Deep eutectic solvents (DES) and glycerol have been successfully employed as efficient catalysts/reaction media in the synthesis of N-aryl phthalimide derivatives from phthalic anhydride and primary aromatic amines. The DES prepared from choline chloride and malonic acid proved to be an efficient catalyst whereas glycerol and the DES of choline chloride and urea played a dual role of catalyst and solvent. These mixtures are biodegradable, nontoxic, and cost-effective thereby providing a good industrial alternative to conventional methods. These methods gave products in moderate to high yields with good recyclability of catalyst/solvent at least up to five consecutive runs.     

Natural deep eutectic solvents as new potential media for green technology

Developing new green solvents is one of the key subjects in Green Chemistry. Ionic liquids (ILs) and deep eutectic solvents, thus, have been paid great attention to replace current harsh organic solvents and have been applied to many chemical processing such as extraction and synthesis. However, current ionic liquids and deep eutectic solvents have still limitations to be applied to a real chemical industry due to toxicity against human and environment and high cost of ILs and solid state of most deep eutectic solvents at room temperature. Recently we discovered that many plant abundant primary metabolites changed their state from solid to liquid when they were mixed in proper ratio. This finding made us hypothesize that natural deep eutectic solvents (NADES) play a role as alternative media to water in living organisms and tested a wide range of natural products, which resulted in discovery of over 100 NADES from nature. In order to prove deep eutectic feature the interaction between the molecules was investigated by nuclear magnetic resonance spectroscopy. All the tested NADES show clear hydrogen bonding between components. As next step physical properties of NADES such as water activity, density, viscosity, polarity and thermal properties were measured as well as the effect of water on the physical properties. In the last stage the novel NADES were applied to the solubilization of wide range of biomolecules such as non-water soluble bioactive natural products, gluten, starch, and DNA. In most cases the solubility of the biomolecules evaluated in this study was greatly higher than water. Based on the results the novel NADES may be expected as potential green solvents at room temperature in diverse fields of chemistry.     

Heat-Induced Formation of Monodisperse Gold Nanoparticles in Different Conditions

We investigate the preparation of nearly monodisperse gold nanoparticles by heat treatment in different conditions. The effects of various solvents, heating temperature, and heating time length on the monodispersity of gold nanoparticles were studied systematically and a general route to generate gold nanoparticles with uniform size was determined. The first step was to prepare gold nanoparticles with less than 3 nm and the following operation was to heat the gold nanoparticles in the present of thiolated solvents where monodispersed gold nanoparticles could be obtained easily. Our approach has enriched synthesis of monodisperse gold nanoparticles, and may provide some valuable experimental data about how the heating process affects the size evolution of gold nanoparticles.     

Phase Behavior of Diglycerol Monomyristate in Different Nonpolar Organic Solvent Systems

We have investigated the phase behavior of diglycerol monomyristate (DGM) in a variety of organic solvents over a wide range of temperatures and compositions. At lower temperature, there exists a surfactant solid, which solubilize different amounts of oils depending on the oil nature. The melting temperature of the solid phase is virtually constant in a wide range of composition. In all the systems, a lamellar liquid crystal (L_α) is formed in surfactant‐rich regions at intermediate temperatures between the solid‐melt and isotropic two‐ or single‐phase regions. In the dilute regions reverse vesicles are formed in the L_α+O regions mainly in the case of linear hydrocarbon type oils. In the aromatic and cyclic aliphatic oils, there are isotropic solutions at 25°C. However, there is dispersion of α‐solid in the case of liner hydrocarbon oils. Two liquid‐phase regions above the L_α phase are observed in the case of tetradecane and hexadecane. In the shorter chain oil systems, such as octane and decane, no two liquid‐phase appear above L_α region. That is the two liquid‐phase region is largely dependent on the chain length of the oils, and becomes wider in longer hydrocarbon oil.