Micro-segregation model calculation of residual tin in boiler and pressure vessel steel

Tin is a typical residual element in steel and mainly originates from Sn-containing complex iron ore and steel scrap. The segregation of Sn in steel is harmful to the performances of steel. In this paper, the micro-segregation of residual element Sn during the solidification process of boiler and pressure vessel steel by micro-segregation model was studied. The results showed that the micro-segregation degree of Sn reduces apparently with the increase of cooling rate and remarkably deteriorates during the solidification process. When the initial content of C is higher than 0.1%, it will cause the solidification transform of the solid phase converting from the ferrite phase to austenite phase and the significant increase in the micro-segregation degree of Sn. However, increasing the initial contents of Si, Mn, P and S separately has non-significant effects on the micro-segregation degree of Sn. In addition, the improvement of initial content of Sn will lead to the micro-segregation degree decrease of Sn and has an inapparent impact on zero strength temperature and zero ductility temperature of the boiler and pressure vessel steel.     

Fluid phase topology of ethanol+benzene+cyclohexane at 101.3 kPa

In this article, isobaric vapor–liquid equilibria for the ternary mixture of ethanol?+?benzene?+?cyclohexane was experimentally investigated at atmospheric pressure. Vapor–liquid equilibria data for ethanol?+?benzene?+?cyclohexane at 101.3?kPa were obtained with a Othmer-type ebulliometer. Data were tested and considered thermodynamically consistent. The experimental results showed that this ternary mixture is completely miscible and exhibits three binary homogeneous azeotropes and a ternary minimum azeotrope at the studied conditions. Satisfactory results were obtained for correlation of equilibrium compositions with UNIQUAC activity coefficients model and also for prediction with UNIFAC method. In both cases, low root mean square deviations of vapor mole fraction and temperature were calculated. The capability of ethanol as modified distillation agent at atmospheric condition is discussed in terms of the thermodynamic topological analysis. However, owing to the complex topology of the ternary mixture it leads to a distillation scheme with three columns and difficult operation and thus, ethanol is not recommended as a separating agent for benzene?+?cyclohexane azeotrope.     

Digital photoelasticity of glass: A comprehensive review

The recent advances in digital photoelasticity have made it possible to use it conveniently for the stress analysis of articles and components made of glass. Depending on the application, the retardation levels to be measured range from a few nanometres to several thousand nanometres, which necessitates different techniques and associated equipments. This paper reviews the recent advances in the photoelasticity of glass with a focus on the techniques/methods developed in the last decade. A brief introduction to the residual stress in glass is provided initially to bring out its tensorial nature. The subsequent sections are organised thematically rather than chronologically, for better readability and easy access of information.     

Improving quantitative gas chromatography-electron ionization mass spectrometry results using a modified ion source: demonstration for a pharmaceutical application

Gas chromatography-mass spectrometry is a well established analytical technique. However, mass spectrometers with electron ionization sources may suffer from signal drifts, hereby negatively influencing quantitative performance. To demonstrate this phenomenon for a real application, a static headspace-gas chromatography method in combination with electron ionization-quadrupole mass spectrometry was optimized for the determination of residual dichloromethane in coronary stent coatings. Validating the method, the quantitative performance of an original stainless steel ion source was compared to that of a modified ion source. Ion source modification included the application of a gold coating on the repeller and exit plate. Several validation aspects such as limit of detection, limit of quantification, linearity and precision were evaluated using both ion sources. It was found that, as expected, the stainless steel ion source suffered from signal drift. As a consequence, non-linearity and high RSD values for repeated analyses were obtained. An additional experiment was performed to check whether an internal standard compound would lead to better results. It was found that the signal drift patterns of the analyte and internal standard were different, consequently leading to high RSD values for the response factor. With the modified ion source however, a more stable signal was observed resulting in acceptable linearity and precision. Moreover, it was also found that sensitivity improved compared to the stainless steel ion source. Finally, the optimized method with the modified ion source was applied to determine residual dichloromethane in the coating of coronary stents. The solvent was detected but found to be below the limit of quantification.     

电感耦合等离子发射光谱法测定渣油中铁、镍、钙、镁、钠、钒金属元素

用电感耦合等离子发射光谱法（ICP-AES）测定渣油中金属元素铁、镍、钙、镁、钠、钒，考察了不同的酸浓度对分析结果的影响和共存元素间的相互干扰，进行了加标回收率和精密度试验。     

固相微萃取-气相色谱法测定食品包装材料中残留有机溶剂

提出了一种以固相微萃取与气相色谱-氢火焰联用技术为基础的测定食品包装材料中15种常用有机溶剂(苯类、醇类、酮类、酯类等)的方法。选择聚二甲亚砜作为固相微萃取的萃取相,采用DB-624毛细管色谱柱进行分离。在优化的试验条件下,15种有机残留溶剂在20min内能很好地分离,15种溶剂的测定下限(10S/N)为0.08～0.69μg.dm-2。加标回收率为60.0%～115.0%,相对标准偏差(n=5)为2.17%～8.34%。     

Design of an experimental procedure for energy evaluation from biomass

The rational and sustainable exploitation of nature resources is one of the priority objectives of our society. In this article a method is proposed to evaluate and exploit the energetic resources contained in different forest formations. This method is based on the use of a combustion bomb calorimeter to determine the calorific values of the different samples studied. These results were complemented with chemical analysis of the samples and with environmental and geomorphological studies of the zones were samples were taken. The results obtained during the last 3 years for the residual biomass originated from the forest formations existing in Galicia ensure the reliability and usefulness of the method that can be extended to any forest formation all over the world.     

The preparation of a cabbage reference material for environmental monitoring and food analysis

 Cabbage is frequently used in environmental monitoring and food control, and, hence, cabbage reference materials (RMs) are required for ensuring quality assurance. A cabbage RM was prepared in view of certification of specific elements from the "black list" of high toxicological interest and nutritive importance. All tasks of the RM production (production of the plant material, cutting and freeze-drying, determination of the residual water content, preparation of the RM, homogeneity testing, stability testing, certification measurements) are described in detail. Received: 12 November 1999 / Accepted: 29 January 2000     

Irradiation effects on hydrases for biomedical applications

To apply an irradiation technique to sterilize “Hybrid” biomedical materials including enzymes, we selected papain, a well-characterized plant endopeptidase as a model to examine durability of enzyme activity under the practical irradiation condition in which limited data were available for irradiation inactivation of enzymes. Dry powder and frozen aqueous solution of papain showed significant durability against ⁶⁰Co-gamma irradiation suggesting that, the commercial irradiation sterilizing method is applicable without modification. Although irradiation of unfrozen aqueous papain solution showed an unusual change of the enzymatic activity with the increasing doses, and was totally inactivated at 15 kGy, we managed to keep the residual activity more than 50% of initial activity after 30-kGy irradiation, taking such optimum conditions as increasing enzyme concentration from 10 to 100 mg/ml and purging with N₂ gas to suppress the formation of free radicals.     

顶空气相色谱法测定盐酸托莫西汀中有机溶剂残留量的研究

建立了盐酸托莫西汀中有机溶剂残留量的顶空气相色谱分析方法.选用大口径HP-快速GC残留溶剂柱为分离柱,FID为检测器,外标法进行定量,并对顶空平衡温度、平衡时间、供试品溶液的制备方法对残留有机溶剂测定的影响进行了研究.甲醇、乙醚、正己烷、乙酸乙酯、四氢呋喃的线性范围分别为 0.41～8.10 μg/mL(r=0.9999)、0.15～3.00 μg/mL(r=0.9995)、0.20～4.01 μg/mL(r=0.9991)、0.32～6.35 μg/mL(r=0.9999)、0.36～7.11 μg/mL(r=0.9999);平均回收率范围96.30%～105.47%,精密度RSD(n=6)2.1%～3.7%;检出限分别为0.2、0.008、0.003、0.04、0.04 μg/mL.