Measurements Of Biogenic Hydrocarbons And Their Atmospheric Degradation In Forests

Abstract

An analytical procedure for the sampling and quantitative determination of biogenic hydrocarbons in the atmosphere is presented. The method is based on the adsorptive preconcentration of the hydrocarbons using Tenax TA/Carbopack B filled sampling tubes followed by thermodesorption of the trapped compounds and gas chromatographic analysis. To avoid losses of the biogenic alkenes as a consequence of their reaction with ozone on the adsorbents during the sampling step, an ozone scrubber is used in front of the adsorption tubes. Diurnal variations of the monoterpene- and ozone-concentrations are determined at different heights in and above a forest stand (coniferous and deciduous trees) in the Vosges (Col du Donon, 760 m a.s.l.) in order to elucidate the importance of terpene-oxidation reactions on the formation of peroxidic products in forest air.     

基于毛竹叶片理化参数的刚竹毒蛾危害检测研究

虫害检测算法研究是开展虫害快速、准确监测，制定精准森防检疫措施的重要基础。以毛竹叶片为研究尺度，基于刚竹毒蛾危害下的寄主外部形态与内部生理现象总结，选择并实测叶损量LL、相对叶绿素含量RCC、相对含水量RWC、原始光谱的733.66~898.56 nm值(ρ_{733.66~898.56})、一阶微分光谱的562.95~585.25 nm值(ρ′_{562.95~585.25})与706.18~725.41 nm值(ρ′_{706.18~725.41})等理化参数，随机划分实验组(63组)和验证组(37组)并设计5次重复实验；分别运用Fisher判别分析、BP神经网络、随机森林等三种方法建立刚竹毒蛾危害等级的检测模型，从检测精度、Kappa系数及R2等指标对模型的检测效果予以分析和比较。结果显示，Fisher判别分析、BP神经网络、随机森林的检测精度分别为69.19%，65.41%，83.78%，Kappa系数分别为0.576 9，0.532 4和0.778 8，R2分别为0.722 2，0.582 6和0.870 9，总体而言，三种方法均具备刚竹毒蛾危害的检测能力，随机森林的检测效果最优，Fisher判别分析次之，再次为BP神经网络；从分等级来看，随机森林的检测精度亦优于Fisher判别分析与BP神经网络，但3种方法对中度危害等级的检测精度均有所不足。该成果可为刚竹毒蛾危害及其他病虫害检测算法的选择提供参考，并为进一步建立冠层、遥感影像像元等尺度的虫害检测模型奠定基础。     

Microstructural and mechanical analysis of Cu and Au interconnect on various bond pads

Effects of High Temperature Storage (HTS) and bonding toward microstructure change of intermetallic compound (IMC) at the wire bonding interface of 3 types of bond pad (Al, AlSiCu and NiPdAu) were presented in this paper. Optical and electron microscope analyses revealed that the IMC growth rate of samples under 175 and 200 °C HTS increased in the order of Al > AlSiCu > NiPdAu. Besides, higher HTS and bonding temperatures also promoted higher IMC thickness. The compositional study showed that higher HTS and bonding temperature developed rapid interdiffusion in bonding interface. In the mechanical ball shear test, a decrease of the shear force of Al and AlSiCu bond pads after 500 h HTS was believed due to poorly developed IMC at bonding interface. On the other hand, shear force degradation at 1000 h was due to excessive growth of IMC that in turn causes the formation of defects. For NiPdAu bond pad, increasing trend of shear force with HTS duration at 175 °C implied a good reliability of the Cu wire bonding. The rapid microscopic inspection on Cu wired Al bond pad under HTS 175 °C showed the IMC development from the periphery to the center of the ball bond. However, after 500 h voids started to develop until the crack was observed at 1000 h.     

Lignin‐based polymers via graft copolymerization

Lignin is an important source of synthetic materials because of its abundance in nature, low cost, stable supply, and no competition to the human food supply. Lignin, a cross‐linked phenolic polymer, contains a large number of aromatic groups that can be used as a substitute for petroleum‐based aromatic fine chemicals. However, modification of lignin is necessary for its application in advanced materials due to its chemically inert nature and structural complexity. Polymeric modification of lignin via graft copolymerization represents an important avenue for modification because this method forms stable covalent bond linkages between lignin and synthetic functional polymers. In this review, we discuss recent synthetic strategies toward polymeric modification of lignin using graft copolymerization and the special properties and applications of the produced lignin copolymers. © 2017 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2017 , 55, 3515–3528     

Digital photoelasticity of glass: A comprehensive review

The recent advances in digital photoelasticity have made it possible to use it conveniently for the stress analysis of articles and components made of glass. Depending on the application, the retardation levels to be measured range from a few nanometres to several thousand nanometres, which necessitates different techniques and associated equipments. This paper reviews the recent advances in the photoelasticity of glass with a focus on the techniques/methods developed in the last decade. A brief introduction to the residual stress in glass is provided initially to bring out its tensorial nature. The subsequent sections are organised thematically rather than chronologically, for better readability and easy access of information.     

Ni/TPC催化剂的制备、表征及在秸秆热解燃气重整中的应用

以废弃汽车外轮胎热解后的副产物轮胎热解焦（Tyre pyrolysis char，TPC）为原料，利用均匀沉淀法制备以轮胎焦为载体的负载型Ni/TPC催化剂，采用EDX、SEM、XRD、TG、BET手段对催化剂进行了表征与分析，同时使用管式炉测试了Ni/TPC催化剂在秸秆热解燃气重整中的催化性能，并考察了热解温度、保温时间、镍负载量及催化时间对秸秆热解燃气重整效果的影响。研究结果表明，TPC富含焦和金属，Ni/TPC催化剂分散均匀，热稳定性好，比表面积为62 m²/g。催化剂活性测试显示，Ni/TPC催化剂用于作物秸秆热解燃气重整具有很强的催化活性，可显著提高燃气中可燃气体含量；热解温度在750℃、保温时间10 min、30%的Ni负载量时Ni/TPC催化剂的催化效率最高，连续使用850 min后，燃气中的H₂含量仍相对提高到50%以上，长时间使用后活性结构由Ni₃ZnC_0.7转变成FeNi₃，催化活性依然较强且趋于稳定，TPC可以作为良好的新型镍基催化剂载体。     

EFFECT OF FORESTLAND AVAILABILITY BY OWNERSHIP TYPE ON LICENSE SALES FOR HUNTING: A SPATIAL APPROACH

Abstract The effect of forestland availability under different ownership types on license sales for hunting in nine Southeastern states is empirically evaluated. An equation that represents license sales for hunting is estimated assuming the sale of hunting licenses in a particular county is related to the characteristics of that county as well as the characteristics and license sales for hunting in its neighboring counties. The positive effects of the amounts of both national and private forestland on license sales reaffirm the potential benefits of maintaining forestland to stimulate hunting. The positive spillover effect of national forests on license sales for hunting suggests that availability and close access to hunting in national forests within neighboring counties are important in supporting hunting license sales in a county. This study contributes to the general understanding of the drivers affecting individuals’ decisions to use natural resources for hunting. Advances in natural resource modeling, specifically the spatial process model and geospatial data used in this research, make it possible to examine the interactions between the spatial dynamics and ownership attributes of the natural system, allowing policy makers to design natural resource management practices that respond to a system characterized by these interactions.     

Colourings of cubic graphs inducing isomorphic monochromatic subgraphs

A -bisection of a bridgeless cubic graph is a -colouring of its vertex set such that the colour classes have the same cardinality and all connected components in the two subgraphs induced by the colour classes ( monochromatic components in what follows) have order at most . Ban and Linial Conjectured that every bridgeless cubic graph admits a -bisection except for the Petersen graph. A similar problem for the edge set of cubic graphs has been studied: Wormald conjectured that every cubic graph with has a -edge colouring such that the two monochromatic subgraphs are isomorphic linear forests (ie, a forest whose components are paths). Finally, Ando conjectured that every cubic graph admits a bisection such that the two induced monochromatic subgraphs are isomorphic. In this paper, we provide evidence of a strong relation of the conjectures of Ban-Linial and Wormald with Ando's Conjecture. Furthermore, we also give computational and theoretical evidence in their support. As a result, we pose some open problems stronger than the above-mentioned conjectures. Moreover, we prove Ban-Linial's Conjecture for cubic-cycle permutation graphs. As a by-product of studying -edge colourings of cubic graphs having linear forests as monochromatic components, we also give a negative answer to a problem posed by Jackson and Wormald about certain decompositions of cubic graphs into linear forests.