摄像型等厚干涉实验仪器的研究

介绍了“摄像型等厚干涉实验仪”的构造及等厚干涉实验新的测量方法。     

On the environmental decoherence and spin interference in mesoscopic loop structures

Mechanisms of ‘environmental decoherence’ such as surface scattering, Elliot–Yafet process and precession mechanisms, as well as their influence on the spin phase relaxation are considered and compared. It is shown that the ‘spin ballistic’ regime is possible, when the phase relaxation length for the spin part of the wave function (L^(s)) is much greater than the phase relaxation length for the ‘orbital part’ (L^(e)). In the presence of an additional magnetic field, the spin part of the electron's wave function (WF) acquires a phase shift due to additional spin precession about that field. If the structure length L is chosen to be L^(s)>L>L^(e), it is possible to ‘wash out’ the quantum interference related to the phase coherence of the ‘orbital part’ of the WF, retaining at the same time that related to the phase coherence of the spin part and, hence, to reveal corresponding conductance oscillations.     

空气隙间隔格兰型棱镜偏光器透射光强扰动的温度效应

线偏振光正入射的情况下，空气隙间隔格兰型棱镜的透射光强随旋转角出现周期性增强的扰 动.扰动的出现影响了透射偏振光的质量.研究表明，透射光强对入射角有着敏感的依赖关系 .实验中空气隙间隔格兰型棱镜的振动引起入射角在棱镜的结构角附近作微小变化，从而导 致了透射光强的扰动.讨论了温度的变化对扰动大小的影响.给出了减小扰动的有效方法. 关键词： 偏光棱镜 热光效应 干涉 扰动     

Structural manipulation of pyrochlores: Thermal evolution of metastable Gd2(Ti1−yZry)2O7 powders prepared by mechanical milling

The structural and microstructural characteristics of metastable Gd₂(Ti_1−yZr_y)₂O₇ powders prepared by mechanical milling have been studied by a combination of XRD and Raman spectroscopy. Irrespective of their Zr content, as-prepared powder phases present an anion-deficient fluorite-type of structure as opposed to the pyrochlore equilibrium configuration obtained for the same solid solution by other synthetic routes. These fluorites are stable versus thermal activation, at least up to temperatures of 800 °C. For the Ti-rich compositions, thermal treatments at higher temperatures facilitate the rearrangement of the cation and anion substructures and the relaxation of mechanochemically induced defects whereas for compositions with high Zr content, the fluorite crystal structure is retained even at temperatures as high as 1200 °C. Interestingly enough, transient pyrochlores showing a very unusual cation distribution were observed during the thermally induced defect-recovery process.     

A microspectroscopic study of the electronic homogeneity of ordered and disordered Sr2FeMoO6

Disordered Sr₂FeMoO₆ shows a drastic reduction in saturation magnetization compared to highly ordered samples, moreover magnetization as a function of the temperature for different disordered samples shows qualitatively different behaviours. We investigate the origin of such diversity by performing spatially resolved photoemission spectroscopy on various disordered samples. Our results establish that e_xtensive electronic inhomogeneity, arising most probably from an underlying chemical inhomogeneity in disordered samples, is responsible for the observed magnetic inhomogeneity. It is further pointed out that these inhomogeneities are connected with composition fluctuations of the type Sr₂Fe_1+x Mo_1-x O₆ with Fe-rich (x > 0) and Mo-rich (x < 0) regions. Dedicated to Prof J Gopalakrishnan on his 62nd birthday.     

Synthesis,characterization and properties of methylaminocellulose

Homogeneously prepared tosylcelluloses (TC) with degrees of substitution (DS) of DS_Tos 0.1–1.8 were used as intermediates for the synthesis of methylaminocelluloses (MAC) by nucleophilic substitution with methylamine. TC with DS_Tos up to 1.1 were shown to be valuable intermediates for selective synthesis of MAC with DS_MA varying from 0.1 to approximately 1. No nucleophilic substitution was observed at higher DS_Tos. At the chosen reaction conditions (60 °C, 48 h) residual tosyl moieties remained unchanged and little hydrolysis took place. The samples obtained were characterized by means of elemental analysis, FTIR and ¹³C CP/MAS NMR spectroscopy. ¹³C CP/MAS NMR spectroscopy was found to be an efficient tool for quantification of DS_MA. Furthermore, the swelling behaviour in water was investigated and preliminary tests concerning the bilirubin adsorption capacity of MAC were carried out.     

Formulation for XPS spectral change of oxides by ion bombardment as a function of sputtering time

XPS measurement revealed that the original state of TiO₂ was changed to Ti₂O₃ and TiO by ion bombardment. TiO₂ decreased and Ti₂O₃ increased at the initial stage. TiO increased at a later stage than Ti₂O₃. Each of them saturated after enough sputtering time.A formulation was proposed in order to explain the change of XPS spectra for oxides as a function of ion sputtering time. This formulation was based on reaction equations that contain two reduction processes (from TiO₂ to Ti₂O₃ and from Ti₂O₃ to TiO), and sputtering effects. Using four fitting parameters (two reduction coefficients, sputtering yield and information depth), the present formula was fitted to the experimental results. The fitting results agree satisfactorily with the experimental results. The calculation shows that the reduction coefficient from TiO₂ to Ti₂O₃ is about ten times larger than that from Ti₂O₃ to TiO. This calculation predicts that surface composition of an oxide that is changed by ion bombardment will reach a different value depending on its bulk composition. Moreover, the present formulation can determine the chemical states of compounds changed by ion bombardment.     

Photoemission study of the modification of the electronic structure of transition-metal overlayers on TiO2 surfaces II. Cr on TiO2(0 0 1)

The electronic states of the Cr overlayers on TiO₂(0 0 1) surfaces have been investigated using angle-resolved and resonant photoemission spectroscopy with synchrotron radiation. At lower coverages, Cr deposition on TiO₂(0 0 1) creates two well separated in-gap emissions due to the formation of surface Ti³⁺ (3d¹) ions and Cr³⁺ (3d³) ions. At higher coverages, the in-gap emission is developed into the 2-peak-structure emission of Cr 3d character. The corresponding state is considered to be of metallic nature from the viewpoint of the high ability of oxygen adsorption, but has no Fermi edge, indicating a possibility of forming small Cr clusters on TiO₂(0 0 1) at this stage.     

Microsolvation of phthalocyanines in superfluid helium droplets.

Experimental and theoretical investigations of the spectroscopy of molecules in superfluid helium droplets provide evidence for the key role of the first helium layer surrounding the dopant molecule in determining the molecule's spectroscopic features. Recent investigations of emission spectra of phthalocyanine in helium droplets revealed a doubling of all transitions. Herein, we present the emission spectra of Mg-phthalocyanine and of phthalocyanine-argon clusters in helium droplets, which confirm the splitting as a general effect of the helium environment. A scheme of levels is deduced from the emission spectra and attributed to quantized states of the first helium layer surrounding the dopant molecule.     

Synthesis and characterization of polyaniline doped with organic acids

Spectroscopic [UV–visible and Fourier transform IR (FTIR)] and thermal properties of chemically synthesized polyanilines are found to be affected by varying the protonation media (acetic, citric, oxalic, and tartaric acid). The optical spectra show the presence of a greater fraction of fully oxidized insulating pernigraniline phase in polyaniline doped with acetic acid. In contrast, the selectivity in the formation of the conducting phase is higher in oxalic acid as a protonic acid media. The FTIR spectra of these polymers reveal a higher ratio of the relative intensities of the quinoid to benzenoid ring modes in acetic acid doped polyaniline. Scanning electron micrographs revealed a sponge‐like structure derived from the aggregation of the small granules in acetic acid and oxalic acid doped polyaniline. A three‐step decomposition pattern is observed in all the polymers, regardless of the protonic acid used for the doping. The second step loss related to the loss of dopant is found to be higher in the oxalic acid doped polymer. In accordance with these results the conductivity is also found to be higher in oxalic acid doped material. The temperature dependent conductivity measurements show the thermal activated behavior in all the polymers. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2043–2049, 2004