The use of 1H NMR microscopy to study proton-exchange membrane fuel cells.

To understand proton-exchange membrane fuel cells (PEMFCs) better, researchers have used several techniques to visualize their internal operation. This Concept outlines the advantages of using 1H NMR microscopy, that is, magnetic resonance imaging, to monitor the distribution of water in a working PEMFC. We describe what a PEMFC is, how it operates, and why monitoring water distribution in a fuel cell is important. We will focus on our experience in constructing PEMFCs, and demonstrate how 1H NMR microscopy is used to observe the water distribution throughout an operating hydrogen PEMFC. Research in this area is briefly reviewed, followed by some comments regarding challenges and anticipated future developments.     

An NMR study of methanol diffusion in polymer electrolyte fuel cell membranes

Methanol diffusion in two polymer electrolyte membranes, Nafion 117 and BPSH 40 (a 40% disulfonated wholly aromatic polyarylene ether sulfone), was measured using a modified pulsed field gradient NMR method. This method allowed for the diffusion coefficient of methanol within the membrane to be determined while immersed in a methanol solution of known concentration. A second set of gradient pulses suppressed the signal from the solvent in solution, thus allowing the methanol within the membrane to be monitored unambiguously. Over a methanol concentration range of 0.5–8 M, methanol diffusion coefficients in Nafion 117 were found to increase from 2.9 × 10⁻⁶ to 4.0 × 10⁻⁶ cm² s⁻¹. For BPSH 40, the diffusion coefficient dropped significantly over the same concentration range, from 7.7 × 10⁻⁶ to 2.5 × 10⁻⁶cm² s⁻¹. The difference in diffusion behavior is largely related to the amount of solvent sorbed by the membranes. Increasing the methanol concentration results in an increase in solvent uptake for Nafion 117, while BPSH 40 actually excludes the solvent at higher concentrations. In contrast, diffusion of methanol measured via permeability measurements (assuming a partition coefficient of 1) was lower (1.3 × 10⁻⁶ and 6.4 × 10⁻⁷ cm² s⁻¹ for Nafion 117 and BPSH 40 respectively) and showed no concentration dependence. The differences observed between the two techniques are related to the length scale over which diffusion is monitored and the partition coefficient, or solubility, of methanol in the membranes as a function of concentration. For the permeability measurements, this length is equal to the thickness of the membrane (178 and 132 μm for Nafion 117 and BPSH 40 respectively) whereas the NMR method observes diffusion over a length of approximately 4–8 μm. Regardless of the measurement technique, BPSH 40 is a greater barrier to methanol permeability at high methanol concentrations.     

Binding Aedes aegypti densonucleosis virus to ion exchange membranes

Experimental and numerical results for binding Aedes aegypti densonucleosis virus (AeDNV) using anion and cation exchange membranes are presented. AeDNV particles are adsorbed by anion and cation exchange membranes providing the virus particles and membranes are oppositely charged. Q membranes which are strongly basic anion exchangers were the most effective. Dynamic and static capacities for Q membranes were found to be similar. A numerical model is proposed which assumes a log normal pore size distribution. By estimating the required parameters from static binding experiments, the model may be used to calculate the breakthrough curve for virus adsorption.     

Novelties of solid-liquid phase transfer catalysed synthesis of p-toluenesulfonyl fluoride from p-toluenesulfonyl chloride

Organic sulfonyl fluorides are of interest owing to their insecticidal, germicidal and enzyme inhibitory properties. In the current work, synthesis of p-toluenesufonyl fluoride was accomplished by reacting p-toluenesulfonyl chloride with solid potassium fluoride using PEG-400 as a catalyst under solid-liquid phase transfer catalysis (S-L PTC) at 30 °C. p-Toluenesulfonyl fluoride is used as peroxygen bleach activator. It also finds use in the treatment of Alzheimer's disease. The mechanism is based on homogeneous solubilization of solid. PEG forms a complex with metal cation which associates with the nucleophile and it participates in SN₂ type reactions. The reaction is intrinsically kinetically controlled. A complete theoretical analysis is done to determine both the rate constant and equilibrium constant from the same set of data. The activation energy and Gibbs free energy are also calculated.     

The interaction of double-charged metal ions with monolayers and bilayers of phospholipids

Electrophoretic mobilities of hexadecane/water emulsions containing dimyristoyl-phosphatidylcholine (DMPC) or egg yolk lecithin (EYL) monolayers at the interface and those of liposomes prepared from the same lipids were measured as functions of the concentrations of Ca²⁺, Mn²⁺, Cu²⁺, and Ni²⁺ cations in the aqueous phase. The surface potentials, surface charge densities (σ), and the Langmuir adsorption isotherms for various distances from the charged surface to the slip plane (d) were calculated on the basis of the Gouy-Chapman theory for 1∶2 electrolytes and the values of ζ-potentials. The binding constants (K) and parametersd were determined under the assumption that the maximum σ values correspond to one ion per phospholipid molecule at the interface. In the case of DMPC, the ion binding constants (L mol⁻¹) at 25°C are 230 and 87 for Ca²⁺, 31.5 and 21 for Mn²⁺, 11 and 6 for Cu²⁺, and 7.5 and 5.3 for Ni²⁺ in liposomes and emulsions, respectively. The affinities of Cu²⁺ and Ni²⁺ ions for EYL monolayers and bilayers are lower than those for DMPC mono- and bilayers. Thed parameters for all ions are smaller than the radii of the hydrated ions. In the case of Ca²⁺, Cu²⁺, and Ni²⁺, thed values for mono- and bilayers are different. The differences in K values between monolayers and bilayers as well as those between DMPC and EYL mono- and bilayers can be attributed to the differences in the local environment and orientation of the interfacial phosphate groups in these systems. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 12, pp. 2490–2495, December, 1998.     

铈离子与氨基甲酸酯类化合物引发丙烯酰胺聚合的研究

本文对铈离子与苯基氨基甲酸酯类化合物在H_2O-CH_3CN(3∶1,V/V)及H_2O-HCONH_2(1∶2,V/V)两种介质中引发丙烯酰胺的聚合进行了研究。考察了不同结构的苯基氨基甲酸酯对聚合的影响。苯基氨基甲酸酯类化合物对铈离子引发聚合均有促进作用,其中对-甲苯基氨基甲酸酯的促进作用最为显著。测定了聚合反应表现活化能及聚合动力学方程,并提出了聚合反应机理。     

臭氧与二乙胺和三乙胺气相反应的速率常数

利用自制的烟雾箱系统研究了臭氧与二乙胺和三乙胺的气相反应动力学. 实验过程中保证二乙胺和三乙胺浓度远远大于臭氧浓度, 使得实验在准一级条件下进行. 加入环己烷以消除实验过程中可能产生的OH自由基对反应的影响. 在(298±1) K和1.01×105 Pa条件下, 测得臭氧与二乙胺和三乙胺反应的绝对速率常数值分别为(1.33±0.15)×10^-17和(8.20±1.01)×10^-17 cm³·molecule^-1·s^-1. 与文献中已有的其它胺类的臭氧反应数据比较后发现, 臭氧与胺的反应可以用亲电反应机制来解释. 另外, 通过对比发现, 臭氧与三取代的烷基胺类的反应速率要远远大于其与二取代的烷基胺类的反应速率. 这在一定程度上可有助于解释外场观测到的气溶胶相中二烷基胺盐较多的事实. 利用测得的速率常数和大气中臭氧浓度, 还估算了二乙胺和三乙胺与臭氧反应的大气寿命. 结果显示, 与臭氧的反应是二乙胺和三乙胺在大气中的一种重要的消除途径, 尤其是在污染严重地区.     

Conversion of sodium lactate to lactic acid with water-splitting electrodialysis

The conversion of sodium lactate to lactic acid with water-splitting electrodialysis was investigated. One way of reducing the power consumption is to add a conductive layer to the acid compartment. Doing this reduced the power consumption by almost 50% in a two-compartment cell, whereas the electric current efficiency was not affected at all. Three different solutions were treated in the electrodialysis unit: a model solution with 70 g/L of sodium lactate and a fermentation broth that had been prefiltered two different ways. The fermentation broth was either filtered in an open ultrafiltration membrane (cut-off of 100,000 Dalton) in order to remove the microorganisms or first filtered in the open ultrafiltration membrane and then in an ultrafiltration membrane with a cut-off of 2000 Dalton to remove most of the proteins. The concentration of sodium lactate in the fermentation broth was 70 g/L, as well. Organic molecules present in the broth (peptides and similar organic material) fouled the membranes and, therefore, increased power consumption. Power consumption increased more when permeate from the more open ultrafiltration membrane was treated in the electrodialysis unit than when permeate from the membrane with the lower cut-off was treated, since there was a higher amount of foulants in the former permeate. However, the electrodialysis membranes could be cleaned efficiently with a 0.1 M sodium hydroxide solution.     

Hydration and Lyotropic Melting of Amphiphilic Molecules: A Thermodynamic Study Using Humidity Titration Calorimetry

The hydration of the lipid 1-palmitoyl-2-oleoylphosphatidylcholine (POPC) and of the cationic detergent dodecyltrimethylammonium bromide (DTAB) has been studied by means of isothermal titration calorimetry (ITC), gravimetry, and infrared (IR) spectroscopy. During the experiments films of the amphiphiles are perfused by an inert gas of variable relative humidity. The measurement of adsorption heats using ITC represents a new adaptation of adsorption calorimetry which has been called the humidity titration technique. This method yields the partial molar enthalpy of water upon adsorption. It is found to be endothermic with respect to the molar enthalpy of water on condensation for the water molecules which interact directly with the headgroups of POPC and DTAB. Consequently, the spontaneous hydration of the amphiphiles is entropy driven in an aqueous environment. IR spectroscopy shows that hydration is accompanied by the increase in the conformational and/or motional freedom of the amphiphilic molecules upon water binding. In particular, a lyotropic chain melting transition is induced at a certain characteristic relative humidity. This event is paralleled by the adsorption of water. The corresponding exothermic adsorption heat is consumed completely (POPC) or partially (DTAB) by the hydrocarbon chains upon melting. Differential scanning calorimetry was used as an independent method to determine transition enthalpies of the amphiphiles at a definite hydration degree. Water binding onto the headgroups is discussed in terms of hydrogen bonding and polar interactions. The adsorption isotherms yield a number of 2.6 tightly bound water molecules per POPC and DTAB molecule.     

Beiträge zur Chemie der Pyrrolpigmente, 78. Mitt.: Die Eigenschaften desb-Nor-bilatrien-abc-b-Nor-biladien-ac-Systems

The redox coupleb-nor-biladiene-ac (2)/b-nor-bilatriene-abc (3) exhibits an oxidative half wave potential of 800 mV in acetonitrile solution. It is demonstrated that it can be used as an extremely efficient electron carrier through bulk membranes. Whereas2 is not suitable as a ligand in carrier mediated cation transport,3 is a medium suited carrier for Cu(II) or Zn(II) ions, however, it is the most efficient one found so far for transport of Hg(II) ions. A 1:1 zinc chelate of3 is isolated and characterized. it is deduced to represent a polymer consisting of about 73 monomer units.