Oxidation of Styrene with Molecular Oxygen in Supercritical CO2

The oxidation of styrene with molecular oxygen catalyzed by PdCl2 CuCl2 has been investigated in supercritical CO2 with a batch reactor. The oxidative system of styrene contains four components at the beginning and seven components during the reaction. The critical temperature, critical pressure, and critical density at different conversions are determined by using a high-pressure view cell. The effect of phase behavior on the conversion and selectivity were studied. Experimental results showed that the critical parameters of the reaction mixture at fixed initial molar ratio changed with the conversion of reactant. The conversion of styrene reached maximum near the critical density of the reaction mixture. Product selectivity also varied with density of reaction mixture and could be tuned to some degree.     

活性炭纤维电极电解法处理墨绿B染料废水

将铁丝缠绕在活性炭纤维(简称ACF)上制成电极,并在阴极鼓入空气,用电解生成的Fenton试剂处理墨绿B染料模拟废水.研究了电压、pH值、温度、空气流量、支持电解质的浓度等因素对染料脱色率的影响.结果表明,pH值越低,温度越高,处理效果越好,气流量的改变对于处理效果影响不大.室温时处理浓度为50mg·L-1的活性染料墨绿B,在实验电压为11V,中性条件下,无水硫酸钠的浓度为20g·L-1,通入空气流量为60L·min-1时,处理60min,色度去除率达到95%左右.55℃时,电解30min色度去除率就达到96%,60min时达到100%.     

A novel and efficient route to diarylmethanes catalyzed by nickel(II) ion on nanoporous carbon

Much improved catalytic carbon-carbon bond-forming reactions between aryl chlorides and Grignard reagents has been achieved using nickel(II) ion on nanoporous carbon.     

在Ar气流中热处理KOH-煤焦制大比表面积活性炭

本文将煤焦与ＫＯＨ混合，在Ａｒ气流中进行低温、高温二次热处理，制得了比表面积为２９１８ｍ２／ｇ的活性炭。考查了操作条件对产品性能的影响，同时用Ｘ射线衍射分析研究了煤焦制活性炭过程中的结构变化特征     

Carbon anode materials from polysiloxanes for lithium ion batteries

Three kinds of silicon-containing disordered carbons have been prepared by pyrolysis of polysiloxanes with different amounts of phenyl side groups. X-ray powder diffraction, X-ray photoelectron spectroscopy and electrochemical capacity measurements were performed to study their behaviors. Graphite crystallites, micropores, and silicon species affect their electrochemical performances. All of them present high reversible capacities, >372 mAh/g. Since the graphite crystallites are very small, they contribute very little to reversible capacity. The number of micropores produced by gas emission during the heat-treatment process decides whether they exhibit reversible capacity. Si mainly exists in the form C–Si–O and influences the irreversible capacity. There is no evident capacity fading in the first ten cycles, indicating promising properties for these disordered carbons.     

XPS C 1s binding energies for fluorocarbon–hydrocarbon microblock copolymers

Fluorocarbon–hydrocarbon microblock copolymers –(CF₂)_n–(CH₂)_m– (n = 4, 6, 8; m = 6, 8, 10) were synthesized. Binding energies of the C 1s and F 1s peaks of these copolymers were measured using x‐ray photoelectron spectroscopy. The binding energy of the C 1s peaks of the carbon atoms of the hydrocarbon segments was set at 285.0 eV as the binding energy reference. Unexpectedly, the binding energy of the C 1s peak corresponding to the CF₂ group of the microblock copolymers was determined to be ～291.4 eV, which is ～0.8 eV lower than that of the CF₂ group of tetrafluoroethylene. Copyright © 2003 John Wiley & Sons, Ltd.     

Use of x-ray microtomography to visualise dynamic adsorption of organic vapour and water vapour on activated carbon

X-ray microtomography coupled with image analysis was used to quantify the adsorption of vapours on activated carbon beds. This technique was tested using three different challenges: CCl₄, water vapour and a mixture of water- and organic vapour. It is shown that the used technique allows determining the adsorption front progress in the case of organic vapour and mixture of water and organic vapour whereas the existence of this front was not so obvious in the case of water vapour. Experimental results obtained for organic vapours were interpreted on the basis of the Wheeler-Jonas equation: a good agreement was found between experimental and theoretical breakthrough times.     

Electrochemical investigation of hymecromone at a multi-wall carbon nano-tube/cetyl pyridine bromine composite film electrode

A multi-wall carbon nanotube (MWNT)/cetyl pyridine bromine (CPB) composite film modified glassy carbon electrode (GCE) was developed for the electrochemical determination of hymecromone in phosphonate buffer. Electrochemical behaviour of hymecromone at the composite film electrode was investigated with voltammetry. Compared with an irreversible oxidation of hymecromone at the bare GCE, the oxidation peak current was enhanced greatly at the film electrode. Some parameters such as pH, scan rate, accumulation potential and accumulation time were optimized. Under optimal conditions, an oxidation peak at 0.82 V was employed to determine hymecromone electrochemically. A linearity between the oxidation peak current and the hymecromone concentration was obtained in the range of 3.0 × 10⁻⁷ − 2.0 × 10⁻⁵ mol 1⁻¹ with a detection limit of 8.0 × 10⁻⁸ mol 1⁻¹. The proposed procedure was successfully applied to assay hymecromone in pharmaceutical formulation with satisfactory results. The text was submitted by the authors in English.     

互通多孔碳/二氧化锰纳米复合材料的原位水热合成及电化学性能

以互通多孔碳（IPC）为载体，水热条件下在碳表面原位反应生成纳米结构的二氧化锰（MnO₂），制备互通多孔碳/二氧化锰纳米（IPC/MnO₂）复合电极材料. 采用扫描电镜（SEM），透射电镜（TEM），X射线衍射（XRD），热重分析（TGA）对其结构进行表征；采用循环伏安法、恒流充放电和交流阻抗对其电化学性能进行研究. 结果表明：生成的MnO₂均匀地负载在碳的表面，形成多层次结构，并且随着温度的升高IPC表面负载的MnO₂由纳米颗粒变为纳米片状结构；MnO₂纳米片具有典型的K-Birnessite 型晶体结构；复合物中MnO₂的含量约为34%（w）. 在100 ℃制备的IPC/MnO₂复合材料在三电极系统中最高比电容达到了411 F·g^-1；随着反应温度的升高,比容量先增长后基本保持不变. 以IPC/MnO₂为正极，活性炭（AC）为负极，1 mol·L^-1 Na₂SO₄溶液为电解液组装成IPC/MnO₂//AC 混合超级电容器，发现IPC/MnO₂电极的电容器其电位窗口从1 V扩展到1.8 V，容量可达86F·g^-1，且表现出良好的电容特性和大电流放电性能.     

Electric conductivity in a fibrous porous medium with thin but polarized double layers

The electric conduction in the fibrous medium constructed by a homogeneous array of parallel, identical, charged, circular cylinders having an arbitrary zeta potential filled with the solution of a symmetrically charged electrolyte is analytically examined. The thickness of the electric double layers surrounding the dielectric cylinders is assumed to be small relative to the radius of each cylinder and to the gap width between two neighboring cylinders, but the polarization of the mobile ions in the diffuse layers is allowed. The effect of interactions among individual cylinders is taken into explicit account by employing a unit cell model. The appropriate equations of conservation of electrochemical potential energies of ionic species are solved for each cell, in which a cylinder is envisaged to be surrounded by a coaxial cylindrical shell of the fluid solution. Analytical expressions for the effective electric conductivity are obtained in closed forms as functions of the porosity of the fiber matrix and other characteristics of the porous system. Comparisons of the results of the cell model with different conditions at the outer boundary of the cell are made. Under an otherwise identical condition, the electric conductivity in a porous medium composed of an array of parallel cylinders in the transverse direction is smaller than that of a suspension of spheres. The effect of interactions among the cylinders or spheres on the effective conductivity can be quite significant under appropriate conditions.