INFLUENCES OF ACID POST-TREATMENT ON THE MORPHOLOGY OF SOAPFREE P（MMA-EA-MAA） PARTICLES PREPARED BY SEEDED EMULSION POLYMERIZATION

Soap-free poly（methyl methacrylate-ethyl acrylate-methacrylic acid） latex particles with narrow size distribution were synthesized by seeded emulsion polymerization, and the porous particles were created by a stepwise alkali/acid treatment method. Effects of acid treatment conditions on the particle morphology were investigated. Results show that one to three pores were formed inside most of particles after post-treatment. At pH 7.0, when the treatment temperature was lower than 70℃, the size of particles and the volume of pores remained almost unchanged, and these two values increased significantly when the temperature was higher than 70℃. Both the particle size and the pore volume decreased with the increase of initial pH value and treatment time in the acid treatment. As the pH was below 4.0 and the treatment time was longer than 180 min, the particles shrunk in size.     

具有平整表面的定向纳米碳管膜的制备

为了获得表面平整的定向纳米碳管，通过化学及物理的方法将纳米碳管膜进行反转，使其原来的AAO模板底面成为新的表面，用溶液逐步去除表面的铝和氧化铝后，获得了平整的定向纳米碳管膜表面，从而可将其作为工作面使用. 还比较了5％NaOH和6%H₃PO₄＋1.8%H₂CrO₄溶液去除氧化铝的效果.     

快速响应的温敏性聚(N-异丙基丙烯酰胺)水凝胶 Ⅰ.以CaCO_3为成孔剂制备方法、表征及动力学研究

以不同粒径的CaCO3粒子为成孔剂 ,合成了快速响应的温敏性聚 (N 异丙基丙烯酰胺 ) (PNIPA)水凝胶 .利用扫描电镜观察到水凝胶具有特殊的孔状结构 ,得到水凝胶的孔径大小为几十微米左右 .动力学研究表明 ,该水凝胶在温敏膨胀或收缩时 ,具有快速的响应速率 ,在 10min内的失水率可达 90 % .比较了干凝胶和4 0℃下失水后的凝胶两种不同状态下水凝胶的膨胀曲线 ,发现两者的溶胀动力学曲线明显不同 ,前者的曲线有拐点 .同时发现与失水收缩速率相比 ,水凝胶具有较慢的吸水膨胀速率 .     

Carbyne — the third allotropic form of carbon

The history of the discovery of carbyne, the chemical and physical methods used to obtain it, the analysis of its structure, and some of its properties are briefly considered. The prospects for its practical applications are discussedThis publication is based on a number of works on carbyne submitted for the Russian State Prize in the field of science and technology in 1993; performed at the A. N. Nesmeyanov Institute of Organoelement Compounds, Russian Academy of Sciences and the M. V. Lomonosov Moscow State University.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 3, pp. 450–463, March, 1993.     

盐酸氨溴索在碳糊电极上阳极伏安法的研究

在０．５ ｍｏｌ／Ｌ Ｈ２ＳＯ４底液中，用碳糊电极阳极伏安法测定盐酸氨溴索，被测的阳极峰电位为１．１０Ｖ（ｖｓ．ＳＣＥ），另外，在０．４６Ｖ处还产生一对可逆的氧化还原峰。１．１０ Ｖ处的峰电流与盐酸氨溴索的浓度在３．９８×１０~（－７）～６．３４ × １０~（－５）ｍｏｌ／Ｌ范围内呈良好的线性关系，该方法的检出下限为３．０ × １０~（－８）ｍｏｌ／Ｌ。用标准加入法测得回收率范围为９２．８％～１０２％，ＲＳＤ为２．９％（ｎ＝１０）。对电极响应机理进行了初步探讨，氨溴索在１．１０ Ｖ处的氧化为不可逆过程，其氧化产物在０．４６０Ｖ处产生一对２电子２质子受扩散控制的可逆波，用该波也可进行定量测定并且干扰较少，但灵敏度略低。     

羧基化碳纳米管嵌入石墨修饰电极对多巴胺和抗坏血酸的电催化

采用涂层和嵌入修饰法 ,将羧基化多层碳纳米管制成两种修饰电极。以多巴胺 (DA)和抗坏血酸(AA)为模型化合物 ,研究了两种修饰电极对DA和AA共存时的电催化作用。结果表明 :嵌入的方式比涂层的方式显示了更多的优点。嵌入修饰电极不仅使峰电流增加 ,并且使两者共存时的氧化峰位分离达 16 0mV ,同时 ,该电极对DA的响应灵敏于AA ,这有利于在大量的AA存在下实现对DA的测定。在 1× 10 - 3 mol/L的AA的存在下 ,还原电流的一阶导数与DA浓度在 5× 10 - 7～ 1× 10 - 4 mol/L范围内呈良好的线性关系 ;检测下限达 1× 10 - 7mol L。     

超声场下苯酚吸附相平衡和均相催化剂氧化降解实验研究

测定了常规条件和超声场条件下苯酚在活性炭上的吸附等温线,并研究了超声再生活性炭和均相催化剂氧化降解苯酚实验.研究结果表明,超声场作用下苯酚在活性炭上的吸附等温线降低,平衡吸附量减少,被脱附下来的苯酚及时被Cu2 和Fe3 型催化剂氧化降解,吸附剂得到更彻底再生,避免了二次污染,而且再生后的活性炭均具有较高的二次吸附能力,对于处理低浓度含酚废水具有实际意义.     

Deposition and characterization of Langmuir‐Blodgett films of cadmium arachidate/SWCNTs composites

The incorporation of single‐wall carbon nanotubes (SWCNTs) in cadmium arachidate film by means of the Langmuir‐Blodgett (LB) technique was investigated as a function of arachidic acid/SWCNT mass ratio at the air/water interface and in Langmuir‐Blodgett films. The behaviour at the air/water interface shows that SWCNTs act as an independent phase with respect to the cadmium arachidate. Deposition conditions are optimized when the weight ratio between the arachidic acid (AA) and SWCNTs is in the range 0.018:1 to 1:1. The general order of the LB multilayered structure was destroyed by the progressive density increase in SWCNT quantity as evidenced by X‐ray reflectivity (XRR) analysis. Scanning electron microscopy images indicated that when a multilayered structure was formed its layers consisted of SWCNT bundles stacked one over the other. Copyright © 2006 John Wiley & Sons, Ltd.     

Copolymer of Di (methacryloyloxymethyl) naphthalene and divinylbenzene as a column packing for high-performance liquid chromatography

Summary A new porous polyaromatic ester packing was synthetized for high performance liquid chromatography. The relationship between retention and chain length of the members of homologous series of alkylbenzenes, N-alkylanilines, alkylarylethers, alkylbenzoates and alkylarylketones on this new stationary phase using different eluents was investigated. Using the alkylarylketone scale the retention indices of the homologues and test compounds were calculated. The results were compared with those obtained for poly (styrene-divinylbenzene) polymers. For both types of packing the first members of each homologous series gave non-linear behaviour. The methylene group index increments are different for the studied homologous series; thus there is no simple additivity of the retention indices. The efficiency of the porous polymeric columns is a function of the capacity factor of the solute and the organic component of the eluent.