Structural and electrical properties of crystalline (1−x)Ta2O5−xTiO2 thin films fabricated by metalorganic decomposition

Polycrystalline (1−x)Ta₂O₅−xTiO₂ thin films were formed on Si by metalorganic decomposition (MOD) and annealed at various temperatures. As-deposited films were in the amorphous state and were completely transformed to crystalline after annealing above 600 °C. During crystallization, a thin interfacial SiO₂ layer was formed at the (1−x)Ta₂O₅−xTiO₂/Si interface. Thin films with 0.92Ta₂O₅–0.08TiO₂ composition exhibited superior insulating properties. The measured dielectric constant and dissipation factor at 1 MHz were 9 and 0.015, respectively, for films annealed at 900 °C. The interface trap density was 2.5×10¹¹ cm⁻² eV⁻¹, and flatband voltage was −0.38 V. A charge storage density of 22.8 fC/μm² was obtained at an applied electric field of 3 MV/cm. The leakage current density was lower than 4×10⁻⁹ A/cm² up to an applied electric field of 6 MV/cm.     

Ultrafiltration of a polymer-electrolyte mixture

We present a mathematical model to describe the ultrafiltration behaviour of polymer-electrolyte mixtures. The model combines the proper thermodynamic forces (pressure, chemical potential and electrical potential differences) with multicomponent diffusion theory. The model is verified with experimental data on the ultrafiltration of aqueous solutions of PEG-4000 and potassium phosphate. The single solute rejection of PEG-4000 goes through a maximum as also found by others. The single solute rejection of potassium phosphate depends on the ionic strength of the solution. At low ionic strength rejections are found of 50%. Solutions containing a high concentration of PEG-4000 and potassium phosphate show a negative rejection for potassium phosphate. This is caused by the strongly non-ideal behaviour of these aqueous solutions. The model predicts the behaviour of single solute experiments quite well, but some deviations are found with the mixed solute experiments. However, negative rejections found in the mixed solute experiments are predicted by the model.     

Holographic image subtraction using a polarization technique

A holographic image subtraction technique is proposed. The vector nature of light is utilized in introducing a phase difference of π between the two reconstructed object waves. The experimental results are also presented.     

Chemical imaging in biology and medicine using ion microscopy

The ability to quantitatively map the distribution of elements on the micrometer scale and smaller with high sensitivity and isotopic discrimination is unique to ion microscopy. The information contained in ion images can be crucial to the study of the solid state, where chemical heterogeneity is often directly related to observed behavior. The tools of digital image processing allow the extraction of quantitative information from the image data. These techniques coupled with improved instrumentation for the detection of ion images drastically increase the problem solving capabilities of the ion microscope. The use of such methods and instrumentation in the ion microscopic analyses of cell cultures and tissues of biological and biomedical relevance will be discussed.     

GS-221高速摄影测量仪测角信息的采集与处理

在GS-221高速摄影测量仪中,测角信息采集与处理速度的快慢是重要性能指标之一。本文讨论了如何在尽可能短的时间内对测角信息进行采集和处理的软件实现方法。     

Circularly polarized light-induced electrogyration in the Au nanoparticles on the ITO

We have found that the gold nanoparticles on the ITO substrates might be considered promising materials for circularly polarized light-induced linear electrogyration (EG). The maximal achieved value of the EG susceptibility described by third-order axial tensor caused by probe circularly polarized light at a wavelength of 1060 nm was equal to about 13 deg/mm at pulsed electric field strength 30.0 V/cm with a duration of about 1 ms. We have revealed that the maximal EG coefficient is achieved for the samples possessing maximal resistivity. The investigated composites possess long-lived EG grating which decreases by not more than 12% after 120 min of laser treatment. Applying a non-circular pump light leads to the diminishing of the observed EG.     

Characterisation of oxygen defects in calciumdifluoride

We study the aggregation of oxygen dipoles well dispersed in a CaF₂ crystal upon annealing at temperatures ranging from 370 to 420 K. The concentration of oxygen dipoles is monitored by measuring the intensity of the ionic thermocurrent peak as well as by absorption and luminescence spectroscopies. Results from three methods agree within experimental error and yield an activation energy of (1.2±0.1) eV for the diffusion of isolated oxygen centres in the crystal.     

Model-Free Analysis of Mixtures by NMR Using Blind Source Separation

The concept of blind source separation is described and examples of its use in 1D and 2D NMR spectroscopy are presented. The goal of this data processing method is to extract the spectra of components molecules when only mixtures are available.     

浅议物理实验教学环节改革

为进一步提高大学物理实验的教学质量，本文就实验课的预习、操作、实验报告的撰写及考核方法进行了探讨。     

Orbital-selective Mott-insulator transition in Ca 2 - x Sr x RuO 4

The electronic structures of the metallic and insulating phases of the alloy series Ca_2-xSr_xRuO₄ ( 0 ? x ? 2) are calculated using LDA, LDA+U and Dynamical Mean-Field Approximation methods. In the end members the groundstate respectively is an orbitally non-degenerate antiferromagnetic insulator (x = 0) and a good metal (x = 2). For x > 0.5 the observed Curie-Weiss paramagnetic metallic state which possesses a local moment with the unexpected spin S = 1/2, is explained by the coexistence of localized and itinerant Ru-4d-orbitals. For 0.2 < x < 0.5 we propose a state with partial orbital and spin ordering. An effective model for the localized orbital and spin degrees of freedom is discussed. The metal-insulator transition at x = 0.2 is attributed to a switch in the orbital occupation associated with a structural change of the crystal. Received 27 July 2001