Acetylcholinesterase biosensor based on single-walled carbon nanotubes--Co phtalocyanine for organophosphorus pesticides detection

A simple and reliable technique has been developed for the construction of an amperometric acetylcholinesterase biosensor based on screen-printed carbon electrodes. For the first time, one-step modification using single-walled carbon nanotubes and Co phtalocyanine has been proposed to decrease the working potential and to increase the signal of thiocholine oxidation. The biosensor developed made it possible to detect 5-50 ppb of paraoxon and 2-50 ppb of malaoxon with detection limits of 3 and 2 ppb, respectively (incubation 15 min). The biosensor showed high reproducibility when measurements of the substrate and inhibitor were performed (R.S.D. about 1% and 2.5%, respectively). The reliability of the inhibition measurements was confirmed by testing spiked samples of sparkling and tape waters.     

Fabrication of a nanostructure-based electrochemical sensor for simultaneous determination of N-acetylcysteine and acetaminophen

A carbon-paste electrode modified with 2,7-bis(ferrocenyl ethyl)fluoren-9-one (2,7-BF) and carbon nanotubes (CNTs) was used for the sensitive and selective voltammetric determination of N-acetylcysteine (NAC). The mediated oxidation of NAC at the modified electrode was investigated by cyclic voltammetry (CV). Also, the values of catalytic rate constant (k), and diffusion coefficient (D) for NAC were calculated. Differential pulse voltammetry (DPV) of NAC at the modified electrode exhibited two linear dynamic ranges with a detection limit (3σ) of 52.0 nmol L⁻¹. DPV was used for simultaneous determination of NAC and acetaminophen (AC) at the modified electrode, and quantitation of NAC and AC in some real samples by the standard addition method.     

Hydrolysis of the amide bond in N-acetylated l-methionylglycine catalyzed by various platinum(II) complexes under physiologically relevant conditions

The hydrolytic reactions between various Pt(II) complexes of the type [Pt(L)Cl₂] and [Pt(L)(CBDCA-O,O′] (L is ethylenediamine, en; (±)-trans-1,2-diaminocyclohexane, dach; (±)-1,2-propylenediamine, 1,2-pn and CBDCA is the 1,1-cyclobutanedicarboxylic anion) and the N-acetylated l-methionylglycine dipeptide (MeCOMet-Gly) were studied by ¹H NMR spectroscopy. All reactions were realized at 37 °C with equimolar amounts of the Pt(II) complex and the dipeptide at pH 7.40 in 50 mM phosphate buffer in D₂O. Under these experimental conditions, a very slow cleavage of the Met-Gly amide bond was observed and this hydrolytic reaction proceeds through the intermediate [Pt(L)(H₂O)(MeCOMet-Gly-S)]⁺ complex. In general, it can be concluded that faster hydrolytic cleavage of the MeCOMet-Gly dipeptide was observed in the reaction with the chloride complex than with corresponding CBDCA Pt(II) complexes. The steric effects of the Pt(II) complex on the hydrolytic cleavage of the amide bond in the MeCOMet-Gly dipeptide were also investigated by ¹H NMR spectroscopy. It was found that the rate of hydrolysis decreases as the steric bulk of the CBDCA and chlorido Pt(II) complexes increase (en > 1,2-pn > dach). These results contribute to a better understanding of the toxic side effects of Pt(II) antitumor drugs and should be taken into consideration when designing new potential Pt(II) antitumor drugs with preferably low toxic side effects.     

氨基化镁铝类水滑石修饰电极及电化学杀菌

以层间插入十二烷基磺酸钠的镁铝类水滑石（Mg/Al-SDS-HTLc）,与十六烷基三甲基溴化铵（CTAB）和3-氨丙基三乙氧基硅烷（APS）缩合反应制备了氨基化镁铝类水滑石（Mg/Al-NH2-HTLc）。 然后以Mg/Al-NH2-HTLc修饰热解石墨电极,通过循环伏安法探讨了该电极对吸附在其表面的大肠杆菌的杀灭作用。 结果表明,被吸附的大肠杆菌在经过循环伏安扫描后死亡率达到98.68%,大肠杆菌的死亡可能是由于细胞膜中易氧化物质（如鸟嘌呤）被氧化所致。     

聚邻氨基苯甲酸-铜复合薄膜修饰电极的制备及其电化学性能

利用聚合物官能团对金属离子的配位作用,在电极表面原位制备了金属粒子。 首先在玻碳电极（GCE）表面电沉积聚邻氨基苯甲酸(PoABA),再化学吸附铜离子(Cu2+),用水合肼还原得到单质铜(Cu0)。 采用扫描电子显微镜和能谱分析表征了聚邻氨基苯甲酸 铜(PoABA-Cu0)复合薄膜的表面形貌和元素构成,研究了PoABA-Cu0修饰电极的电化学性能,并以其检测了过氧化氢（H2O2）。 结果表明,电极表面被修饰上了一层PoABA-Cu0复合薄膜;制备的修饰电极对H2O2具有良好的电催化性能,在邻氨基苯甲酸的聚合圈数为10、Cu2+的吸附时间为10 min、工作电压为-0.3 V时,该修饰电极对H2O2表现出了最佳的检测性能,其线性浓度范围为5.0×10-5～1.0×10-2 mol/L,灵敏度为96.3 μA·L/(mmol·cm),检测限为5.0×10-5 mol/L,且具有较好的稳定性。     

茜素S复合铋膜电极电催化还原氯霉素

本研究采用电化学法制备茜素S复合铋膜修饰玻碳电极,利用循环伏安法、差示脉冲伏安法(DPV)研究氯霉素在茜素S复合铋膜电极上的电化学行为,并对其电化学测试条件进行优化.在pH 7.0的KH2PO4-Na2HPO4缓冲溶液中,氯霉素在-0.63 V处产生一灵敏的不可逆还原峰,显示出复合铋膜对氯霉素的还原有很好的催化作用.D...     

肉桂酸修饰电极同时测定多巴胺和抗坏血酸的研究

用电化学聚合方法制备肉桂酸(CA)修饰的玻碳电极(PCA/GC),研究多巴胺(DA)和抗坏血酸(AA)在修饰电极上的电化学行为.结果表明,在DA和AA共存体系中,DA、AA在PCA/GC电极上氧化峰电流增大且氧化峰电位相差200 mV,据此可同时检测DA和AA.在pH 7.0磷酸盐缓冲液中,DA和AA的氧化峰电流与其浓...     

Ru0.7Si0.3O2/Ti电极电催化氧化处理硝基苯废水

制备了Ru0.7Si0.3O2/Ti电极,并以该电极作为氧化阳极,不锈钢为阴极,电催化氧化降解废水中硝基苯。 实验结果表明,当硝基苯初始质量浓度为220 mg/L时,最佳条件为：电流密度25×10-3 A/cm2;Na2SO4作为电解质时加入量为8 g/L;溶液初始pH=2。 在此最佳条件下,硝基苯去除率大于85%,TOC去除率大于50%,表明Ru0.7Si0.3O2/Ti阳极能有效去除废水中有机污染物;对中间产物的检测结果表明,硝基苯的降解是阴阳两极协同作用的结果。     

聚氨基黑10B修饰电极检测维生素B6

采用电化学聚合的方法将氨基黑10B染料分子修饰到玻碳电极表面,制备了聚氨基黑10B修饰电极,其稳定性和重复性较好。 该修饰电极对维生素B6（VB6）的氧化有明显的电催化作用,VB6的氧化峰电位负移,电流显著增加。 利用微分脉冲伏安和安培检测技术对VB6进行了定量检测,检测限均可达到0.05 μmol/L,与已报道的修饰电极比较,是目前最低的。 将该修饰电极用于不同药物制剂中VB6浓度的测定,操作方便、快速,方法灵敏,准确度高。     

HBF4溶液中全铅液流电池

报道了一种HBF₄水溶液中的全铅液流电池,正、负电极电解液均采用Pb（BF₄）₂的HBF₄水溶液.在酸性的四氟硼酸铅电解液中考察了石墨电极和玻碳电极作为工作电极的循环伏安性能,石墨电极较适于用作全铅液流电池的正、负电极.采用石墨电极作为电池的正、负电极并在四氟硼酸铅酸性电解液中进行充放电实验,其中Pb（BF₄）₂浓度分别为0.5、1.0和1.5 mol·L^-1,且保持游离的HBF₄浓度为1.0 mol·L^-1.该电池为单液流电池,不需要隔膜分隔正、负极的电解液,电流密度为10、20和40 mA.cm^-2,当限定充电容量为7.0 mAh.cm^-2,放电电压截止到1.0 V时,平均库仑效率大于87%,平均能量效率大于68%;当电解液采用1.0或1.5 mol·L^-1 Pb（BF₄）₂+1.0 mol·L^-1HBF₄水溶液时,在10及20 mA.cm^-2电流下的能量效率最高可超过74%.